• JSTS:Journal of Semiconductor Technology and Science
• /
• v.1 no.1
• /
• pp.15-19
• /
• 2001

Current leakage is the major failure mode of semiconductor device characteristic failures. Conventionally, failures such as short circuit breaks and gate breakdowns have been analyzed and the detected causes have been reflected in the fabrication process. By using a wafer-level emission-leakage failure analysis method (in-line QC), we analyzed leakage mode failure, which is the major failure detected during the probe inspection process for LSIs, typically DRAMs and CMOS logic LSIs. We have thus developed a new technique that copes with the critical structural failures and random failures that directly affect probe yields.

• Electrical & Electronic Materials
• /
• v.10 no.1
• /
• pp.26-32
• /
• 1997

The gate induced drain leakage(GIDL) current under the stress of worse case in -MOSFET's with ultrathin gate oxides has been measured and characterized. The GIDL current was shown that P-MOSFET's of the thicker gate oxide is smaller than that of the thinner gate oxide. It was the results that the this cur-rent is decreased with the increamental stress time at the same devices.It is analyzed that the formation components of GIDL current are both energy band to band tunneling at high gate-drain voltage and energy band to defect tunneling at low drain-gate voltage. The degradations of GIDL current was analyzed the mechanism of major role in the hot carriers trapping in gate oxide by on-state stress.

• ETRI Journal
• /
• v.38 no.2
• /
• pp.244-251
• /
• 2016

In this paper, we investigate the electrical characteristics of two trench-gate-type super-barrier rectifiers (TSBRs) under different p-body implantation conditions (low and high). Also, design considerations for the TSBRs are discussed in this paper. The TSBRs' electrical properties depend strongly on their respective p-body implantation conditions. In the case of the TSBR with a low p-body implantation condition, it exhibits MOSFET-like properties, such as a low forward voltage ($V_F$) drop, high reverse leakage current, and a low peak reverse recovery current owing to a majority carrier operation. However, in the case of the TSBR with a high p-body implantation condition, it exhibits pn junction diode.like properties, such as a high $V_F$, low reverse leakage current, and high peak reverse recovery current owing to a minority carrier operation. As a result, the TSBR with a low p-body implantation condition is capable of operating as a MOSFET, and the TSBR with a high p-body implantation condition is capable of operating as either a pn junction diode or a MOSFET, but not both at the same time.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2015.10a
• /
• pp.889-893
• /
• 2015

In this work, the characteristics of GIDL current in nanowire GAA MOSFET with different channel width and hot carrier stress. When the gate length is fixed as a 250nm the GIDL current with different channel width of 10nm, 50nm, 80nm, and 130nm have been measured and analyzed. From the measurement, the GIDL is increased as the channel width decreaes. However, the derive current is increased as the channel width increases. From measurement results after hot carrier stress, the variation of GIDL current is increased with decreasing channel width. Finally, the reasons for the increase of GIDL current with decreasing channel width and r device. according to hot carrier stress GIDL's variation shows big change when width and the increase of GIDL current after hot carrier stress are confirmed through the device simulation.

• Journal of the Microelectronics and Packaging Society
• /
• v.13 no.1 s.38
• /
• pp.17-22
• /
• 2006

Ferroelectric PZT thin films were formed by 2-step sputtering and their dielectric properties and conduction mechanisms were investigated. Also. donor impurity doping was tried to compensate the carriers in PZT thin films. The leakage current density was able to reduce to $10^{-7}A/cm^2$ order by 2-step sputtering with thickness control of room temp.-layer. The conduction mechanism was confirmed as bulk-limited, and optimum donor impurities on PZT thin film were taken. Especially, leakage current characteristics was improved to $10^{-8}A/cm^2$ order in donor-doped PZT thin films formed by 2-step sputtering.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.54 no.11
• /
• pp.490-492
• /
• 2005

A study on radiation hardening of infrared(IR) detector, the chief component of IR camera was performed. The radiation test on IR sensor passivated with the ZnS by Co$^{60}$ gamma-ray over 1 Mrads showed the reduction in Ro by 1/100 which was related to the noise level. This effect that was caused by carrier trapping in the ZnS passivation layer increased the leakage current and resulted in degradation in the device performance. For the radiation hardening of IR devices we suggested the ones with CdTe passivation layer which had a tendency to reluctant to carrier trapping in its layer and developed test patterns. Radiation test to the patterns showed that the our CdTe passivated device could survived over 1 Mrad gamma-ray dose.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.11a
• /
• pp.40-40
• /
• 2009

The electrical characteristic of the conventional self-aligned polycrystalline silicon (poly-Si) TFTs are known to present several undesired effects such as large leakage current, kink effect and hot-carrier effects. In this paper, LTPS TFTs with different GOLDD length were fabricated and investigated the effect of the GOLDD. GOLDD length of 1, 1.5 and $2{\mu}m$ were used, while the thickness of the gate dielectrics($SiN_x/SiO_2$) was fixed at 65nm(40nm/25nm). The electrical characteristics show that the kink effect is reduced at the LTPS TFTs, and degradation from the hot-carrier effect was also decreased by increasing GOLDD length.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.24 no.4
• /
• pp.625-630
• /
• 1987

Thermal evaporated SiO rf sputtered SiO2 thin films were most widely used to the gate oxide of TFTs. In this paper, the difference of trap density and distribution between SiO2 and SiO2 film were studied. TFTs using SiO and SiO2 thin film for the gate oxide were fabricated. The output characteirstics of TFTs and the time dpendencd of the leakage current were measured. Models of the carrier transport and carrier trapping in TFT were proposed. The trap density was obtained by substituting measured value for the equation derived from the proposed model. It was found that rf sputtered SiO2 had more traps at interface than thermal evaporated SiO.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1999.05a
• /
• pp.450-453
• /
• 1999

In this paper, The relationship between device performance and channel length(1.5-50$\mu$m) in polysilicon thin-film transistors fabricated by SPC technology was Investigated by measuring electric Properties such as 1-V characteristics, field effect mobility, threshold voltage, subthreshold swing, and trap density in grain boundary with channel length. The drain current at ON-state increases with decreasing channel length due to increase of the drain field, while OFF-state current (leakage current) is independent of channel length. The field effect mobility decrease with channel length due to decreasing carrier life time by the avalanche injection of the carrier at high drain field. The threshold voltage and subthreshold swing decrease with channel length, and then increase in 1.5 $\mu$m increase of increase of trap density in grain boundary by impact ionization.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.14 no.11
• /
• pp.869-873
• /
• 2001

The effects of alternate bias stress on p-channel poly-Si TFT\`s has been systematically investigated. We alternately applied positive and negative bias stress on p-channel poly-Si TFT\`s, device Performance(V$\_$th/, g$\_$m/, leakage current, S-slope) are alternately appeared to be increasing and decreasing. It has been shown that device performance degrade under the negative bias stress while improve under the positive bias stress. This effects have been related to the hot carrier injection into the gate oxide rather than the generation of defect states within the poly-Si/SiO$_2$ interface under alternate bias stress.