• Journal of Navigation and Port Research
• /
• v.30 no.10 s.116
• /
• pp.847-853
• /
• 2006

In this paper, we designed VCO(voltage controlled oscillator} that is composed of a dielectric resonator and a varactor diode, and the PLDRO(phase locked dielectric resonator oscillator) that is combined with the sampling phase detector and loop filter. The results at 12.05 GHz show the output power is 13.54 dBm frequency tuning range approximately +/- 7.5 MHz, and power variation over the tuning range less than 0.2 dB, respectively. The phase noise which effects on bits error rate in digital communication is obtained with -114.5 dBc/Hz at 100 kHz offset from carrier, and The second harmonic suppression is less than -41.49 dBc. These measured results are found to be more improved than those of VCO without adopting PLL, and the phase noise and power variation performance characteristics show the better performances than those of conventional PLL.

• Proceedings of the KIEE Conference
• /
• 1999.07g
• /
• pp.3184-3186
• /
• 1999

In this paper, a new structure of fully differential delay cell VCO using quadrature phase for low phase noise and high speed operation is suggested. It is realized by inserting voltage clamp circuit into input pairs of delay cells that include three-control current source having high output impedance. In this reason. this newly designed delay cell for VCO has the low power supply sensitivity so that the phase noise can be reduced. The whole characteristics of VCO were simulated by using HSPICE and SABER. Simulation results show that the phase noise of new VCO is quite small compared with conventional fully differential delay cell VCO and ring oscillator type VCO. It is also very beneficial to low power supply design because of wide tuning range.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.7 s.337
• /
• pp.63-70
• /
• 2005

We investigated the phase noise of an oscillator with a extremely high-Q resonator used as the resonant element. A TE$_{011}$ mode rutile-loaded resonator with high-temperature superconductive (HTS) $YBa_2Cu_3O_{7-\delta}$(YBCO) films used as the endplates is prepared for this purpose. At 23.5 K, the unloaded Q and the loaded Q are 863000 and 180000, respectively. The phase noise of -104.8 dBc/Hz at 1 KHz offset was observed for the oscillator having a resonator with $Q_{L}$ =180000 at the $TE_{01\delta$ mode resonant frequency of 8.545 GHz at 23.5 K Such oscillators with very low phase noise are expected to be used for building up communication systems capable of efficient use of the frequency band and high-speed data transmission as well as for Doppler radars. Frequency tuning could be realized for the resonator by using a piezoactuator Applicability of the tunable rutile resonator for fabricating tunable oscillators of high performances is discussed.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.14 no.4
• /
• pp.484-494
• /
• 2014

We describe a digitally controlled oscillator (DCO) which compensates the frequency variations for process, voltage, and temperature (PVT) variations with an accuracy of ${\pm}2.6%$ at 2.5 GHz. The DCO includes an 8 phase current-controlled ring oscillator, a digitally controlled current source (DCCS), a process and temperature (PT)-counteracting voltage regulator, and a bias current generator. The DCO operates at a center frequency of 2.5 GHz with a wide tuning range of 2.2 GHz to 3.0 GHz. At 2.8 GHz, the DCO achieves a phase noise of -112 dBc/Hz at 10 MHz offset. When it is implemented in an all-digital phase-locked loop (ADPLL), the ADPLL exhibits an RMS jitter of 8.9 ps and a peak to peak jitter of 77.5 ps. The proposed DCO and ADPLL are fabricated in 65 nm CMOS technology with supply voltages of 2.5 V and 1.0 V, respectively.

• Proceedings of the IEEK Conference
• /
• 1999.11a
• /
• pp.283-286
• /
• 1999

A 2㎓, low noise, low power CMOS voltage-controlled oscillator (VCO) with an integrated LC resonator is presented. The design of VCO relies heavily on the on-chip spiral inductor. An optimized spiral inductor with Q-factor of nearly 8 is achieved and used for the VCO. The simulated result of phase noise is as low as -l14 ㏈c/Hz at an offset frequency of a 600KHz from a 2㎓ carrier frequency. The VCO is tuned with standard available junction capacitors, resulting in an about 400MHz tuning range (20%). Implemented in a five-metal 0.25${\mu}{\textrm}{m}$ standard CMOS process, the VCO consumes only 2㎽ from a single 2.5V supply. It occupies an active area of 620${\mu}{\textrm}{m}$$\times$720${\mu}{\textrm}{m}$.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.10 no.2
• /
• pp.187-195
• /
• 1999

A series feedback DRO operating at 3.2 GHz applicable to the spectrum analyzer as the second local oscillator, is designed and fabricated. We can obtain a low noise by utilizing the small signal S-parameter of the transistor and adjusting the reflection coefficient from the coupling coefficient between dielectric resonator and microstrip line. The results show that output power is 10.50 dBm, a stable low phase noise is -116 dBc/Hz at a 10 kHz offset frequency and a harmonic characteristic is 19.33 dBc.

• Proceedings of the IEEK Conference
• /
• summer
• /
• pp.218-220
• /
• 2004

A new wide-band VCO topology using Miller capacitance is proposed. Contrary to conventional VCO using the Miller capacitance where the variable amplifier gain is negative, the proposed VCO uses both the negative and positive variable amplifier gain to enhance the frequency tuning range significantly. The proposed VCO is simulated using HSPICE. The simulations show that 410MHz and 220MHz frequency tuning range are obtained using the negative .and positive variable amplifier gain, respectively. The tuning range of the proposed VCO is $23\%$ of the center frequency(2.8GHz). The phase noise is -104dBc/Hz at 1MHz offset by simple model. The operating current is only 3.84mA at 2.5V power supply.

• Proceedings of the IEEK Conference
• /
• 2003.11c
• /
• pp.86-89
• /
• 2003

In this paper, Self-Oscillating Mixer is designed by oscillator that was based on a general nonlinear input-output model for the subharmonic injection locked oscillator is analysed. We have designed and fabricated the Self-Oscillating Mixer for 5GHz by proposed subharmonic injection locked oscillator based frequency synthesizer structure that have characteristic of good frequency sensitivity, good phase noise. The design strategy leading to an optimized SILO with regards to its locking range is described and a test SOM circuit is demonstrated a 4dB conversion gain at 280MHz IF frequency from the carrier.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.8
• /
• pp.2029-2036
• /
• 2014

The performance analysis of optoelectronic oscillator(OEO) based on a directly modulated semiconductor laser was theoretically achieved. First, the analysis was performed on the open response of the key components that constitute the OEO loop. Using the results, we simulated the open-loop characteristics of the OEO loop. By combining oscillation conditions of loop oscillator in addition to the open-loop magnitude and phase responses, theoretical performance analysis such as OEO's oscillation frequency, spurious tones and phase noise was successfully completed.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• v.9 no.1
• /
• pp.1057-1060
• /
• 2005

Noises from circuits components and interference with other circuits components generate the phase noise in voltage controlled oscillators (VCO). The effects of the random noise on the phase noise is depending on the instant when the noise enters the VCO. When the noise enters at the transition time of the output of VCO, the effect is most prominent. Using this time variable system, it is revealed that the power spectral density of phase noise of VCO is made of the integrated noise powers of frequency components slightly offset from the fundamental and harmonic frequencies.