• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.11
• /
• pp.108-116
• /
• 2013

The input buffer in Network on Chip (NoC) router plays a key role in on-chip-network performance, which is utilized in flow control and virtual channel. However, increase in area and power due to input buffers as the network size gets larger is becoming severe. To solve this problem, a bufferless deflection routing without input buffer was suggested. Since the bufferless deflection routing shows poor performance at high network load, other approaches which combine the deflection routing with small size side buffers were also proposed. Nonetheless these new methods still show deficiencies caused by frequent path collisions. In this paper, we propose a modified deflection routing technique using a location based priority. In comparison with existing deflection routers, experimental results show improvement by 12% in throughput with only 3% increase in area.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.9
• /
• pp.25-32
• /
• 2009

Recently, research for Network-on-chip(NoC) is progressing. However, due to the increase of system complexity and demand on high performance, conventional copper-based electrical interconnect would be faced with the design limitation of performance, power, and bandwidth. As an alternative to these problems, combined use of Electrical Interconnects(EIs) and Optical Interconnects(OIs) has been introduced. In this paper we propose efficient routing optimization strategy and hybrid switch architecture, which use OIs for critical path and EIs for non-critical path. The proposed method shows up to 25% performance improvement and 38% power reduction.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.7
• /
• pp.103-110
• /
• 2014

Recent TSV based 3D Integrated Circuit (IC) technology needs more powerful thermal management techniques. However, because cooling cost and form factor are restricted, thermal management are emphasis on software based techniques. But in case of throttling thermal management which one of the most candidate technique, increasing bus occupation induce total performance decrease. To solve communication bottleneck issue in TSV based 3D SoC, we proposed adaptive throttling technique Experimental results show that the proposed method can improve throughput by about 72% compare with minimal path routing.

• IEMEK Journal of Embedded Systems and Applications
• /
• v.5 no.1
• /
• pp.1-6
• /
• 2010

본 논문에서는 네트워크 온 칩(NoC: network on chip) 구조에서의 내부 데이터 통신의 성능을 최적화 할 수 있는 새로운 온 칩 네트워크 인터페이스 구조를 제안하였다. 제안하는 NoC 구조는 기본적으로 하드웨어 면적을 줄이기 위하여 XY 라우팅 알고리듬을 기반으로 구현되었으며, 전달되는 패킷의 크기 또는 플릿의 개수를 최소화하기 위하여 Golomb-Rice 인코딩/디코딩 알고리듬에 기반을 둔 하드웨어 압축기/해제기를 이용하여 통신되는 데이터의 양을 크게 줄임으로써 네트워크 지연시간을 최소화 할 수 있는 새로운 구조를 제안하였다. 즉 전송될 데이터는 전송자(sender)의 네트워크 인터페이스에서 내장된 하드웨어 인코더를 통해 압축된 형태로 패킷의 개수를 최소화하여 온 칩 네트워크상의 데이터를 업로드하게 된다. 이러한 압축된 데이터가 리시버(receiver)에 도착하면, 하드웨어 디코더를 통해서 원래의 데이터로 복원된다. 사이클 수준의 시뮬레이터를 통하여 제안된 라우터 구조가 온 칩 시스템의 네트워크 지연시간을 크게 줄일 수 있음을 증명하였다.

• ETRI Journal
• /
• v.35 no.5
• /
• pp.767-774
• /
• 2013

In this paper, a novel parallel Viterbi decoding scheme is proposed to decrease the decoding latency and power consumption for the software-defined radio (SDR) system. It implements a divide-and-conquer approach by first dividing a block into a series of subblocks, then performing independent Viterbi decoding for each subsequence, and finally merging the surviving subpaths into the final path. Moreover, a network-on-chip-based SDR platform is used to evaluate the performance of the proposed parallel Viterbi decoding scheme. The experiment results show that our scheme can speed up the Viterbi decoding process without increasing the BER, and it performs better than the current state-of-the-art methods.

• ETRI Journal
• /
• v.38 no.6
• /
• pp.1240-1249
• /
• 2016

With the number of IP cores in a multicore system-on-chip increasing to up to tens or hundreds, the role of on-chip interconnection networks is vital. We propose a networks-on-chip-style bus network as a compromise and redefine the exploration problem to find the best IP tiling patterns and communication path combinations. Before solving the problem, we estimate the time complexity and validate the infeasibility of the solution. To reduce the time complexity, we propose two fast exploration algorithms and develop a program to implement these algorithms. The program is executed for several experiments, and the exploration time is reduced to approximately 1/22 and 7/1,200 at the first and second steps of the exploration process, respectively. However, as a trade-off for the time saving, the time cost (TC) of the searched architecture is increased to up to 4.7% and 11.2%, respectively, at each step compared with that of the architecture obtained through full-case exploration. The reduction ratio can be decreased to 1/4,000 by simultaneously applying both the algorithms even though the resulting TC is increased to up to 13.1% when compared with that obtained through full-case exploration.

• Journal of applied mathematics & informatics
• /
• v.28 no.1_2
• /
• pp.539-551
• /
• 2010

Low scalability and power efficiency of the shared bus in SoCs is a motivation to use on chip networks instead of traditional buses. In this paper we have modified the Orion power model to reach an analytical model to estimate the average message energy in K-Ary n-Cubes with focus on the number of virtual channels. Afterward by using the power model and also the performance model proposed in [11] the effect of number of virtual channels on Energy-Delay product have been analyzed. In addition a cycle accurate power and performance simulator have been implemented in VHDL to verify the results.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.14 no.6
• /
• pp.760-767
• /
• 2014

This paper describes a high-radix crossbar switch design with low latency and power dissipation for Network-on-Chip (NoC) applications. The reduction in latency and power is achieved by employing a folded-clos topology, implementing the switch organized as three stages of low-radix switches connected in cascade. In addition, to facilitate the uniform placement of wires among the sub-switch stages, this paper proposes a Mux-Matrix-Mux structure, which implements the first and third switch stages as multiplexer-based crossbars and the second stage as a matrix-type crossbar. The proposed 256-radix, 8-bit crossbar switch designed in a 65nm CMOS has the simulated power dissipation of 1.92-W and worst-case propagation delay of 0.991-ns while operating at 1.2-V supply and 500-MHz frequency. Compared with the state-of-the-art designs in literature, the proposed crossbar switch achieves the best energy-delay-area efficiency of $0.73-fJ/cycle{\cdot}ns{\cdot}{\lambda}^2$.

• Journal of the Semiconductor & Display Technology
• /
• v.18 no.3
• /
• pp.42-46
• /
• 2019

In this paper, we introduce the novel idea to improve parallel test efficiency of semiconductor test. The idea includes the test interface card consisting of NoC structure able to transmitting test data regardless of ATE speed. We called the scheme "Multi-Clock" mode. In the proposed mode, because NoC can spread over the test data in various rates, many semiconductors are tested in the same time. We confirm the proposed idea will be promising through a FPGA board test and it is important to find a saturation point of the Multi-Clock mode due to the number of test chips and ATE channels.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.10
• /
• pp.82-90
• /
• 2013

An Optical Network-on-Chip(ONoC) based on silicon photonics is one of promising technology for next generation exascale computing architectures. Recent active researches on ONoC focus on improving bandwidth further and avoiding path collisions by using wavelength division multiplexing (WDM). However, the number of wavelengths used for the WDM increases linearly as the number of Processing Element (PE) increases in existing ONoCs which adopt centralized routing architecture. The problem will also arises growing cost of optical devices such as light switches and light sources and limits the scalability of ONoC due to the sinal loss caused by interference of distinct light sources. In this paper, we proposes a distributed routing architecture for ONoC which is based on 2D-mesh structure using WDM technique and present a method that minimize the required number of wavelengths exploiting the connectivity of communication. In comparison with existing centralized routing architectures, results show reduction by 56% of the number of wavelengths and 21% of the number of optical switches in $8{\times}8$ networks.