• Journal of Korean Society of Transportation
• /
• v.26 no.1
• /
• pp.79-88
• /
• 2008

VMS based dispersion of traffic flows enables to decrease delay and congestion. Such being the case, there has been growing interests in VMS operation strategy. The strategy is based on driver's behavior or diversion rate. However, it was not easy to obtain each in practice. The diversion rate, thus far, was investigated by stated preference analysis or simulators. As an alternative, in this paper, a new method to obtain diversion flow rate was suggested using the toll collection system and freeway traffic management system data. A large gap of diversion rate between stated preference analysis and field survey was observed. Out of surveyed 8 tollgate data, the diversion rate was about 7% and was quite lower compared with that of 21%${\sim}$87% from stated preference analysis or simulators. With this at hand, a more careful information provision strategy should be devised and employed to correctly account this kind of differences.

• International Journal of Highway Engineering
• /
• v.14 no.1
• /
• pp.73-83
• /
• 2012

Effective use of traffic marking can lead to driver's safer driving by speed management and visibility enhancement. One of the critical factors in designing traffic marking is how to incorporate human factor issues into the design process. This study presented a methodology for evaluating the effectiveness of Hi-pass marking on Korean freeways based on kansei engineering. Hi-pass marking scenarios made by a virtual reality tool were used to evaluate the user's perceptions. Various combination of chevron angles and peripheral transverse(PT) bars were used for the evaluation. The results show that the most effective scenario is a combination of 60 degree chevron angle and an askew parallelogramshaped PT bar shaped. It is expected that the proposed method and outcome will be useful for making safer driving maneuvers.

• International Journal of Highway Engineering
• /
• v.15 no.3
• /
• pp.31-36
• /
• 2013

PURPOSES: This study is to investigate a generated traffic noise when vehicle pass over a transverse rumble strip at toll plaza of highway. METHODS: To investigate traffic noise at toll plaza of highway, Pass-by method which is the most common used for measuring traffic noise was adopted and the traffic noise at toll plaza was measured for 10 min per hour for 11hours(13:00~24:00). RESULTS: The measured traffic noise by pass-by method was changed as function of the transverse rumble strip configuration. Generally, the maximum difference among three noise measurement sections was 7 dB(A). It might be related with traffic speed. Also, the measured traffic noise was strongly generated from a passenger car which was 2 axle. It means that the most of traffic noise on the road is generated at tire/pavement interface of the passenger car. CONCLUSIONS: The traffic noise was strongly related with vehicle speed and transverse rumble strip configuration on the road. For driver safety, the transverse rumble strip is definitely necessary. However, the complaints from residents near highway was increased by traffic noise from transverse rumble strip. Therefore, To satisfy both safety and reduction of traffic noise, the development of configuration of transverse rumble strip is necessary in the further study.

• International Journal of Highway Engineering
• /
• v.14 no.5
• /
• pp.201-206
• /
• 2012

PURPOSES: This study evaluated a measuring technique for tire-pavement interaction noise that uses a noble close proximity (NCPX) method as well as for noise level measured inside of a car (e.g., Inside Noise Level) in term of rumble strips constructed at a tall gate. METHODS: According to the measurements of NCPX and inside noise level (INL), 1/3 octave band frequency analysis and overall noise level calculation were conducted in order to evaluate noise levels of NCPX and INL, depending on types of rumble strips. RESULTS: The tested sections of general concrete pavement surface and two different types of rumble strips were evaluated, using 1/3 octave band frequency analysis and overall noise level. From the analyzed results, it can be concluded that rumble strips generate a relatively huge noise levels when compared to the concrete pavement surface. CONCLUSIONS: Noting that above 3 dBA different noise levels can let drivers know that they are getting close to toll gate; therefore, they should apply their brakes. Thus, the noise levels of rumble strips are required to be reduced, based on considering the neighbors living near toll gates.

• Journal of Korean Society of Transportation
• /
• v.20 no.4
• /
• pp.51-61
• /
• 2002

In this dissertation, We demonstrated the Travel Time forecasting model in the freeway of multi-section with regard of drives' attitude. Recently, the forecasted travel time that is furnished based on expected travel time data and advanced experiment isn't being able to reflect the time-lag phenomenon specially in case of long distance trip, so drivers don't believe any more forecasted travel time. And that's why the effects of ATIS(Advanced Traveler Information System) are reduced. Therefore, in this dissertation to forecast the travel time of the freeway of multi-section reflecting the time-lag phenomenon & the delay of tollgate, we used traffic volume data & TCS data that are collected by Korea Highway Cooperation. Also keep the data of mixed unusual to applicate real system. The applied model for forecasting is consisted of feed-forward structure which has three input units & two output units and the back-propagation is utilized as studying method. Furthermore, the optimal alternative was chosen through the twelve alternative ideas which is composed of the unit number of hidden-layer & repeating number which affect studying speed & forecasting capability. In order to compare the forecasting capability of developed ANN model. the algorithm which are currently used as an information source for freeway travel time. During the comparison with reference model, MSE, MARE, MAE & T-test were executed, as the result, the model which utilized the artificial neural network performed more superior forecasting capability among the comparison index. Moreover, the calculated through the particularity of data structure which was used in this experiment.

• Journal of Wetlands Research
• /
• v.22 no.2
• /
• pp.145-152
• /
• 2020

Highways are characterized by high non-point pollutant emissions due to high traffic volumes and sections that cause abrupt change in driving speed (i.e. rest stations, ticketing office, etc.). Most highways in Korea were constructed with layers that do not allow adequate infiltration. Moreover, non-point pollution reduction facilities were not commonly installed on domestic highways. This study was conducted to evaluate a facility treating highway runoff and develop a cost-effective design for infiltration facilities by using soil amendment techniques. Performing soil amendment increased the hydraulic retention time (HRT) and infiltration rate in the facility by approximately 30% and 20%, respectively. The facility's efficiency of removing non-point pollutants (Total Suspend Soiled (TSS), Chemical Oxygen Demand(COD), Biological Oxygen Demand(BOD), Total Nitrogen (TN) and Total Phosphorus, (TP) were also increased by 20%. Performing soil amendment on areas with low permeability can increase the infiltration rates by improving the storage volume capacity, HRT, and infiltration area. The application of infiltration facilities on areas with low permeability should comply with the guidelines presented in the Ministry of Environment's Standards for installation of non-point pollution reduction facilities. However, soil amendment may be necessary if the soil infiltration rate is less than 13 mm/hr.

• Journal of Korean Society for Atmospheric Environment
• /
• v.28 no.5
• /
• pp.506-517
• /
• 2012

Electronic Toll Collection System (ETCS), so called "Hi-Pass" in Korea, has improved traffic flow at toll gate of highways. It is known that the improvement of traffic flow should reduce air pollutants and $CO_2$ from vehicles. In this study, real driving emission of a light duty truck with Portable Emission Measurement System(PEMS) has been measured to evaluate the emission reduction effect due to ETCS. The correlations between driving variables and emissions have been analyzed to verify its effect on traffic flow improvement and emission reduction at toll gate. We considered average vehicle speed, Relative Positive Acceleration (RPA), and the distance of queue as driving variables. Compared to passing Manual Toll Collection System (MTCS) lane without queue, ETCS was able to reduce 38.7% of $NO_x$, 21.6% of soot, and 27.7% of $CO_2$. The results showed that the higher the average vehicle speed, the lower RPA and no queue in ETCS contributed to the emission reductions. Linear equation models with RPA and queue have been established by the multiple linear regression method. The linear models resulted in the higher coefficient of determination than those with only average vehicle speed used for establishing vehicle emission factors.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.6 no.3
• /
• pp.67-76
• /
• 2007

Although Hi-pass have been operated for alleviating traffic congestion and enhancing mobility in expressways since 2000, there is not any standard for safe operation. For that reason, we investigated about tubular markers, which is a typical facility for safety in Hi-pass. Tubular Markers are installed for separating same or opposite traffic flows spatially, supporting the marks at a place which has not only high possibility of accidents but distinguished carefulness of drivers. In this paper, it is noted two considerings; one is prevention of accident from the speed gap of autos and Hi-pass vehicles; the other is guarantee of necessary distance that Hi-pass vehicles could be changes the lanes for off-ramp. Focusing those considerations, it is proposed not only prefer distance of tubular markers, but also fundamental basic subjects. We anticipate that the results of this study would be useful reference in more safe and efficient tollgate operation of Hi-pass.

• Journal of the Korean Society of Hazard Mitigation
• /
• v.8 no.6
• /
• pp.155-160
• /
• 2008

The urban areas have various landuses such as residential, commercial, industrial and official purposes that are highly concerned with human activities. The other landuses are relating to vehicle activities, which are roads, parking lots, bridges, parks etc. The mainly using landuses by human activities are possessing three different areas that are buildings, parking lots/roads and landscapes. Of these areas, the buildings and landscapes can be classified as non-pollution areas. However, the parking lots or roads are classifying as the main pollution areas because of vehicle activities. Therefore, the landuses arising the nonpoint pollution during a storm in urban areas are roads and parking lots. The vehicles are emitting lots of nonpoint pollutants such as metals and particulate matters and it is impacting on water qualities and aqua-ecosystems nearby the city areas. Therefore, this research was conducted for characterizing the pollutant types and determining the EMCs (Event Mean Concentrations) and unit pollutant loads during a storm. The monitoring was performed on 9 locations such as highways, service area, tollgates, parking lot and bridges. All of the landuses selected for monitoring are concerned with transportation. The results can be effectively used to predict the pollutant loading before urban planning and to select the BMPs (Best Management Practices) for reducing the pollution.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.12 no.4
• /
• pp.22-32
• /
• 2013

Since the percentage of vehicles equipped with Hi-pass, an electronic toll collecting device, has increased rapidly, it is very crucial to determine the optimal location of Hi-pass lanes at a toll plaza in terms of traffic control and operation. In this study, the appropriateness of existing Hi-pass lanes of a toll plaza is evaluated considering its physical geometry and traffic characteristics. A new evaluating criterion called "traffic dispersion rate" is developed in order to measure the level of traffic spreading across the toll booth lanes at a toll plaza. Logistic regression models are constructed to estimate the relationship between the traffic dispersion rate and its affecting variables. The model estimation results show that several variables including Hi-pass lane traffic volume, length of toll plaza, entering/exiting taper lengths, and locations of Hi-pass lanes. The results also suggest that traffic dispersion rate can be increased by adjusting the location of Hi-pass lanes. The study enables us to quantify traffic dispersion rate which can be used to optimize the location and operation of Hi-pass lanes at toll plazas.