• 조명전기설비학회논문지
• /
• 제27권6호
• /
• pp.88-94
• /
• 2013

This paper proposes a capacitive touch switch using a switched-capacitor. The proposed method charges capacitance for measurement using the switched-capacitor until the voltage across the capacitance reaches a threshold voltage. As the proposed method uses the number of times being charged to measure the capacitance, the method has no relation with the operating frequency of the switched-capacitor. This paper also shows the quantization resolution of the proposed method is related to the capacitance in the switched-capacitor and the threshold voltage, i.e., the resolution is improved when the capacitance in the switched-capacitor is decreased and the threshold voltage is increased. Simulation result shows the method gives 31fF quantization resolution when the capacitance in the switched-capacitor is 50fF and threshold voltage is 80% of the supply voltage.

• Journal of Power Electronics
• /
• 제18권6호
• /
• pp.1912-1919
• /
• 2018

The output capacitance of power semiconductor devices is important in determining the switching losses and in the operation of some resonant converter topologies. Thus, it is important to be able to accurately determine the output capacitance of a particular device operating at elevated power levels so that the contribution of the output capacitance discharge to switch-on losses can be determined under these conditions. Power semiconductor switch manufacturers usually measure device output capacitance using small-signal methods that may be insufficient for power switching applications. This paper shows how first principle methods are applied in a novel way to obtain more relevant large signal output capacitances of Gallium-Nitride (GaN) FETs using the drain-source voltage transient during device switch-off numerically. A non-linear capacitance for an increase in voltage is determined with good correlation. Simulations are verified using experimental results from two different devices. It is shown that the large signal output capacitance as a function of the drain-source voltage is higher than the small signal values published in the data sheets for each of the devices. It can also be seen that the loss contribution of the output capacitance discharging in the channel during switch-on correlates well with other methods proposed in the literature, which confirms that the proposed method has merit.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제15권6호
• /
• pp.653-657
• /
• 2015

A new paired gate-source voltage RF capacitance-voltage (C-V) method of extracting the effective channel length and parasitic capacitance using the intersection between two closely spaced linear regression lines of the gate capacitance versus gate length measured from S-parameters is proposed to remove errors from conventional C-V methods. Physically verified results are obtained at the gate-source voltage range where the slope of the gate capacitance versus gate-source voltage is maximized in the inversion region. The accuracy of this method is demonstrated by finding extracted value corresponding to the metallurgical channel length.

• Transactions on Electrical and Electronic Materials
• /
• 제14권4호
• /
• pp.177-181
• /
• 2013

In this paper, silicon solar cells are analyzed regarding power conversion efficiency by changed capacitance in the depletion region. For the capacitance control in the depletion region of silicon solar cell was applied for 10, 20, 40, 80, 160 and 320 Hz frequency band character and alternating current(AC) voltage with square wave of 0.2~1.4 V. Academically, symmetry formation of positive and negative change of the p-n junction is similar to the physical effect of capacitance. According to the experiment result, because input of square wave with alternating current(AC) voltage could be observed to changed capacitance effect by indirectly method through non-linear power conversion (Voltage-Current) output. In addition, when input alternating current(AC) voltage in the silicon solar cell, changed capacitance of depletion region with the forward bias condition and reverse bias condition gave a direct effect to the charge mobility.

• Transactions on Electrical and Electronic Materials
• /
• 제17권5호
• /
• pp.293-296
• /
• 2016

Using capacitance-voltage (C-V) and conductance-voltage (G/ω-V) measurements, the electrical properties of Cu/n-InP Schottky diodes were investigated. The values of C and G/ω were found to decrease with increasing frequency. The presence of interface states might cause excess capacitance, leading to frequency dispersion. The negative capacitance was observed under a forward bias voltage, which may be due to contact injection, interface states or minority-carrier injection. The barrier heights from C-V measurements were found to depend on the frequency. In particular, the barrier height at 200 kHz was found to be 0.65 eV, which was similar to the flat band barrier height of 0.66 eV.

• ETRI Journal
• /
• 제32권1호
• /
• pp.68-72
• /
• 2010

The coupling between the transverse and longitudinal components of the channel electron motion in NMOS devices leads to a reduction in the barrier height. Therefore, this study theoretically investigates the effects of the in-plane velocity of channel electrons on the capacitance-voltage characteristics of nano NMOS devices under inversion bias. Numerical calculation via a self-consistent solution to the coupled Schrodinger equation and Poisson equation is used in the investigation. The results demonstrate that such a coupling largely affects capacitance-voltage characteristic when the in-plane velocity of channel electrons is high. The ballistic transport ensures a high in-plane momentum. It suggests that such a coupling should be considered in the quantum capacitance-voltage modeling in ballistic transport devices.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2005년도 하계학술대회 논문집 Vol.6
• /
• pp.131-132
• /
• 2005

In this paper, the capacitance properties of degraded thyristor with temperature and voltage were presented. As degraded thyristor, 8 thyristors with each other different reverse blocking voltage used. Its impedance and resistance properties were measured from frequency 100Hz to 10MHz applied with bias voltage from 0V to 40V. As a result, at low frequency region, that is, at the frequency 100 - 10kHz, the abrupt increasement of its capacitance was confirmed. And also, at high frequency region, the capacitance peak move toward low frequency in the region of frequency 4 - 6MHz as degradation of thyristor.

• Journal of Electrical Engineering and Technology
• /
• 제11권6호
• /
• pp.1656-1663
• /
• 2016

A capacitive wireless power transfer (C-WPT) system uses an electric field to transmit power through a physical isolation barrier which forms a pair of ac link capacitors between the metal plates. However, the physical dimension and low dielectric constant of the interface medium severely limit the effective link capacitance to a level comparable to the main switch output capacitance of the transmitting circuit, which thus narrows the soft-switching range in the light load condition. Moreover, by fundamental limit analysis, it can be proved that such a low link capacitance increases operating frequency and capacitor voltage stress in the full load condition. In order to handle these problems, this paper investigates optimal design of double matching transformer networks for C-WPT. Using mathematical analysis with fundamental harmonic approximation, a design guideline is presented to avoid unnecessarily high frequency operation, to suppress the voltage stress on the link capacitors, and to achieve wide ZVS range even with low link capacitance. Simulation and hardware implementation are performed on a 5-W prototype system equipped with a 256-pF link capacitance and a 200-pF switch output capacitance. Results show that the proposed scheme ensures zero-voltage-switching from full load to 10% load, and the switching frequency and the link capacitor voltage stress are kept below 250 kHz and 452 V, respectively, in the full load condition.

• 대한전자공학회논문지SD
• /
• 제41권7호
• /
• pp.1-6
• /
• 2004

나노 급 소자에서의 성능이 유효 채널 길이에 대하여 더욱 민감하게 되므로 정확한 유효 채널 길이의 추출이 중요하다. 본 논문에서는 100 ㎚ 이하의 MOSFET에서 유효 채널 길이를 추출하기 위하여 새로운 정전용량-전압(Capacitance-Voltage) 방법을 제안하였다. 제안한 방법에서는 게이트와 소스와 드레인 사이의 정전용량(C/sub gsd/)를 측정하여 유효 채널 길이를 추출하였다. 그리고 추출된 유효 채널 길이와 기존의 1/β 과 Terada 방법 그리고 다른 정전용량-전압 방법의 추출된 유효 채널 길이의 결과들과 비교하여 본 논문에서 제안한 추출방법이 100 ㎚ 이하 크기의 MOSFET의 유효 채널 길이를 추출함에 타당함을 증명하였다.

• 전기학회논문지
• /
• 제61권6호
• /
• pp.817-820
• /
• 2012

We studied p-type capacitance characteristics of ZnO thin-film transistors (TFT's), grown by metal organic chemical vapor deposition (MOCVD). We compared two ZnO TFT's: one grown at $450^{\circ}C$ and the other grown at $350^{\circ}C$. ZnO grown at $450^{\circ}C$ showed smooth capacitance profile with electron density of $1.5{\times}10^{20}cm^{-3}$. In contrast, ZnO grown at $350^{\circ}C$ showed a capacitance jump when gate voltage was changed to negative voltages. Current-voltage characteristics measured in the two samples did not show much difference. We explain that the capacitance jump is related to p-type ZnO layer formed at the $SiO_2$ interface. Current-voltage and capacitance-voltage data support that p-type characteristics are observed only when background electron density is very low.