Venetian blinds are used with windows to improve the uniformity ratio of illuminance and interior daylighting distribution under direct sunlit conditions. The main objective of Venetian blinds shading system is to obstruct direct sunlight and at the same time allow daylight to penetrate into the room. Venetian blinds would have greater effect on the interior daylighting condition under clear sky which has both skylight and sunlight than overcast sky which has only skylight. However, due to the lack of data, design and evaluation tools, it is difficult for architects to choose or install venetian blinds during the building design stages. The purpose of this study was to develop an analysis method for shading and daylighting effects of Venetian blinds using the RADIANCE program. The major variables related to the venetian blinds included blinds's slat angle and the ratio of slat width to window height, the radius slat of curvature and the building azimuth. In this study, a series of parametric physical mock-up model measurements and genblinds command in the RADIANCE simulations. The results of this study will provide building designers with the design data at early design stages.

The recent trends of high-density and high-rise in apartment housing have caused the problems of decrease in ventilation rates and increase of indoor pollutant contaminants. SHS(Sick House Syndrome) has now become a major issue and threats the health of residents. To solve these indoor air problems, increase in ventilation rate is considered as one of the most efficient approach. Thus, the recent housing development is pursuing improvement in the site design and the layout of apartment building blocks to promote natural ventilation is now investigated as one of the fundamental solutions. This study was focused on the air flow characteristics of outdoor environment in an apartment complex to keep the pollutants out of the site. Age of air and pressure difference have been used as indices of the outdoor air quality. Four different types of apartment building layouts have been analyzed by CFD simulation. This study again selected a real apartment housing complex as a case study model. By analyzing the pressure differences between the front and rear of an apartment building block, the ventilation performance in each individual unit was evaluated, and its impact on ventilation performance is investigated by analyzing the stagnant air around the apartment building blocks. During this process, existing patterns of apartment housing layout have been evaluated, and the most appropriate site layout has been chosen to analyze the outdoor airflow patterns. Based on the analysis of airflow patterns of site layout, the possibilities of improving ventilation performance of an individual apartment housing is proposed.

Until today, rainwater management was processed without disposing the peak discharge, which was due to rainfall, to provide stability against flood damage. In this process, the natural hydrologic cycle changed quickly, and because of this, some problems that could harm human beings and the environment arose. These problems need to be addressed accordingly. One of the proposals was to carry out decentralized rainwater management through a natural hydrologic cycle on site, including utilization, infiltration, detention, and retention of rainwater. This study aims to set the direction of applicable decentralized rainwater management to housing complex in Korea. Therefore, spacial properties in urban housing complexes were analysed such as the impervious area-to-land ratio, the green area-to-land ratio, artificial land-to-land ratio etc. As the result of this study, when a housing complex was small and developed by reconstruction, the impervious area, artificial land, the green area in the artificial land-to-land ratio were high. So, direction of decentralized rainwater management of these housing complexes is available to utilize and detain rainwater. On the other hand, those of big housing complexes in land development district were low relatively. So, direction of decentralized rainwater management of these housing complexes is available to infiltrate and evaporate rainwater.

Computer simulations were performed for Heating Ventilating and Air-Conditioning (HVAC) systems to figure out more efficient maintenance methods for the building used for adolescent trainees. This study aims at suggesting design alternatives for optimum operation and performing life cycle cost (LCC) for each alternative. First, the capacity of the heat source equipment was determined using annual maximum heating and cooling loads. Annual loads were calculated and applied to the alternative for the purpose of calculating annual energy cost. Second, several types of data were collected to predict energy cost. Finally, the pay back period for each alternative was calculated using total cost estimation during standard duration period. This study indicates that the absorption chiller that does not occupy most part of a mechanical room, and does not need much operation cost was most economical.

The existing building code regulates the minimum distance between buildings and the minimum required sunshine hours for winter solstice to ensure the right to light. Especially, the minimum sunshine hours have been guaranteed by the constitution after the right for the people to live in a healthy and comfortable environment was established. However, the existing regulation on the sunshine hours only considers the duration of sunshine hours, but ignores the minimum amount of sunlight. Therefore, the calculated sunshine hours are not coincident with the hours occupants actually feel. Therefore, the purpose of this study is to investigate the effect of solar incident angle on interior illuminance distribution, which will be used to propose a new code on the minimum sunshine hours and levels.

Before occupation of an apartment housing, the builders are required to inform the test result of IAQ to the public. However, there is no simplified method to predict IAQ before measurement of pollutant concentration. In this study, a simplified way of predicting IAQ based on the distribution of indoor pollutant concentration is proposed. 7 different cases of air change rate have been simulated through CFD analysis to get the distribution ratio of each pollutant material and then simplified functions were used with CRIAQ1 values derived from CFD simulation to evaluate by comparing the influence of each material in the indoor pollutant concentration. Again, a lot of efforts which can improve the indoor air quality have been performed. Materials used in indoor space are labeled with their pollutant emission level. Installation of ventilation system in residential buildings will be regulated by a building codes sooner or later. But it is important to understand the fact that layout of walls, location or size of openings will influence the indoor air flow and pollutant concentration. And location of emitting material influences to indoor air pollutants distribution. But until now there is few recognition and consideration of these factors. Therefore, in this paper the effects of these factors is proved and some kind of guideline is made for designers after a comparison of typical apartment floor plan and a new type plan with their average pollutant concentration and its distribution of each room. CFD(Computational Fluid Dynamics) program was used to show the indoor air flow and pollutant concentration distribution. For this purpose, a typical $100m^2$ apartment floor plan was chosen as a case study model and several alternatives were reviewed to improve the IAQ performance. The simulation took place in the condition of natural ventilation through windows.

Recently the Volatile Organic Compound, HCHO, a harmful object spout from the construction materials is made an issue of social problem. Also the appearance of the building where the confidentiality is high was interior air pollution and it was brought about a huge problem. The government research facility and a relation industry sector conducts a many effort to improves like this actual condition. The Diverse ability building material which contains the natural material of the jade, the charcoal and the hwangto instead of the finish material which contains the harmful chemical material, is becoming development and utility. Hereupon the study have carried out research on hwangto plaster that was composed of hwangto and rice straw. The result of test that is deduced by basic proportion is properly appeared with suitable ratio of the hwangto and the sand to 4:6~5:5 by the compressive strength and crack control, workability. The result of test, that adds the rice straw to basic blending for a crack control, appeared with the fact that it is most suitable 3%to add the rice straw that has a length of 0.5cm~2cm. The result of test that plaster over the large size to compare a cement plaster with a hwangto plaster show a similar efficiency by workability. Also it controlled the crack and peeling off actual condition which is discovered from the hwangto plaster of existing perfectly.