• Journal of Magnetics
• /
• v.16 no.4
• /
• pp.332-336
• /
• 2011

We studied the effect on the electronic and magnetic properties of the N defect in clean and Cu-doped wurtzite III-nitrides by using the first-principles calculations. When it is doped two Cu atoms in the nearest neighboring sites, the system of AlN, GaN, or InN with the N vacancy is energetically more favorable than that without the N vacancy site. When the Cu concentration increases, the total magnetic moment of a supercell becomes small. The ferromagnetism of Cu atom is very low due to the weak 3d-3d coupling. It is noticeable that the spin-exchange interaction between the Cu-3d and N defect states is important.

• Proceedings of the Korean Magnestics Society Conference
• /
• 2002.12a
• /
• pp.94-95
• /
• 2002

Recently, we have seen a rapid advance in the evolving field of spin electronics (or spintronics). In spintronics, some feasibilities of new electronic applications utilizing spin degree of freedom have been explored. Diluted magnetic semiconductors (DMSs) are premising materials for spintronics because they have both charge and spin degree of freedom in a single substance. DMSs are refereed to semiconductor alloys in which some atoms are randomly substituted for by magnetic atoms. (omitted)

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.4 no.4
• /
• pp.312-317
• /
• 2004

High dose ($3{\times}10^{16}cm^{-2}$) implantation of Fe or Ni ions into bulk, single-crystal ZnO substrates was carried out at substrate temperature of ${\sim}350^{\circ}C$ to avoid amorphization of the implanted region. The samples were subsequently annealed at $700^{\circ}C$ to repair some of the residual implant damage. X-Ray Diffraction did not show any evidence of secondary phase formation in the ZnO. The Ni implanted samples remained paramagnetic but the Fe-implanted ZnO showed evidence of ferromagnetism with an approximate Curie temperature of ${\sim}$240K. Preliminary X-Ray Photoelectron Spectroscopy measurements showed the Fe to be ill the 2+ oxidation state. The earrler density in the implanted region still appears to be too low to support carrier-meditated origin of the ferromagnetism and formation of bound magnetic polarons may be one potential explanation for the observed magnetic properties, No evidence of the Anomalous Hall Effect could be found in the Fe-implanted ZnO, but its transport properties were dominated by the conventional or ordinary Hall effect.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2006.11a
• /
• pp.792-796
• /
• 2006

In recent years, the semiconductor industry and the optical industry is developed rapidly. The recent demand has expanded for optical components such as a optical lens, a optical semiconductor and a measuring instrument. Object transport systems are driven typically by the magnetic field and the conveyer belt. Recent industry requires more faster and efficient transport system. However, conventional transport systems are not adequate for transportation of optical elements and semiconductors. Because conveyor belts can damage precision optical elements by the contact force and magnetic systems can destroy the inner structure of semiconductor by the magnetic field. In this paper, the levitation transport system using ultrasonic wave is developed for transporting precision elements without damages. This transport system is using 2-mode ultrasonic wave excitation and flexural beam modes shapes are evaluated. It compared simulation results with experimental results

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2006.05a
• /
• pp.331-332
• /
• 2006

Transport systems which are the important part of the factory automation have much influence on improving productivity. Object transport systems are driven typically by the magnetic field and conveyer belt. In recent years, as the transmission and processing of information is required more quickly, demands of optical elements and semiconductors increase. However, conventional transport systems are not adequate for transportation of those. The reason is that conveyor belts can damage precision optical elements by the contact force and magnetic systems can destroy the inner structure of semiconductor by the magnetic field. In this paper, the levitation transport system using ultrasonic wave is developed for transporting precision elements without damages. Vibration modes of each flexural beam are verified by using Laser Scanning Vibrometer.

• Journal of Magnetics
• /
• v.12 no.4
• /
• pp.144-148
• /
• 2007

We report on the observation of p-type conductivity and ferromagnetism in diluted magnetic semiconductor $(Zn_{0.97}Mg_{0.01}Mn_{0.02})O:P$ films grown on $SiO_2/Si$ substrates by pulsed laser deposition. The p-type conduction with hole concentration over $10^{18}cm^{-3}$ is obtained by codoping of Mg and P followed by rapid thermal annealing in an $O_2$ atmosphere. Structural and compositional analyses for the p-type $(Zn_{0.97}Mg_{0.01}Mn_{0.02})O:P$ films annealed at $800^{\circ}C$ indicates that highly c-axis oriented homogeneous films were grown without any detectable formation of secondary phases. The films were found to be transparent in the visible range. The magnetic measurements clearly revealed an enhancement of room temperature ferromagnetism by p-type doping.

• Journal of Magnetics
• /
• v.13 no.3
• /
• pp.88-91
• /
• 2008

This study examined the effect of Sn co-doping on the transport and magnetic properties of Cr-doped $In_2O_3$ thin films grown on (100) silicon substrates by pulsed laser deposition. The experimental results showed that Sn co-doping enhances the magnetization and appearance of the anomalous Hall effect, and increases the carrier (electron) concentration. These results suggest that the conduction carrier plays an important role in enhancing the ferromagnetism of a laser-deposited Cr-doped $In_2O_3$ film, which may have applications in transparent oxide semiconductor spin electronics devices.

• Journal of Magnetics
• /
• v.13 no.1
• /
• pp.23-29
• /
• 2008

The magnetic and other physical characteristics of $Mn_xSi_{1-x}Te$ have been investigated by electron magnetic resonance (EMR), X-ray diffraction (XRD) and other experiments. $Mn_xSi_{1-x}Te$ is found to have corundum structure for manganese contents up to 10% and also to be ferromagnetic for temperatures below 80 K. While ferromagnetic resonance signal coexists with the usual paramagnetic resonance signal, invariance of the g-factor inferred from the electron paramagnetic resonance signals throughout all temperature ranges clearly confirms that the manganese ions are in the electronic 3d5 state. The temperature dependence of EMR line-width is the same as other diluted magnetic semiconductors. From the EMR signals relaxation times $T_2$ and $T_1$ of $Mn_xSi_{1-x}Te$ compounds are estimated to be about $4.4{\times}10^{-10}s$ and $9.3{\times}10^{-8}s$ respectively and are found to vary slightly with temperature or composition change. Exchange narrowing of the EMR line-width becomes dominant for the sample in which the substitution ratio, x = 30%. For one sample, in which x = 0.5%, spin glass-like behavior is indicated by EMR signals for temperatures lower than 60 K. This behavior may authentic for samples within a certain range of x.

• Journal of the Korean Magnetics Society
• /
• v.15 no.3
• /
• pp.181-185
• /
• 2005

We have investigated the effects of Al codoping on the structural, electrical transport, and magnetic properties of oxide diluted magnetic semiconductor $Zn_{1-x}Cr_xO$ thin films prepared by reactive sputtering. Nondoped $Zn_{0.99}Cr_{0.01}O$ thin films show semiconducting transport behavior and weak ferromagnetic characteristic. The Al doping increases the carrier concentration and results in an decrease of resistivity and metal-insulator transition behavior. With increasing carrier concentration, the magnetic properties drastically change, exhibiting a remarkable increase of the saturation magnetization. These results show carrier-enhanced ferromagnetic order in Cr-doped ZnO.

• Journal of Sensor Science and Technology
• /
• v.27 no.4
• /
• pp.237-241
• /
• 2018

The real-time enrichment and detection of pathogens are serious issues and rapidly evolving field of research because of the ability of these pathogens to cause infectious diseases. In general, bacterial detection is accomplished by conventional colony counting or by polymerase chain reaction (PCR) after DNA extraction. As colony counting requires considerable time to cultivate, PCR is an attractive method for rapid detection. A small number of pathogens can cause diseases. Hence, a pretreatment process, such as enrichment is essential for detecting bacteria in an actual environment. Thus, in this study, we developed a microfluidic chip capable of performing rapid enrichment of bacteria and the extraction of their genes. A lectin, i.e., Concanavalin A (ConA), which shows binding affinity to the surface of most bacteria, was coated on the surface of magnetic particles to nonspecifically capture bacteria. It was subsequently concentrated through magnetic forces in a microfluidic channel. To lyse the captured bacteria, magnetic particles were irradiated by a wavelength of 532nm. The photo-thermal effect on the particles was sufficient for extracting DNA, which was consequently utilized for the identification of bacteria. Our device will help monitor the existence of bacteria in various environmental situations such as water, air, and soil.