• Journal of Power Electronics
• /
• 제5권3호
• /
• pp.224-232
• /
• 2005

A new three phase three-level Pulse Width Modulation (PWM) Switched Voltage Source (SVS) inverter with zero neutral point potential is proposed. It consists of three single-phase inverter modules. Each module is composed of a switched voltage source and inverter switches. The major advantage is that the peak value of the phase output voltage is twice as high as that of a conventional neutral-point-clamped (NPC) PWM inverter. Thus, the proposed inverter is suitable for applications with low voltage sources such as batteries, fuel cells, or solar cells. Furthermore, three-level waveforms of the proposed inverter can be achieved without the switch voltage imbalance problem. Since the average neutral point potential of the proposed inverter is zero, a common ground between the input stage and the output stage is possible. Therefore, it can be applied to a transformer-less Power Conditioning System (PCS). The proposed inverter is verified by a PSpice simulation and experimental results based on a laboratory prototype.

• 한국정보통신학회논문지
• /
• 제14권1호
• /
• pp.197-204
• /
• 2010

본 논문은 저 전압 및 저 왜곡 스위치형 커패시터 (switched-capacitor, SC)를 적용한 새로운 형태의 몸체효과 보상형 스위치 구조를 제안한다. 제안된 회로는 저 전압 SC회로를 위해서 rail-to-rail 스위칭을 허용하며, 기존의 부트스트랩 된 회로 (19dB)보다 더 우수한 총 고조파 왜곡을 가진다. 설계된 2-1 캐스케이드 시그마 델타 변조기는 통신 송수신 시스템내의 오디오 코덱을 위한 고해상도 아날로그-디지털변환을 수행한다. 1단 폴드형 캐스코드 연산증폭기 및 2-1 캐스케이드 시그마 델타 변조기는 0.25 마이크론 이중 폴리 3-금속 표준 CMOS 공정으로 제작되었으며, 2.7V에서 동작한다. 연산증폭기의 1% 정착시간은 16 pF의 부하 용량에 대해 560ns를 보였다. 제작된 시그마 델타 변조기에 대한 검사는 비트 스트림 검사 및 아날로그 분석기를 이용하여 수행 되었다. 다이크기는 $1.9{\times}1.5\;mm^2$였다.

• 전자공학회논문지S
• /
• 제36S권11호
• /
• pp.15-21
• /
• 1999

전송성능 열화요소들을 고려하여 광상호분배기 노드의 극장성을 분석하였다. 고려된 전송성능 열화요소들은 광증폭기에서 발생하는 ASE 잡음 누적과 이득포화 특성, 그리고 파장 다중/역다중화기와 광스위치에서 발생하는 누화 등이 있다. 파장 다중/역다중화기 누화비가 25dB이하이면 10단의 노드를 통과한 후에도 1dB이하의 power penalty를 갖는다. 10Gbps 신호의 다단 전송에서 입출력 포트수가 4와 16일 때 스위치 누화비가 각각 30dB와 45dB이상이면 ASE 잡음누적보다 누화에 의한 성능열화가 보다 지배적이다. 10Gbps 신호를 21dB 손실을 갖는 광섬유 링크 전송시 $10^{-12}$의 BER을 얻기 위해 광상호분배기 노드에서의 최대 손실은 34dB이하이어야 한다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2007년도 심포지엄 논문집 정보 및 제어부문
• /
• pp.267-269
• /
• 2007

PLL(Phase Locked Loop) are widely used circuit technique in modern electronic systems. In this paper, We propose the low voltage and high speed PLL. We design the PFD(Phase Frequency Detector) by using TSPC (True Single Phase Clock) circuit to improve the performance and solve the dead-zone problem. We use CP(Charge Pump} and LP(Loop filter) for Negative feedback and current reusing in order to solve current mismatch and switch mismatch problem. The VCO(Voltage controlled Oscillator) with 5-stage differential ring oscillator is used to exact output frequency. The divider is implemented by using D-type flip flops asynchronous dividing. The frequency divider has a constant division ratio 32. The frequency range of VCO has from 200MHz to 1.1GHz and have 1.7GHz/v of voltage gain. The proposed PLL is designed by using 0.18um CMOS processor with 1.8V supply voltage. Oscillator's input frequency is 25MHz, VCO output frequency is 800MHz and lock time is 5us. It is evaluated by using cadence spectra RF tools.

• 조명전기설비학회논문지
• /
• 제21권4호
• /
• pp.19-27
• /
• 2007

This paper presents a novel soft-switching PWM utility frequency AC to high frequency AC power conversion circuit incorporating boost H-bridge inverter topology, which is more suitable and acceptable for cost effective consumer induction heating applications. The operating principle and the operation modes are presented using the switch mode equivalent circuits and the operating voltage and current waveforms. The performances of this high-frequency inverter using the latest IGBTs are illustrated, which includes high frequency power regulation and actual efficiency characteristics based on zero voltage soft-switching(ZVS) operation ranges, and the power dissipation as compared with those of the conventional type high frequency inverter. In addition, a dual mode control scheme of this high frequency inverter based on asymmetrical pulse width modulation(PWM) and pulse density modulation(PDM) control scheme is discussed in this paper in order to extend the soft switching operation ranges and to improve the power conversion efficiency at the low power settings. The power converter practical effectiveness is substantially proved based on experimental results from practical design example.

• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2006년도 춘계종합학술대회
• /
• pp.906-909
• /
• 2006

본 논문은 저 전압 및 저 왜곡 스위치형 커패시터 (switched-capacitor, SC)를 적용한 새로운 형태의 몸체효과 보상형 스위치 구조를 제안한다 제안된 회로는 저 전압 SC 회로를 위해서 rail-to-rail 스위칭을 허용하며 기존의 부트스트랩된 회로 (19dB) 보다 더 우수한 총 고조파 왜곡을 가진다. 설계된 2-1 캐스케이드 시그마 델타 변조기는 통신 송수신시스템내의 오디오 코덱을 위한 고해상도 아날로그-디지털변환을 수행한다. 1단 폴드형 캐스코드 연산증폭기 및 2-1 캐스케이드 시그마 델타 변조기는 0.25 마이크론 이중 폴리 3-금속 표준 CMOS 공정으로 제작되었으며, 2.7V에서 동작한다.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2019년도 전력전자학술대회
• /
• pp.83-85
• /
• 2019

The use of high voltage gain converters is essential for the distributed power generation systems with renewable energy sources such as the fuel cells and solar cells due to their low voltage characteristics. In this paper, a high voltage gain topology combining cascode Inverting Buck-Boost converter and voltage multiplier structure is introduced. In proposed converter, the input voltage is connected in series at the output, the portion of input power is directly delivered to the load which results in continuous input current. In addition, the voltage multiplier stage stacked in proper manner is not only enhance high step-up voltage gain ratio but also significantly reduce the voltage stress across all semiconductor devices and capacitors. As a result, the high current-low voltage switches can be employed for higher efficiency and lower cost. In order to show the feasibility of the proposed topology, the operation principle is presented and the steady-state characteristic is analyzed in detail. A 380W-40/380V prototype converter was built to validate the effectiveness of proposed converter.

• 한국정보통신학회논문지
• /
• 제16권9호
• /
• pp.1847-1855
• /
• 2012

클록 보정회로를 가진 1V 1.6-GS/s 6-비트 flash 아날로그-디지털 변환기 (ADC: analog-to-digital converter)가 제안된다. 1V의 저전압에서 고속 동작의 입력단을 위해 bootstrapped 아날로그 스위치를 사용하는 단일 track/hold 회로가 사용되며, 아날로그 노이즈의 감소와 고속의 동작을 위해 평균화 기법이 적용된 두 단의 프리앰프와 두 단의 비교기가 이용된다. 제안하는 flash ADC는 클록 보정회로에 의해 클록 duty cycle과 phase를 최적화함으로 flash ADC의 동적특성을 개선한다. 클록 보정 회로는 비교기를 위한 클록의 duty cycle을 제어하여 evaluation과 reset 시간을 최적화한다. 제안된 1.6-GS/s 6-비트 flash ADC는 1V 90nm의 1-poly 9-metal CMOS 공정에서 제작되었다. Nyquist sampling rate인 800 MHz의 아날로그 입력신호에 대해 측정된 SNDR은 32.8 dB이며, DNL과 INL은 각각 +0.38/-0.37 LSB, +0.64/-0.64 LSB이다. 구현된 flash ADC의 면적과 전력소모는 각각 $800{\times}500{\mu}m2$와 193.02 mW 이다.

• 전력전자학회논문지
• /
• 제17권6호
• /
• pp.486-494
• /
• 2012

In this paper, we proposes the three-phase embedded Z-source inverter consisting of the three embedded Z-source converters and it's the output voltage control method. Each embedded Z-source converter can produce the bipolar output capacitor voltages according to duty ratio D such as single-phase PWM inverter. The output AC voltage of the proposed system is obtained as the difference in the output capacitor voltages of each converter, and the L-C output filter is not required. Because the output AC voltage can be stepped up and down, the boost DC converter in the conventional two-stage inverter is unnecessary. To confirm the validity of the proposed system, PSIM simulation and a DSP based experiment were performed under the condition of the input DC voltage 38V, load $100{\Omega}$, and switching frequency 30kHz. Each converter is connected by Y-connection for three-phase loads. In case that the output phase voltage is the same $38V_{peak}$ as the input DC voltage and is the 1.5 times($57V_{peak}$), the simulation and experimental results ; capacitor voltages, output phase voltages, output line voltages, inductor currents, and switch voltages were verified and discussed.

• KIEE International Transaction on Electrical Machinery and Energy Conversion Systems
• /
• 제3B권3호
• /
• pp.147-154
• /
• 2003

This paper presents a high-frequency boost type ZVS-PWM chopper-fed DC-DC power converter with a single active auxiliary edge-resonant snubber at the load stage which can be designed for power conditioners such as solar photovoltaic generation, fuel cell generation, battery and super capacitor energy storages. Its principle operation in steady-state is described in addition to a prototype setup. The experimental results of boost type ZVS-PWM chopper proposed here, are evaluated and verified with a practical design model in terms of its switching voltage and current waveforms, the switching v-i trajectory and the temperature performance of IGBT module, the actual power conversion efficiency, and the EMI of radiated and conducted emissions, and then discussed and compared with the hard switching scheme from an experimental point of view. Finally, this paper proposes a practical method to suppress parasitic oscillation due to the active auxiliary resonant switch at ZCS turn-off mode transition with the aid of an additional lossless clamping diode loop, and can be reduced the EMI conducted emission.