• Journal of the Korean Applied Science and Technology
• /
• v.34 no.1
• /
• pp.1-11
• /
• 2017

Bio-oil has attracted considerable interest as one of the promising renewable energy resources because it can be used as a feedstock in conventional petroleum refineries for the production of high value chemicals or next-generation hydrocarbon fuels. Zeolites have been shown to effectively promote cracking reactions during pyrolysis resulting in highly deoxygenated and hydrocarbon-rich compounds and stable pyrolysis oil products. In this study, catalytic pyrolysis was applied to upgrade bio-oil from yellow poplar and then fuel characteristics of upgraded bio-oil was investigated. Yellow Poplar(500 g) which ground 0.3~1.4 mm was processed into bio-oil by catalytic pyrolysis for 1.64 seconds at $465^{\circ}C$ with Control, Blaccoal, Whitecoal, ZeoliteY and ZSM-5. Under the catalyst conditions, bio-oil productions decreased from 54.0%(Control) to 51.4 ~ 53.5%, except 56.2%(Blackcoal). HHV(High heating value) of upgraded bio-oil was more lower than crude bio-oil while the water content increased from 37.4% to 37.4 ~ 45.2%. But the other properties were improved significantly. Under the upgrading conditions, ash and TAN(Total Acid Number) is decrease and particularly important as transportation fuel, the viscosity of bio-oil decreased from 6,933 cP(Control) to 2,578 ~ 4,627 cP. In addition, ZeoliteY was most effective on producing aromatic hydrocarbons and decreasing of from the catalytic pyrolysis.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.25 no.3
• /
• pp.55-62
• /
• 2017

In this study, we investigated the effect of seaweed (SW) addition on the anaerobic digestion of food waste (FW). Anaerobic batch experiments were carried out at various substrate concentrations (2.5 to 10.0 g VS/L) and mixing ratios (FW:SW=100:0, 75:25, 50:50, 25:75 and 0:100 on VS basis) of FW and SW. The methane yield of FW alone was 394, 377, 276, $49mL\;CH_4/g\;VS_{added}$ at each substrate concentration (2.5 to 10.0 g VS/L). In cases of co-digestion, methane yield decreased (up to 15 %) with increasing mixing ratio of SW at low substrate concentration (2.5 to 5.0 g VS/L), while it increased (up to 240 %) at high substrate concentration (7.5 to 10.0 g VS/L). The synergistic effect was calculated based on the amount of methane generated from the single-feedstock digestion of FW and SW. The synergistic effect was not found at 2.5 and 5.0 g VS/L. However, the synergistic effect increased (up to 25% = synergistic increment/total methane production at 10.0 g VS/L, FW:SW=50:50) with increasing the ratio of seaweed at 7.5 and 10.0 g VS/L. At 10.0 g VS/L of FW alone, the accumulated amount of organic acids was 7,426 mg COD/L, which was decreased to 2,346 mg COD/L by seaweed (FW:SW=50:50) addition. The reason for the synergistic effect was to control the production rate of the organic acids by adding SW that has a relatively lower biodegradability compared to FW.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.60 no.3
• /
• pp.374-380
• /
• 2015

This study firstly provides basic data for selection of cultivatable bioenergy grass in barren reclaimed lands applied with solidified sewage sludge. The experimental plots consisted of a plot containing reclaimed land mixed with solidified sewage sludge (MSS 50), a plot covered by solidified sewage sludge (CSS 100), and an original reclaimed soil plot (ORS). The growth, biomass production of bioenergy grasses and soil chemical properties were investigated in each experimental plot for 5 years. The organic matter (OM) and total nitrogen (T-N) content in both MSS 50 and CSS 100 were considerably higher than those in ORS. In bioenergy grasses, M. sacchariflorus cv. Geodae 1 showed an excellent growth and adaptability on reclaimed land applied with solidified sewage sludge. The application of solidified sewage sludge may provided soil nutrition in the reclaimed land due to the fact that bioenergy crops grew better in soils applied with solidified sewage sludge than in untreated soils, and treated soils had higher OM and T-N content than untreated soils. This study suggests that M. sacchariflorus cv. Geodae 1 is the most suitable biomass feedstock crop for biomass production and that solidified sewage sludge may be used as a soil material for cultivation of bioenergy grass on reclaimed lands.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.56 no.4
• /
• pp.299-307
• /
• 2011

This study was carried out to obtain the basic data for selecting the cultivatable bioenergy crops through application of solidified sewage sludge in reclaimed lands. The experimental plots consisted of the mixing with solidified sewage sludge plot (SS50), the covering with solidified sewage sludge plot (SS100), and the original reclaimed land plot (ORL) on reclaimed land for the intended landfill in Sudokwon Landfill Site Management Corporation (SLC). The growth of energy crops (Geodae-Uksae 1, Miscanthus sacchariflorus, and Phragmites australis) were investigated from May to October, 2010 in each experimental plot. The soil from ORL showed higher salinity with high contents of exchangeable $Na^+$ cation than that of SS50 and SS100. Soil properties on reclaimed land used in this study must be improved by increasing the buffering capacity of saline with the treatment of solidified sewage sludge due to the fact that the contents of organic matter (OM) in both of SS50 and SS100 were higher than that of the ORL. Thus the growth of energy crops cultivated in the solidified sewage sludge plots were better than in ORL. Geodae-Uksae 1 which showed an excellent adaptability on reclaimed land treated with the solidified sewage sludge has considerably higher biomass than those of other energy crops (M. sacchariflorus and P. australis). This study suggested that Geodae-Uksae 1 is the most suitable biomass feedstock crop for bioenergy productions, and the solidified sewage sludge may be possible to utilize as a soil cover materials for cultivation of bioenergy crops in reclaimed land.

• Korean Chemical Engineering Research
• /
• v.47 no.6
• /
• pp.762-767
• /
• 2009

In this study, the feasibility of using vegetable oil extracted from tropical crop seed as a biodiesel feedstock was investigated by producing biodiesel and analysing the quality parameters as a transport fuel. In order to produce biodiesel efficiently, two step reaction process(pre-treatment and transesterificaion) was required because the tropical crop oil have a high content of free fatty acids. To determine the suitable acid catalyst for the pre-esterification, three kinds of acid catalysts were tested and sulfuric acid was identified as the best catalyst. After constructing the experimental matrix based on RSM and analysing the statistical data, the optimal pre-treatment conditions were determined to be 26.7% of methanol and 0.982% of sulfuric acid. Trans-esterification experiments of the pre-esterified oil based on RSM were carried out, then discovered 1.24% of KOH catalyst and 22.76% of methanol as the optimal trans-esterification conditions. However, the quantity of KOH was higher than the previously established KOH concentration of our team. So, we carried out supplemental experiment to determine the quantity of catalyst and methanol. As a result, the optimal transesterification conditions were determined to be 0.8% of KOH and 16.13% of methanol. After trans-esterification of tropical crop oil, the produced biodiesel could meet the major quality standard specifications; 100.8% of FAME, 0.45 mgKOH/g of acid value, 0.00% of water, 0.04% of total glycerol, $4.041mm^2/s$ of kinematic viscosity(at $40^{\circ}C$).

• Korean Journal of Weed Science
• /
• v.30 no.4
• /
• pp.340-360
• /
• 2010

The depletion of fossil fuels, ecological problems associated with $CO_2$ emissions climate change, growing world population, and future energy supplies are forcing the development of alternative resources for energy (heat and electricity), transport fuels and chemicals: the replacement of fossil resources with $CO_2$ neutral biomass. Several options exist to cover energy supplies of the future, including solar, wind, and water power; however, chemical carbon source can get from biomass only. When used in combination with environmental friend production and processing technology, the use of biomass can be seen as a sustainable alternative to conventional chemical feedstocks. The biorefinery concept is analogous to today's petroleum refinery, which produce multiple fuels and chemical products from petroleum. A biorefinery is a facility that integrates biomass conversion processes and equipment to produce fuels, power, and value-added chemicals from biomass. Biorefinery is the co-production of a spectrum of bio-based products (food, feed, materials, and chemicals) and energy (fuels, power, and heat) from biomass [definition IEA Bioenergy Task 42]. By producing multiple products, a biorefinery takes advantage of the various components in biomass and their intermediates therefore maximizing the value derived from the biomass feedstocks. A biorefinery could, for example, produce one or several low-volume, but high-value, chemical or nutraceutical products and a low-value, but high-volume liquid transportation fuel such as biodiesel or bioethanol. Future biorefinery may play a major role in producing chemicals and materials as a bridge between agriculture and chemistry that are traditionally produced from petroleum. Industrial biotechnology is expected to significantly complement or replace the current petroleum-based industry and to play an important role.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.59 no.3
• /
• pp.369-374
• /
• 2014

The rice stem borer (Chilo suppressalis Walker) was one of the most destructive pest of rice for the 1960s and 1970s in Korea. Recently, it is newly recognized as a potential risk factor to the biomass yield of bioenergy crops. The current research was firstly conducted to investigate overwintering larvae population density and pattern of rice stem borer attacking Miscanthus sacchariflorus cv. Geodae 1 which is referred to as an ideal lignocellulosic bioenergy crop in Korea. Population density of larvae per $1m^2$ in stems and rhizomes at the Miscanthus experimental plots and rates of damage (wormhole, abscission) of M. sacchariflorus cv. Goedae 1 were investigated from October 2012 to March 2013. The population of larvae per $1m^2$ in stems of Miscanthus were 23, 4, 1, and 1 in October, November, December 2012, and January 2013, respectively. Over the same period, the population of larvae in basal stem rots and rhizomes were increased, whereas decreased in stems. Interestingly, the positions of larvae for overwintering in Miscanthus were confirmed to 5~10 cm below the soil surface such as basal stem rot and rhizome, whereas the most common overwintering position known in rice is a part of stem on the ground such as rice straw and rice stubble. It would suggest that the larvae gradually moved to bottom of stems and rhizomes in soil in line with decline in temperature. Moreover, the damage rates of stems per $1m^2$ were up to more than 50% in some places. In conclusion, this might be the first report that rice stem borer could affect the productivity of biomass of Miscanthus in case of mass cultivation. Moreover, it should be necessary to make a decision in insect control management for this bioenergy feedstock and other related crops.

• Clean Technology
• /
• v.25 no.2
• /
• pp.129-139
• /
• 2019

Bamboo is an evergreen perennial plant, and it is known as one of the most productive and fastest-growing plants in the world. It grows quickly in moderate climates with only moderate water and fertilizer. Traditionally in Asia, bamboo is used for building materials, as a food source, and as versatile raw materials. Bamboo as a biomass feedstock can be transformed to prepare activated carbon using the thermal treatment of pyrolysis. The effect of process variables such as carbonization temperature, activation temperature, activation time, the amount of steam, and the mixing ratio of phosphoric acid and bamboo were systematically investigated to optimize the preparation conditions. Steam activation was proceeded after carbonization with a vapor flow rate of $0.8{\sim}1.8mL-H_2O\;g-char^{-1}\;h^{-1}$ and activation time of 1 ~ 3 h at $700{\sim}900^{\circ}C$. Carbon yield and surface area reached 2.04 ~ 20.59 wt% and $499.17{\sim}1074.04m^2\;g^{-1}$, respectively, with a steam flow rate of $1.4mL-H_2O\;g-char^{-1}\;h^{-1}$ for 2 h. Also, the carbon yield and surface area were 24.67 wt% and $1389.59m^2\;g^{-1}$, respectively, when the bamboo and phosphoric acid were mixed in a 1:1 weight ratio ($700^{\circ}C$, 2 h, $1.4mL-H_2O\;g-char^{-1}\;h^{-1}$). The adsorption of methylene blue into the bamboo activated carbon was studied based on pseudo first order and second order kinetics models. The adsorption kinetics were found to follow the pseudo second order model, which is governed by chemisorption.

• Food Science and Industry
• /
• v.55 no.2
• /
• pp.188-202
• /
• 2022

In the insect industry, as the scope of application of insects is expanded from pet insects and natural enemies to feed, edible and medicinal insects, the demand for quality control of insect raw materials is increasing, and interest in securing the safety of insect products is increasing. In the process of expanding the industrial scale, controlling the temperature and humidity and air quality in the insect breeding room and preventing the spread of pathogens and other pollutants are important success factors. It requires a controlled environment under the operating system. European commercial insect breeding facilities have attracted considerable investor interest, and insect companies are building large-scale production facilities, which became possible after the EU approved the use of insect protein as feedstock for fish farming in July 2017. Other fields, such as food and medicine, have also accelerated the application of cutting-edge technology. In the future, the global insect industry will purchase eggs or small larvae from suppliers and a system that focuses on the larval fattening, i.e., production raw material, until the insects mature, and a system that handles the entire production process from egg laying, harvesting, and initial pre-treatment of larvae., increasingly subdivided into large-scale production systems that cover all stages of insect larvae production and further processing steps such as milling, fat removal and protein or fat fractionation. In Korea, research and development of insect smart factory farms using artificial intelligence and ICT is accelerating, so insects can be used as carbon-free materials in secondary industries such as natural plastics or natural molding materials as well as existing feed and food. A Korean-style customized breeding system for shortening the breeding period or enhancing functionality is expected to be developed soon.