• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1992년도 하계학술대회 논문집 B
• /
• pp.820-824
• /
• 1992

An accurate method for extracting both Si film doping concentration and front or back silicon-to-oxide fixed charge density of fully depleted SOI devices is proposed. The method utilizes the current-to-voltage and capacitance-to-voltage characteristics of both SOI NMOSFET and PMOSFET which have the same doping concentration. The Si film doping concentration and the front or back silicon-to-oxide fixed charge density are extracted by mainpulating the respective threshold voltages of the SOI NMOSFET and PMOSFET according to the back surface condition (accumulation or inversion) and the capacitance-to-voltage characteristics of the SOI PMOSFET. Device simulations show that the proposed method has less than 10% errors for wide variations of the film doping concentration and the front or the back silicon-to-oxide fixed charge density.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2003년도 하계종합학술대회 논문집 II
• /
• pp.707-710
• /
• 2003

10nm 이하의 두께를 갖는 얇은 SOI 층 위에서 우수한 동작 특성을 보이는 Fully-Depleted SOI nMOSFET 을 제작하였다. 게이트의 길이가 큰 경우에는 SOI 층이 얇지 않아도 좋은 특성을 보이지만, 게이트 길이가 100nm 이하에서는 Short Channel Effect 에 의한 특성 열화 때문에 SOI thin body 의 두께가 게이트 길이에 따라 같이 얇아져야 한다. [1] 100nm 게이트 길이 SOI-NMOSFET에서 10nm 이하 body 두께에 따라 Vth는 조금 상승했고, Subthreshold slope은 조금 개선되는 특성을 보였다. 또한, 45nm 게이트 길이와 3nm 로 추정되는 body 두께를 갖는 nMOSFET 에서 우수한 I-V 동작 특성을 얻었다.

• 전자공학회논문지A
• /
• 제31A권12호
• /
• pp.64-70
• /
• 1994

In this paper, we inverstigated how a parricular internal inverter circuit, which is located far from the input protection in CMOS DRAM, can be easily damaged by external ESD stress, while the protection circuit remains intact. It is shown in a mega bit DRAM that the internal circuit can be safe from ESD by simply improving the input protection circuit. An inverter, which consists of a relatively small NMOSFET and a very large PMOSFET, is used to speed up DRAMs, and the small NMOSFET is vulnerable to ESD in case that the discharge current beyond the protection flows through the inverter to Vss or Vcc power lines on chip. This internal circuit damage can not be detected by only measuring input leakage currents, but by comparing the standby and on operating current before and after ESD stressing. It was esperimentally proven that the placement of parasitic bipolar transistor between input pad and power supply is very effective for ESD immunity.

• 전자공학회논문지A
• /
• 제30A권9호
• /
• pp.38-45
• /
• 1993

In this study, the degradation characteristics of drain output resis-tance was described due to hot electron effects. An semi-empirical model for the degraded drain output resistance was derived from the measured device characteristics. The suggested model was verified from the measured data and the device parameter dependence was also analyzed. The degradation of drain output resistance was increased with stress time and had linear relationship with the degradation of drain current. The device lifetime which was defined by failure criteria of drain output resistance (such as $\Delta$ro/roo=5%) was equivalent to that of failure criteria of drain current (such as $\Delta$ID/ID=5%)

• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제51권9호
• /
• pp.397-407
• /
• 2002

A new simulator which predicts the quantum effect in NMOSFET structure is developed. Using the self-consistent method by numerical method, this simulator accurately predicts the carrier distribution due to improved calculation precision of potential in the inversion layer. However, previous simulator uses analytical potential distribution or analytic function based fitting parameter Using the developed simulator, threshold voltage increment and gate capacitance reduction due to the quantum effect are analyzed in NMOS. Especially, as oxide thickness and channel doping dependence of quantum effect is analyzed, and the property analysis for the next generation device is carried out.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2006년도 하계학술대회 논문집 Vol.7
• /
• pp.140-141
• /
• 2006

Background doping concentration (BDC) is proven to be a critical factor to affect the high current behavior of the extended drain NMOSFET (EDNMOS) devices. The EDNMOS device with low BDC suffers from strong snapback in the high current region, which results in poor electrostatic discharge (ESD) protection performance and high latchup risk. However, the strong snapback can be avoided in the EDNMOS device with high BDC. This implies that both the good ESD protection performance and the latchup immunity can be realized in terms of the EDNMOS by properly controlling its BDC.

• 전자공학회논문지A
• /
• 제33A권10호
• /
• pp.123-129
• /
• 1996

LDD structure is widely accepted in fabricating short channel MOSFETs due to reduced short channel effect originated form lower drain edge electric field. However, modeling of the LDD device is troublesome because the analysis methods of LDD region known are either too complicated or inaccurate. To solve the problem, this paper presents a nonlinear resistance model for the LDD region based on teh fact that the electron mobility changes with positive gate bias because accumulation layer of electrons is formed at the surface of the LDD region. To prove the usefulness of the model, single source/drain and LDD nMOSFETs were fabricated with 0.35$\mu$m CMOS technolgoy. For the fabricated devices we have measured I$_{ds}$-V$_{gs}$ characteristics and compare them to the modeling resutls. First of all, we calculated channel and LDD region mobility from I$_{ds}$-V$_{gs}$ characteristics of 1050$\AA$ sidewall, 5$\mu$m channel length LDD NMOSFET. Then we MOSFET and found good agreement with experiments. Next, we use calculated channel and LDD region mobility to model I$_{ds}$-V$_{gs}$ characteristics of LDD mMOSFET with 1400 and 1750$\AA$ sidewall and 5$\mu$m channel length and obtained good agreement with experiment. The single source/drain device characteristic modeling results indicates that the cahnnel mobility obtained form our model in LDD device is accurate. In the meantime, we found that the LDD region mobility is governed by phonon and surface roughness scattering from electric field dependence of the mobility. The proposed model is useful in device and circuit simulation because it can model LDD device successfully even though it is mathematically simple.

• 전기전자학회논문지
• /
• 제24권4호
• /
• pp.975-981
• /
• 2020

위상 잡음을 개선하기 위한 출력 신호의 진폭을 제어하는 회로를 가진 10 GHz LC 전압 제어 발진기(VCO : voltage-controlled oscillator)가 제안된다. 제안된 LC VCO를 위한 진폭 제어 회로는 피크 검출 회로, 증폭기, 그리고 전류원 회로로 구성된다. 피크 검출 회로는 2 개의 diode-connected NMOSFET과 하나의 커패시터로 구성되어 출력 신호의 최젓값을 감지함으로 수행된다. 제안하는 진폭 제어 회로를 가진 LC VCO는 1.2 V 공급 전압을 사용하는 55 nm CMOS 공정에서 설계된다. 설계된 LC VCO의 면적은 0.0785 ㎟이다. 제안된 LC VCO에 사용된 진폭 제어 회로는 기존 LC VCO의 출력 신호에서 발생되는 242 mV의 진폭 변화를 47 mV로 줄인다. 또한, 출력 신호의 peak-to-peak 시간 지터를 8.71 ps에서 931 fs로 개선한다.

• 전기전자학회논문지
• /
• 제3권1호
• /
• pp.118-125
• /
• 1999

게이트 아래의 기판과 쏘오스/드레인의 접합부분 사이의 길이로 정의되는 LDD MOSFET의 metallurgical 채널 길이를 커패시턴스 측정을 이용하여 결정할 수 있는 방법을 제안하였다. 전체의 게이트 면적이 동일한 평판 모양과 손가락 모양의 LDD MOSFET 게이트 테스트 패턴의 커패시턴스를 측정하였다. 각 테스트 패턴의 쏘오스/드레인과 기판의 전압을 접지시키고 게이트의 전압을 변화시키면서 커페시턴스를 측정하였다. 두 테스트 패턴의 측정치의 차이를 그려서 최대점이 나타나는 점의 값를 간단한 수식에 대입하여 metallurgical 채널 길이를 구하였다. 이차원적 소자 시뮬레이터를 사용하여 수치해석적 모의 실험을 함으로써 제안한 방법을 증명하였다.

• 센서학회지
• /
• 제14권6호
• /
• pp.387-394
• /
• 2005

In order to design SOI CMOS image sensors, SOI MOSFET model parameters were extracted using the equation of bulk MOSFET model parameters and were optimized using SPICE level 2. Simulated I-V characteristics of the SOI NMOSFET using the extracted model parameters were compared to the experimental I-V characteristics of the fabricated SOI NMOSFET. The simulation results agreed well with experimental results. A unit pixel for SOI CMOS image sensors was designed and was simulated for the PPS, APS, and logarithmic circuit using the extracted model parameters. In these CMOS image sensors, a nano-wire MOSFET photodetector was used. The output voltage levels of the PPS and APS are well-defined as the photocurrent varied. It is confirmed that SOI CMOS image sensors are faster than bulk CMOS image sensors.