• Korean Journal of Applied Biomechanics
• /
• v.16 no.4
• /
• pp.125-134
• /
• 2006

The purpose of this study was to analyze the Biomechanical elements by looking at the differences on the motions of the right and left spikes of right-handed offense volleyball players, using 3D image analysis and force platform. For that purpose, spike motions of six male university volleyball players were recorded three times each using two 16mm high speed cameras and the speed of recording was set at 60 frames/sec. The coordinated raw data was leveled as 6Hz using low pass filtering method and the calculation of 3D coordinates was done by using a DLT (Direct Linear Transformation) method. Also KWON 3D program was used to analyze the variables. Through the experiments and research, the following results were found: That is, in case of the right spike, the required time from the toss to the impact, which affected the success rate of offense showed as longer and on the take-off, the exact timing to touch the ball was longer because the pace between right and left feet was wider, and also after the jump, the distance between the feet indicated shorter, than the left. In addition, the degree of somersault and horizontal adduction of shoulder joint was smaller and the degree of medial rotation of shoulder joint showed bigger than the left, so it indicated that it was not centered on the body, but by the arm with an axis of shoulder using a swing motion. After the impact, the speed of the ball indicated slower compared to the left spike.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.37 no.2
• /
• pp.29-36
• /
• 2000

The principle and design of two-stage CMOS operational amplifier with rail-to-rail input and class-AB output stage is presented. The rail-to-rail input stage shows almost constant transconductance independent of the common mode input voltage range in global transistor operation region. This new technique does not make use of accurate current-voltage relationship of MOS transistors. Hence it was achieved by using simple linear relationship of currents. The simulated transconductance variation using SPICE is less the 4.3%. The proposed global two-stage opamp can operate both in strong inversion and in weak inversion. Class AB output stage proposed also has a full output voltage swing and a well-defined quiescent current that does not depend on power supply voltage. Since feedback class- AB control is used, it is expected that this output stage can be operating in extremely low voltage. The variation of DC-gain and unity-gain frequency is each 4.2% and 12%, respectively.

• Journal of the Korean Society for Library and Information Science
• /
• v.49 no.1
• /
• pp.17-43
• /
• 2015

Dyslexia is an obstacle for reading that should be found and treated in the early stage. Although dyslexia is not a common symptom appeared many people, they are alienated group which the government should pay attention and support. Yet the government of the Republic of Korea has low awareness and interests on dyslexia. This study aims to survey on measuring the awareness of parents, elementary school teachers, kindergarten teachers, and school librarians, who should sensitively distinguish dyslexia among children in its full-swing time, and to find their perception gaps. In order to gain result, this study conducted questionnaire survey targeting parents, elementary school teachers, kindergarten teachers, and school librarians resided in metropolis, small and medium sized cities, and farming and fishing village, with the total number of 623 people, and analyzed their answers using SPSS 20.0 program. The research shows that awareness on dyslexia depends on their jobs, residence, gender, knowledge on dyslexia, and experience in encountering a person in dyslexia.

• Journal of Sensor Science and Technology
• /
• v.29 no.4
• /
• pp.266-269
• /
• 2020

In this study, we investigated the effect of a sulfur passivation (S-passivation) process step on the electrical properties of surface-channel In_0.7Ga_0.3As quantum-well (QW) metal-oxide-semiconductor field-effect transistors (MOSFETs) with S/D regrowth contacts. We fabricated long-channel In_0.7Ga_0.3As QW MOSFETs with and without (NH₄)₂S treatment and then deposited 1/4 nm of Al₂O₃/HfO₂ through atomic layer deposition. The devices with S-passivation exhibited lower values of subthreshold swing (74 mV/decade) and drain-induced barrier lowering (19 mV/V) than the devices without S-passivation. A conductance method was applied, and a low value of interface trap density D_it (2.83×10¹² cm^-2eV^-1) was obtained for the devices with S-passivation. Based on these results, interface traps between InGaAs and high-κ are other defect sources that need to be considered in future studies to improve III-V microsensor sensing platforms.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.6 no.1
• /
• pp.22-29
• /
• 2006

We demonstrate highly manufacturable Multi-channel Field Effect Transistor (McFET) on bulk Si wafer. McFET shows excellent transistor characteristics, such as $5{\sim}6 times higher drive current than planar MOSFET, ideal subthreshold swing, low drain induced barrier lowering (DIBL) without pocket implantation and negligible body bias dependency, maintaining the same source/drain resistance as that of a planar transistor due to the unique feature of McFET. And suitable threshold voltage ($V_T$) for SRAM operation and high static noise margin (SNM) are achieved by using TiN metal gate electrode.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.6 no.1
• /
• pp.52-58
• /
• 2006

Single-electron transistor (SET)-based logic cells and SET/FET hybrid integrated circuits have been fabricated on SOI chips. The input-output voltage transfer characteristic of the SET-based complementary logic cell shows an inverting behavior where the output voltage gain is estimated to be about 1.2 at 4.2K. The SET/FET output driver, consisting of one SET and three FETs, yields a high voltage gain of 13 and power amplification with a wide-range output window for driving next circuit. Finally, the SET/FET literal gate for a multi-valued logic cell, comprising of an SET, an FET and a constant-current load, displays a periodic voltage output of high/low level multiple switching with a swing as high as 200mV. The multiple switching functionality of all the fabricated logic circuits could be enhanced by utilizing a side gate incorporated to each SET component to enable the phase control of Coulomb oscillations, which is one of the unique characteristics of the SET-based logic circuits.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.30 no.1
• /
• pp.54-58
• /
• 2017

The effect of low temperature ($250^{\circ}C$) heat treatment after electron irradiation (irradiation time = 30, 180, 300s) on the chemical bonding and electrical properties of ZnO thin films prepared using a sol-gel process were examined. XPS (X-ray photoelectron spectroscopy) analysis showed that the electron beam irradiation decreased the concentration of M-O bonding and increased the OH bonding. As a result of the electron beam irradiation, the carrier concentration of ZnO films increased. The on/off ratio was maintained at ${\sim}10^5$ and the $V_{TH}$ values shifted negatively from 11 to 1 V. As the irradiation time increased from 0 to 300s, the calculated S. S. (subthreshold swing) of ZnO TFTs increased from 1.03 to 3.69 V/decade. These values are superior when compared the sample heat-treated at $400^{\circ}C$ representing on/off ratio of ${\sim}10^2$ and S. S. value of 10.40 V/decade.

• The KIPS Transactions:PartA
• /
• v.17A no.1
• /
• pp.19-26
• /
• 2010

As standard of living is higher and aging society is coming, it is needed to develop transportation that is easy to use for weak person. To comply with the demands, it is started to make Bi-modal Tram that is on KRRI(Korea Railroad Research Institute)'s hands. This tram has to have good accessibility like bus, be low level from ground like subway, and park accurately so wheel chair's or passenger's foot can't fall into the gap. But Bi-modal Tram have long length, so it need development of All Wheel Steering System. The Bi-modal Tram that have all wheel steering system steer not only the first axle but also the second and third axle from the first axle or articulation angle, and velocity, and so on. At this study, we discuss AWS ECU's development process.

• Korean Journal of Social Welfare
• /
• v.66 no.4
• /
• pp.233-255
• /
• 2014

The article attempts to explore community change perceived by participants result from The Integrated Program for Infant and Young Children, a program operated by the Community Chest. The participants expressed and shared their experiences through photos and discussions using the Photo-voice method under the theme of 'community life, its meaning and change'. The main themes were 1. In the past, 'community life,' non-meaningful space; 2. Now, we have shared identity, 'You are not alone'; 3. Our village which is a new place in my life. The article also may suggest issues on both community intervention for early children development program and organization for fosterers as social capital. Additionally, photo-voice method enabled participants to find the way to restructure their community from non-place to place. There were three stages, the first was to reflect on their community, the second was to re-inhabit in the community, and the last was to restore the community.

• Korean Journal of Applied Biomechanics
• /
• v.16 no.1
• /
• pp.139-149
• /
• 2006

This study is to analyze the kinematic variables of inward $1{\frac{1}{2}}$ somersault in platform diver. For the manner, 3 people form the national diving team in the year 2000were chosen as the subjects and two S-VHS video cameras set in 60frames/sec were used for recording their motions. Coordinated raw positions data through digitizing are smoothing by butter-worth's low-pass filterin method at a cut off frequency 6.0Hz. and the direct linear transformation(DLT) method was employed to obtain 3-D position coordinates. The conclusions were as follows. However, horizontal distance which is the change of the COG, form the point of the jump to the point of Event 3 where the player is out of the board range completely, Subject B showed 105.1cm and 71.1cm of the vertical distance which are shorter horizontal distance and higher vertical distance, thus, took a great advantage of the position to prepare for the entry. Therefore, if a player takes higher position by speeding up the vertical velocity at the moment of the jumping off the board, and stays in the air longer, the player can have more time to show his skill. Because of the use of the characteristics of the inward somersault, keeping the safe distance form the board is important but in order to higher the completeness, it is ideal to keep the horizontal distance little over 100cm. Also, the angles of shoulder and elbow from Event 1 to 4, depending on swing of the arms, motions in the air, getting ready for the entry, showed some difference individual by individual, according to the velocity of the thigh and shank showed much difference while getting ready and take-off, and it's because of the individual's different bending and straightening for horizontal and vertical distance.