• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.10
• /
• pp.76-81
• /
• 2013

A new phase frequency detector based digital phase-locked loop (PLL) of 125 MHz was designed using the 130 nm CMOS technology library consisting of inverting edge detectors along with a typical digital phase-locked loop to reduce the lock time and jitter for mid-frequency applications. XOR based inverting edge detectors were used to obtain a transition earlier than the reference signal to change the output more quickly. The HSPICE simulator was used in a Cadence environment for simulation. The performance of the digital phase-locked loops with the proposed phase frequency detector was compared with that of conventional phase frequency detector. The PLL with the proposed detector took $0.304{\mu}s$ to lock with a maximum jitter of approximately 0.1142 ns, whereas the conventional PLL took a minimum of $2.144{\mu}s$ to lock with a maximum jitter of approximately 0.1245 ns.

• Journal of IKEEE
• /
• v.27 no.4
• /
• pp.573-578
• /
• 2023

This paper introduces a new locking technique applicable to high-performance digital Phase-Locked Loops (DPLL). The study employs additional thermometer codes to reduce quantization errors in LC-based Digital Controlled Oscillators (DCO). Despite not implementing the entire DCO codes in thermometer mode, this method effectively reduces quantization errors through enhanced linearity. In the initial locking phase, binary codes are used, and upon completion of locking, the system transitions to thermometer codes, achieving high frequency linearity and reduced jitter characteristics. This approach significantly reduces the number of switches required and minimizes the oscillator's area, especially in applications requiring low DCO gain (Kdco), compared to the traditional method that uses only thermometer codes. Furthermore, the jitter performance is maintained at a level equivalent to that of the thermometer-only approach. The efficacy of this technique has been validated through modeling and design at the RTL level using SystemVerilog and Verilog HDL.

• Proceedings of the IEEK Conference
• /
• 2001.06a
• /
• pp.197-200
• /
• 2001

본 논문에서는 병렬귀환 유전체 발진기를 P-HEMT 게이트단의 바이어스 진압을 제어시켜 안정된 위상동기신호가 나타나도록 P-HEMT 게이트 바이어스 튜닝에 의한 Ku-band 고안정 위상동기 마이크로파 발진기를 설계하였다. 위상동기방식은 외부에서 제공되는 125MHz의 기준주파수를 SRD로 체배시켜 하모닉 신호를 이용한 마이크로파 샘플링 위상검파 방식으로 설계하였으며, 고안정 특성과 저위상잡음을 나타내는 위상동기 마이크로파 발진기(phase locked microwave oscillator)를 바랙터 다이오드를 사용하지 않고 P-HEMT의 게이트단을 동조시키는 방식으로 위상동기 발진기를 설계하고 게이트 바이어스에 따른 위상잡음 관계를 분석하였다

• Journal of information and communication convergence engineering
• /
• v.8 no.2
• /
• pp.197-200
• /
• 2010

The FLL(frequency locked loop) circuit is used to generate an output signal that tracks an input reference signal. The locking time of FLL is short compared to PLL(phase locked loop) circuit because the output signal of FLL is synchronized only in frequency. Also the FLL is designed to allow the circuit to be fully integrated. In this paper, the temperature stable FLL circuit is designed by using full CMOS transistors. When the temperature is varied from $-20^{\circ}C$ to $70^{\circ}C$, the variation of output frequency is about from -2% to 1.6% from HSPICE simulation results.

• Journal of information and communication convergence engineering
• /
• v.7 no.1
• /
• pp.62-65
• /
• 2009

In this paper, the temperature characteristics of full CMOS FLL(frequency locked loop) re analyzed. The FLL circuit is used to generate an output signal that tracks an input efference signal. The locking time of FLL is short compared to PLL(phase locked loop) circuit because the output signal of FLL is synchronized only in frequency. Also the FLL s designed to allow the circuit to be fully integrated. The FLL circuit is composed two VCs, two buffers, a VCO and two frequency dividers. The temperature variation of frequency divider, FVC and buffer cancelled because the circuit structure. is the same and he temperature effect is cancelled by the comparator. Simulation results are shown to illustrate the performance of the designed FLL circuit with temperature.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.26 no.10B
• /
• pp.1464-1469
• /
• 2001

본 논문에서는 디지털 하이브리드 위상고정루프(Digital Hybrid Phase-Locked Loop, DHPLL) 주파수 합성기 구조에서 고 순도 스펙트럼과 초고속 스위칭 속도를 위한 설계기술을 제안한다. D/A 변환기 출력으로 전압제어발진기(Voltage Controlled Oscillator, VCO)를 구동하는 개 루프(open-loop) 구성 방식과 기존 위상고정루프(Phase Locked Loop, PLL)의 폐 루프(closed-loop) 구성 방식을 혼합한 하이브리드 구조의 주파수 합성기를 고려하여, 시스템 변수(개 루프 대역과 위상 여유)와 성능 파라미터(정착시간, 위상 잡음, 그리고 최대 오버슈트(Max. overshoot)의 관계를 연구하였다. 그리고 이 관계를 통해 스펙트럼 순도와 스위칭 속도를 향상시키기 위한 최적의 3가지 설계방안을 제시한다. 컴퓨터 시뮬레이션 결과, 주파수 스위칭 과정에서 발생하는 최대 오버슈트가 0.0991%이고 완전 정상상태 도달시간은 0.288msec이다. offset 주파수 10KHz에서 위상 잡음은 -128.15dBc이다.

• Proceedings of the Korean Society of Marine Engineers Conference
• /
• 2005.06a
• /
• pp.1005-1010
• /
• 2005

In this paper, it is presented a frequency modulated continuous wave radar (FMCW) for distance measurement. The frequency range is $10{\sim}11$ GHz and the sweep time of the signal is 100 ms. The test target is 0.8 m2 of metal plate. The experiment is performed in open ground and the pyramidal horn antenna of about 22 dBi gain is used. The beat frequency according to the target moving to 40 m is measured. There is a good agreement between measured and calculated results. But the resolution of the FMCW radar is not good such as about 10 cm. It is result from the nonlinear signal of voltage controlled oscillator (VCO). To improve the nonlinear characteristic of VCO, a high pass filter and phase locked loop (PLL) frequency synthesizer are included in the radar system.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.15 no.2
• /
• pp.89-94
• /
• 2022

In this paper, a discrete-time loop filter(DLF) phase-locked loop with a Frequency Fluctuation Converting Circuit(FFCC) has been proposed. Discrete-time loop filter can improve spur characteristic by connecting the charge pump and voltage oscillator discretely unlike a conventional continuous-time loop filter. The proposed PLL is designed to operate stably by the internal negative feedback loop including the SSC acting as a negative feedback to the discrete-time loop filter of the external negative feedback loop. In addition, the phase noise is further improved by reducing the magnitude of the loop filter output voltage variation through the FFCC. Therefore, the magnitude of jitter has been reduced by 1/3 compared to the conventional structure. The proposed phase locked loop has been simulated with Hspice using the 1.8V 180nm CMOS process.

• Proceedings of the IEEK Conference
• /
• 2006.06a
• /
• pp.605-606
• /
• 2006

Voltage Controlled Oscillator(VCO) plays an important role in today's communication systems. Especially, a Clock Generator(CG) in phase-locked loop(PLL) is usually realized by the VCO. This paper proposes a new VCO with a controllable duty cycle buffer, that can be adopted in low-power high-speed communication systems. Delay cell of the VCO is implemented with gilbert cell. Frequency dynamic range of the VCO is in the range of approximately $50MHz{\sim}500MHz$. Parameters with N-well CMOS 0.18-um process with 1.8V supply voltage was used for the simulations.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.19 no.1
• /
• pp.31-38
• /
• 2024

The digital phase-locked loop(DPLL) is one of the circuits composed of a digital detector, digital loop filter, voltage-controlled oscillator, and divider as a fundamental circuit, widely used in many fields such as electrical and circuit fields. A state estimator using various mathematical algorithms is used to improve the performance of a digital phase-locked loop. Traditional state estimators have utilized Kalman filters of infinite impulse response state estimators, and digital phase-locked loops based on infinite impulse response state estimators can cause rapid performance degradation in unexpected situations such as inaccuracies in initial values, model errors, and various disturbances. In this paper, we propose a two-layer Frobenius norm-based finite impulse state estimator to design a new digital phase-locked loop. The proposed state estimator uses the estimated state of the first layer to estimate the state of the first layer with the accumulated measurement value. To verify the robust performance of the new finite impulse response state estimator-based digital phase locked-loop, simulations were performed by comparing it with the infinite impulse response state estimator in situations where noise covariance information was inaccurate.