• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.7 no.1
• /
• pp.143-150
• /
• 1997

The electrical properties of polysilicon thin films implanted with $B_2H_6$ diluted in $H_2$ as dopant source using ion mass doping technique and the effect of radiation damage on the dopant activation behavior were investigated. Comparing the SIMS profiles of boron in polysilicon films with that obtained from computer simulation using TRIM92 the most probable ion species were $B_2H_x\;^+$(x＝1, 2, 3‥‥) type molecular ions. As a result of the Implantation of energetic massive ions, a continuous amorphized layer was created in polysilicon films where the fraction of amorphized layer varied with doping time. This amorphization comes from the fact that mass separation of implanting species is not employed in this ion mass doping technique. In the dopant activation behavior, reverse annealing phenomenon appeared in the intermediate annealing temperature range for a severely damaged specimen. The experimental result showed that the off-state current of the p-channel polysilicon thin film transistor is dependent on the degree of radiation damage.

• Journal of Semiconductor Engineering
• /
• v.3 no.2
• /
• pp.161-167
• /
• 2022

Electrical characteristics of LDMOS power device with LDD(Lightly Doped Drain) structure is studied with variation of the region of channel and LDD. The channel in LDMOSFET encloses a junction-type source and is believed to be an important parameter for determining the circuit operation of CMOS inverter. Two-dimensional TCAD MEDICI simulation is used to study hot-carrier effect, on-resistance Ron, breakdown voltage, and transient switching characteristic. The voltage-transfer characteristics and on-off switching properties are studied as a function of the channel length and doping levels. The digital logic levels of the output and input voltages are analyzed from the transfer curves and circuit operation. Study indicates that drain current significantly depends on the channel length rather than the LDD region, while the switching transient time is almost independent of the channel length. The high and low logic levels of the input voltage showed a strong dependency on the channel length, while the lateral substrate resistance from a latch-up path in the CMOS inverter was comparable to that of a typical CMOS inverter with a guard ring.

• Journal of the Korean Institute of Telematics and Electronics T
• /
• v.36T no.2
• /
• pp.8-13
• /
• 1999

In this paper, an analytical threshold voltage model is proposed by replacing the conventional GCA(Gradual Channel Approximation) with the assumption that a normal depletion layer width in the intrinsic region will vary quasi-linearly according to the channel direction. Derived threshold voltage expression is written as a function of the effective channel length, drain voltage, substrate bias voltage, substrate doping concentration, and the oxide thickness. Calculated results show almost similar trends with BSIM3v3's results in a satisfactory accuracy.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.382.1-382.1
• /
• 2014

Graphene field-effect transistors (GFET) is one of candidates for future high speed electronic devices since graphene has unique electronic properties such as high Fermi velocity (vf=10^6 m/s) and carrier mobility ($15,000cm^2/V{\cdot}s$) [1]. Although the contact property between graphene and metals is a crucial element to design high performance electronic devices, it has not been clearly identified. Therefore, we need to understand characteristics of graphene/metal contact in the GFET. Recently, it is theoretically known that graphene on metal can be doped by presence of interface dipole layer induced by charge transfer [2]. It notes that doping type of graphene under metal is determined by difference of work function between graphene and metal. In this study, we present the GFET fabricated by contact metals having high work function (Pt, Ni) for p-doping and low work function (Ta, Cr) for n-doping. The results show that asymmetric conductance depends on work function of metal because the interfacial dipole is locally formed between metal electrodes and graphene. It induces p-n-p or n-p-n junction in the channel of the GFET when gate bias is applied. In addition, we confirm that charge transfer regions are differently affected by gate electric field along gate length.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.17 no.1
• /
• pp.156-161
• /
• 2017

This work presents a novel structure for junction-less tunneling field effect transistor (JL-TFET) with a floating gate over the source region. Introduction of floating gate instead of fixed metal gate removes the limitation of fabrication process suitability. The proposed device is based on a heavily n-type-doped Si-channel junction-less field effect transistor (JLFET). A floating gate over source region and a control-gate with optimized metal work-function over channel region is used to make device work like a tunnel field effect transistor (TFET). The proposed device has exhibited excellent ID-VGS characteristics, ION/IOFF ratio, a point subthreshold slope (SS), and average SS for optimized device parameters. Electron charge stored in floating gate, isolation oxide layer and body doping concentration are optimized. The proposed JL-TFET can be a promising candidate for switching performances.

• Transactions on Electrical and Electronic Materials
• /
• v.15 no.2
• /
• pp.87-90
• /
• 2014

The effects of electric field frequency on the ac electrical treeing phenomena in an epoxy/reactive diluent/layered silicate (1.5 wt%) were carried out, in needle-plate electrode arrangement. A layered silicate was exfoliated in an epoxy base resin, by using our ac electric field apparatus. To measure the treeing propagation rate, constant alternating current (AC) of 10 kV with three different electric field frequencies (60, 500 and 1,000 Hz) was applied to the specimen, in needle-plate electrode arrangement, at $30^{\circ}C$ of insulating oil bath. As the electric field frequency increased, the treeing propagation rate increased. At 500 Hz, the treeing propagation rate of the epoxy/PG/nanosilicate system was $0.41{\times}10^{-3}$ mm/min, which was 3.4 times slower than that of the epoxy/PG system. The electrical treeing morphology was dense bush type at 60 Hz; however, as the frequency increased, the bush type was changed to branch type, having few branches, with very slow propagation rate.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.5 no.2
• /
• pp.136-147
• /
• 2005

A theoretical design evaluation based on a hydrodynamic transport simulation of strained Si-SiGe on insulator (SSOI) type nMOSFETs is reported. Although, the net performance improvement is quite limited by the short channel effects, simulation results clearly show that the strained Si-SiGe type nMOSFETs are well-suited for gate lengths down to 20 nm. Simulation results show that the improvement in the transconductance with decreasing gate length is limited by the long-range Coulomb scattering. An influence of lateral and vertical diffusion of shallow dopants in the source/drain extension regions on the device performance (i.e., threshold voltage shift, subthreshold slope, current drivability and transconductance) is quantitatively assessed. An optimum layer thickness ($t_{si}$ of 5 and $t_{sg}$ of 10 nm) with shallow Junction depth (5-10 nm) and controlled lateral diffusion with steep doping gradient is needed to realize the sub-50 nm gate strained Si-SiGe type nMOSFETs.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.16 no.6
• /
• pp.847-853
• /
• 2016

Applications of Si have been increasingly exploited and extended to More-Moore, More-than-Moore, and beyond-CMOS approaches. Ge is regarded as one of the supplements for Si owing to its higher carrier mobilities and peculiar band structure, facilitating both advanced and optical applications. As an emerging metal-oxide device, the junctionless field-effect transistor (JLFET) has drawn considerable attention because of its simple process, less performance fluctuation, and stronger immunity against short-channel effects due to the absence of anisotype junctions. In this study, we investigated lateral field scalability, which is equivalent to channel-length scaling, in Si and Ge JLFETs. Through this, we can determine the usability of Si CMOS and hypothesize its replacement by Ge. For simulations with high accuracy, we performed rigorous modeling for ${\mu}_n$ and ${\mu}_p$ of Ge, which has seldom been reported. Although Ge has much higher ${\mu}_n$ and ${\mu}_p$ than Si, its saturation velocity ($v_{sat}$) is a more determining factor for maximum $I_{on}$. Thus, there is still room for pushing More-Moore technology because Si and Ge have a slight difference in $v_{sat}$. We compared both p- and n-type JLFETs in terms of $I_{on}$, $I_{off}$, $I_{on}/I_{off}$, and swing with the same channel doping and channel length/thickness. $I_{on}/I_{off}$ is inherently low for Ge but is invariant with $V_{DS}$. It is estimated that More-Moore approach can be further driven if Si is mounted on a JLFET until Ge has a strong possibility to replace Si for both p- and n-type devices for ultra-low-power applications.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.47 no.10
• /
• pp.14-22
• /
• 2010

The source/channel/drain regions are formed by ion implantation with different dopant types of $n^+/p^{(+)}/n^+$ in the fabrication of the conventional n-type metal-oxide-semiconductor field effect transistor(NMOSFET). In implementing the ultra-small devices with channel length of sub-30 nm, in order to achieve the designed effective channel length accurately, low thermal budget should be considered in the fabrication processes for minimizing the lateral diffusion of dopants although the implanted ions should be activated as completely as possible for higher on-current level. Junctionless (JL) MOSFETs fully capable of the the conventional NMOSFET operations without p-type channel for enlarging the process margin are under researches. In this paper, the optimum design of the JL MOSFET based on silicon nanowire (SNW) structure is carried out by 3-D device simulation and the basic radio frequency (RF) characteristics such as conductance, maximum oscillation frequency($f_{max}$), current gain cut-off frequency($f_T$) for the optimized device. The channel length was 30 run and the design variables were the channel doping concentration and SNW radius. For the optimally designed JL SNW NMOSFET, $f_T$ and $f_{max}$ high as 367.5 GHz and 602.5 GHz could be obtained, respectively, at the operating bias condition $V_{GS}$ = $V_{DS}$ = 1.0 V).

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.29 no.12
• /
• pp.759-763
• /
• 2016

We demonstrate the utilization of ion gel gate dielectrics for operating non-volatile transistor memory devices based on polymer semiconductor thin films. The gating process in typical electrolyte-gated polymer transistors occurs upon the penetration and escape of ionic components into the active channel layer, which dopes and dedopes the polymer film, respectively. Therefore, by controlling doping and dedoping processes, electrical current signals through the polymer film can be memorized and erased over a period of time, which constitutes the transistor-type memory devices. It was found that increasing the thickness of polymer films can enhance the memory performance of device including (i) the current signal ratio between its memorized state and erased state and (ii) the retention time of the signal.