• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.5
• /
• pp.99-105
• /
• 2014

A reference spur suppressed PLL with two-symmetrical loops without changing the bandwidth which is optimized to suppress phase noise and reduce locking time has been designed. The principle of suppressing a reference signal spur is to stabilize the input voltage of voltage controlled oscillator (VCO). The proposed PLL consists of a phase-frequency detector(PFD) which has two outputs, two charge pumps(CP), two loop filters(LF), a divider and a VCO which has two inputs. Simulation results with $0.18{\mu}m$ CMOS process show that the reference spur is approximately suppressed to 1/2 of the reference spur in a conventional PLL. Even though there is a 5% process variation in the magnitude of R and C, the simulation result shows that the reference spur is still suppressed to 1/2 of the reference spur in a conventional PLL. The power consumption is 6.3mW at the power supply of 1.8V.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.16 no.6
• /
• pp.873-879
• /
• 2016

A charge pump circuit with very short turn-on time is presented for minimizing reference spurs in CMOS PLL frequency synthesizers. In the source switching charge pump circuit, applying proper voltages to the source nodes of the current source FETs can significantly reduce the unwanted glitch at the output current while not degrading the rising time, thus resulting in low spur at the synthesizer output spectrum. A 1.1-1.6 GHz PLL synthesizer employing the proposed charge pump circuit is fabricated in 65 nm CMOS. The current consumption of the charge pump is $490{\mu}A$ from 1 V supply. Compared to the conventional charge pump, it is shown that the reference spur is improved by dB through minimizing the turn-on time. Theoretical analysis is described to show that the measured results agree well with the theory.

• Proceedings of the IEEK Conference
• /
• 2000.06b
• /
• pp.209-212
• /
• 2000

Charge pump based upon a phase locked loop(PLL) is described. This charge pump show that it is possible to overcome the issue of charge pump current mismatch by using a current subtraction circuit. Also, this charge pump can suppress reference spurs and disturbance of the VCO control voltage. HSPICE simulations are performed using 0.25$\mu\textrm{m}$ CMOS process.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.59 no.2
• /
• pp.465-470
• /
• 2010

The charge pump in a phase-locked loop is a key block in determining reference spurs of the VCO output signal. To reduce reference spurs, the current mismatch in the charge pump must be minimized. This paper presents a dual compensation method to reduce the current mismatch. The proposed charge pump and PLL were realized in a $0.18{\mu}m$ CMOS process. Measured current matching characteristics were achieved with less than 1.4% difference and with the current variation of 3.8% in the pump current over the charge pump output voltage range of 0.35-1.35V at 1.8V. The reference spur of the PLL based on the proposed charge pump was measured to be -71dBc.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.11 no.5
• /
• pp.531-537
• /
• 2018

A novel PLL with a delta-sigma modulator and a spur reduction circuit is proposed. delta-sigma modulator makes the LF remove noise easily by moving the spur noise to a higher frequency band. Therefore, the magnitude of spur can be reduced the reasonable bandwidth. The spur reduction circuit reduces the spur size by reducing the LF voltage change generated during the period of reference signal. The spur reduction circuit is designed as simple as possible not to increase the size of PLL. The proposed PLL with the previous two techniques is designed with a supply voltage of 1.8V in a 0.18um CMOS process. Simulation results show an almost 20dB reduction in the magnitude of spur. The spur reduced PLL can be used in narrow bandwidth communication system.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.11 no.6
• /
• pp.651-657
• /
• 2018

A novel PLL with a delta-sigma modulator and a spur reduction circuit is proposed. delta-sigma modulator makes the LF remove noise easily by moving the spur noise to a higher frequency band. Therefore, the magnitude of spur can be reduced the reasonable bandwidth. The spur reduction circuit reduces the spur size by reducing the LF voltage change generated during the period of reference signal. The spur reduction circuit is designed as simple as possible not to increase the size of PLL. The proposed PLL with the previous two techniques is designed with a supply voltage of 1.8V in a 0.18um CMOS process. Simulation results show an almost 20dB reduction in the magnitude of spur. The spur reduced PLL can be used in narrow bandwidth communication system.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.9 no.3
• /
• pp.153-159
• /
• 2009

A CMOS frequency synthesizer for $5{\sim}6$ GHz UNII-band sub-harmonic direct-conversion receiver has been developed. For quadrature down-conversion with sub-harmonic mixing, octa-phase local oscillator (LO) signals are generated by an integer-N type phase-locked loop (PLL) frequency synthesizer. The complex timing issue of feedback divider of the PLL with large division ratio is solved by using multimodulus prescaler. Phase noise of the local oscillator signal is improved by employing the ring-type LC-tank oscillator and switching its tail current source. Implemented in a $0.18{\mu}m$ CMOS technology, the phase noise of the LO signal is lower than -80 dBc/Hz and -113 dBc/Hz at 100 kHz and 1MHz offset, respect-tively. The measured reference spur is lower than -70 dBc and the power consumption is 40 m W from a 1.8 V supply voltage.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.9
• /
• pp.903-911
• /
• 2014

This paper proposes a high speed frequency synthesizer with dual phase-locked loop(PLL) structure to improve phase noise level and shape in a wideband receiver. To reduce phase noise and fractional spur, a output frequency of $1^{st}$ PLL used as reference frequency of $2^{nd}$ PLL is changed. The frequency synthesizer has been designed with 1 Hz frequency resolution using digital NCO in 6.5~8.5 GHz wide spectrum. The measured results of the fabricated frequency synthesizer show that the output power is about -3 dBm, the maximum lock-in time and phase noise are within 60 us and -95 dBc/Hz at 10 kHz offset, respectively.

• Journal of electromagnetic engineering and science
• /
• v.11 no.2
• /
• pp.105-112
• /
• 2011

In phase-locked frequency synthesizers, a fast-lock technique is frequently employed to overcome the trade-off between a lock-time and a spurious response. The function of fast-lock in a conventional PLL (Phased Lock Loop) IC (Integrated Circuit) is limited by a factor of 16, which is usually implemented by a scaling of charge pumper, and consequently a lock time improvement of a factor of 4 is possible using the conventional PLL IC. In this paper, we propose a novel external active fast-lock loop filter. The proposed loop filter provides, conceptually, an unlimited scaling of charge pumper current, and can overcome conventional trade-off between lock-time and spur suppression. To demonstrate the validity of our proposed loop-filter, we fabricated an X-band frequency synthesizer using the proposed loop filter. The loop filter in the synthesizer is designed to have a loop bandwidth of 100 kHz in the fast-lock mode and a loop bandwidth of 5 kHz in the normal mode, which corresponds to a charge pumper current change ratio of 400. The X-band synthesizer shows successful performance of a lock-time of below 10 ${\mu}sec$ and reference spur suppression below -64 dBc.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.4
• /
• pp.37-44
• /
• 2009

A novel phase-locked loop(PLL) architecture with resistance and capacitance scaling scheme has been proposed. The proposed PLL has three charge pumps. The effective capacitance and resistance of the loop filter can be scaled up/down according to the locking status by controlling the direction and magnitude of each charge pump current. This architecture makes it possible to have a narrow bandwidth and low resistance in the loop filter, which improves phase noise and reference spur characteristics. It has been fabricated with a 3.3V $0.35{\mu}m$ CMOS process. The measured locking time is $25{\mu}s$ with the measured phase noise of -105.37 dBc/Hz @1MHz and the reference spur of -50dBc at 851.2MHz output frequency