• JSTS:Journal of Semiconductor Technology and Science
• /
• v.6 no.4
• /
• pp.257-263
• /
• 2006

New charge pump circuits with low area and high power efficiency are proposed and verified in this paper. These pump circuits do not suffer the voltage stress higher than $V_{DD}$ across their pumping capacitors. Thus they can use the thin-oxide MOSFETs as the pumping capacitors. Using the thin-oxide capacitors can reduce the area of charge pumps greatly while keeping their driving capability. Comparing the new pump (NCP-2) with the conventional pump circuit using the thick-oxide capacitors shows that the power efficiency of NCP-2 is the same with the conventional one but the area efficiency of NCP-2 is improved as much as 71.8% over the conventional one, when the $V_{PP}/V_{DD}$ ratio is 3.5 and $V_{DD}$=1.8V.

• Journal of Satellite, Information and Communications
• /
• v.12 no.4
• /
• pp.95-99
• /
• 2017

The lifetime of a battery that supplies all the power required by a satellite in the eclipse is directly related to the lifetime of the satellite. Because the lifetime of the battery is influenced by the charging method of the battery, the power control unit that controls the charging of the battery should be designed in consideration of battery life. The battery charging is performed by controlling the charge current in the power control unit generated from the solar cell in the daytime. In order to prevent overcharge of the battery and for considering frequency of eclipse in each season, parameters related battery charging should be designed differently according to the season and to prevent over-current charging and over-voltage charging during charging, charge current is controlled by monitoring battery charge / discharge status, charge current amount, battery voltage, battery capacity, battery temperature and battery cell voltage. In satellite, tapering method is used to control charge current by reflecting each condition. In this paper, design battery charging algorithm of satellite power control unit using tapering charging method. convert the designed algorithm into a code that can be uploaded to satellites and verify the operation through testing in the established satellite environment.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.12
• /
• pp.80-86
• /
• 2009

In this paper, we present a new charge pump circuit feasible for the implementation with standard twin-well CMOS process technology. The proposed charge pump employs PMOS-switching dual charge-transfer paths and a simple two-phase clock. Since charge transfer switches are fully turned on during each half of clock cycle, they transfer charges completely from the present stage to the next stage without suffering threshold voltage drop. During one clock cycle, the pump transfers charges twice through two pumping paths which are operating alternately. The performance comparison by simulations and measurements demonstrates that the proposed charge pump exhibits the higher output voltage, the larger output current and a better power efficiency over the traditional twin-well charge pumps.

• Proceedings of the KIPE Conference
• /
• 2016.07a
• /
• pp.323-324
• /
• 2016

In this paper a high efficiency bidirectional resonant converterfor Vehicle-to-Grid applications (V2G) is proposed.The proposed converter has adopted an LC auxiliary circuit in the third winding of the transformer. With the proposed method full softswitching can be ensured in all switches over a wide range of loadsand the secondary ringing can be removed with no additional snubber or clamp circuitry.In addition, since the proposed resonant converter is able to operate at an almost constant resonant frequencyregardless of the load, CC/CV charge of the battery can be simply implemented with high efficiency. A 3.3 kW bidirectional converter for On-Board Charger of Electric Vehicle is implemented to verify the validity of the proposed method. The experimental results show the high efficiency characteristics of the proposed converter over the wide range of load in both charge and discharge mode. The maximum efficiency of the proposed system was 98.13 % at 2.3 kW during the constant voltage mode charge operation.

• Bulletin of the Korean Chemical Society
• /
• v.28 no.8
• /
• pp.1317-1321
• /
• 2007

Arginine conjugated PAMAM dendrimer, PAMAM-R was modified with propylene oxide via hydroxylation of primary amines of arginine residues. About 49 amines were detected to be converted to amino alcohols by 1H NMR. The newly synthesized polymer, PAMAM-R-PO was able to completely retard pDNA from a charge ratio of 2. The average diameter of PAMAM-R-PO polyplex was found to be 242 nm at a charge ratio of 30. The Zeta-potential value of PAMAM-R-PO polyplex was able to reach 20-30 mV over a charge ratio of 10. PAMAM-R-PO indicated higher cell viability than unmodified PAMAM-R on HeLa and 293 cells because of its hydroxylated amines. Transfection experiments on 293 cells showed that the transfection efficiency of PAMAM-R-PO was found to be 1.5-1.9 times higher than that of PEI25kDa at a charge ratio of 30. The polymer eventually displayed about 2 times greater transfection efficiency than PAMAM-R at the same charge ratio in the absence of serum. Therefore, we concluded that the modification of primary amines of PAMAMR to amino alcohols gives positive effects such as reduced cytotoxicity and enhanced transfection efficiency on 293 cells for gene delivery potency of PAMAM-R.

• Transactions on Electrical and Electronic Materials
• /
• v.17 no.1
• /
• pp.25-28
• /
• 2016

We investigate the effect of interface states on the endurance of a charge trap flash (CTF) NOR array using charge pumping methods. The endurance test was completed from one cell selected randomly from 128 bit cells, where the memory window value after 10² program/erase (P/E) cycles decreased slightly from 2.2 V to 1.7 V. However, the memory window closure abruptly accelerated after 10³ P/E cycles or more (i.e. 0.97 V or 0.7 V) due to a degraded programming speed. On the other hand, the interface trap density (Nit) gradually increased from 3.13×10¹¹ cm⁻² for the initial state to 4×10¹² cm⁻² for 10² P/E cycles. Over 10³ P/E cycles, the Nit increased dramatically from 5.51×10¹² cm⁻² for 10³ P/E cycles to 5.79×10¹² cm⁻² for 10⁴ P/E cycles due to tunnel oxide damages. These results show good correlation between the interface traps and endurance degradation of CTF devices in actual flash cell arrays.

• Journal of Photoscience
• /
• v.6 no.3
• /
• pp.91-96
• /
• 1999

Zeolites and microporouos materials continue to attract attention as novel hosts for photochemical reactions. Zeolities are attractive because of their ability to selectivity exchange and incorporate species within the void spaces and interconnecting channels, providing a spatial arrangement of molecules. Our research has primarily focused on intrazeolitic electron transfer from excited Ru(bpy)32+ in supercages of zeolite Y to a series of bipyridinium ions. In the Ru(bpy)32+ viologen-zeolite Y samples, the slowing of the back electron transfer from the bipyridinium radical cation to Ru(bpy)32+ allows for charge propagation via self exchange between diquat molecules. This provides an opportunity for permanent charge separation. When the migrating charge on the diquat radical within the zeolite reaches the surface, it can be transferred to a neutral viologen (PVS) in solution, resulting in permanent charge separation. The advantage of long-lived charge separation can be exploited for useful chemistry if suitable catablysts can be assembled on the zeolities. We have studied Ru(bpy)2 as water oxdiation catalysts. We have demonstrated that synthesis of RuO2 fibers on a zeolite via thermal decomposition of Ru3(CO)12 leads to the most active water decomposition catalyst reported to date. Because of the extensive interest of photochemical water reduction to H2, much is known about catalytic systems usin gone electron catalyst, and even more importantly, that no reaction of viologen occurred with H2 over this catalyst. The present challenge is to incorporate all these elements of the system into an architecture and we are examining zeolite membranes for this purpose.

• The Transactions of the Korean Institute of Electrical Engineers
• /
• v.40 no.8
• /
• pp.808-815
• /
• 1991

The behavior of space charge in PE/ionomer blends has been investigated using the thermally stimulated current (TSC) technique. In the blends, at least two TSC peaks over the temperature range from -50 to 100\ulcorner are observed, one at -5 ~ 10\ulcorner (a peak) and the others at above 60\ulcorner (a peak). The a peak is assigned as the orientation of dipoles from the ionomer component. Two a peaks seem to be related to the charge trapping at sites related to the crystalline phases. One a peak is associated with the ionic interfaces and the other with the ethylene chains without the ionic interfaces. The amount of charges stored in PE/Surlyn 1652 blends increases as the poling field increases over the field range of +8 ~ +30 kV/mm, whereas that in PE/Surlyn 1601 blends increases slightly at low poling fields and then decreases at high poling fields above +10 kV/mm. Exact reasons for such a dirrerence are not known at this point.

• Proceedings of the KIPE Conference
• /
• 1999.07a
• /
• pp.210-213
• /
• 1999

A battery is the device that transforms the chemical energy into the direct-current electrical energy directly without a mechanical process. Unit cells are connected in series to obtain the necessary voltage, while being connected in parallel to organize capacity for load current and to decrease the internal resistance for corresponding the sudden shift of the load current. The circular-current, however, could be occurred when the system is driven in parallel. As a result, the new batteries are heated by over-change and discharge, and the over charge current makes to increase the rust of the positive grid and consequently the shortened life of the new batteris would be shown. In this paper, the internal resistance of charge and discharge will be balanced, through inserting the resistance into the system by way of calculation of the changed amount of internal resistance.

• Electrical & Electronic Materials
• /
• v.10 no.3
• /
• pp.239-246
• /
• 1997

The ZnO is stabilize dielectric constant over a broad temperature range because its addition makes the relaxation time short. In this study, the composite oxide material (B $a_{0.85}$ $Ca_{0.15}$)Ti $O_{3}$ was mixed by ZnO additive material and the dielectric polarization characteristics was studied. The relative density was over 90[%] at all specimen in the structural characteristics. Among of the specimen, the relative density of (B $a_{0.85}$ $Ca_{0.15}$)Ti $O_{3}$ with ZnO (0.4mol) has a 95[%]. The grain size of composite oxide material with an increasing ZnO increased and it was 1.0[.mu.m]-1.22[.mu.m]. In the electrical characteristics, the charge and discharge current was increased by ZnO addition. The dielectric relaxation time was increased by space charge polarization at above 110[.deg. C] and the dielectric relaxation time was fixed by space charge polarization of para-dielectric layer at below 110[.deg. C]. The dielectric relaxation time was maximum when the grain size was small. The dielectric relaxation time is decreased with an additive material ZnO and interface polarization, existing void at the grain and grain boundary. The remnant polarization is increased and the coercive electric field is decreased by ZnO.