• Proceedings of the Korean Vacuum Society Conference
• /
• 2016.02a
• /
• pp.266.2-266.2
• /
• 2016

최근 디스플레이 산업의 확대에 따라 투명 전도 산화물(Transparent Conducting Oxides:TCOs)의 수요가 급증하고 있다. 이 중 ZnO는 wide bandgap (3.37eV)와 large exciton binding energy (60meV)의 값을 가져 차세대 투명 전도 산화물, LED와 LD 등의 소자 소재로 각광받고 있다. ZnO는 electron을 내어놓는 native defect 때문에 기본적으로 n-type 물성을 띈다. 그래서 dopant를 이용해 p-type ZnO를 제작할 때 native defect를 줄이는 것이 중요한 요점이 된다. 이 때 buffer layer를 사용하여 native defect를 줄이는 방법이 사용되고 있다. 본연구에서는 RF-magnetron sputtering법을 이용하여 c-plane sapphire 기판 위에 다양한 조건의 ZnO buffer layer를 증착하고, 그 위에 ZnO:(Al,P) co-doping한 APZO를 증착하였다. ZnO buffer layer 증착조건의 변수는 증착온도와 Ar:O2의 비율을 변수로 두었다. 이러한 박막을 FE-SEM, XRD, Hall effect measurement, AFM을 통하여 미세구조와 물성을 관찰하였다. 이 때 APZO보다 낮은 증착온도에서 ZnO buffer layer가 증착되면 APZO를 증착하는 동안 chamber 내부에서 열처리하는 효과를 얻게 되고, UHV(Ultra High Vaccum)에서 열처리 될 때 ZnO buffer layer의 mophology와 결정성이 변하게 되는 모습을 관찰아혔다. 또한 본 실험을 통해 ZnO buffer layer의 증착 온도가 APZO의 증착온도보다 높을 때 제어 가능한 실험이 됨을 확인 할 수 있었다.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.07a
• /
• pp.290-294
• /
• 2001

In this study, ZnO is evaporated to be coated on n-type Si wafer substrate. Refractive coefficient of thin film that is evaporating TiO$_2$ onto ZnO increases linearly as thickness is getting thinner to have high value and high angle and it satisfies theoretical equation I(x)=Io exp (-$\alpha$x) theory that represents the strength of photon energy advancing through ZnO thin film. And dielectric constant of TiO$_2$ thin film evaporated onto ZnO is high and $\varepsilon$$_2$ is smaller than $\varepsilon$$_1$. The specimen TiO$_2$ thin film evaporated onto ZnO has much higher dielectric constant when photon energy is increased.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.18 no.7
• /
• pp.600-604
• /
• 2005

We studied that structural and optical properties of ZnO films depend on oxygen contents. ZnO films were deposited on Si (111) substrates at room temperature by rf sputtering system and the thickness of films was 100 nm. The ZnO films were annealed in thermal furnace for 2 h at 800 and $900^{\circ}C$ in $H_2O,\;N_2$, and air ambient gases to control oxygen contents. We used AES, PL, XRD, AFM. As our result, crystal quality and luminescence improved until O/Zn is 1. However, when O/Zn ratio Is larger than 1, the structural and optical properties were getting worse.

• Journal of Sensor Science and Technology
• /
• v.15 no.2
• /
• pp.84-89
• /
• 2006

Highly concentrated p-type ZnO thin films can be obtained by doping of N, P and As elements. In this study, undoped ZnO buffer layers were prepared on a (0001) sapphire substrate by a ultra high vaccum pulsed laser deposition(UHV-PLD) method. ZnO buffer layers were deposited with various deposition temperature($400{\sim}700^{\circ}C$) at 350 mtorr of oxygen working pressure. Arsenic doped(1 wt%) ZnO thin films were deposited on the ZnO buffer layers by UHV-PLD. Crystallinity of the samples were evaluated by X-ray diffractometer and scanning electron microscopy. Optical, electrical properties of the ZnO thin films were estimated by photoluminescence(PL) and Hall measurements. The optimal condition of the undoped ZnO buffer layer for the deposition of As-doped ZnO thin films was at $600^{\circ}C$ of deposition temperature.

• Journal of Powder Materials
• /
• v.22 no.6
• /
• pp.391-395
• /
• 2015

We report on the successful fabrication of ZnO nanorod (NR)/polystyrene (PS) nanosphere hybrid nanostructure by combining drop coating and hydrothermal methods. Especially, by adopting an atomic layer deposition method for seed layer formation, very uniform ZnO NR structure is grown on the complicated PS surfaces. By using zinc nitrate hexahydrate $[Zn(NO_3)_2{\cdot}6H_2O]$ and hexamine $[(CH_2)_6N_4]$ as sources for Zn and O in hydrothermal process, hexagonal shaped single crystal ZnO NRs are synthesized without dissolution of PS in hydrothermal solution. X-ray diffraction results show that the ZnO NRs are grown along c-axis with single crystalline structure and there is no trace of impurities or unintentionally formed intermetallic compounds. Photoluminescence spectrum measured at room temperature for the ZnO NRs on flat Si and PS show typical two emission bands, which are corresponding to the band-edge and deep level emissions in ZnO crystal. Based on these structural and optical investigations, we confirm that the ZnO NRs can be grown well even on the complicated PS surface morphology to form the chestnut-shaped hybrid nanostructures for the energy generation and storage applications.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.19 no.8
• /
• pp.769-774
• /
• 2006

In this paper the ZnO thin films, which has used spotlight of next generation short wavelength LEDs and semiconductor laser were deposited based on RF magnetron sputtering is described. The temperature at substrate and work pressure, which has implemented in sputtering process of ZnO thin films were settle down at $100^{\circ}C$ and 15 mTorr respectively. The ZnO 5N has used target. The thickness of ZnO thin films was about $1.6{\mu}m$ which was measured by SEM analysis after the sputtering process. Structural properties of ZnO thin films by in-situ and atmosphere annealing were analyzed by XRD. Transformation of grain size and surface roughness were observed by AFM. XPS spectra showed that ZnO thin film had a peak positions corresponding to the $Zn_{2p}$ and the $O_{1s}$. As form above XPS, we confirmed that post-annealing condition changed the atom ratio of Zn/O and microstructure in ZnO thin films.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.06a
• /
• pp.49-49
• /
• 2008

ZnO-based varistors have been widely used for voltage stabilization or transient surge suppression in electric power systems and electronic circuits. Recently, It has reported that the varistor behavior with nonlinear coefficient of 6~17 in Mn-doped ZnO. In this study we have chosen the composition of ZnO-$TeO_2-Mn_3O_4$ (ZTM) system to the purpose of whether varistor behavior appeared in doped ZnO by the solid state sintering or not. We investigated the sintering and electric properties of 0.5~3.0 at% Mn doped ZnO-1.0 at% $TeO_2$ system. Electrical properties, such as current-voltage (I-V), capacitance-voltage (C-V), and impedance spectroscopy were conducted. $TeO_2$ itself melts at $732^{\circ}C$ in air but forms the $ZnTeO_3$ phase with ZnO as increasing temperature and therefore retards the densification of ZnO to $1000^{\circ}C$. The average grain size of sintered samples was at about $3{\mu}m$ and decreased with increasing Mn contents. It was found that a good varistor characteristics were developed in ZTM system sintered at $1100^{\circ}C$ (nonlinear coefficient $\alpha$ ~ 60). The results of C-V characteristics such as barrier height ($\Theta$), donor density ($N_d$), depletion layer (W), and interface state density ($N_t$) in ZTM ceramics were $4\times10^{17}cm^{-3}$, 0.7 V, 40 nm, and $1.6\times10^{12}cm^{-2}$, respectively. It will be discussed about the stability and homogeneity of grain boundaries using distribution parameter ($\alpha$) simulated with the Z(T)"-logf plots in ZTM system.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2007.08b
• /
• pp.1298-1300
• /
• 2007

The interface between SiNx and ZnO was investigated with Near Edge X-ray Absorption Fine Structure (NEXAFS) for ZnO based thin film transistor (TFT) applications. Impurity species were interstitial $N_2$ molecules at the SiNx / ZnO interface. The evolution of $N_2$ is decreased with increasing of anneal temperature.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.18 no.3
• /
• pp.231-236
• /
• 2005

To investigate the electrical properties at the single grainboundary of ZnO varistors, micro-electrodes were fabricated on the surface which was polished and thermally etched. Our micro-electrode had 2000 $\AA$ silicon nitride layer between micro-electrode and ZnO surface. This layer was deposited by PECVD and etched by RIE after photoresistor pattering process using by mask 1. The metal patterning of micro-electrodes used lift-off method. We found that the breakdown voltage of single grainboundary is about 3.5∼4.2 V at 0.1 mA on I-V curves. Also, capacitance-voltage measurement at single grainboundary gave several parameters( $N_{d}$, $N_{t}$, $\Phi$$_{b}$, t) which were related with grainboundary.ary.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1999.11a
• /
• pp.95-98
• /
• 1999

ZnO thin films on (001) sapphire substrates have been deposited by pulsed laser deposition technique using a Nd:YAG laser with the wavelength of 355 nm. In order to investigate the effect of the deposition conditions on the properties of ZnO thin films at an oxygen pressure of 350 mTorr, the experiment has been Performed at various substrate temperatures in the range of 20$0^{\circ}C$ to $700^{\circ}C$. According to XRD, (002) textured ZnO films of high crystalline quality have been obtained and the intensity of UV emission was the highest at 40$0^{\circ}C$ substrate temperature.