• 전력전자학회논문지
• /
• 제6권3호
• /
• pp.265-272
• /
• 2001

기존의 전자레인지의 마그네트론 구동용 전원장치는 성층 철심을 사용한 60[Hz]고압 변압기, 큰 용량의 콘덴서와 싸이리스터를 이용한 위상제어 회로를 사용하기 때문에 부피가 크고 무거우며, 저효율의 단점을 가지고 있다. 본 논문은 출력 600[W]마그네트론을 장착한 전자레인지의 전원장치로 최대출력1[kW], 스위칭 주파수20[kHz]의 Phase-shifted Full-Bridge(FB)Zero-Voltage-Switched(ZVS) PWM 컨버터의 사용을 제안하고, 이를 개발.적용하여 전체 시스템의 경량화 및 고전력밀도의 목적을 달성하였다.

• 전력전자학회논문지
• /
• 제24권3호
• /
• pp.201-206
• /
• 2019

This study presents the design and experimental result of a GaN-based DC-DC converter with an integrated gate driver. The GaN device is attractive to power electronic applications due to its superior device performance. However, the switching loss of a GaN-based power converter is susceptible to the common source inductance, and converter efficiency is severely degraded with a large loop inductance. The objective of this study is to achieve high-efficiency power conversion and the highest power density using a multiphase integrated half-bridge GaN solution with minimized loop inductance. Before designing the converter, several GaN and Si devices were compared and loss analysis was conducted. Moreover, the impact of common source inductance from layout parasitic inductance was carefully investigated. Experimental test was conducted in buck mode operation at 48 -12 V, and results showed a peak efficiency of 97.8%.

• 전력전자학회논문지
• /
• 제6권3호
• /
• pp.243-249
• /
• 2001

본 논문에서는 전파형 ZVT-PWM 승압형 컨버터를 제안한다. 보조 스위치를 전파형 모드에서 동작을 시킴으로써, 기존의 컨버터에서 보조 스위치가 턴-오프 순간에 하드 스위칭(hard switching)을 하는 반면에 제안된 컨버터는 수동 및 능동 소자를 추가하지 않고 보조 스위치의 턴-오프 손실과 스위칭 잡음(noise)을 줄였고 그리고 고전력 밀도 시스템을 구현할 수 있다.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 1998년도 Proceedings ICPE 98 1998 International Conference on Power Electronics
• /
• pp.648-653
• /
• 1998

The conventional three-phase rectifier with bulky LC output filter has been widely used in the industry because of its distinctive advantages over the active power factor correction rectifier such as simple circuit, high reliability, and low cost. Over than 0.9 power factor can be achieved, which is acceptable in most of industry applications. This rectifier, however, is not easy to use for high power density applications since the LC filter is bulky and heavy. To solve this problem, a new simple rectifier is presented in this paper. By eliminating the bulky LC filter from the conventional diode rectifier without losing most of the advantages of the conventional rectifier, very high power density power conversion with high power factor can be achieved. Operation principle and design considerations are illustrated and verified by Pspice simulation and experimental results from a prototype of 3.3 kW rectifier followed by 100KHz zero voltage switching full bridge PWM converter

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2008년도 하계학술대회 논문집
• /
• pp.373-375
• /
• 2008

Studying for environmentally-friendly and efficient energy source is now actively under way on because problems like environmental pollution and exhaust of natural resources are in issue. Pure Cell which is an alternative energy source has low voltage and high current characteristic, therefore boost up voltage converter and DC-AC converter is required to use as a common power source. In this paper, DC-DC converter which has high efficient and high power density is proposed and verified by experimental result.

• 전력전자학회논문지
• /
• 제16권6호
• /
• pp.627-637
• /
• 2011

본 논문은 새로운 형상을 가지는 평면 변압기를 적용한 200W급 공진컨버터에 대한 내용이다. 제안된 평면변압기는 기존 누설인덕턴스가 작은 평면변압기와 달리 누설인덕턴스가 조정이 가능하여 원하는 공진 특성을 얻을 수 있는 특징을 가지는 저가형 고집적화에 용이한 변압기이다. 본 논문에서는 제안된 평면변압기를 적용하여 200W급 전원장치에 적용하여 실험하였으며, 실험결과와 이론적인 해석에 대해 서술하였다.

• 전력전자학회논문지
• /
• 제16권3호
• /
• pp.293-301
• /
• 2011

본 논문에서는 정류용 브릿지 다이오드가 없는 고효율 하프 브릿지 AC-DC 컨버터를 제안한다. 제안하는 컨버터는 비대칭 펄스 폭 변조 방식의 하프 브릿지 DC-DC 컨버터와 정류용 브릿지 다이오드가 없는 역률 개선 회로가 통합된 회로 구조를 지닌다. 제안하는 컨버터는 정류용 브릿지 다이오드를 사용하지 않고 교류 입력 전압으로부터 절연된 직류 출력 전압을 공급한다. 간단한 회로 구조와 함께 도통 손실을 줄일 수 있다. 또한 스위칭 소자들의 영전압 스위칭을 통하여 스위칭 손실을 줄일 수 있다. 두 개의 직렬 연결된 트랜스포머를 구비함으로서 프로파일을 낮추고 전력밀도를 높일 수 있다. 250 W (48 V / 5.2 A) 회로 설계 및 실험을 통하여 제안된 컨버터의 성능을 $90 \;V_{rms}$ 교류 입력 전압에 대하여 입증하였다.

• 한국조명전기설비학회:학술대회논문집
• /
• 한국조명전기설비학회 2005년도 학술대회 논문집
• /
• pp.377-382
• /
• 2005

This paper presents two new circuit topologies of DC bus lineside active edge resonant snubber assisted soft-switching PWM full-bridge DC-DC converter acceptable for either utility AC 200V-rms or AC 400V-rms input voltage source. One topology of proposed DC-DC converters is composed of a typical voltage source-fed full-bridge high frequency PWM inverter using DC busline side series power semiconductor switching devices with the aid of a parallel capacitive lossless snubber. All the active power switches in the full-bridge arms and DC busline can achieve ZCS turn-on and ZVS turn-off commutations and the total turn-off switching power losses of all active switches can be reduced for high-frequency switching action. It is proved that the more the switching frequency of full-bridge soft switching inverter increases, the more soft-switching PWM DC-DC converter with a hish frequency transformer link has remarkable advantages for its efficiency and power density as compared with the conventional hard-switching PWM inverter type DC-DC converter

• 전기학회논문지
• /
• 제64권6호
• /
• pp.885-890
• /
• 2015

LLC resonant converter has been widely used because of its high efficiency and high energy density. In this paper, we designed a LLC resonant converter as the main power supply of the Nd:YAG pulse laser. First harmonic approximation (FHA) is used to model the LLC resonant converter. FHA equivalent circuit model and the transfer function of the LLC resonant converter is proposed. Soft start technology is also used to suppress the surge current. The laser output simulation test result is identical with the practical test, the laser energy of every pulse can reach up to 2.5J, and the pulse per second (PPS) can be adjusted from 6 to 18. The power system is verified stable and reliable by both of the simulation and experiment results.

• Journal of Power Electronics
• /
• 제12권3호
• /
• pp.458-467
• /
• 2012

Single phase converters suffer from ripple power pulsating at twice the line frequency. The ripple power is usually absorbed by a bulky capacitor bank and/or a dedicative LC resonant link, resulting in a low power density and a high cost. An alternative solution is using a dc link active power filter (APF) to direct the pulsating power into another energy-storage component. The main dc link filter capacitor can then be reduced substantially. Based on a mainstream dc APF topology, this paper proposed a new control strategy incorporating both dual-loop control and repetitive control. The circuit parameter design is also re-examined from a control point of view. The proposed APF scheme has better control performance, and is more suited for high power applications since it works in CCM and with a low switching frequency.