• Resources Recycling
• /
• v.30 no.6
• /
• pp.3-11
• /
• 2021

In this study, the effect of the solubility of ammonium metavanadate and the decomposition ratio of ammonium ions on a precipitation reaction-the precipitation of ammonium metavanadate by adding ammonium chloride to a sodium vanadate solution-was investigated. As the precipitation temperature and pH increased, the decomposition ratio of ammonium ions increased, and the decomposition ratio was greater than 81% at 45 ℃ and pH 9.3. This was approximately four times higher than that at pH 8. The result of the precipitation reaction, in view of these two factors that significantly influence the precipitation reaction, was that the precipitation yield increased as the temperature increased. However, the effect of temperature was not significant above 35 ℃. A kinetic study of the precipitation reaction revealed that the activation energy of the reaction was 42.3 kJ/mol. Therefore, considering the solubility of ammonium metavanadate, the lower the temperature, the better the vanadium recovery yield. Additionally, considering the decomposition of ammonium ions, the lower the pH of the aqueous solution, the more advantageous. However, at pH 8 or less, sodium polyvanadate is precipitated and the purity of vanadium oxide may reduce.

• Composites Research
• /
• v.32 no.1
• /
• pp.78-84
• /
• 2019

This study focused on the prediction of the long-term performance of carbon fiber/epoxy composites using Dynamic Mechanical Analysis (DMA) and Time-Temperature Superposition (TTS). Single-frequency test, multi-frequency test, and creep TTS test were performed. A sinusoidal load of $20{\mu}m$ amplitude was applied while increasing the temperature from $-30^{\circ}C$ to $240^{\circ}C$ at $2^{\circ}C/min$ for the single-frequency test and the multi-frequency test. The frequencies applied to the multi-frequency test were 0.316, 1, 3.16, 10 and 31.6 Hz. In the creep TTS test, a stress of 15 MPa was applied for 10 minutes at every $10^{\circ}C$ from $-30^{\circ}C$ to $230^{\circ}C$. The glass transition temperature was determined by single-frequency test. The activation energy and the storage modulus curve for each temperature were obtained from glass transition temperature for each frequency by the multi-frequency test. The master curve for the reference temperature was obtained by applying the shift factor using the Arrhenius equation. Also, TTS test was used to obtain the creep compliance curves for each temperature and the master curve for the reference temperature by applying the shift factors using the manual shift technique. The master curve obtained through this process can be applied to predict the long-term performance of carbon fiber/epoxy composites for a given environmental condition.

• Korean Journal of Metals and Materials
• /
• v.49 no.2
• /
• pp.167-173
• /
• 2011

Nickel cobalt ferrite($Ni_{0.5}Co_{0.5}Fe_2O_4$) powder was prepared through the ceramic route by the calcination of a stoichiometric mixture of NiO, CoO and $Fe_2O_3$ at $1100^{\circ}C$. The pressed pellets of $Ni_{0.5}Co_{0.5}Fe_2O_4$ were isothermally reduced in pure hydrogen at $800{\sim}1100^{\circ}C$. Based on the thermogravimetric analysis, the reduction behavior and the kinetic reaction mechanisms of the synthesized ferrite were studied. The initial ferrite powder and the various reduction products were characterized by X-ray diffraction, scanning electron microscopy, reflected light microscope and vibrating sample magnetometer to reveal the effect of hydrogen reduction on the composition, microstructure and magnetic properties of the produced Fe-Ni-Co alloy. The arrhenius equation with the approved mathematical formulations for the gas solid reaction was applied to calculate the activation energy($E_a$) and detect the controlling reaction mechanisms. In the initial stage of hydrogen reduction, the reduction rate was controlled by the gas diffusion and the interfacial chemical reaction. However, in later stages, the rate was controlled by the interfacial chemical reaction. The nature of the hydrogen reduction and the magnetic property changes for nickel cobalt ferrite were compared with the previous result for nickel ferrite. The microstructural development of the synthesized Fe-Ni-Co alloy with an increase in the reduction temperature improved its soft magnetic properties by increasing the saturation magnetization($M_s$) and by decreasing the coercivity($H_c$). The Fe-Ni-Co alloy showed higher saturation magnetization compared to Fe-Ni alloy.

• Journal of Microbiology and Biotechnology
• /
• v.31 no.2
• /
• pp.207-216
• /
• 2021

Supplement of high-protein food plays an important role in improving the symptoms of malnutrition and the immune capacity of the body, but the association of high-protein diet and gut microbiota remained unaddressed. Here, we systematically analyzed the internal organs and gut microbiota in C57(WT) or PD-1H-depleted (KO) mice (T cells were activated) fed with pupae or feed for six weeks. We observed that the body weight gain in the mice fed with pupae increased less significantly than that of the feed group, while the villi and small intestine lengths in the pupa group were reduced compared with that of mice given feed. However, the average body weight of the KO mice increased compared with that of the WT mice fed with pupae or feed. Pupae increased the concentration of blood glucose in WT, but not in KO mice. Moreover, in the feed group, there was no difference in the weight of the internal organs between the WT and KO mice, but in the pupae-fed group, liver weight was decreased and spleen weight was increased compared with that of KO mice. The amounts/plural/amounts of Melainabacteria, Chloroflexi, and Armatimonadetes were specifically upregulated by pupae, and this upregulation was weakened or eliminated by PD-1H depletion. Some bacteria with high abundance in the feed-fed KO mice, such as Deferribacteres, Melainabacteria, Acidobacteria, Bacteroidetes, Spirochaetes and Verrucomicrobia, were decreased in pupae-fed KO mice, and Proteobacteria and Deinococcus were specifically enriched in pupae-fed KO mice. Bacteroidetes, Firmicutes and Akkermansia were associated with weight loss in the pupae-fed group while Lachnospiraceae and Anaerobiospirillum were related glucose metabolism and energy consumption. Based on high-throughput sequencing, we discovered that some gut bacteria specifically regulated the metabolism of a high-protein diet, and PD-1H deficiency improved life quality and sustained blood glucose. Moreover, PD-1H responses to high-protein diet through modulating the type and quantity of gut bacteria. These findings provide evidence about the association among gut microbiota, T cell activation (for PD-1H depletion) and high-protein diet metabolism, have important theoretical significance for nutrition and health research.

• Korean Chemical Engineering Research
• /
• v.60 no.1
• /
• pp.159-168
• /
• 2022

Catalytic activity in ammonia decomposition reaction was studied on Mo-Al nitride obtained through temperature programmed nitridation of calcined Mo-Al mixed oxide prepared by varying the MoO₃ quantity in the range of 10-50 wt%. N₂ sorption analysis, X-ray diffraction analysis (XRD), X-ray photoelectron spectroscopy (XPS) and H₂-temperature programmed reduction (H₂-TPR), and transmission electron microscopy (TEM) to investigate the physicochemical properties of the prepared catalyst were performed. After calcination at 600 ℃, the XRD of Mo-Al oxide showed γ-Al₂O₃ and Al₂(MoO₄)₃ phases, and the nitride after nitridation showed an amorphous form. The specific surface area after nitridation by topotactic transformation of MoO₃ to nitride was increased due to the formation of Mo nitride, and the Mo nitride was observed to be supported on γ-Al₂O₃. As for the catalytic activity in the ammonia decomposition reaction, 40 wt% MoO₃ showed the best activity, and as the nitridation time increases, the activity increased, and thus the activation energy decreased.

• Korean Chemical Engineering Research
• /
• v.60 no.2
• /
• pp.193-201
• /
• 2022

5-HMF(5-Hydroxymethylfurfural) and LA(levulinic acid) derived from biomass are green platform chemicals, which have a wide of potential applications as biofules and biochemicals. In this study, the kinetics of LA formation from glucose decomposition with various concentration of sulfuric acid at different temperature was investigated. The experiments were performed in a broad temperature (140-200 ℃), using H₂SO₄ (1-3 wt%) as the catalyst. Glucose solution was made by dissolving 1 g of glucose in 10 ml of H₂SO₄ solution. The reactions rates increased with temperature and the activation energy showed a similar tendency to previous reported values. Reaction time for maximum concentration of 5-HMF decreased as the temperature increased. Furthermore, the decomposition of 5-HMF was fast as the acid concentration increased. Reaction time to reach maximum concentration of levulinic acid was reduced as the acid concentration increased. Continuing to raise the temperature decreased the maximum concentration of levulinic acid and increased the amount of humins. On the basis of results, kinetic parameters help to understand mechanism of LA and 5-HMF. In addition, this study provides useful information to achieve high concentration of LA and 5-HMF from biomass.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.35 no.5
• /
• pp.499-503
• /
• 2022

La_0.7Sr_0.3MnO₃ precursor solution were prepared by a sol-gel method. La_0.7Sr_0.3MnO₃ thin films were fabricated by a spin-coating method on a Pt/Ti/SiO₂/Si substrate. Structural and electrical properties with the variation of sintering temperature were measured. All specimens exhibited a polycrystalline orthorhombic crystal structure, and the average thickness of the specimens coated 6 times decreased from about 427 nm to 383 nm as the sintering temperature increased from 740℃ to 830℃. Electrical resistance decreased as the sintering temperature increased. In the La_0.7Sr_0.3MnO₃ thin films sintered at 830℃, electrical resistivity, TCR, B-value, and activation energy were 0.0374 mΩ·cm, 0.316%/℃, 296 K and 0.023 eV, respectively.

• BMB Reports
• /
• v.54 no.5
• /
• pp.266-271
• /
• 2021

Estrogen-related receptor γ (ERRγ), a member of the orphan nuclear receptor family, is a key mediator in cellular metabolic processes and energy homeostasis. Therefore, ERRγ has become an attractive target for treating diverse metabolic disorders. We recently reported that ERRγ acts as a negative regulator of osteoclastogenesis induced by receptor activator of nuclear factor-κB ligand (RANKL). In the present study, we explored the effects of an ERRγ-specific modulator, GSK5182, on ERRγ-regulated osteoclast differentiation and survival. Interestingly, GSK5182 increased ERRγ protein levels much as does GSK4716, which is an ERRγ agonist. GSK5182 inhibited osteoclast generation from bone-marrow-derived macrophages without affecting cytotoxicity. GSK5182 also attenuated RANKL-mediated expression of cFos and nuclear factor of activated T-cells cytoplasmic 1 (NFATc1), pivotal transcription factors for osteoclastogenesis. Arrested osteoclast differentiation was associated with reduced RANK expression, but not with the M-CSF receptor, c-Fms. GSK5182 strongly blocked the phosphorylation of IκBα, c-Jun N-terminal kinase, and extracellular signal-regulated kinase in response to RANKL. GSK5182 also suppressed NF-κB promoter activity in a dose-dependent manner. In addition to osteoclastogenesis, GSK5182 accelerated osteoclast apoptosis by caspase-3 activation. Together, these results suggest that GSK5182, a synthetic ERRγ modulator, may have potential in treating disorders related to bone resorption.

• Korean small business review
• /
• v.42 no.4
• /
• pp.251-283
• /
• 2020

The purpose of this study is to provide assistance to the establishment of related policies to improve the level of acceptance and use of smart factories for SMEs in Korea. To this end, the Unified Technology Acceptance Model (UTAUT) was extended to select additional factors that could affect the intention to accept technology, and to demonstrate this. To achieve the research objective, a questionnaire composed of 7-point Likert scales was prepared, and a survey was conducted for manufacturing-related companies. A total of 136 questionnaires were used for statistical processing. As a result of the hypothesis test, performance expectation and social influence had a positive (+) positive effect on voluntary use, but effort expectation and promotion conditions did not have a significant effect. As an extension factor, the network effect and organizational characteristics had a positive (+) effect, and the innovation resistance had a negative effect (-), but the perceived risk had no significant effect. When the size of the company is large, the perceived risk and innovation resistance are low, and the level of influencing factors for veterinary intentions, veterinary intentions, and veterinary behaviors are excluded. Through this study, factors that could have a positive and negative effect on the adoption (reduction) of smart factory-related technologies were identified and factors to be improved and factors to be reduced were suggested. As a result, this study suggests that smart factory-related technologies should be accepted.

• Journal of Life Science
• /
• v.31 no.11
• /
• pp.1037-1045
• /
• 2021

The prevalence of obesity is increasing worldwide, and since obesity is associated with dietary factors and sedentary lifestyles, it is a disease that is readily developing in the modern population. Because obesity is accompanied by serious complications such as diabetes and cardiovascular disease, prevention and treatment are important. Currently, drugs such as liraglutide and phentermine are used to treat obesity by suppressing appetite and inducing gastrointestinal motility delay. However, various side effects may occur, including thyroid cancer, cardiovascular problems, and central nervous system disorders. Therefore, to explore an obesity treatment method with relatively few side effects, a method known as "fat browning" was introduced to change white adipose tissue into brown adipose tissue to increase energy consumption. Ongoing studies are attempting to find effective natural substances to safely induce browning. Many natural substances have been identified. The induction of browning by treatment with natural substances generally involves three mechanisms: positive control of browning-inducing factors, inhibition of differentiation into white adipose tissue, and the activation of mechanisms related to browning. In this study, we describe plant extracts with known browning-inducing effects, such as strawberry, black raspberry, cinnamomum cassia, and Ecklonia stolonifera extracts. We also summarize the underlying mechanisms of action identified thus far, including the signaling pathway mediated by these extracts to induce browning. Furthermore, the effects of brown adipose tissue generated through browning on heart disease as an endocrine organ disruptor are discussed.