• JSTS:Journal of Semiconductor Technology and Science
• /
• v.7 no.4
• /
• pp.260-266
• /
• 2007

Analytical compact form models for the signal transients and crosstalk noise of inductive-effect-prominent multi-coupled RLC lines are developed. Capacitive and inductive coupling effects are investigated and formulated in terms of the equivalent transmission line model and transmission line parameters for fundamental modes. The signal transients and crosstalk noise expressions of two coupled lines are derived by using a waveform approximation technique. It is shown that the models have excellent agreement with SPICE simulation.

• Proceedings of the KIEE Conference
• /
• 2001.07a
• /
• pp.491-493
• /
• 2001

This paper describes the effect of lightning current on combination transmission line. In the paper, an lightning current which can generate 2/80[${\mu}s$]. 20[kA] - 40[kA] waveform is modeled in ATPDraw. The lightning current invaded to the overhead power transmission line propagates to the underground power cable. The simulation was performed to analyze the effect of arrester location and overvoltage occurred in power cable.

• Proceedings of the KIPE Conference
• /
• 2005.07a
• /
• pp.143-145
• /
• 2005

This paper describes the transmission method of an information using communication networks between RTU(Remote Terminal Unit) and PCU(Protection and Control System) of the DC switchgear for Light Railway Vehicle. Also the test result carried out in the laboratory was represented. In this test, transmission signal waveform, polling time, response time and request/response frame between RTU and PCU were measured. The field test including the measurements of analog signal and status of the digital logic operation of PCU was conducted in Gyeongsan Test Track.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.14 no.4
• /
• pp.463-470
• /
• 2014

A Verilog model is proposed for transmission lines to perform the all-Verilog simulation of high-speed chip-to-chip interface system, which reduces the simulation time by around 770 times compared to the mixed-mode simulation. The single-pulse response of transmission line in SPICE model is converted into that in Verilog model by converting the full-scale analog signal into an 11-bit digital code after uniform time sampling. The receiver waveform of transmission line is calculated by adding or subtracting the single-pulse response in Verilog model depending on the transmitting digital code values with appropriate time delay. The application of this work to a USB 2.0 high-speed PHY interface reduces the simulation time to less than three minutes with error less than 5% while the mixed-mode simulation takes more than two days for the same circuit.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.6
• /
• pp.955-961
• /
• 2016

Fault location estimation is an important element for rapid recovery of power system when fault occur in transmission line. In order to calculate line impedance, most of fault location algorithm uses by measuring relaying waveform using DFT. So if there is a calculation error due to the influence of phasor by DC offset component, due to large vibration by line impedance computation, abnormal and non-operation of fault locator can be issue. It is very important to implement the robust fault location algorithm that is not affected by DC offset component. This paper describes an enhanced fault location algorithm based on the DC offset elimination filter to minimize the effects of DC offset on a long transmission line. The proposed DC offset elimination filter has not need any erstwhile information. The phase angle delay of the proposed DC offset filter did not occurred and the gain error was not found. The enhanced fault location algorithm uses DFT filter as well as the proposed DC offset filter. The behavior of the proposed fault location algorithm using off-line simulation has been verified by data about several fault conditions generated by the ATP simulation program.

• Proceedings of the KIEE Conference
• /
• 1990.11a
• /
• pp.184-187
• /
• 1990

This paper presents the self-matched line pulse generator and the concerned principles on its operation and characteristics are mentioned. The circuit consists of a charged transmission line and a high speed switch, and it generates a square wave pulse with the very fast rise time. The generated waveform depends on the load resistance. As the load resistance is infinite, a single rectangular wave pulse is generated and its efficiency is nearly unity.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.7 no.4
• /
• pp.1-5
• /
• 1970

This presents the way in shich the input impedance, and the output waveform of the line discriminator are influenced by a discrepancy of less than $\pm$10% in the coupling resistor resistance from the optium value(Characteristic impedance of the transmission line used in the line discriminator)

• Journal of the Korea Society for Simulation
• /
• v.12 no.4
• /
• pp.17-24
• /
• 2003

In this paper, we propose a model that simulates the reflective waveform from underwater objects by means of Doppler effect, highlight and elongation phenomenon. Also, this paper presents a hardware Implementation of simulation model with the input and output parameters. The underwater target simulator consists of transducer, receiver, transmitter and control parts. According to the experimental results of the simulator, it carried out the performances of real target in response to transmission signal.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.9 no.1
• /
• pp.8-13
• /
• 2009

In this paper, discontinuous interconnect lines are modeled as a cascaded line composed of many uniform interconnect lines. The system functions of respective uniform interconnect lines are determined, followed by its time domain response. Since the time domain response expression is a transcendental form, the waveform expression is reconfigured as an approximated linear expression. The proposed model has less than 2% error in the delay estimation.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.24 no.3
• /
• pp.412-419
• /
• 2020

The strategic unit communication infrastructure for military command, communications requires a dualized network structure of various communication methods, considering the direction of development, strategic unit and line characteristic. It has been pointed out that MicroWave, which is typical of wireless systems, is inefficient because it operates only with existing technologies. Therefore, it is necessary to analyze the structure, efficiency of the MW transmission system and its effects. It is difficult to transfer efficiently considering wireless environment due to a fixed type of access structure in the existing MW transmission system. Adaptive modulation allows improvement, but with traditional access structures and fixed bandwidth, there is a limit. Following the transmission performance improvement technique considering availability and link distance in the previous study, this paper presented improved packetized MW transmission system structure and variable bandwidth transmission in consideration of adaptive modulation based variable transmission waveform, bandwidth and distance, and performed the analysis in view of the strategic unit and command control circuit.