• ETRI Journal
• /
• v.29 no.4
• /
• pp.421-429
• /
• 2007

This paper presents a direct-conversion CMOS transceiver for fully digital DS-UWB systems. The transceiver includes all of the radio building blocks, such as a T/R switch, a low noise amplifier, an I/Q demodulator, a low pass filter, a variable gain amplifier as a receiver, the same receiver blocks as a transmitter including a phase-locked loop (PLL), and a voltage controlled oscillator (VCO). A single-ended-to-differential converter is implemented in the down-conversion mixer and a differential-to-single-ended converter is implemented in the driver amplifier stage. The chip is fabricated on a 9.0 $mm^2$ die using standard 0.18 ${\mu}m$ CMOS technology and a 64-pin MicroLead Frame package. Experimental results show the total current consumption is 143 mA including the PLL and VCO. The chip has a 3.5 dB receiver gain flatness at the 660 MHz bandwidth. These results indicate that the architecture and circuits are adaptable to the implementation of a wideband, low-power, and high-speed wireless personal area network.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2001.11a
• /
• pp.44-48
• /
• 2001

In this paper we describe the design of symbol timing and carrier synchronization algorithms for burst receiver. The demodulator consists of digital down converter, matched filter and synchronization circuits. For symbol timing recovery we use modified Gardner algorithm. And we use decision directed method for carrier phase recovery. For the sake of performance analysis, we compare simulation results with the board implemented by FPGA which is APEX20KE series chip for Alter. The performance results show it works quite well up to the condition that a frequency offset equal to 0.1% of symbol rate.

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 2004.11a
• /
• pp.363-363
• /
• 2004

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.2B
• /
• pp.59-68
• /
• 2008

In order to activate the digital broadcasting in Korea, the analog broadcasting will have been closed down until 2012. Recently IPTV(Internet Protocol TV) thorough internet has been regarded as the fourth media following the terrestrial, satellite, and cable for the digital broad casting. And it has been the important medium for the communication and broadcasting system. However IP is not easy to replace the entire broadcasting system with the digital - type broadcasting system. For the digital broadcasting, we should replace all TV sets, install the settop-boxes to receive the various IP media, solve problems about time delaying when changing channels, and support communication and broadcasting consolidation service for such as PVR and Network CCTV. IPMG is the digital converter that is able to solve these problems. In this paper, I'll develop and analyze IPMG converter's performance which sends and receives both the analogue and digital broadcasting signals through various media gives the Network PVR service.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.13 no.5
• /
• pp.403-411
• /
• 2020

Since the analog circuit of the beta ray sensor circuit for the true random number generator and the power and ground line used in the comparator circuit are shared with each other, the power generated by the digital switching of the comparator circuit and the voltage drop at the ground line was the cause of the decreasein the output signal voltage drop at the analog circuit including CSA (Charge Sensitive Amplifier). Therefore, in this paper, the output signal voltage of the analog circuit including the CSAcircuit is reduced by separating the power and ground line used in the comparator circuit, which is the source of digital switching noise, from the power and ground line of the analog circuit. In addition, in the voltage-to-voltage converter circuit that converts VREF (=1.195V) voltage to VREF_VCOM and VREF_VTHR voltage, there was a problem that the VREF_VCOM and VREF_VTHR voltages decrease because the driving current flowing through each current mirror varies due to channel length modulation effect at a high voltage VDD of 5.5V when the drain voltage of the PMOS current mirror is different when driving the IREF through the PMOS current mirror. Therefore, in this paper, since the PMOS diode is added to the PMOS current mirror of the voltage-to-voltage converter circuit, the voltages of VREF_VCOM and VREF_VTHR do not go down at a high voltage of 5.5V.

• Proceedings of the IEEK Conference
• /
• 2007.07a
• /
• pp.45-46
• /
• 2007

In order to go digital broadcasting in Korea, it is conducted various policies in the country which be expanded network, be increased digital broadcasting hours. And broadcasting stations in the country close down analog broadcasting until 2012. Moreover IPTV is a method of delivering broadcast television and on-demand, rich media content that uses an IP(Internet protocol network) as the medium. And an IP is regarded as a very favorable approach for the future "Medium for Digital TV". However It is not easy to replace the entire digital infrastructure. And there are some problems in the digital infrastructure for Digital TV(i.e. channel zapping delay). Moreover user require service. IPMG is to solve these problems. IPMG is digital converter that allows receive and transmit signal by using many kinds of medium for Digital TV. Moreover IPMG provides users a Network PVR service. In this paper we developing, manufacturing IPMG and analyze its performance.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.13 no.3
• /
• pp.503-508
• /
• 2018

This study describes the design and implementation of EGSE for Digital Satellite Communication. The EGSE is a equipment that evaluates digital satellite communication and requires precise and accurate measurement. EGSE consists of a PLDIU and IIU(Instrument Interface Unit), Up/Down converter for SHF band, Modems to verify the Digital Satellite Communication. The EGSE was used for performance verification and space environment test such as thermal vacuum after developing digital satellite communication.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.22 no.3
• /
• pp.332-340
• /
• 2019

Electronic warfare systems are needed to be advantageous in the modern war. Many radar threat signals with various frequency spectrums and complicated techniques exist. For detecting the threats, a receiver with wide and narrow-band digital processing is needed. To process a wide-band searching mode, a polyphase filter bank has become the architecture of choice to efficiently detect threats. A polyphase N-path filter aligns the re-sampled time series in each path, and a discrete Fourier transform aligns phase and separates the sub-channel baseband aliases. Multiple threats and CW are detected or rejected when the signals are received in different sub-channels. And also, to process a narrow-band precision mode, a direct down converter is needed to reduce aliasing by using a decimation filter. These digital logics are designed in a FPGA. This paper shows how to design and develop a wide and narrow-band digital receiver that is capable to detect the threats.

• Proceedings of the IEEK Conference
• /
• 2001.09a
• /
• pp.951-954
• /
• 2001

본 논문에서는 SDR (Software Defined Radio)시스템을 위한 디지털 IF (Intermediate Frequency)수신기를 구현하였다[1][2]. 구현된 수신기의 하드웨어 구조는 AD변환부, PDC(Programmable Down Converter)부, DSP (Digital Signal Processing)부분으로 이루어졌다. AD변환부는 Analog Devices사의 AD6644를 이용하여 아날로그 신호를14bit의 디지털 신호로 변환된다. PDC부분은 Intersil사의 HSP 50214B를 이용하여 14bit 샘플 된 IF(Intermediate Frequency)입력을 혼합기와 NCO(Numerically Controlled Oscillator)에 의해 기저대역으로 다운 시키는 역할을 한다. PDC는 CIC (Cascaded Integrator Comb)필터, Halfband 필터 그리고 프로그램할 수 있는 FIR필터로 구성되어 있다. 그리고 PDC부분을 제어하고 PDC부분에서 처리할 수 없는 캐리어, 심볼 트래킹을 위해 Texas Instrument사의 16비트의 고정소수점 DSP인 TMS320C5416과 Altera사의 FPGA를 사용하였다. 그러므로 중간주파수 대역과 기저대역 간의 신호변환을 디지털 신호처리를 수행함으로써 일반적인 아날로그 처리방식보다 고도의 유연성과 고성능 동작이 가능하고 시간과 환경 변화에 우수한 동작 특성을 제공한다.

• Proceedings of the IEEK Conference
• /
• 2002.07c
• /
• pp.1984-1987
• /
• 2002

This paper describes the design and implementation of a single-chip digitally synthesized 0-35MHz agile function generator. The chip comprises an integrated direct digital synthesizer (DDS) with a 10-bit on- chip digital-to-analog converter (DAC) using an n-well single-poly triple-metal 0.5-$\mu\textrm{m}$ CMOS technology. The main features of the chip include maximum clock frequency of 100 MHz at 3.3-V supply voltage, 32-bit frequency tuning word resolution, 12-bit phase tuning word resolution, and an on-chip 10-bit DAC. The chip provides sinusoidal, ramp, saw-tooth, and random waveforms with phase and frequency modulation, and power-down function. At 100-MHz clock frequency, the chip covers a bandwidth from dc to 35 MHz in 0.0233-Hz frequency steps with 190-ns frequency switching speed. The complete chip occupies 12-mm$^2$die area and dissipates 0.4 W at 100-MHz clock frequency.