• Proceedings of the Korean Society for Agricultural Machinery Conference
• /
• 2000.11b
• /
• pp.132-138
• /
• 2000

Complex gear shifting and high speed-reduction ratio reduce the transmission efficiency in power driveline of agricultural tractors. According to a field test, the power transmission efficiency of a tractor in transporting operations was estimated about 70%. However, the actual efficiency was found by the experiment to fluctuate in a range of 56 to 87%. Therefore, the constant efficiency model commonly used for a simulation of power drivelines is not likely to simulate its performance more accurately. In order to predict power transmission efficiency more accurately, a new model was proposed and the new concepts of the maximum efficiency and sticking torque were introduced. The error mean between the measured and the predicted efficiencies was about 2.3% in mean. The new model reflecting the transmission characteristics in the power driveline of tractors could be used to analyze and predict the power transmission performance of tractors more accurately.

• Environmental Engineering Research
• /
• v.13 no.3
• /
• pp.141-146
• /
• 2008

Transport of Escherichia coli ATCC 11105 through porous media was investigated in this study using two sets of column experiments to quantify the attachment-related parameters (sticking efficiency, attachment rate coefficient and filter factor). The first set of experiments was performed in quartz sand under different ionic strength conditions (1, 20, 100, 200 mM) while the second experiments were carried out in quartz sand mixed with metal oxyhydroxide-coated sand (0, 5, 10, 25%). The breakthrough curves of bacteria were obtained by monitoring effluent, and then bacterial mass recovery and attachment-related parameters were quantified from these curves. The first experiments showed that the mass recoveries were in the range of 13.3 to 64.7%, decreasing with increasing ionic strength. In the second experiments, the mass recoveries were in the range of 15.0 to 43.4%, decreasing with increasing coated sand content. The analysis indicated that the sticking efficiency, attachment rate coefficient and filter factor increased with increasing ionic strength and coated sand content. The value of filter factor in the first experiments ranged from 1.45 e-2 to 6.72 e-2 1/cm while in the second experiments it ranged from 2.78 e-2 to 6.32 e-2 1/cm. Our filter factor values are one order of magnitude lower than those from other studies. This discrepancy can be attributed to the size of sand used in the experiment. The analysis demonstrated that the travel distance of bacteria estimated using the filter factor can be varied greatly depending on the solution chemistry and charge heterogeneity of porous media.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.6 no.3
• /
• pp.56-68
• /
• 2003

The main purpose of this study was to verify the shore margin protection effect of the root system of Salix gracilistyla Miq. developed from direct sticking cuttings on wetland, through the measurement of root growth and comparison of soil slaking rate depending on the planting method applied to shore-marginal slope. Comparison of growth rate and soil dispersion rate was made between five planted slope and one naked slope. The planting methods applied to the planted slope were (a) horizontally layed burying of stick(45cm) bundle (b) horizontally layed covering the slope with sticks (c) horizontally fencing with normal cuttings(20cm) (d) elected sticking of normal cutting at equal distances (e) random scattering short cuttings(3-4cm). As results, the most effective planting method was horizontally layed burying, and in order to increase its efficiency scattering the live stem chips in 2-3cm on the slope is recommended. The growth of root was negatively regressive to the distance from water floor.

• Journal of computational fluids engineering
• /
• v.17 no.2
• /
• pp.58-64
• /
• 2012

Turbulent flows in a intake part of vacuum cleaner are studied by RANS simulations. The governing equations are solved by the SIMPLE algorithm based on the finite volume method of the unstructured grid system. The predicted results show that the suction performance is closely related to the variation of flow structure in the intake part. In order to investigate for the cleaning of bedclothes and carpet without sticking, several design changes are applied. The introduction of a solid cylinder in the intake part changes vortical structures significantly. Based on this result, a new design with spiral brushes is proposed. The design shows a good behavior for the suction performance and the flow control.

• Journal of the Korean Society of Manufacturing Technology Engineers
• /
• v.18 no.4
• /
• pp.375-380
• /
• 2009

In this paper, it has been proposed an automatic vegetable bundling mechanism that makes use of heat melt sticking. The proposed mechanism is consisted of three modules for the rationality of manufacture. Design specification has been determined by the bundling mechanism that was optimized mechanically. And, it has been manufactured the prototype of the automatic bundling machine. It has been carried out directly the field test for verification of performance in farmhouse which produces vegetable. In field test, this bundling machine showed efficiency of about 3.6 times than the manual working by manpower, and other performance it got satisfied result. This automatic vegetable-bundling machine was already registered as the agricultural machine. and This machine will be commercialized soon.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2000.02a
• /
• pp.157-157
• /
• 2000

The adsorption processes of methyl chloride on Si(100)-2$\times$1 have been studied by low energy electron diffraction (LEED), Auger electron spectroscopy (AES) and semiempirical PM3 calculations. The dissociative adsorption of the methyl chloride on Si(100) takes place without breaking of the silicon dimer with high efficiency. For adsorption at the room temperature, the existence of a precursor state is confirmed by the behavior of the sticking probability depending on the coverage and temperature. From AES measurements, the determined activation barrier of adsorption ($\Delta$ Hads) is -28.4 kj/mol. This results indicate that the dissociative process is nonactivated. The optimized precursor state of CH3Cl on the Si(100)-2$\times$1 surface was determined by PM3 calculations based on a cluster model.

• Journal of the Korean Institute of Gas
• /
• v.16 no.3
• /
• pp.48-53
• /
• 2012

The purpose of this paper studies the failure cases including with system of liquefied phase injection in liquified petroleum gas vehicle. The first case, resulting with inspection the injector of LPG, it occasionally certified the injection damage phenomenon that the fuel efficiency(km/l) was decreased to 5% by carbon deposit with injector hole when the driver operates the vehicle. The second case, it certified the interference phenomenon of air flow with carbon deposit in ISA system control for idle speed of engine and throttle body suppling air into engine. As a result, the fuel efficiency was decreased 7%. The third case, the outer air during intake stroke was intermittently flowed in this gasket gap because of weaken adhesion power phenomenon for cylinder block by intake manifold gasket tearing. Consequentially, it certified the decrease for fuel efficiency to 3% by risen the amount of fuel injection as the air inflow quantity. These failure examples reduced the power performance of engine and the fuel efficiency of vehicle. It have to minimize of failure phenomenon preparing through quality management.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.5 no.4
• /
• pp.435-442
• /
• 2010

The efficiency of the car's wiper blade has a great contribution to the guarantee of security. To guarantee the wiper blade's ability of getting rid of dust sticking on the glass surface, the qualities of lubricant, durability, heat resistant, low temperature, ozone resistant, chemical resistant must be good as well as it being noiseless. Like this, in order to improve the wiper's skills, it is essential to have a system that is able to assess and analyse the properties of the wiper. In this paper, to create a system that measures the car's wiper pressure, an analog/digital converter (ADC) that receives signals generated from the pressure sensor and transmits it to a personal computer is proposed. The designed ADC is one of the pipeline ADCs that can obtain fast movement rate and also a structure that can optimize the entire system's area as well as the consumption of strength.

• Journal of the korean Society of Automotive Engineers
• /
• v.10 no.5
• /
• pp.61-68
• /
• 1988

This paper reports the basic performance of a naturally aspirated DI diesel engine which is used widely in industry and agriculture when vegetable oils are used as fuel substitutes. In this paper, the properties of vegetable oils as diesel fuel were investigated and the load-performance of diesel engine when vegetable oils were used, as tested compared against diesel fuel. The general objective of this investigation is to realize an efficient, clean, and low carbon deposit combustion of the vegetable oils in diesel engines, showing their feasibility as diesel fuel substitutes. The results of this experiment were as follows; (1) Compared with diesel fuel, the droplet size of vegetable oil is very large. (2) Compared with diesel fuel, rapeseed oil, palm oil, and their blend fuels offered lower smoke, lower NOx, ower engine noise, and high thermal efficiency in a D.I. diesel engine However, there were carbon deposit and piston ring sticking problems with long-term operation. (3) For ethanol-rapeseed oil blends, a 10-20% of ethanol content is recommended to enable lower BSHC and less smoke without a remarkable increase in engine noise compared with pure rapeseed oil. (4) A 10% oxygen content in the vegetable oils is contributed to reduced smoke emission.

• Journal of Oriental Neuropsychiatry
• /
• v.30 no.3
• /
• pp.265-274
• /
• 2019

Objectives: The purpose of this study was to research the trend related to pharmacopuncture for insomnia in China for further development of pharmacopuncture in Korea. Methods: This study reviewed and analyzed 21 Chinese journals related to pharmacopuncture 2013~2019 sourced with the following keywords in the China National Knowledge Infrastructure (CNKI). 'Shimian', 'Wuewei zhushe', 'Shuizhen', 'Xuewei yaowu zhushe', 'Yaowu xuewei zhushe', 'Xuewei zhuyao', 'Xuezhu', and 'Xueweiyaowu zhuru'. Results: The following results were obtained in this study. 1. A total of 21 papers were selected, comprised of clinical research and case reports. 2. Pharmacopuncture was often used for insomnia, and as the medicine of injection, Salvia, Gastrodin, Acanthopanax, Hominis Placenta, Qingkailing, Shenmai, Bozhi Glycopeptide, Fufang Danggui, Vitamin B12, and Chlorpromazine Hydrochloride were used. 3. In combined treatments, acupuncture, chiropractic, auricular sticking, and herbal medicine were used. 4. It was more effective compared to conservational acupuncture therapy. Conclusions: It was established that they have efficiency to treat insomnia with pharmacopuncture in China, but there were limitations in this study, so we need more research to identify new medicines for neuropsychiatric diseases.