• Journal of Advanced Navigation Technology
• /
• v.7 no.2
• /
• pp.211-216
• /
• 2003

In this paper, characteristics of Ta-Ti alloy was studied as a gate electrode for NMOS devices to replace the widely used polysilicon. Ta-Ti alloy was deposited directly on $SiO_2$ by a co-sputtering method using two of Ta and Ti targets. The sputtering power of each metal target was 100W. To compare with Ta-Ti, Ta deposited with a 100W sputtering power was fabricated as well. In order to investigate the thermal/chemical stability of the Ta-Ti alloy gate, the alloy was annealed at $600^{\circ}C$ with rapid thermal annealer. No appreciable degradation of the device was observed. Also the results of electrical analysis showed that the work function of Ta-Ti metal alloy was about 4.1eV which was suitable for NMOS devices and sheet resistance of alloy was lower than that of polysilicon.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.07a
• /
• pp.832-835
• /
• 2001

We report the structural and electrical properties of hafnium oxide (HfO$_2$) films with tungsten silicide (WSi$_2$) metal gate. In this study, HfO$_2$thin films were fabricated by oxidation of sputtered Hf metal films on Si, and WSi$_2$was deposited directly on HfO$_2$by LPCVD. The hysteresis windows in C-V curves of the WSi$_2$HfO$_2$/Si MOS capacitors were negligible (<20 mV), and had no dependence on frequency from 10 kHz to 1 MHz and bias ramp rate from 10 mV to 1 V. In addition, leakage current was very low in the range of 10$^{-9}$ ~10$^{-10}$ A to ~ 1 V, which was due to the formation of interfacial hafnium silicate layer between HfO$_2$and Si. After PMA (post metallization annealing) of the WSi$_2$/HfO$_2$/Si MOS capacitors at 500 $^{\circ}C$ EOT (equivalent oxide thickness) was reduced from 26 to 22 $\AA$ and the leakage current was reduced by approximately one order as compared to that measured before annealing. These results indicate that the effect of fluorine diffusion is negligible and annealing minimizes the etching damage.

• Proceedings of the KIEE Conference
• /
• 1996.07c
• /
• pp.1450-1452
• /
• 1996

In order to optimize the characteristics of gate insulator for FED(field emission device), we investigated the effect of wet-etching process on the gate insulator for fabrication of FED. We used the general three types of etchants for fabrication of the metal tip FEA(field emitter array), they are MO and oxide etchants to form the gate hole, and Al etchant to remove the release layer. In the result of the breakdown field of the insulator by the measure of the current-voltage characteristics, the breakdown field of insulator for immersing in oxide etchant was rapidly lowering with increasing etching time, but that for immersing in Al etchant was slow lowering. Also, in comparing cleaning with non-cleaning samples, the breakdown field of the cleaning samples was higher than that of non-cleaning samples.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2005.05a
• /
• pp.60-60
• /
• 2005

• Journal of the Microelectronics and Packaging Society
• /
• v.27 no.1
• /
• pp.31-35
• /
• 2020

This study demonstrates metal-oxide based memtransistor device and the gate tunable memristive characteristic using atomic layer deposition (ALD) and ZnO n-type oxide semiconductor. We fabricated a memtransistor device having channel width 70 ㎛, channel length 5 ㎛, back gate, using 40 nm thick ZnO thin film, and measured gate-tunable memristive characteristics at each gate voltage (50V, 30V, 10V, 0V, -10V, -30V, -50V) under humidity of 40%, 50%, 60%, and 70% respectively, in order to investigate the relation between a memristive characteristic and hydrogen doping effect on the ZnO memtransistor device. The electron mobility and gate controllability of memtransistor device decreased with an increase of humidity due to increased electron carrier concentration by hydrogen doping effect. The gate-tunable memristive characteristic was observed under humidity of 60% 70%. Resistive switching ratio increased with an increase of humidity while it loses gate controllability. Consequently, we could obtain both gate controllability and the large resistive switching ratio under humidity of 60%.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2004.02a
• /
• pp.173-173
• /
• 2004

• Journal of Sensor Science and Technology
• /
• v.23 no.4
• /
• pp.284-289
• /
• 2014

In this paper, modeling of a gate/body-tied (GBT) PMOSFET photodetector with built-in transfer gate is performed. It can control the photocurrent with a high-sensitivity. The GBT photodetector is a hybrid device consisted of a MOSFET, a lateral BJT, and a vertical BJT. This device allows for amplifying the photocurrent gain by $10^3$ due to the GBT structure. However, the operating parameters of this photodetector, including its photocurrent and transfer characteristics, were not known because modeling has not yet been performed. The sophisticated model of GBT photodetector using a process simulator is not compatible with circuit simulator. For this reason, we have performed SPICE modeling of the photodetector with reduced complexity using Cadence's Spectre program. The proposed modeling has been demonstrated by measuring fabricated chip by using 0.35 im 2-poly 4-metal standard CMOS technology.

• Transactions on Electrical and Electronic Materials
• /
• v.17 no.5
• /
• pp.302-305
• /
• 2016

In this paper, a low on-resistance and high current driving capability trench gate power metal-oxide-semiconductor field-effect transistor (MOSFET) incorporating a current sensing feature is proposed and evaluated. In order to realize higher cell density, higher current driving capability, cost-effective production, and higher reliability, self-aligned trench etching and hydrogen annealing techniques are developed. While maintaining low threshold voltage and simultaneously improving gate oxide integrity, the double-layer gate oxide technology was adapted. The trench gate power MOSFET was designed with a 0.6 μm trench width and 3.0 μm cell pitch. The evaluated on-resistance and breakdown voltage of the device were less than 24 mΩ and 105 V, respectively. The measured sensing ratio was approximately 70:1. Sensing ratio variations depending on the gate applied voltage of 4 V ~ 10 V were less than 5.6%.

• Transactions on Electrical and Electronic Materials
• /
• v.16 no.5
• /
• pp.254-259
• /
• 2015

This paper reports the optimized mixed-signal performance of a high-voltage (HV) laterally double-diffused metaloxide-semiconductor (LDMOS) field-effect transistor (FET) with a dual gate oxide (DGOX). The fabricated device is based on the split-gate FET concept. In addition, the gate oxide on the source-side channel is thicker than that on the drain-side channel. The experiment results showed that the electrical characteristics are strongly dependent on the source-side channel length with a thick gate oxide. The digital and analog performances according to the source-side channel length of the DGOX LDMOS device were examined for circuit applications. The HV DGOX device with various source-side channel lengths showed reduced by maximum 37% on-resistance (R_ON) and 50% drain conductance (g_ds). Therefore, the optimized mixed-signal performance of the HV DGOX device can be obtained when the source-side channel length with a thick gate oxide is shorter than half of the channel length.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.27 no.2
• /
• pp.76-80
• /
• 2014

Dual-gate PCRAM which unify capacitor-less DRAM and NVM using a PCM instead of a typical SONOS flash memory is proposed as 1 transistor. $VO_2$ changes its phase between insulator and metal states by temperature and field. The front-gate and back-gate control NVM and DRAM, respectively. The feasibility of URAM is investigated through simulation using c-interpreter and finite element analysis. Threshold voltage of NVM is 0.5 V that is based on measured results from previous fabricated 1TPCM with $VO_2$. Current sensing margin of DRAM is 3 ${\mu}A$. PCM does not interfere with DRAM in the memory characteristics unlike SONOS NVM. This novel unified dual-gate PCRAM reported in this work has 1 transistor, a low RESET/SET voltage, a fast write/erase time and a small cell so that it could be suitable for future production of URAM.