• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.15 no.7
• /
• pp.559-563
• /
• 2002

A threshold voltage model of SiC N-channel MOSFETs for high-temperature and hard radiation environments has been developed and verified by comparing with experimental results. The proposed model includes the difference in the work functions, the surface potential, depletion charges and SiC/$SiO_2$acceptor-like interface state charges as a function of temperature. Simulations of the model shoved that interface slates were the most dominant factor for the threshold voltage decrease as the temperature increase. To verify the model, SiC N-chnnel MOSFETS were fabricated and threshold voltages as a function of temperature were measured and compared wish model simulations. From these comparisons, extracted density of interface slates was $4{\times}10^{12}\textrm{cm}^{-2}eV^{-1}$.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.9
• /
• pp.1771-1777
• /
• 2016

In this thesis, the breakdown voltage characteristics of silicon nanowire N-channel GAA MOSFETs were analyzed through experiments and 3-dimensional device simulation. GAA MOSFETs with the gate length of 250nm, the gate dielectrics thickness of 6nm and the channel width ranged from 400nm to 3.2um were used. The breakdown voltage was decreased with increasing gate voltage but it was increased at high gate voltage. The decrease of breakdown voltage with increasing channel width is believed due to the increased current gain of parasitic transistor, which was resulted from the increased potential in channel center through floating body effects. When the positive charge was trapped into the gate dielectrics after gate stress, the breakdown voltage was decreased due to the increased potential in channel center. When the negative charge was trapped into the gate dielectrics after gate stress, the breakdown voltage was increased due to the decreased potential in channel center. We confirmed that the measurement results were agreed with the device simulation results.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.10 no.3
• /
• pp.240-250
• /
• 2010

Double Gate MOSFETs (DG MOSFETs) with doping in one or two thin layers of an otherwise intrinsic channel are simulated to obtain the transport characteristics, threshold voltage and leakage current. Two different device structures- one with doping on two layers near the top and bottom oxide layers and another with doping on a single layer at the centre- are simulated and the variation of device parameters with a change in doping concentration and doping layer thickness is studied. It is observed that an n-doped layer in the channel reduces the threshold voltage and increases the drive current, when compared with a device of undoped channel. The reduction in the threshold voltage and increase in the drain current are found to increase with the thickness and the level of doping of the layer. The leakage current is larger than that of an undoped channel, but less than that of a uniformly doped channel. For a channel with p-doped layer, the threshold voltage increases with the level of doping and the thickness of the layer, accompanied with a reduction in drain current. The devices with doped middle layers and doped gate layers show almost identical behavior, apart from the slight difference in the drive current. The doping level and the thickness of the layers can be used as a tool to adjust the threshold voltage of the device indicating the possibility of easy fabrication of ICs having FETs of different threshold voltages, and the rest of the channel, being intrinsic having high mobility, serves to maintain high drive current in comparison with a fully doped channel.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1999.05a
• /
• pp.485-488
• /
• 1999

In this paper, the effects of back-gate bias on n-channel SOI MOSFETs has been systematically investigated. Back-gate surface is accumulated when negative bias is applied. It is found that the driving current ability of SOI MOSFETs is reduced because the threshold voltage and subthreshold slope are increased and transconductance is decreased due to the hole accumulation in Si body.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.4 no.2
• /
• pp.94-99
• /
• 2004

silicided 50-nm-gate-length n-type Schottky barrier metal-oxide-semiconductor field-effect-transistors (SB-MOSFETs) with 5 nm gate oxide thickness are manufactured. The saturation current is $120{\mu}A/{\mu}m$ and on/off-current ratio is higher than $10^5$ with low leakage current less than $10{\mu}A/{\mu}m$. Novel phenomena of this device are discussed. The increase of tunneling current with the increase of drain voltage is explained using drain induced Schottky barrier thickness thinning effect. The abnormal increase of drain current with the decrease of gate voltage is explained by hole carrier injection from drain into channel. The mechanism of threshold voltage increase in SB-MOSFETs is discussed. Based on the extracted model parameters, the performance of 10-nm-gate-length SB-MOSFETs is predicted. The results show that the subthreshold swing value can be lower than 60 mV/decade.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.29A no.11
• /
• pp.91-96
• /
• 1992

The technology of LOCOS(LOCal Oxidation of Silicon) was used to form the island of SOI film. After this, the SOI film was recrystallized by CO$_2$ laser and metal gate nMOSFETs were fabricated on this SOI film and their electrical characteristics were measured. The kink effect was not nearly observed and edge channel effect was found in the SOI nMOSFETs. The threshold voltage was about 0.5V, the electron mobility was about 340cm$^2$V$\cdot$S and an ON/OFF ratio above 10$^{5}$ was obtained at V_{DS}$=4V. The electrical characteristics were improved by laser recrystallization.

• Proceedings of the KIEE Conference
• /
• 1999.11d
• /
• pp.956-958
• /
• 1999

We designed and fabricated p-type MOSFETs with floating gate in n-type well lesion and examined their photo characteristics. The fabricated MOBFETs showed a high photo-respsonse characteristics, indicating a possibility as a photo sensor. The structures of MOSFETs were changed as to the number of gate and channel. As the number of channel increased, the induced current by light source s increased. However, the effect of the number of gate was negligble on the photo-response characteristics of the device.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1990.10a
• /
• pp.55-59
• /
• 1990

N-Channel polysilicon MOSFETs (W/L=20/1.5, 3, 5.10$\mu\textrm{m}$) were fabricated using RTP(Rapid Thermal Processor) and hydrogen passivation. The N+ Source, drain and gate were annealed and recrystallized using RTP at temperature of 1000$^{\circ}C$-1100$^{\circ}C$. But the active areas were now specially crystallized before growing the gate oxide. Without the hydrogen passivation, excellent transistor characteristics (ON/OFF=5${\times}$10$\^$6/, s=85mv/dec, I$\_$L/=51pA/$\mu\textrm{m}$) were obtained for 1.5$\mu\textrm{m}$ MOSFET. Also the transistor characteristics were improved by hydrogen passivation.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.11 no.2
• /
• pp.189-194
• /
• 2018

Nowadays most integrated circuits are built using the bulk CMOS technology, but it has much difficulty in further reduction of the power consumption and die size. As a super low-power technology to solve such problems, the SOI technology attracts great attention recently. In this paper, the study results of the temperature dependency of the hot carrier effects in the n-channel MOSFETs fabricated on the thin SOI substrate were discussed. In spite that the devices employed the LDD structure, the hot carrier effects were more serious than expected due to the high series resistance between the channel region and the substrate contact to the ground, and were found to be less serious for the higher temperature with the more phonon scattering in the channel region, which resulted in reducing the hot electron generation.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.8 no.3
• /
• pp.221-226
• /
• 2008

A new two dimensional (2-D) analytical model for the Threshold Voltage on dual material surrounding gate (DMSG) MOSFETs is presented in this paper. The parabolic approximation technique is used to solve the 2-D Poisson equation with suitable boundary conditions. The simple and accurate analytical expression for the threshold voltage and sub-threshold swing is derived. It is seen that short channel effects (SCEs) in this structure is suppressed because of the perceivable step in the surface potential which screens the drain potential. We demonstrate that the proposed model exhibits significantly reduced SCEs, thus make it a more reliable device configuration for high speed wireless communication than the conventional single material surrounding gate (SMSG) MOSFETs.