• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.35D no.11
• /
• pp.62-69
• /
• 1998

The general degradation model has been applied to analyze the hot carrier induced degradation of the DC and RF characteristics of RF-nMOSFET. The degradation of cut-off frequency has been severer than the degradation of bulk MOSFET drain current. The value of the degradation rate n and the degradation parameter m for RF-nMOSFET has been equal to those for bulk MOSFET. The decrease of device degradation with the increase of fingers could be explained by the large source/drain parasitic resistance and drain saturation voltage. It has been also found that the RF performance degradation could be explained by the decrease of $g_{m}$ and $C_{gd}$ and the increase of $g_{ds}$ after stress. The degradation of the DC and RF characteristics of RF-nMOSFET could be predicted by the measurement of the substrate current.t.

• ETRI Journal
• /
• v.39 no.1
• /
• pp.62-68
• /
• 2017

In this paper, we present the design and characterization analysis of a cascode GaN field-effect transistor (FET) for switching power conversion systems. To enable normally-off operation, a cascode GaN FET employs a low breakdown voltage (BV) enhancement-mode Si metal-oxide-semiconductor FET and a high-BV depletion-mode (D-mode) GaN FET. This paper demonstrates a normally-on D-mode GaN FET with high power density and high switching frequency, and presents a theoretical analysis of a hybrid cascode GaN FET design. A TO-254 packaged FET provides a drain current of 6.04 A at a drain voltage of 2 V, a BV of 520 V at a drain leakage current of $250{\mu}A$, and an on-resistance of $331m{\Omega}$. Finally, a boost converter is used to evaluate the performance of the cascode GaN FET in power conversion applications.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.39 no.12
• /
• pp.1001-1007
• /
• 2002

In this paper we analyzed the effects of pentacene thickness and the location of source/drain contacts on the performance of pentacene TFT Above a certain thickness of pentacene thin film the pentacene grain was turned from the thin film phase into the bulk phase, resulting in degrading the crystallinity and then performance as well. For the top contact structure in which source/drain contacts are located above pentacene film, the contact resistance decreased comparing with the bottom contact structure. However, the leakage current in the off-state became large and then the related parameters such as on/off current ratio were deteriorated. We found that the thickness of around 300$\AA$-700$\AA$ was suitable, and that the bottom contact was more feasible for hig Performance pentacene OTFT.

• Journal of the Institute of Electronics Engineers of Korea TE
• /
• v.37 no.2
• /
• pp.6-11
• /
• 2000

In this paper, suggesting a new linearly -graded depletion edge approximation, the current-voltage characteristics of an n-type short-channel GaAs MESFET device has been analyzed by solving the two dimensional Poisson's equation in the depletion region. In this model, the expressions for the threshold voltage, the source and the drain ohmic resistance, and the drain current were derived. As a result, typical Early effect of a short channel device was shown and the ohmic voltage drop by source and drain contact resistances could be explained. Furthermore our model could analyze both the short-channel device and the long-channel device in a unified manner.

• Journal of Satellite, Information and Communications
• /
• v.8 no.1
• /
• pp.45-53
• /
• 2013

An electrostatic discharge (ESD) protection device, so called, N-type extended drain silicon controlled rectifier (NEDSCR) device, was analyzed for high voltage I/O applications. A conventional NEDSCR device shows typical SCR-like characteristics with extremely low snapback holding voltage. This may cause latch-up problem during normal operation. However, a modified NEDSCR device with proper junction/channel engineering using counter pocket source (CPS) ion implantation demonstrates itself with both the excellent ESD protection performance and the high latch-up immunity. Since the CPS implant technique does not change avalanche breakdown voltage, this methodology does not reduce available operation voltage and is applicable regardless of the operation voltage.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.27 no.9
• /
• pp.1409-1418
• /
• 1990

Characteristics of NMOS transistors with phosphorus source/drain junctions formed by two-step rapid thermal diffusion (RTD) process using a solid diffusion source have been investigated. Phosphorus profiles after RTD were measured by SIMS analysis. In the case of 1100\ulcorner, 10sec RTD of, P, the specific contact resistance of n+ Si-Al was 2.4x10**-7 \ulcorner-cm\ulcorner which is 1/5 of the As junction The comparison fo P junction devices formed by RTD and conventional As junction devices shows that both short channel effect and hot carrier effect of P junction devices are smaller than those of As junction devices when the devices have same junction depths. P junction device had maximum of 0.4 times lower Isub/Id than As junction device. Characteristics of P junction formed by several different RTD conditions have been compared and 1000\ulcorner RTD sample had the smaller hot carrier generation. Also, it has been shown that the hot carrier generation can be futher reduced by forming the P junctions by 3-step RTD which has RTO-driven-in process additionally.

• Proceedings of the IEEK Conference
• /
• 2005.11a
• /
• pp.579-582
• /
• 2005

In this study, the electrical characteristic of asymmetric high voltage MOSFET (AHVMOSFET) for display IC was investigated. Measurement data are taken over range of temperature (300K-400K) and various extended drain length, and gate oxide thickness ($175{\AA}$, $350{\AA}$). In high temperature condition, drain current decreased over 30% and max transconductance deceased over 40%, and specific on-resistance increased over 30% in comparison with room temperature.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.50 no.10
• /
• pp.489-493
• /
• 2001

The on-current of offset and LDD structured devices in slightly decreased while the off-current are remarkably reduced and almost constant independent of gate and drain voltage because offset and LDD regions behave as a series resistance and reduce the lateral electric field in the drain depletion. Degradation of these devices is dependent upon the offset and LDD length rather than doping concentration in these regions. Also, degradation mechanism has been related to the interface generation rather than the hot carrier injection into gate oxide.

• Journal of the Semiconductor & Display Technology
• /
• v.19 no.3
• /
• pp.82-87
• /
• 2020

The comprehensive and physics-based compact noise models for advanced CMOS devices were presented. The models incorporate important physical effects in nanoscale MOSFETs, such as the low frequency correlation effect between the drain and the gate, the trap-related phenomena, and QM (quantum mechanical) effects in the inversion layer. The drain current noise model was improved by including the tunneling assisted-thermally activated process, the realistic trap distribution, the parasitic resistance, and mobility degradation. The expression of correlation coefficient was analytically described, enabling the overall noise performance to be evaluated. With the consideration of QM effects, the comprehensive low frequency noise performance was simulated over the entire bias range.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2009.10a
• /
• pp.1193-1196
• /
• 2009

Low resistivity interconnection and high-mobility channel are required to realize ultrahigh-definition LCDs such as 4k ${\times}$ 2k TVs. We evaluated fully Cu-based gate and Source/Drain interconnections, consisting of stacked pure-Cu/Cu-Mn layers for TFT-LCDs, and found the underlying Cu-Mn alloy film has superior adhesion to glass substrates and CVD-SiOx films. It was also confirmed that wet etching of the Cu/Cu-Mn films without residues and low contact resistance with both channel IGZO and pixel ITO films can be obtained. It is thus considered that the stacked Cu/Cu-Mn structure is one of candidates to replacing conventionally pure-Cu/refractory metal.