• Journal of Sensor Science and Technology
• /
• v.23 no.2
• /
• pp.114-121
• /
• 2014

We report a polysilicon active area membrane field effect transistor (PSAFET) pressure sensor for low stress deflection of membrane. The PSAFET was produced in conventional FET semiconductor fabrication and backside wet etching. The PSAFET located at the front side measured pressure change using 300 nm thin-nitride membrane when a membrane was slightly strained by the small deflection of membrane shape from backside with any physical force. The PSAFET showed high sensitivity around threshold voltage, because threshold voltage variation was composed of fractional function form in sensitivity equation of current variation. When gate voltage was biased close to threshold voltage, a fractional function form had infinite value at $V_{tn}$, which increased the current variation of sensitivity. Threshold voltage effect was dominant right after the PSAFET was turned on. Narrow transistor channel established by small current flow was choked because electron could barely cross drain-source electrodes. When gate voltage was far from threshold voltage, threshold voltage effect converged to zero in fractional form of threshold voltage variations and drain current change was mostly determined by mobility changes. As the PSAFET fabrication was compatible with a polysilicon FET in CMOS fabrication, it could be adapted in low pressure sensor and bio molecular sensor.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.15 no.3
• /
• pp.639-644
• /
• 2011

By the development of the information superhighway, the current data communication system can be exchanged data quickly and precisely between subscribers. In this paper, LVTTL(Low Voltage Transistor Transistor Logic), Using the fundamental one logic at several kinds of used in communication systems, the LVTTL transmission characteristics were measured by according to the change data transfer rate and the transmission line length. Because the transmission line length required on the current system is 30cm, We analysed LVTTL data transfer characteristics according to the transmission line length required on the current system. The amplitude level of LVTTL at 10Mbps is 3V and 50Mbps is 2.2V and 100Mbps is 2V and 125Mbps is 1.5V and 150Mbps is 1.4V. The length of transmission line 30cm was stable state up to 100Mbps data transfer rate.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.9
• /
• pp.1627-1634
• /
• 2017

In this work, a junctionless transistor with different film thickness of amorphous InGaZnO has been fabricated and it's instability has been analyzed with different film thickness under positive and negative gate stress as well as light illumination. It was found that the threshold voltage shift and the variation of drain current have been increased with decrease of film thickness under the condition of gate stress and light illumination. The reasons for the observed results have been explained by stretched-exponential model and device simulation. Due to the reduced carrier trapping time with decrease of film thickness, electrons and holes can be activated easily. Due to the increase of vertical channel electric field reaching the back interface with decrease of film thickness, more electrons and holes can be accumulated in back interface. When one decides the film thickness for the fabrication of junctionless transistor, the more significant device instability with decrease of film thickness should be consdered.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.16 no.4
• /
• pp.292-297
• /
• 2003

We fabricated a single crystal silicon thin film transistor for active matrix organic light emitting displays(AMOLEDs) using silicon on insulator wafer (SOI wafer). Poly crystal silicon thin film transistor(poly-Si TFT) Is actively researched and developed nowsdays for a pixel switching devices of AMOLEDs. However, poly-Si TFT has some disadvantages such as high off-state leakage currents and low field-effect mobility due to a trap of grain boundary in active channel. While single crystal silicon TFT has many advantages such as high field effect mobility, low off-state leakage currents, low power consumption because of the low threshold voltage and simultaneous integration of driving ICs on a substrate. In our experiment, we compared the property of poly-Si TFT with that of SOI TFT. Poly-Si TFT exhibited a field effect mobility of 34 $\textrm{cm}^2$/Vs, an off-state leakage current of about l${\times}$10$\^$-9/ A at the gate voltage of 10 V, a subthreshold slope of 0.5 V/dec and on/off ratio of 10$\^$-4/, a threshold voltage of 7.8 V. Otherwise, single crystal silicon TFT on SOI wafer exhibited a field effect mobility of 750 $\textrm{cm}^2$/Vs, an off-state leakage current of about 1${\times}$10$\^$-10/ A at the gate voltage of 10 V, a subthreshold slope of 0.59 V/dec and on/off ratio of 10$\^$7/, a threshold voltage of 6.75 V. So, we observed that the properties of single crystal silicon TFT using SOI wafer are better than those of Poly Si TFT. For the pixel driver in AMOLEDs, the best suitable pixel driver is single crystal silicon TFT using SOI wafer.

• Bulletin of the Korean Chemical Society
• /
• v.33 no.5
• /
• pp.1659-1663
• /
• 2012

New semiconducting polymer, poly[1,4-bis(($E$)-2-(5-bromo-3-dodecylthiophen-2-yl)vinyl)benzene], was designed, synthesized and characterized. The structure of polymer was confirmed by $^1H$-NMR, IR and elemental analysis. The polymer was soluble in specific organic solvent. The weight-average molecular weights (MW) of polymer was found to be 11,000 with polydispersity of 1.82. UV-Visible absorption spectrum showed the maximum absorption at 428 nm (in solution) and 438 nm (in film). The highest occupied molecular orbital (HOMO) energy of the polymer is -5.36 eV by measuring cyclic voltammetry (CV). A solutionprocessed polymer thin film transistor device shows a mobility of $8.59{\pm}10^{-4}\;cm^2\;V^{-1}\;s^{-1}$, an on/off current ratio of $2.0{\times}10^4$.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.08a
• /
• pp.256-256
• /
• 2012

Oxide semiconductors such as zinc tin oxide (ZTO) or indium gallium zinc oxide (IGZO) have attracted a lot of research interest owing to their high potential for application as thin film transistors (TFTs) [1,2]. However, the instability of oxide TFTs remains as an obstacle to overcome for practical applications to electronic devices. Several studies have reported that the electrical characteristics of ZnO-based transistors are very sensitive to oxygen, hydrogen, and water [3,4,5]. To improve the reliability issue for the amorphous InGaZnO (a-IGZO) thin-film transistor, back channel passivation layer is essential for the long term bias stability. In this study, we investigated the instability of amorphous indium-gallium-zinc-oxide (IGZO) thin film transistors (TFTs) by the back channel contaminations. The effect of back channel contaminations (humidity or oxygen) on oxide transistor is of importance because it might affect the transistor performance. To remove this environmental condition, we performed vacuum seasoning before the deposition of hybrid passivation layer and acquired improved stability. It was found that vacuum seasoning can remove the back channel contamination if a-IGZO film. Therefore, to achieve highly stable oxide TFTs we suggest that adsorbed chemical gas molecules have to be eliminated from the back-channel prior to forming the passivation layers.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.16 no.2
• /
• pp.185-190
• /
• 2016

A 70-${\AA}$ nanowire field-effect transistor (FET) for sub-10-nm CMOS technology is designed and simulated in order to investigate the impact of an oxide trap on random telegraph noise (RTN) in the device. It is observed that the drain current fluctuation (${\Delta}I_D/I_D$) increases up to a maximum of 78 % due to the single electron trapping. In addition, the effect of various trap positions on the RTN in the nanowire FET is thoroughly analyzed at various drain and gate voltages. As the drain voltage increases, the peak point for the ${\Delta}I_D/I_D$ shifts toward the source side. The distortion in the electron carrier density and the conduction band energy when the trap is filled with an electron at various positions in the device supports these results.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.16 no.2
• /
• pp.159-165
• /
• 2016

Recently, active efforts are being made for future Si CMOS technology by various researches on emerging devices and materials. Capability of low power consumption becomes increasingly important criterion for advanced logic devices in extending the Si CMOS. In this work, a junctionless field-effect transistor (JLFET) with ultra-thin poly-Si (UTP) channel is designed aiming the sub-10-nm technology for low-power (LP) applications. A comparative study by device simulations has been performed for the devices with crystalline and polycrystalline Si channels, respectively, in order to demonstrate that the difference in their performances becomes smaller and eventually disappears as the 10-nm regime is reached. The UTP JLFET would be one of the strongest candidates for advanced logic technology, with various virtues of high-speed operation, low power consumption, and low-thermal-budget process integration.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.17 no.2
• /
• pp.192-198
• /
• 2017

In this paper, we propose a novel double gate vertical channel tunneling field effect transistor (DVTFET) with a dielectric sidewall and optimization characteristics. The dielectric sidewall is applied to the gate region to reduced ambipolar voltage ($V_{amb}$) and double gate structure is applied to improve on-current ($I_{ON}$) and subthreshold swing (SS). We discussed the fin width ($W_S$), body doping concentration, sidewall width ($W_{side}$), drain and gate underlap distance ($X_d$), source doping distance ($X_S$) and pocket doping length ($X_P$) of DVTFET. Each of device performance is investigated with various device parameter variations. To maximize device performance, we apply the optimum values obtained in the above discussion of a optimization simulation. The optimum results are steep SS of 32.6 mV/dec, high $I_{ON}$ of $1.2{\times}10^{-3}A/{\mu}m$ and low $V_{amb}$ of -2.0 V.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.17 no.2
• /
• pp.216-222
• /
• 2017

The most prominent challenge for MOSFET scaling is to reduce power consumption; however, the supply voltage ($V_{DD}$) cannot be scaled down because of the carrier injection mechanism. To overcome this limit, a new type of field-effect transistor using positive feedback as a carrier injection mechanism (FBFET) has been proposed. In this study we have investigated the electrical characteristics of a $Si_{1-x}Ge_x$ FBFET with one gate and one-sided $Si_3N_4$ spacer using TCAD simulations. To reduce the drain bias dependency, $Si_{1-x}Ge_x$ was introduced as a low-bandgap material, and the minimum subthreshold swing was obtained as 2.87 mV/dec. This result suggests that a $Si_{1-x}Ge_x$ FBFET is a promising candidate for future low-power devices.