• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.47 no.1
• /
• pp.86-93
• /
• 2010

A system-on-chip (SoC) includes more functions and requires rapidly increased data bandwidth as the development of semiconductor process technology and SoC design methodology. As a result, the data bandwidth of on-chip-networks in SoCs becomes a key factor of the system performance, and the research on the on-chip-network is performed actively. Either AXI or OCP is considered to a substitute of the AHB which has been the most popular on-chip-network. However, they have much increased number of signal wires, which make it difficult to design the interface logic and the network hardware. The compatibility of the protocols with other protocols is not so good. In this paper, we propose a new interface protocol for on-chip-networks to improve the problems mentioned above. The proposed protocol uses less number of signal wires than that of the AHB and considers the compatibility with other interface protocols such as the AXI. According the analysis results, the performance of the proposed protocol per wire is much better than that of the AXI although the absolute performance is slightly inferior.

• Journal of KIISE:Computer Systems and Theory
• /
• v.33 no.8
• /
• pp.554-561
• /
• 2006

In recent years, as SoC design research is actively conducted, a large number of IPs are included in a system. Various bus protocols and bus architectures are designed to increase IP reusability. Among them, the AMBA AHB became a de facto standard although it is somewhat inadequate for a large scale SoC. We proposed SNP and SNA, high performance on-chip-bus protocol and architecture, respectively, to solve the problem of the conventional shared buses. However, it seems to be imperative that the new on-chip-bus system support AMBA-compatible IPs for a while since there are a lot of IPs with AMBA interface. In this paper, we propose an extended SNP specification and a corresponding SNA component to support ABMA-compatible IPs used in SNA - based system. We extend the phase of the SNP by 1 bit to add new 8 phases to support communication based on AMBA protocol without penalty of elongated cycle latency. The ARB-to -XSNP converter translates the protocol between AHB and SNP to attach AMBA -compatible IPs to SNA based system. We show that AMBA IPs can communicate through SNP without any degradation of performance using the extended SNP and AHB - to- XSNP converter.

• Proceedings of the Korean Information Science Society Conference
• /
• 2004.04a
• /
• pp.919-921
• /
• 2004

최근 임베디드 시스템 설계에서 저전력 소모와 SoC가 주된 관심사가 되면서, ARM 프로세서와 AMBA 버스가 각광을 받고 있다. AMBA 버스가 고속 모듈에 대해서는 장점을 지니지만. 저속 모듈과의 인터페이스에는 많은 제약이 따른다. 따라서 속도가 서로 다른 이종 모듈간에 속도 보상을 위한 bridge 가 필요하다. 이러한 용도로 APB bridge가 표준으로 자리 매김하고 있지만, 속도가 고정되어 있기 때문에 융통성이 배제된다. 본 논문에서는 이러한 단정을 보완하기 위해, 구조가 간단하고 구현이 쉬운 ISA 방식의 bridge를 제안하여, 많은 주변장치들을 손쉽게 AHB Slave로 인터페이스 할 수 있게 만든다.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.44 no.4
• /
• pp.24-31
• /
• 2007

Up to date, a lot of bus protocol and bus architecture are released though most of them are based on the shared bus architecture and inherit the limitation of performance. SNP (SoC Network Protocol), and hence, SNA (SoC Network Architecture) which are high performance on-chip-bus protocol and architecture, respectively, have been proposed to solve the problems of the conventional shared bus. We refine the SNA specification and improve the performance and functionality. The performance of the SNA is improved by supporting simultaneous routing for bus request of multiple masters. The internal routing logic is also improved so that the gate count is decreased. The proposed SNA employs XSNP (extended SNP) that supports almost perfect compatibility with AMBA AHB protocol without performance degradation. The hardware complexity of the improved SNA is not increased much by optimizing the current routing logic. The improved SNA works for IPs with the original SNP at its best performance. In addition, it can also replace the AMBA AHB or interconnect matrix of a system, and it guarantees simultaneous multiple channels. That is, the existing AMBA system can show much improved performance by replacing the AHB or the interconnect matrix with the SNA. Thanks to the small number of interconnection wires, the SNA can be used for the off-chip bus system, too. We verify the performance and function of the proposed SNA and XSNP simulation and emulation.

• Journal of IKEEE
• /
• v.28 no.1
• /
• pp.116-122
• /
• 2024

AMBA AHB-Lite bus is widely used in on-chip bus protocol for low-power and cost-effective SoC. However, it lacks built-in error detection and correction for end-to-end data integrity. This can lead to data corruption and system instability, particularly in harsh environments like automotive applications. To mitigate this problem, this paper proposes the application of SEC-DED (Single Error Correction-Double Error Detection) to AMBA AHB-Lite bus. It aims not only to detect errors in real-time but also to correct them, thereby enhancing end-to-end data integrity. Simulation results demonstrate real-time error detection and correction when errors occur, which bolsters end-to-end data integrity of automotive on-chip bus.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2019.05a
• /
• pp.251-253
• /
• 2019

This paper describes an implementation of a security SoC (System-on-Chip) prototype that interfaces a microprocessor with a block cipher crypto-core. The Cortex-M0 was used as a microprocessor, and a crypto-core implemented by integrating ARIA and AES into a single hardware was used as an intellectual property (IP). The integrated ARIA-AES crypto-core supports five modes of operation including ECB, CBC, CFB, CTR and OFB, and two master key sizes of 128-bit and 256-bit. The integrated ARIA-AES crypto-core was interfaced to work with the AHB-light bus protocol of Cortex-M0, and the crypto-core IP was expected to operate at clock frequencies up to 50 MHz. The security SoC prototype was verified by BFM simulation, and then hardware-software co-verification was carried out with FPGA implementation.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.4A
• /
• pp.390-398
• /
• 2004

This paper describes a study on the automatic generation system of the interface for communication among AMBA bus and IPs with different protocols. Employing an extended STG, the proposed system generates the interface modules required for the communication among IPs with different protocols. For an example system, the interface module for communication between AMBA AHB bus and a video decoder has been generated and verified in its functionality. The area and latency have been compared with the manually designed interface. For burst-mode communication, the generated interface module shows the comparable performance with the manually designed module. For single-mode communication, the generated interface module shows a slightly worse performance than the manually designed module. However, the increased area is negligible considering the size of the IP.

• Journal of KIISE:Computer Systems and Theory
• /
• v.32 no.9
• /
• pp.465-474
• /
• 2005

For high density SoC design, on-chip communication based on bus interconnection encounters bandwidth limitation while an NoC(Network-on-Chip) approach suffers from unacceptable complexity in its Implementation. This paper introduces a new on-chip communication protocol, SNP (SoC Network Protocol) to overcome these problems. In SNP, conventional on-chip bus signals are categorized into three groups, control, address, and data and only one set of wires is used to transmit all three groups of signals, resulting in the dramatic decrease of the number of wires. SNP efficiently supports master-master communication as well as master-slave communication with symmetric channels. A sequencing rule of signal groups is defined as a part of SNP specification and a phase-restoration feature is proposed to avoid redundant signals transmitted repeatedly over back-to-back transactions. Simulation results show that SNP provides about the same bandwidth with only $54\%$ of wires when compared with AMBA AHB.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2012.10a
• /
• pp.780-783
• /
• 2012

Recently, the SoC industry mainly uses various multi-layered bus architectures. However, reckless use of bus layers may results in on-chip communication resources and waste of silicon area. This paper performs a quantitative analysis to compare the two de-facto on-chip buses and SNP. Through the performance estimation, the performance of SNP turns out to be significantly enhanced for asymmetric write and read traffic (non-central F distribution) while symmetric traffic is similar to that of AXI. More specifically, SNP properly places IP cores on the top or bottom, induces the write and read channels to be balanced, and achieves about twenty percent improved performance compared to AXI.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2009.04a
• /
• pp.195-199
• /
• 2009

NoC 시스템은 기본적으로 서로 다른 클럭 도메인에서 동작하는 여러 버스 시스템들이 NoC를 통해서 연결되는 것으로 간주할 수 있다. NoC에 다른 버스 인터페이스 IP를 부착하려면 별도의 래퍼를 사용해야 하며, 면적과 지연시간이 추가되는 것이 일반적이다. 본 논문에서는, 추가적인 래퍼의 필요성을 제거하기 위하여, 주어진 버스 인터페이스에 맞는 인터페이스 에이전트 또는 네트워크 인터페이스를 자동 생성하는 방법을 제안한다. 이를 위하여, 한가지 NoC 시스템을 위해 표준적인 패킷 포맷을 정의하였으며, 거기에는 패킷에 대한 라우팅 정보 뿐 아니라, 여러 종류의 버스 프로토콜의 데이터, 주소, 제어 정보도 포함될 수 있도록 정의되었다. 그리고, 인터페이스 에이전트는 표준 패킷 포맷과 특정 버스 인터페이스 프로토콜 간의 변환 작업을 수행한다. 실험을 통해서, PVCI, WISHBONE, AHB, OCP와 같은 몇 가지 버스 인터페이스에 대해 자동생성된 네트워크 인터페이스들 간에, 표준 패킷 포맷을 이용한 데이터 통신이 중요 정보의 손실 없이 잘 이루어짐을 보인다.