• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2002년도 하계학술대회 논문집 B
• /
• pp.1134-1136
• /
• 2002

This paper proposes a FSK(Frequency Shift Keying) transmitter which has a inverter for power amplification instead of linear amplifier. As it can generate large signal using resonant circuit under the low voltage source even if the impedance of antenna is large as like a loop antenna of TWC(Train to Way-side Communication) system. In this paper, the proposed fully digital controlled transmitter including FSK modulation is presented and its control schemes are discussed.

• 대한의용생체공학회:의공학회지
• /
• 제3권2호
• /
• pp.113-118
• /
• 1982

This paper presents a frequency modulated radio-telemetry, transmitter for monitoring and transmitting an exercise electrocardiogram (ECG) and respiration activity simultaneously on single carrier frequency in the standard FM broadcast band of 88-108 MHz. We have evaluated the performance of the FM telemetry transmitter which is proposed on the basis of an exercise ECG test in the treadmill.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 1999년도 추계종합학술대회 논문집
• /
• pp.909-912
• /
• 1999

This paper describes realized APC and pre-equalizer circuit, and their operation principle and test results. In analog optical transmitter, constant lasing power control, free of signal clipping and linearity are important considerations. We examined pre-equalizer and APC(Automatic Power Control) circuit to improve the analog optical transmitter performance.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2006년도 하계종합학술대회
• /
• pp.653-654
• /
• 2006

A Pre-emphasis transmitter for DRAM bus system has achieved 3.2Gbps/pin operation at 1.8V supply voltage with 0.18um CMOS process. The transmitter has 800MHz PLL to generate 4 phase clocks. The 4 phase clocks are used for input clock of PRBS and multiplexing. One tap pre-emphasis is used to reduce inter symbol interference (ISI) caused by channel low pass effects. The analog calibration makes the optimized driver impedance independent with the PVT variation.

• 한국군사과학기술학회지
• /
• 제5권2호
• /
• pp.159-168
• /
• 2002

In this paper, a study on the design of the transmitter-receiver of fuze sensor for discriminating target position is presented. We propose the algorithm for detecting target distance/direction through investigating the operational concept and principle of fuze sensor. Based on the algorithm, We design transmitter-receiver, calculate various design variables and estimate the performance of that one. The estimated result shows that the required performance of fuze sensor is satisfied. Further research on confirming the performance of proposed algorithm through encounter simulation test with real target and resolving problem will be continued.

• 한국광학회:학술대회논문집
• /
• 한국광학회 1997년도 Advance Program of 14th optics andquantum Electronics conference, 1997제14 회 광학 및 양자전자 학술 발표회 논문 요약집
• /
• pp.111-113
• /
• 1997

The purpose of this paper is to propose a production flow for 155Mbps transmitter/receiver optical modules. Compact optical module packages for use as 155Mbps optical interfaces are developed by implementing a self-alignment principle for the formation of V-grooves and solder bumps. on the bases of experimental results of two hundreds of receiver/transmitter optical modules, each steps and flows of our production are developed by production efficiencies.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제17권3호
• /
• pp.326-332
• /
• 2017

A switched VCO-based UWB transmitter for 3-5 GHz is implemented using $0.18{\mu}m$ CMOS technology. Using RF switch and timing control of DPGs, the uniform RF power and low power consumption are possible regardless of carrier frequency. And gate control of RF switch enables the undesired side lobe rejection sufficiently. The measured pulse width is tunable from 0.5 to 2 ns. The measured energy efficiency per pulse is 4.08% and the power consumption is 0.6 mW at 10 Mbps without the buffer amplifier.

• Journal of information and communication convergence engineering
• /
• 제6권4호
• /
• pp.359-363
• /
• 2008

In this paper, the capacity of MIMO fading channel in the OFDM-based spatial multiplexing systems is analyzed when there is scattering at both transmitter and receiver. The employed MIMO channel model is spanning from the correlated low-rank case to uncorrelated high-rank case at both transmitter and receiver. The effects of spatial fading correlation on the capacity of MIMO channel is examined when the channel is known and unknown at the transmitter. We also evaluate the impacts of a channel estimation error at the transmitter on the MIMO channel capacity.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2009년도 제40회 하계학술대회
• /
• pp.1939_1941
• /
• 2009

The modulation quality of the RF transmitter in a wireless communication system usually affects system performance and it mostly depends on both a nonlinearity and a distortion, from the intermodulation products and the I/Q mismatch such as I/Q amplitude error and a local phase error, respectively. This paper focused on how much the error vector magnitude(EVM) which describes the modulation accuracy changes according to the variation of the I/Q mismatch components at I/Q modulator. For this work, the equation for the EVM including the I/Q mismatch components can be induced and calculated in accordance with the variation of the I/Q mismatch components. Consequently, the effect of I/Q mismatch components on the EVM, which is required in the transmitter specification of Personal Area Network, can be clearly analyzed.

• 조명전기설비학회논문지
• /
• 제28권3호
• /
• pp.51-56
• /
• 2014

The flat power spectrum of the transmitter output signal for the desired frequency range is ideal to achieve the best performance of ultrashort pulse reflectometry. However, the power spectrum of a typical pulse generator decreases significantly as frequency increases. A configuration of three chirped waveforms was employed to improve the power spectrum of the transmitter signal at higher frequencies. To determine the amplification gain required for higher frequency components, three chirped waveforms were theoretically generated and their power spectra were measured using numerical band-pass filters. Based on the results of numerical computations, the three chirp configuration was successfully applied to the design of the transmitter for a broadband system.