• Polymer(Korea)
• /
• v.25 no.5
• /
• pp.719-727
• /
• 2001

Recently it was found that the charge carrier transport properties are significantly enhanced due to effective intermolecular $\pi$-orbital overlapping and low disorder of hopping sites caused by self-organization of liquid crystal molecules. In this study, the xerographic properties of a double-layer photoconductor doped with nematic liquid crystal, 4-pentyl-4'-cyanoterphenyl (5CT), as a charge-carrier transport material to enhance the charge-tarrier mobility were investigated. From the results of measured surface voltage properties for the photoconductor doped with various concentrations of liquid crystal, 5CT, the initial voltage was found to increase with the concentration of 5CT and the dark decay decreased with the concentration of 5CT. The highest sensitivity was obtained at a specific concentration, 40wt% 5CT. The fluorescence behavior of the carrier transport layer (CTL) was also investigated. It was found that the charge-carrier transport properties of the organic photoconductor depend on the charge-carrier transport properties of the complex. The TNF : 5CT (40 wt%) and OXD : 5CT (40 wt%)samples showed the highest sensitivity because the greatest charge transport complex was termed between the charge-carrier transport materials in these samples.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.15 no.2
• /
• pp.19-21
• /
• 1978

The electrical drift mobility of charge carrier of Cholesteryl Benzoate was measured by Polarity inversion method in the temperature range 140~ 185$^{\circ}C$. with a view to revealing the mechanism of charge carrier transport. The electrical drift mobility of charge carrier of that increased from 2.5$\times$10-7$\textrm{cm}^2$/V.sec to 2.0$\times$10-6$\textrm{cm}^2$/v.sec as the temperature increased. As a result of the experiment, the mechanism of current transport is believed to be ionic mechanism.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.07a
• /
• pp.844-847
• /
• 2001

In this work, transient characteristics of the Non-Punch Through(NPT) Insulated Gate Bipolar Transistor(IGBT) has been studied. we has analyzed with lifetimes excess minority carrier injected into N-dirft, base region of IGBT's BJT part and accumulated charge of on-state which affected swiching characteristic. In this paper, excess minority carrier and charge distribution in active base region is expressed analytically. This analysis proposed optical trade-off between lifetimes and accumulated charge for decreasing switching losses because charge result in switching loss when device was tuned off.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2007.08b
• /
• pp.1203-1205
• /
• 2007

Confinement of charge carrier and exciton is the essential factor for enhancing the efficiency and stability of the electrophosphorescent devices. The interplay between the properties of emitters and other adjacent layers are studied based on the physical interpretation with difference of energy level, charge carrier mobility, and corresponding charge-trapping behavior.

• Korean Journal of Materials Research
• /
• v.9 no.5
• /
• pp.473-477
• /
• 1999

Xerographic properties of double-layer photoconductor doped with 4-butyl-4'-methoxyazobenzene (BMAB) as charge-carrier transport material were investigated. BMAB can undergo reversible trans-cis isomerization by light with appropriate wavelength. In the results of measured surface voltage properties for photoconductor doped with BMAB, TNF: BMAB(4-wt%) sample with trans form showed the lowest dark decay, the lowest residual voltage, and the highest sensitivity among cis form. The trans isomer of BMAB has ordering orientation because the molecule possesses a rodlike shape, while the cis isomer has random orientation due to its bent shape. Therefore the molecular arrangement of trans form enhanced charge-carrier transport mobility.

• Proceedings of the IEEK Conference
• /
• 1999.06a
• /
• pp.970-973
• /
• 1999

When the size of the device is decreased, the hot carrier degradation presents a severe problem for long-term device reliability. In this paper we fabricated & tested the 0.26${\mu}{\textrm}{m}$ NMOSFET with wet gate oxide and nitride oxide gate to compare that the characteristics of hot carrier effect, charge to breakdown, transistor Id_Vg curve and charge trapping using the Hp4145 device tester As a result we find that the characteristics of nitride oxide gate device better than wet gate oxide device, especially a hot carrier lifetime(nitride oxide gate device satisfied 30years, but the lifetime of wet gate oxide was only 0.1year), variation of Vg, charge to breakdown and charge trapping etc.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.41 no.7
• /
• pp.21-29
• /
• 2004

Hot carrier degradation characteristics of Nano-scale CMOSFETs with dual gate oxide have been analyzed in depth. It is shown that, PMOSFET lifetime dominate the device lifetime than NMOSFET In Nano-scale CMOSFETs, that is, PMOSFET lifetime under CHC (Channel Hot Carrier) stress is much lower than NMOSFET lifetime under DAHC (Dram Avalanche Hot Carrier) stress. (In case of thin MOSFET, CHC stress showed severe degradation than DAHC for PMOSFET and DAHC than CHC for NMOSFET as well known.) Therefore, the interface trap generation due to enhanced hot hole injection will become a dominant degradation factor in upcoming Nano-scale CMOSFET technology. In case of PMOSFETs, CHC shows enhanced degradation than DAHC regardless of thin and thick PMOSFETs. However, what is important is that hot hole injection rather than hot electron injection play a important role in PMOSFET degradation i.e. threshold voltage increases and saturation drain current decreases due to the hot carrier stresses for both thin and thick PMOSFET. In case of thick MOSFET, the degradation by hot carrier is confirmed using charge pumping current method. Therefore, suppression of PMOSFET hot carrier degradation or hot hole injection is highly necessary to enhance overall device lifetime or circuit lifetime in Nano-scale CMOSFET technology

• Biomolecules & Therapeutics
• /
• v.19 no.2
• /
• pp.231-236
• /
• 2011

The aim of this study was to investigate the effect of charge carrier lipid on the skin penetration, retention, and hair growth of topically applied finasteride-containing liposomes. Finasteride-containing liposomes were prepared by traditional thin film hydration method using Phospholipon$^{(R)}$ 85 G and cholesterol with or without charge carrier lipid (1,2 dimyristoyl-sn-glycero-3-phosphate or 1,2-dioleoyl-trimethylammonium-propane for anionic and cationic charge, respectively). Freshly prepared finasteride-containing liposome suspension was applied on the hairless mouse skin, and skin penetration and retention were measured using Keshary-Chien diffusion cell. Non-liposomal formulation (ethanol 10% solution containing 0.5 mg/ml of FNS) was also used as a control. The amount of finasteride in the diffusion cell and mouse skin was measured by HPLC. The hair growth was evaluated using depilated male C57BL/6N mice. Mean particle size of all finasteride-containing liposomes was less than a micron, and polydispersity index revealed size homogeneity. Skin penetration and retention studies showed that significantly less amount of finasteride was penetrated when applied as anionic liposome while more amount of the drug was retained. Specifically, in liposome prepared with 10% anionic charge carrier lipid, penetration was 12.99 ${\mu}g/cm^2$ while retention was 79.23 ${\mu}g/cm^2$ after 24 h of application. In hair growth study, finasteride-containing anionic liposomes showed moderate efficacy, but the efficacy was not found when applied as cationic liposomes. In conclusion, topical application of finasteride using anionic liposome formulation appears to be useful option for the treatment of androgenetic alopecia to avoid systemic side effects of the drug.

• The KIPS Transactions:PartA
• /
• v.15A no.4
• /
• pp.211-216
• /
• 2008

In this paper we fabricated and measured the $0.26{\mu}m$ NMOSFET with wet gate oxide and nitride oxide gate to compare that the charateristics of hot carrier effect, charge to breakdown, transistor Id_Vg curve, charge trapping, and SILC(Stress Induced Leakage Current) using the HP4145 device tester. As a result we find that the characteristics of nitride oxide gate device better than wet gate oxide device, especially hot carrier lifetime(nitride oxide gate device satisfied 30 years, but the lifetime of wet gate oxide was only 0.1 year), variation of Vg, charge to breakdown, electric field simulation and charge trapping etc.

• Macromolecular Research
• /
• v.17 no.11
• /
• pp.894-900
• /
• 2009

This study examined the charge carrier photogeneration and hole transport properties of blends of poly (9-vinylcarbazole) (PVK), $\pi$-conjugated polymer, with different weight proportions (0~29.4 wt%) of (PEA)$VOPO_4{\cdot}H_2O$ (PEA: phenethylammonium cation), a novel organic-inorganic hybrid material, using IR, UV-Vis, and energy dispersive spectroscopy (EDS), thermogravimetric analysis (TGA), steady state photocurrent (SSPC) measurement, and atomic force microscopy (AFM). The SSPC measurements showed that the photocurrent of PVK was reduced by approximately three orders of magnitude by the incorporation of a small amount (~12.5 wt%) of (PEA) $VOPO_4{\cdot}H_2O$, suggesting that hole transport occurred through the PVK carbazole groups, whereas a reverse trend was observed at high proportions (>12.5 wt%) of (PEA)$VOPO_4{\cdot}H_2O$, suggesting that transport occurred via (PEA)$VOPO_4{\cdot}H_2O$ molecules. The transition to a trap-controlled hopping mechanism was explained by the difference in ionization potential and electron affinity of the two compounds as well as the formation of charge percolation threshold pathways.