• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2016.05a
• /
• pp.20-21
• /
• 2016

Aids to Navigation (AtoN) is marine traffic safety facility to facilitate the safe and efficient movement of shipping and enhance the protection of the marine environment by the regulation or guideline of The International Association of Marine Aids to Navigation and Lighthouse Authorities (IALA). By IALA NAVGUIDE, the term "New Danger" is defined as newly discovered hazards not yet shown in nautical documents and includes naturally occurring obstructions such as sandbanks or rocks or man-made dangers such as wrecks. 'New Dangers' should be appropriately marked using Lateral, Cardinal, Isolated Danger marks or by using the Emergency Wreck Marking Buoy. However, the Emergency Wreck Marking Buoy has difficulties with implementation conditions in terms of speed and accuracy to install the buoy. In case of sinking accidents, it is difficult immediately to install the Emergency Wreck Marking Buoy because of weather conditions, marine environments and accident position. This paper studies Auto Releasing New Danger Mark Buoy on the deck which can be automatically to release from the deck of a vessel and float in the water and quickly install the accident position in case of sinking accidents. The buoy will be to reduce the risk of navigation and prevent secondary collisions.

• Journal of Navigation and Port Research
• /
• v.41 no.3
• /
• pp.79-86
• /
• 2017

Ballast water filled into and discharged from the ballast tank of a ship has a negative impact on local marine environment due to various aquatic organisms contained therein. The IMO developed and adopted "The International Convention for the Control and Management of Ships Ballast Water and Sediments, 2004" with the purpose of protecting the marine environment from transfer of harmful aquatic organisms in ballast water carried by ships. The IMO BWM Convention was approved in September 2016 and ships must be equipped with ballast water management system after September 2017. Ships' ballast water treatment methods are divided into using active substances as electrolytic type, ozone type, chemical dosing type and using physical treatment type as filter type, ultraviolet type. It is also used with a combination of two methods. Electrolysis is superior in terms of cost and efficiency. In this study, basic principles, components, and land base test contents of electrolysis ballast water treatment system, a direct electrolyzed ballast water treatment system, were examined. Land base test was conducted with 300m3/h capacity device at the KIOST Geoje plant where the government test facility was installed. This test validated that the system meets IMO standards.

• Journal of Korea Port Economic Association
• /
• v.36 no.2
• /
• pp.1-18
• /
• 2020

The Internet of things (IoT) has been applied to a variety of industrial uses such as public service sectors, medical industries, automotive industries, and so on. Led by smart cities, this is typical. However, from a logistics perspective, the level of application is insufficient. This study examines the applicability of IoT-related technology in a container terminal, an object of the present invention, to derive an applicable plan. Analytic network process (ANP) analysis reveals the following results for IoT applications in container terminals: operating systems (26.7%), safety/environmental/security systems (26.4%), equipment maintenance systems (25.3%), and facility maintenance systems (21.6 %). The second ANP analysis reveals the following results: Economy (40.2%), productivity (21.1%), service level (19.5%), and utilizing technology level (19.2%). The application or standard of evaluation is important when applying IoT technology to container terminals; however, it is not concentrated in a certain area. It is desirable to build each container system with linkage and efficiency from a macroscopic view.

• Journal of Navigation and Port Research
• /
• v.35 no.8
• /
• pp.631-636
• /
• 2011

Stable power supply to a light mounted on a navigational buoy is indispensable factor because unstable power can lead to fatal marine accident. Despite the difference lies between onshore and offshore environment, as well as the power output characteristics, the PV(Photovoltaic) power generation system is designed by the independent onshore power generation system standards. Furthermore, the capacity of PV power generation system does not take into account the structural characteristics of the buoy in the sea. Therefore, the faulty design makes battery over-discharge owing to lack of the power generation and the battery can not supply stable power to the light. This paper introduces a design method for a power system of the PV powered buoy. The data has been acquired for 3 months period, which includes PV-generated electricity, power consumption and battery voltage from experimental buoy. Further, a power management features of the buoy has been analyzed based on the acquired data. From the analysis of the acquired data, it was evident that PV power generation system produces different electric power output depend on its installed environment - land and sea. Based on the analytical result, a design criterion has been proposed for the power system in the navigational buoy.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.21 no.6
• /
• pp.169-177
• /
• 2017

Recently, as the size of transportation vessels has increased, there is a growing need for securing the front-water depths of existing port facilities. The method of deepening front-water depth is securing the depth of the port facility, and it is reinforced by grouting after excavating the rubble-mound to the required depth. The purpose of this study is to investigate the reinforcing performance and filling performance of thixotropic grout as a grouting material for reinforcing rubble-mound. Compressive strength tests were carried out for two types of thixotropic grout, and 5 specimens with a diameter of 400 mm and a height of 530 mm were manufactured and evaluated for filling performance. The required strength of reinforced rubble-mound required to ensure the safety of the structure is 6 MPa. All the thixotropic grouts used in this study were found to satisfy the required strength over 9 MPa at 7 days of age. As a result of visual observation of filling state of the filling performance test specimens, it was confirmed that the thixotropic grout was well filled up to the desired fillet height.

• Journal of Korean Port Research
• /
• v.13 no.2
• /
• pp.333-350
• /
• 1999

Today freeway is thought to be a very important transportation facility carrying tremendous traffic flow as the main corridor within the area of between the areas. However freeway is experiencing severe congestion and accidents by increased entrance ramp flow especially at peak time period. Ramp meters on the freeway entrance ramps that supply traffic to the freeway in a measured or appropriately regulated amount are needed for alleviating freeway congestion. Because ramp meters can be operated to discharge traffic at a measured or regulated rate thus maintaining more uniform speed on the mainline section maximizing the throughput to the freeway within the capacity of a downstream bottleneck and reducing the congestion related accidents. Thus the objectives in this study were to analyze the traffic characteristics on the freeway I-94 with ramp metering system before/after ITS technology in Detroit (Michigan) area compare shifts of the traffic characteristics on the freeway I-94 before/after ITS technology and finally suggest a better ramp metering strategy for the freeway system The following results were obtained: i)Flow occupancies and speeds on the mainline merge section of freeway were shown to be a big difference depending on the peak periods areas and directions based on the distribution of traffic flow characteristics on the freeway. ii)Reduced speed was shown to be more than 5 mph and ramp flow was also shown to be more than 240 vph at peak periods if there was the ramp metering system constructed on the freeway. iii)Ramp metering system was shown to be optimally operated on the freeway if ramp flow could be maximized within the range of over 900 vph and reduced occupancy could be also maximized by no more than 2 percent at peak periods. iv)The average flows on the freeway after the ITS technology were shown to be a decrease of over 20% depending on the peak periods areas and directions when compared with those flow on the freeway before the ITS technology. over 20% depending on the peak periods areas and directions when compared with those speeds on the freeway before the ITS technology. vi)The average metering rates on the freeway after the ITS technology were shown to be an increase of over 10% depending on the peak periods areas and directions when compared with those metering rates on the freeway before the ITS technology.

• Journal of Navigation and Port Research
• /
• v.36 no.5
• /
• pp.401-407
• /
• 2012

The purpose of this study was to examine the preferences to yacht tourism and perceptions to importance of yacht tourism industry's activation strategies from consumers perspectives. In order to such a purpose, this study employed survey methodology with a total of 300 visitors to yacht facility and beach located in B metropolitan city. With 265 usable questionnaires, data collected were analyzed using descriptive statistics such as frequency, percentage, mean and standard deviation. Accordingly, following findings were derived from current study. First, 32% of participants had yacht tourism experiences and more than 64% of them had willing to purchase yacht tourism products in the future, which indicates optimistic increases in yacht tourism demand. In addition, amount of willingness to pay for yacht tourism was less than 100 thousand Won per day. Second, the most preferred product was a yacht training and experience program, and preferred time for yacht tourism was weekend and or vacation with the period of one day or one night and two days. The main motivation was to spend leisure time and enjoyment with accompanying persons of family or friend members. Third, consumers' restriction factors included high expenditures, time consuming and lack of various yacht tourism products but their selection attributes included low expenditures, associated tourism products and quality of yacht tourism products. Finally, the most important activation strategies included the development of yacht tourism products, building yacht tourism conditions and establishing marketing strategies, but the least important activation strategies from consumers views included policies, experts and facilities.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.1
• /
• pp.133-138
• /
• 2006

Electronic Navigational Charts(ENCs) are official nautical charts which are equivalent to paper charts with supplementary information. Although their main purpose is to be used for the safe navigation of ships, they also contain much information on coasts and seas which may be interesting to ordinary people. However, there is no easy way to access them because of therir specialized data format, access method and visualization. This paper proposes on implementation of SVG for the access and services of ENCs. SVG(Scalable Vector Graphic) makes it possible to make use of Vector graphics for servicing maps in basic internet browsing environment. Implement of SVG for ENC applications by this research is free of special server side GIS mapping system and client side extra technology. The implementation of SVG for ENC Applications can be summarized as follows: Firstly, SVG provides spatial information to possess searching engine to embody SVG map. Secondly, SVG can provide high-quality vector map graphics and interactive facility without special Internet GIS system. It makes it possible to use services with very low cost. Thirdly, SVG information service targeting on maritime transportation can be used as template, so it can be used dynamically any other purpose such as traffic management and vessel monitoring. Many good characteristics of SVG in mapping at computer screen and reusability of SVG document provide new era of visualization of marine geographic information.

• Journal of Navigation and Port Research
• /
• v.42 no.1
• /
• pp.9-16
• /
• 2018

The development of limited petroleum resources for use with mankind inevitably explores and seeks to develop oil fields in the deep sea area, under the rise of the oil prices market situation. The use of Oceanic Thermal Energy Conversion (OTEC) technology, which operates the power generation facility using the temperature differences between the deep water and the surface water, is progressing actively as a trend to follow. In this study, the application of the Discharged Thermal Energy Conversion (DTEC) was designed and analyzed under the condition that the supply condition of seawater used in the FPSO installed in the deep sea area is changed up to 400m depth. In this case, it was confirmed that the design of the system that can generate more electric power according to the depth of water is confirmed, by thus applying the DTEC system by taking the cooling water at a deeper water depth than the existing design water depth. The FPSO considers the similarity of the OTEC power generation facilities, and will apply the DTEC system to FPSO in the deep sea area to accumulate technology and the conversion to further utilize the OTEC power generation facilities after the end of life cycle of oil production, which could be a solution to two important issues, namely, resource development and sustainable development.

• Journal of Korea Port Economic Association
• /
• v.34 no.3
• /
• pp.1-16
• /
• 2018

The demand for biopharmaceuticals is on the rise spurred by the fourth industrial revolution and an aging society in Korea. Consequently, the scale of the biopharmaceutical industry is continuously increasing globally, thereby leading to an increase in the distribution of biopharmaceuticals. However, the relative inferiority of the domestic drug distribution structure, when compared to the advanced countries, and strict logistics regulations concerning the handling of biopharmaceuticals have raised the need for systematic management. Essentially, the significance of third-party logistics companies in the cold chain for pharmaceutical cold chain has increased with an intense management environment for pharmaceuticals. The purpose of this study is to investigate the selection factors of drug cold chain's third-party logistics companies and to examine the influence of selection factors on satisfaction. A multiple regression analysis was conducted to investigate how cold chain third-party logistics factors affect the satisfaction of third-party logistics in cold chain. The results of analysis showed that expertise, facility, and linkage are factors affect customer satisfaction. The managerial capacity was derived not as an influential factor. These findings suggest that the future cold chain industry will be equipped to provide direction and strategic implications.