• Proceedings of the Optical Society of Korea Conference
• /
• 2003.02a
• /
• pp.146-147
• /
• 2003

무선 통신 시스템이 발달하고 정보의 양이 많아짐에 따라 고주파를 이용한 통신 시스템에 대한 수요가 증가하고 있다. 최근 이러한 고주파 통신 시스템을 optical fiber를 이용하여 구현(Radio-on-fiber system)하는 연구가 주목받고 있다. 무선 고주파 통신 시스템에서는 많은 수의 안테나 기지국이 필요하게 되는데 optical fiber를 이용하면 적은 전송 손실로 기지국간의 연결이 가능하게 된다. 안테나 기지국의 구축을 위해서 최근 InP High Electron Mobility Transistor(HEMT)를 이용하여 광 검출을 구현하는연구가 활발히 진행되고 있다. (중략)

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.10
• /
• pp.766-772
• /
• 2018

A 6~10 GHz wide-band power amplifier was designed using an InGaAs enhancement-mode(E-mode) $0.15{\mu}m$ pseudomorphic high-electron-mobility transistor(pHEMT). The positive gate bias of the E-mode pHEMT device removes the need for complex negative voltage generation circuits, therefore reducing the module size. The wire bond and substrate loss parameters were modeled and extracted using a three-dimensional electromagnetic(3D EM) simulation. For wideband characteristics, lossy matching was adopted and the gate bias was optimized for maximum power and efficiency. The measured gain, in/output return loss, output power, and power-added efficiency were greater than 20 dB, 8 dB, 27 dBm, and 35 %, respectively, in the 6~10 GHz band.

• Journal of the Korean Vacuum Society
• /
• v.20 no.5
• /
• pp.345-355
• /
• 2011

GaAs-based metamorphic high electron mobility transistors (MHEMTs) and InP-based high electron mobility transistors (HEMTs) have good microwave and millimeter-wave frequency performance with lower minimum noise figure. MHEMTs have some advantages, especially for cost, compared with InP-based ones. In this paper, InAlAs/InxGa1-xAs/GaAs MHEMTs are simulated for DC/RF small-signal analysis. The hydrodynamic simulation parameters are calibrated to a fabricated 0.1-${\mu}m$ ${\Gamma}$-gate MHEMT device having the modulation-doped $In_{0.52}Al_{0.48}As/In_{0.53}Ga_{0.47}As$ heterostructure on the GaAs substrate, and the simulations for RF small-signal characteristics are performed, compared with the measured data, and analyzed for the devices. In addition, the simulations for the DC/RF characteristics of the MHEMTs with different gate-recess structures are performed, compared and analyzed.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.48 no.11
• /
• pp.1-8
• /
• 2011

One of the most important parameters that limit maximum output power of transistor is breakdown. InAlAs/InGaAs/GaAs Metamorphic HEMTs (MHEMTs) have some advantages, especially for cost, compared with InP-based ones. However, GaAs-based MHEMTs and InP-based HEMTs are limited by lower breakdown voltage for output power even though they have good microwave and millimeter-wave frequency performance with lower minimum noise figure. In this paper, InAlAs/$In_xGa_{1-x}As$/GaAs MHEMTs are simulated and analyzed for breakdown. The parameters affecting breakdown are investigated in the fabricated 0.1-${\mu}m$ ${\Gamma}$-gate MHEMT device having the modulation-doped $In_{0.52}Al_{0.48}As/In_{0.53}Ga_{0.47}As$ heterostructure on the GaAs wafer using the hydrodynamic transport model of a 2D commercial device simulator. The impact ionization and gate field effect in the fabricated device including deep-level traps are analyzed for breakdown. In addition, Indium mole-fraction-dependent impact ionization rates are proposed empirically for $In_{0.52}Al_{0.48}As/In_xGa_{1-x}As$/GaAs MHEMTs.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.02a
• /
• pp.168-168
• /
• 2010

InAs는 0.35eV의 낮은 밴드갭을 가지며 상온에서 약 $30,000cm^2/Vs$의 높은 전자이동도를 보여, GaAs/AlGaAs 및 InGaAs/InP 2DEG HEMT에 이은 차세대 초고속 전자소자의 2DEG용 물질로 각광을 받고 있다. 그러나 InAs의 격자상수는 약 0.61nm로 이에 적절한 반절연기판을 구할수 없어, GaAs상에 Al(Ga)Sb를 이용하여 성장하는 방법으로 2DEG을 실현하고 있다. 상기 방법으로 상온에서 ${\sim}30,000cm^2/Vs$ 전자이동도를 보이는 InAs/AlSb 2DEG HEMT 소자를 여러 연구팀에서 시현하였으나, 실제적으로 응용하기 위해서 etch-stop층 또는 contact층의 제작이 용이치 않아 실제의 회로구현에는 어려움을 격고 있다. 이에 InGaAs/InP 2DEG내에 InAs를 넣어 InAs 2DEG을 제작하는 방법이 NTT[1]에 의해 제안되어, SPINTRONICS등의 InAs 2DEG이 필요한 곳에 응용되고 있다. [2] 본 발표에서는 고품질의 InAs 2DEG을 실현하기 위해, 다양한 성장 변수 (온도, As 분압, 성장 시퀀스, InAs층의 두께등)와 2DEG의 전기적특성간의 관계를 발표한다. 최종적으로 상온전자이동도 ${\sim}12,000cm^2/Vs$의 InAs 2DEG을 제작할수 있었으며, 이를 다양한 전자소자에 차후 응용할 예정이다.

• Proceedings of the IEEK Conference
• /
• 1999.11a
• /
• pp.295-298
• /
• 1999

AlGaAs/InGaAs power P-HEMTS (Pseudo-morphic High Electron Mobility Transistors) with 1.0-${\mu}{\textrm}{m}$ gate length for PCS applications have been fabricated. We adopted single heterojunction P-HEMT structure with two Si-delta doped layer to obtain higher current density. It exhibits a maximum current density of 512㎃/mm, an extrinsic transconductance of 259mS/mm, and a gate to drain breakdown voltage of 12.0V, respectively. The device exhibits a power density of 657㎽/mm, a maximum power added efficiency of 42.1%, a linear power gain of 9.85㏈ respectively at a drain bias of 6.0V, gate bias of 0.6V and an operation frequency of 1.765㎓.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.19 no.7
• /
• pp.605-610
• /
• 2006

We have investigated $Al_{0.25}Ga_{0.75}As/In_{0.2}Ga_{0.8}As$ structures for pseudomorphic high electron mobility transistor(pHEMT), which were grown by molecular beam epitaxy(MBE) and consequently annealed by rapid thermal anneal(RTA), using Hall measurement, photoluminescence, and transmission electron microscopy (TEM). According to intensity and full-width at half maximum maintained stable at the same energy level, the quantized energy level in $Al_{0.25}Ga_{0.75}As/In_{0.2}Ga_{0.8}As$ quantum wells was independent of the RTA conditions. However, the Hall mobility was decreased from $6,326cm^2/V.s\;to\;2,790cm^2/V.s\;and\;2,078cm^2/V.s$ after heat treatment respectively at $500^{\circ}C\;and\;600^{\circ}C$. The heat treatment which is indispensable during the fabrication procedure would cause catastrophic degradation in electrical transport properties. TEM observation revealed atomically non-uniform interfaces, but no dislocations were generated or propagated. From theoretical consideration about the mobility changes owing to inter-diffusion, the degraded mobility could be directly correlated to the interface scattering as long as samples were annealed below $600^{\circ}C$ lot 1 min.

• Journal of electromagnetic engineering and science
• /
• v.17 no.3
• /
• pp.147-152
• /
• 2017

This paper presents a frequency doubler operating at G-band that exceeds the maximum oscillation frequency ($f_{max}$) of the given transistor technology. A common-source transistor is biased on class-B to obtain sufficient output power at the second harmonic frequency. The input and output impedances are matched to achieve high output power and high return loss. The frequency doubler is fabricated in a commercial 150-nm GaAs pHEMT process and obtains a measured conversion gain of -5.5 dB and a saturated output power of -7.5 dBm at 184 GHz.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.9 no.4
• /
• pp.506-514
• /
• 1998

The design and fabrication of X-band(11.7~12 GHz) 2-stage monolithic microwave integrated circuit(MMIC) low noise amplifier (LNA) for active antenna are presented using $0.15{\mu}m\times140{\mu}m$ AlGaAs/InGaAs/GaAs pseudomorphic high electron mobility transistor (P-HEMT). In each stage of the LNA, a series feedback by using a source inductor is used for both input matching and good stability. The measurement results are achieved as an input return loss under -17 dB, an output return loss under -15dB, a noise figure of 1.3dB, and a gain of 17 dB at X-band. This results almost concur with a design results except noise figure(NF). The chip size of the MMIC LNA is $1.43\times1.27$.

• Journal of the Semiconductor & Display Technology
• /
• v.11 no.2
• /
• pp.53-57
• /
• 2012

This paper is for accurately simulating the breakdown of MHEMTs with an InP-etchstop layer. 2D-Hydrodynamic simulation parameters are investigated and calibrated for the InP-epitaxy layer. With these calibrated parameters, simulations are performed and analyzed for the breakdown of devices with an InP-etchstop layer. In the paper, the impact-ionization coefficients, the mobility degradation due to doping concentration, and the saturation velocity for InP-epitaxy layer are newly calibrated for more accurate breakdown simulation.