• Asian-Australasian Journal of Animal Sciences
• /
• 제17권9호
• /
• pp.1255-1259
• /
• 2004

The objective of this study was to evaluate the effects of halogenated compounds, organic acids, unsaturated fatty acids and their mixtures on in vitro methane production and fermentative characteristics of mixed rumen microorganisms. Agents used in two in vitro experiments were bromoethanesulfonic acid (BES) and pyromellitic diimide (PMDI) as halogenated compound, fumarate and malate as organic acid, and linoleic acid and linolenic acid as unsaturated fatty acid sources. Ruminal fluid collected from a Holstein steer fed tall fescue and concentrate mixtures was incubated at $39^{\circ}C$ for 48 h with addition of those materials. Single supplementation of halogenated compounds, organic acids or unsaturated fatty acids decreased in vitro methane production (p<0.05). The second experiment was designed to investigate effects of combination of one of halogenated compounds and either organic acids or fatty acids on methane production. Lower concentration of methane and lower A:P ratio were observed with PMDI compared with BES (p<0.01). In general medium pH, VFA, total gas and hydrogen production, and dry matter degradability were affected by addition of the same compounds. In addition, PMDI+malate treatment resulted in the highest molar proportion of propionate, and lowest A:P ratio and methane production (p<0.01). Hydrogen production was highest in PMDI+linolenic acid and lowest in BES+malate treatment (p<0.01). PMDI+malate combination was the most recommendable in reducing methane production without too much influence on digestibility under conditions of present studies.

• 한국수소및신에너지학회논문집
• /
• 제27권6호
• /
• pp.712-720
• /
• 2016

When bioethanol and water are mixed at a proper ratio, phase separation can occur because of the immiscibility of biobutanol with water. Phase separation in bioethanol blends fuels is a major problem for gasoline vehicle users due to effect of octane number and component corrosion. Thus, in this study, the phase separation of bioethanol was examined effect of bioethanol blends (E3 (3 vo.% bioethanol in gasoline), E5 and E10) in presence of water. The effect were evaluated behavior with phase separation test, simulation test of fuel tank in gas station according to water addition volume and it was investigated change of water content, bioethanol content and octane number for gasoline phase in bioethanol blends (E3, E5 and E10) every 1 week after water addition. The E3 occurred phase separation more easily than the E5 and E10 in small water contents because solubility of water on ethanol content difference in gasoline-ethanol. It was kept a initial level of water content, bioethanol content, and octane number by repeated sample replacing in simulation test of fuel tank.

• 미생물학회지
• /
• 제52권1호
• /
• pp.74-83
• /
• 2016

안전성이 확보되고 amo 유전자가 있는 토종미생물 Bacillus subtilis SRCM 101269는 전통발효식품으로부터 분리하였으며, cellulase, xylanase 생성능, 동정, 악취저감화능 등을 조사하여 우분 적용을 위한 특성 연구를 진행하였다. 가축분뇨 악취제어 관련 우분 적용 결과, 발효 6일 경과 후 대조구에 비해 2배 이상 암모니아 가스가 감소하였고 9일 경과 후 10 ppm 미만으로 농도가 감소하였다. 우분에 계분과 기타 목질성분이 첨가된 혼합분의 경우 발효 3일 후부터 일정 농도로 암모니아 가스가 유지되는데 반해, B. subtilis SRCM 101269를 접종한 시료에서만 발효시간의 경과에 따라 암모니아 가스가 감소하였으며, 황화수소의 농도 또한 9일이 경과한 시료에서 65 ppm으로 감소됨이 확인되었다. 발효 경과에 따른 아질산염과 황산염의 시료 내 변화량을 측정한 결과 우분에서의 아질산염은 변화가 없었으나, 혼합분에서는 대조구에 비교하여 증가하였다. 황산염의 경우 우분에서는 발효초기보다 감소하였으나 대조구와 비교하여 큰 차이를 보이지 않았고, 혼합분에서는 변화가 없는 것으로 분석되었다. 최종적으로 앞선 연구들을 토대로 B. subtilis SRCM 101269 균주의 우분퇴비 생산의 산업적 활용이 가능함을 확인하였다.

• Journal of Microbiology and Biotechnology
• /
• 제19권7호
• /
• pp.698-708
• /
• 2009

High rate sulfate reduction under acidic conditions opens possibilities for new process flow sheets that allow the selective recovery of metals from mining and metallurgical waste and process water. However, knowledge about high-rate sulfate reduction under acidic conditions is limited. This paper investigates sulfate reduction in a membrane bioreactor at a controlled pH of 5. Sulfate and formate were dosed using a pH-auxostat system while formate was converted into hydrogen, which was used for sulfate reduction. Sulfide was removed from the gas phase to prevent sulfide inhibition. This study shows a high-rate sulfate-reducing bioreactor system for the frrst time at pH 5, with a volumetric activity of 188 mmol $SO_4^{2-}$/I/d and a specific activity of 81 mmol $SO_4^{2-}$volatile suspended solids/d. The microbial community at the end of the reactor run consisted of a diverse mixed population including sulfate-reducing bacteria.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2008년도 추계학술대회B
• /
• pp.1996-2000
• /
• 2008

In autothermal reforming reaction, oxygen to carbon ratio (OCR) and steam to carbon ratio (SCR) are significant factors, which control temperature and carbon deposition into the reactor. The OCR is more sensitive than the SCR to affect the temperature distribution and reforming efficiency. In conventional operation, hydrocarbon fuel, steam, and oxygen was homogeneously mixed and injected into the reactor in order to get hydrogen-rich gas. The temperature was abruptly raised due to fast oxidation reaction in the former part of the reactor. Deactivation of packed catalysts can be accelerated there. In the present study, therefore, the effect of the oxygen distribution is introduced and investigated to suppress the carbon deposition and to maintain the reactor in the mild operating temperature (e.g., $700{\sim}800^{\circ}C$). In order to investigate the effect numerically, the following models are adopted; heterogeneous reaction model and two-medium model for heat balance.

• 한국분말재료학회지
• /
• 제15권2호
• /
• pp.107-113
• /
• 2008

Ultrafine TiC-5%Co powders were synthesized by spray drying of aqueous solution of TiO$(OH)_2$ slurry and cobalt nitrate, followed by calcination and carbothermal reaction. The oxide powders with carbon powder was reduced and carburized at $900^{\circ}C{\sim}1250^{\circ}C$ under hydrogen atmosphere. During reduction, CO gas was mainly evolved by reducing reaction of oxides. Ultrafine TiC-5%Co powders were easily formed by carbothermal reaction at $1250^{\circ}C$ due to using ultrafine powders as raw materials. The ultrafine WC-TiC-Co alloy prepared by sintering of mixed powder of ultrafine WC-13%Co powder and ultrafine TiC-5%Co powder has higher sintered density and mechanical properties than WC-TiC-Co alloy prepared by commercial WC, TiC and Co powders.

• 한국전기전자재료학회논문지
• /
• 제24권6호
• /
• pp.468-472
• /
• 2011

Conductive $SrMoO_3$ thin films were fabricated by RF magnetron sputtering with the powder-type sputtering target, and annealed for crystallization. When RTP (rapid thermal processing) in vacuum was applied, the fabricated thin films showed the mixed phases of $SrMoO_3$ and $SrMoO_4$, but $SrMoO_3$ phase could be promoted by the lowering of the working pressure during deposition. In order to eliminate $O_2$ gas during deposition and annealing, further lowering of the working pressure and furnace annealing in hydrogen atmosphere were tried. With the optimization of the deposition and annealing conditions, the thin film with nearly single-phase of $SrMoO_3$ was obtained, and it showed good electrical conduction properties with a low resistivity of $2.5{\times}10^{-3}{\Omega}{\cdot}cm$ at room temperature.

• 한국표면공학회지
• /
• 제54권6호
• /
• pp.357-364
• /
• 2021

In this study, DLC films deposited by PECVD were evaluated to the properties of super-hydrophobic by CF₄ treatment. The structure of DLC films were confirmed by Raman Spectra whether or not mixed sp³ (like diamond) peak and sp² (like graphite) peak. And the hydrogen contents in the DLC films (F-DLC) were measured by RBS analysis. In addition, DLC films were analyzed by scratch test for adhesion, nano-indentation for hardness and tribo-meter of Ball-on-disc type for friction coefficient. In the result of analysis, DLC films had traditional structure regardless of variation of hardness at constant conditions. Also adhesion of DLC film was increased as higher material hardness. Otherwise, friction coefficient was increased as lower material hardness. The DLC films were treated by CF₄ plasma treatment to enhance the properties of super-hydrophobic. And the DLC films were measured by ESEM(Enviromental Scanning Electron Microscope) for water condensation.

• 한국분말재료학회지
• /
• 제18권3호
• /
• pp.262-268
• /
• 2011

In order to investigate the microstructure and mechanical properties of WC-10 wt% Co insert tool alloy fabricated by PIM (Powder Injection Molding) process, the feedstock of WC-10 wt% and wax used as a kind of binder were mixed together by two blade mixer. After injection molding, the debinding process was carried out by two-steps. First, solvent extraction, in which the binder was eliminated by putting the specimen into normal hexane for 24 hrs at $60^{\circ}C$, and subsequently thermal debinding which was conducted at $260^{\circ}C$ and $480^{\circ}C$ for 6 hrs in the mixed gas of $H_2/N_2$, respectively. Meantime, in order to compensate the decarburization due to hydrogen, 1.2~1.8% of carbon was added to ensure the integrity of the phase. Finally, the specimens were sintered in vacuum under different temperatures, and the relative density of 99.8% and hardness of 2100 Hv can be achieved when sintered at $1380^{\circ}C$, even the TRS is lower than the conventional sintering process.

• Asian-Australasian Journal of Animal Sciences
• /
• 제22권1호
• /
• pp.42-48
• /
• 2009

An in vitro incubation study was conducted to investigate effects of 2-bromoethanesulfonic acid (BES) on ruminal fermentation characteristics and methanogen population. BES at the final concentration of 0, 1 and 5 mM with two different substrates having a different ratio of timothy and concentrate (100% timothy vs. 40% timothy-60% concentrate) was incubated for 0, 24, 48 and 72 h in a $39^{\circ}C$ incubator. Total DNA extracted from culture fluid was used as a template for real-time PCR to measure the population of methanogens. Four different primer sets were used for amplification of total bacteria, total methanogens, the order Methanobacteriales and the order Methanomicrobiales. BES reduced (p<0.01) total gas and methane production in a dose-dependent manner. BES at 5 mM inhibited methane production by more than 95% compared to the control. An interaction between substrate and level of BES in total gas and methane was detected (p<0.01). The decrease of methane production with increasing BES level was more pronounced on mixed substrate than on timothy alone. However, hydrogen production was increased by BES treatment (p<0.01). Total VFA concentration was not affected, but molar percentage of propionate and butyrate was increased and acetate to propionate ratio was reduced by BES treatment (p<0.01). BES did not affect the population density of total bacteria but reduced (p<0.01) the population of total methanogens, the order Methanobacteriales and the order Methanomicrobiales in a dose-dependent manner. The type of substrate did not influence the trend, although the magnitude of response was different between all-roughage and 40% roughage substrate.