• Journal of the Korean Institute of Telematics and Electronics T
• /
• v.35T no.1
• /
• pp.48-58
• /
• 1998

For the purpose of designing novel capacitance pressure sensor, several effects on sensitivity such as parasitic capacitance effects, temperature/thermal drift and leakage current have to be eleiminated. This paper proposed the experimental studies on frequency compensation method by electronic circuit technique, C-V converting method with switched capacitor and C-F converting method with schmitt trigger circuit. The third interface circuit by frequency compensation method is composed to eliminate the drift and leakage component by comparision sensing frequency with reference frequency. The signal transmission is realized by digital signal to minimize the influence of noise and high resolution is obtained by means of increasing the number of digital bits. In the fabricated high performance C-V interface, the offset voltage was not appeared, and in case of voltage source, 4.0V, feed back capacitance, 10㎊, the pressure, 0~10 ㎪, the sensitivity of C-V converter is 28 ㎷/㎪.V, the temperature drift characteristic, 0.051 %F.S./$^{\circ}C$ and C-F converter shows -6.6 Hz/pa, 0.078 %F.S./$^{\circ}C$ respectively, relatively good ones.

• Applied Science and Convergence Technology
• /
• v.24 no.2
• /
• pp.33-40
• /
• 2015

$ZrO_2$ and Al-Zr composite oxide film was prepared by vacuum assisted sol-gel dip coating method and anodizing. $ZrO_2$ films annealed above $400^{\circ}C$ have tetragonal structure. $ZrO_2$ layers inside etch pits were successfully coated from the $ZrO_2$ sol. The double layer structures of samples were obtained after being anodized at 100 V to 600 V. From the TEM images, it was found that the outer layer was $Al_2O_3$, the inner layer was multi-layer of $ZrO_2$, Al-Zr composite oxide and Al hydrate. The capacitance of $ZrO_2$ coated foil exhibited about 28.3% higher than that of non-coating foil after being anodized at 100 V. The high capacitance of $ZrO_2$ coated foils anodized at 100 V can be attributed to the relatively high percentage of inner layer in total thickness. The electrical properties, such as withstanding voltage and leakage current of coated and non-coated Al foils showed similar values. From the results, $ZrO_2$ and Al-Zr composite oxide is promising to be used as the partial dielectric of high voltage capacitor to increase the capacitance.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.07a
• /
• pp.58-61
• /
• 2001

Metal-insulator-semiconductor (MIS) C-V properties with high dielectric AIN thin films showed no hysteresis and good interface properties. The dielectric constant of the AIN film calculated from the capacitance at the accumulation region in the capacitance-voltage(C-V) characteristics was about 8. The C-V characteristics of MFIS capacitor showed a hysteresis loop due to the ferroelectric nature of the LiNbO$_3$ thin films. Typical dielectric constant value of LiNbO$_3$ film of MFIS device was about 23. The memory window width was about 1.2V at the gate voltage of $\pm$5 V ranges. Typical gate leakage current density of the MFIS structure was the order of 10$^{-9}$ A/cm$^2$ at the range of within $\pm$500 kV/cm. The ferroelectric capacitors showed no polarization degradation up to about 10$^{11}$ switching cycles when subjected to symmetric bipolar voltage pulse(peak-to-peak 8V, 50% duty cycle) in the 500kHz.

• Proceedings of the IEEK Conference
• /
• 2003.07b
• /
• pp.679-682
• /
• 2003

Improvement in MOS fabrication technology have led to high-density high-performance integrated circuits with MOSFET channel lengths in the sub-micron range. For devices of the size, transistor characteristics become highly sensitive to effective channel length. We propose a new approach to extract the effective channel length of MOSFET by Capacitance-Voltage (C-V) method. Gate-to-Source, Drain capacitance ( $C_{gsd}$) are measured and the effective channel length can be extracted. In addition, compared to l/$\beta$ method and Terada method, which has been point out that it fails to extract the accurate effective channel length of the devices, we prove that our approach still works well for the devices with down to sub-micron regime.e.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.54 no.2
• /
• pp.63-68
• /
• 2005

Total 12 units of high power klystron-modulator systems as microwave source are under operation for 2.5 GeV electron linear accelerator in Pohang Light Source (PLS) linac. The klystron-modulator system has an important role for the stable operation to improve an availability statistics of overall system performance of klystron-modulator system. RF power and beam power of klystron are precisely measured for the effective control of electron beam. A precise measurement and measurement equipment with good response characteristics are demanded for this. Input power of klystron is calculated from the applied voltage and the current on its cathode. Tiny measurement error severely effects RF output power value of klystron. Therefore, special care is needed to measure precise beam voltage. Capacitive voltage divider (CVD), which divides input voltage as capacitance ratio, is intended for the measurement of a beam voltage of 400 kV generated from the klystron-modulator system. Main parameter to determine standard capacitance in the high arm of CVD is dielectric constant of insulation oil. Therefore CVD should be designed to have a minimum capacitance variation due to voltage, frequency and temperature in the measurement range. This paper will be present and discuss the design concept and analysis of capacitive voltage divider for a pulsed high-voltage measurement, and the empirical relations between capacitance effects and oil temperature variation.

• Proceedings of the IEEK Conference
• /
• 2000.11b
• /
• pp.29-32
• /
• 2000

Meta1-ferroelectric-insulator-semiconductor(MFIS) devices using Pt/LiNbO$_{3}$/AIN/Si structure were successfully fabricated. AIN thin films were made into metal-insulator-semiconductor(MIS) devices by evaporating aluminum in a dot array on the film surface. The dielectric constant of the AIN film calculated from the capacitance in the accumulation region in the capacitance-voltage(C-V ) characteristic is 8. The gate leakage current density of MIS devices using a aluminum electrode showed the least value of 1$\times$10$^{-8A}$ $\textrm{cm}^2$ order at the electric field of 500㎸/cm. A typica] value of the dielectric constant of MFIS device was about 23 derived from 1MHz capacitance-voltage (C-V) measurement and the resistivity of the film at the field of 500㎸/cm was about 5.6$\times$ 10$^{13}$ $\Omega$.cmcm

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.52 no.10
• /
• pp.464-468
• /
• 2003

The double layers of $SiO_2$/$Si_3$$N_4$ have superior charge storage stability than a single layer of $SiO_2$. Many researchers are very interested in the charge storage mechanism of $SiO_2$/$Si_3$$N_4$ [1,2]. In this paper, the electrical characteristics of thermal oxide and atmospheric pressure chemical vapor deposition (APCVD) of $Si_4$$N_4$ have been investigated and explained using high frequency capacitance-voltage measurements. Additionally, this paper will describe capacitance-voltage characteristics for double layers of $SiO_2$/$Si_4$$N_4$ by "Athena", a semiconductor device simulation tool created by Silvaco, Inc.vaco, Inc.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.27 no.2
• /
• pp.132-135
• /
• 2014

The Sr based ceramic thin films were deposited on Si substrate by RF magnetron sputtering method. And Sr based thin films were annealed at $500{\sim}700^{\circ}C$ using RTA. The surface roughness showed about 2.4 nm in annealed thin film at $600^{\circ}C$. The capacitance density of Sr based thin films were increased with the increase of annealing temperature. The maximum capacitance density of $0.6{\mu}F/cm^2$ was obtained by annealing temperature at $700^{\circ}C$. The voltage dependence of dielectric loss showed about 0.02 in voltage ranges of -10~+10 V. The leakage current density of annealing temperature of $600^{\circ}C$ was the $4.0{\times}10^{-6}\;A/cm^2$ at applied voltage of -5~+5 V.

• Transactions on Electrical and Electronic Materials
• /
• v.14 no.4
• /
• pp.177-181
• /
• 2013

In this paper, silicon solar cells are analyzed regarding power conversion efficiency by changed capacitance in the depletion region. For the capacitance control in the depletion region of silicon solar cell was applied for 10, 20, 40, 80, 160 and 320 Hz frequency band character and alternating current(AC) voltage with square wave of 0.2~1.4 V. Academically, symmetry formation of positive and negative change of the p-n junction is similar to the physical effect of capacitance. According to the experiment result, because input of square wave with alternating current(AC) voltage could be observed to changed capacitance effect by indirectly method through non-linear power conversion (Voltage-Current) output. In addition, when input alternating current(AC) voltage in the silicon solar cell, changed capacitance of depletion region with the forward bias condition and reverse bias condition gave a direct effect to the charge mobility.

• KIEE International Transactions on Electrophysics and Applications
• /
• v.3C no.2
• /
• pp.55-58
• /
• 2003

This paper examines the electrical characteristic of single oxide layer due to various diffusion conditions, substrate orientations, substrate resistivity and gas atmosphere in a diffusion furnace. The oxide quality was examined through the capacitance-voltage characteristic due to the annealing time after oxidation process, and the capacitance-voltage characteristics of the single oxide layer by will be described via semiconductor device simulation.