• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2000년도 제1회 학술대회 논문집
• /
• pp.13-14
• /
• 2000

21.6" a-Si:H TFT array for direct conversion X-ray detector with 2480 by 3072 pixel is successfully developed. To obtain good X-ray image quality, novel structure, storage on BCB structure, is proposed. The structure reduces the parasitic capacitance of data line, one of the main sources of signal noise. Also, the structure shows higher failure resistance against defects than that of the old design.

• 전자공학회논문지D
• /
• 제36D2호
• /
• pp.55-61
• /
• 1999

DRAM에서 알파 입자의 입사에 의한 소프트 에러율을 예측하는 시뮬레이터를 개발하였다. 새로운 시뮬레이터는 수집 전하량에 대한 해석적 모델을 사용함으로서 소자 시뮬레이터나 몬테칼로 시뮬레이터를 사용하는 기존의 예측 시뮬레이터에 비하여 계산시간을 크게 감소하였다. DRAM에서 발생하는 소프트 웨어의 모드를 분석한 결과, bit-bar 모드에 의한 소프트 에러율이 가장 큰 것을 알 수 있었으며 256M DRAM의 셀 구조에 대한 소프트 에러율을 시뮬레이션하여 storage 캐패시턴스가 약 5fF의 margin을 갖고있음을 밝혔다.

• 한국진공학회지
• /
• 제4권S1호
• /
• pp.145-150
• /
• 1995

PZT thin films were fabricated on Pt/Ti/SiO2/Si substrates at $500^{\circ}C$ by ECR-PECVD for the application to the charge storage capacitor of ULSI DRAMs. Perovskite single phase PZT films were obtained by controling the film compositional ratio Pb/(Zr+Ti) close to 1. The anion concentrations in the PZT films were successfully controlled by adjusting the flow rates of each MO sources. Capacitance of a typical 94 nm thick PZT film prepared at $500^{\circ}C$ in this work was about 5.3 uF/$\textrm{cm}^2$, which corresponds to the equivalent SiO2 thickness of 0.65nm.

• 대한전자공학회논문지
• /
• 제26권6호
• /
• pp.124-130
• /
• 1989

ITIC를 중심으로 고밀도 DRAM을 위한 획기적인 밀도 향상을 기할 수 있는 공정과정과 회로디자인의 기술 혁신에 대하여 지다이너 입장에서 논의하였다. 여기서 개발한 TETC라 부르는 DRAM은 trench 기술과 SEG기술을 이용하였는데 $n^+-polysilycon$인 storage 전극과 $n^+-source$ 전극이 self-con-tact되고 soft error 를 극복할 만큼 충분히 큰 정전용량을 갖으므로 절연 영역을 따라서 만든 수직의 캐패시터를 이용함으로써 셀 크기를 기존의 BSE cell구조에 비하여 약 30% 감소되었다.

• 대한기계학회논문집B
• /
• 제32권4호
• /
• pp.275-282
• /
• 2008

In Korea, air source heat pump system is less efficient than conventional heat source facilities, because the air temperature in winter season is so low that COP of air source heat pump system drops below 3.0. Therefore, the study on the application of heat pump heating and cooling systems is crucial for the efficient popularization of heat pump. In this work, we present the dynamic analysis of energy consumption for the large hospital building by heat resistance-capacitance method. The system simulation of water storage air source heat pump is additionally performed by changing sizes and locations of the hospital building. The computed results show that energy cost of water storage air source heat pump is low, so it is more economical than absorption chiller & heater.

• 한국표면공학회지
• /
• 제57권4호
• /
• pp.338-347
• /
• 2024

𝛼-MnO₂ as a cathode material for Zn-ion batteries allows insertion and extraction of Zn ions within its tunnel structure during charge and discharge. The morphology and crystal structure of 𝛼-MnO₂ particles critically determine their electrochemical behavior and energy storage performance. In this study, 𝛼-MnO₂ was synthesized from precursor solutions under varying pH conditions using a hydrothermal method. The effects of pH values on the morphology, crystal structure, and electrochemical performance were systematically analyzed. The analysis revealed that materials synthesized at higher pH levels exhibited elongated and narrow nanorods with a lower specific surface area. In contrast, those formed at lower pH levels showed shorter, thicker nanorods with a higher specific surface area. This increased surface area at a lower pH enhanced the specific capacitance by providing a greater electrode/electrolyte interfacial area. By contrast, the material synthesized at higher pH conditions demonstrated superior rate capability, attributed to its crystal structure with wider lattice spacings. Wide lattice parameters in the material synthesized at higher pH conditions facilitated easier ion transport than at lower pH levels. Consequently, the study confirms that adjusting the pH of the precursor solution can optimize the electrochemical properties of 𝛼-MnO₂ for Zn-ion batteries.

• 한국재료학회지
• /
• 제29권8호
• /
• pp.505-510
• /
• 2019

Zn-ion supercapacitors (ZICs) show high energy densities with long cycling life for use in electronic devices. Porous Zn electrodes as anodes for ZICs are fabricated by chemical etching process using optimized conditions. The structures, morphologies, chemical bonding states, porous structure, and electrochemical behavior are examined. The optimized porous Zn electrode shows a root mean square of roughness of 173 nm and high surface area of $153{\mu}m^2$. As a result, ZIC using the optimized porous Zn electrode presents excellent electrochemical performance with high specific capacitance of $399F\;g^{-1}$ at current density of $0.5A\;g^{-1}$, high-rate performance ($79F\;g^{-1}$ at a current density of $10.0A\;g^{-1}$), and outstanding cycling stability (99 % after 1,500 cycles). The development of energy storage performance using synergistic effects of high roughness and high surface area is due to increased electroactive sites by surface functionalization of Zn electrode. Thus, our strategy will lead to a rational design and contribute to next-generation supercapacitors in the near future.

• 한국재료학회지
• /
• 제31권5호
• /
• pp.272-277
• /
• 2021

Owing to its low cost, easy fabrication process, and good ionic properties, aqueous supercapacitors are under strong consideration as next-generation energy storage devices. However, the limitation of the current collector is its poor electrochemical stability, leading to low energy storage performance. Therefore, a reasonable design of the current collector and the acidic electrolyte is a necessary, as well as interfacial engineering to enhance the electrochemical performance. In the present study, graphite foil, with excellent electrochemical stability and good electrical properties, is suggested as a current collector of aqueous supercapacitors. This strategy results in excellent electrochemical performance, including a high specific capacitance of 215 F g^-1 at a current density of 0.1 A g^-1, a superior high-rate performance (104 F g^-1 at a current density of 20.0 A g^-1), and a remarkable cycling stability of 98 % at a current density of 10.0 A g^-1 after 9,000 cycles. The superior energy storage performance is mainly ascribed to the improved ionic diffusion ability during cycling.

• 전기화학회지
• /
• 제6권2호
• /
• pp.145-152
• /
• 2003

전해 캐패시터와 supercapacitor의 특성을 함께 가지는 하이브리드 캐패시터의 용량은 표면이 산화물로 피복된 양극에 의해서 좌우된다 본 연구에서는 고전압 하이브리드 슈퍼캐패시터의 제조를 위해 양극의 용량 최적화를 수행하였다. $40{\mu}m$의 입자경을 갖는 알루미늄 분말과 NaCl분말을 4:1의 무게비로 혼합하여 디스크 형태의 전극을 만들고 열처리를 하였다. 열처리 후 $50^{\circ}C$의 증류수에서 NaCl을 용해시켜 열처리 온도에 따른 용량과 저항을 비교하였다. 최적의 열처리 과정을 거친 후 electropolishing 및 화학처리, 1차 및 2차 에칭을 단계별로 행하였고 각각의 단계에서 최적의 조건을 조사하였다 각각의 단계에서의 용량과 저항은 ac impedance analyzer를 사용하여 측정하였으며 전극의 표면은 SEM을 이용하여 관찰하였다. 2차 에칭 후 내전압이 300V급인 전극으로 만들기 위하여 365V로 양극산화 시켰으며, 산화된 알루미늄 디스크 전극을 사용하여 단위 셀을 제조하여 주파수에 따른 용량과 저항 특성을 기존의 300V급 알루미늄 전해 캐패시터와 비교하였다.

• Carbon letters
• /
• 제19권
• /
• pp.66-71
• /
• 2016

The development of nanostructured functional materials derived from biomass and/or waste is of growing importance for creating sustainable energy-storage systems. In this study, nanoporous carbonaceous materials containing numerous heteroatoms were fabricated from waste coffee grounds using a top-down process via simple heating with KOH. The nanoporous carbon nanosheets exhibited notable material properties such as high specific surface area (1960.1 m² g⁻¹), numerous redox-active heteroatoms (16.1 at% oxygen, 2.7 at% nitrogen, and 1.6 at% sulfur), and high aspect ratios (>100). These unique properties led to good electrochemical performance as supercapacitor electrodes. A specific capacitance of ~438.5 F g⁻¹ was achieved at a scan rate of 2 mV s⁻¹, and a capacitance of 176 F g⁻¹ was maintained at a fast scan rate of 100 mV s⁻¹. Furthermore, cyclic stability was achieved for over 2000 cycles.