• Progress in Superconductivity and Cryogenics
• /
• v.4 no.1
• /
• pp.89-93
• /
• 2002

We investigated the resistance distribution n 4"diameter SFCLS. $YBa_2CU_3O_7$ films coated in-situ with a gold layer were patterned into 3 mm wide 142 cm long meander lines by Photolithography. The limiters were tested with simulated fault currents. The resistance was uniform all over the film except at the edge. At lower source voltages, CFCLs did not quench simultaneously and the resistance distribution was less uniform. Compared with 2" diameter SFCLS 4" SFCLS had similar values and time dependence of resistivity at similar electric fields The resistance distribution was more uniform in 4" SFCLS. The area at the edge where the distribution was not uniform was around 3 mm wide in SFCLs of both sizes. The experimental results were quantitatively explained with a heat transfer concept.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.6
• /
• pp.1706-1712
• /
• 2014

The OH($X^2{\Pi}$, ${\upsilon}^{\prime\prime}=0,1$) internal state distribution following the reaction of electronically excited oxygen atom ($O(^1D_2)$) with cyclo-$C_3H_6$ has been measured using laser-induced fluorescence, and compared with that following the reaction of $O(^1D_2)$ with $C_3H_8$. The overall characteristics of the OH internal energy distributions for both reactions were qualitatively similar. The population propensity of the ${\Pi}(A^{\prime})$ ${\Lambda}$-doublet sub-level suggested that both reactions proceeded via an insertion/elimination mechanism. Bimodal rotational population distributions supported the existence of two parallel mechanisms for OH production, i.e., statistical insertion and nonstatistical insertion. However, detailed analysis revealed that, despite the higher exoergicity of the reaction, the rotational distribution of the OH following the reaction of $O(^1D_2)$ with $C_3H_8$ was significantly cooler than that with cyclo-$C_3H_6$, especially in the vibrational ground state. This observation was interpreted as the effect of the flexibility of the insertion complex and faster intramolecular vibrational relaxation (IVR).

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.12
• /
• pp.2899-2904
• /
• 2015

This paper introduces about the effect on $I_{DS}-V_{GS}$ characteristic of transistor that interface trap charge is created by damage due to heat in a 3D sequential inverter. A interface trap charge distribution in oxide layer in a 3D sequential inverter is extracted using two-dimensional device simulator. The variation of threshold voltage of top transistor according to the gate voltage variation of bottom transistor is also described in terms of Inter Layer Dielectric (ILD) length of 3D sequential inverter, considering the extracted interface trap charge distribution. The extracted interface trap density distribution shows that the bottom $HfO_2$ layer and both the bottom and top $SiO_2$ layer were relatively more affected by heat than the top $HfO_2$ layer with latest process. The threshold voltage variations of the shorter length of ILD in 3D sequential inverter under 50nm is higher than those over 50nm. The $V_{th}$ variation considering the interface trap charge distribution changes less than that excluding it.

• Journal of the Korean Magnetics Society
• /
• v.3 no.1
• /
• pp.18-22
• /
• 1993

The cationic distributions and magnetic properties of $Cu_{x}Zn_{1-x}Fe_{2}O_{4}(0{\leq}x{\leq}1)$ have been studied by X-ray diffraction and $M\"{o}ssbauer$ spectroscopy. The crystal structures are cubic spinels in the range $0{\leq}x{\leq}0.9$. The ionic distribution of ${(Zn_{1-x}Fe_{x})}_{A}{[Zn_{x}Fe_{2-x}]}_{B}O_{4}$, where x=0.1. The distribution of $Fe^{3+}$ ions was extracted from the $M\"{o}ssbauer$ spectra below Curie temperature in the whole range $0{\leq}x{\leq}1$. The number of $Fe^{3+}$ ions in the tetrahedral sites and Curie temperature of Cu-Zn ferrite increase with increasing Cu-concentration.

• Journal of the Korean Ceramic Society
• /
• v.42 no.6 s.277
• /
• pp.384-390
• /
• 2005

[ ${\alpha}-Al_2O_3$ ] precursor was synthesised by sol-gel method using aluminum sulfate, sodium sulfate and sodium carbonate as law materials. The flaky ${\alpha}-Al_2O_3$ crystals were prepared by heating using precursor about $1,050^{\circ}C$. In this study, the effect of some transition-metal sulfate ($FeSO_4,\;SnSO_4,\;ZnSO_4$) addition have been investigated. When iron sulfate was added, it could see that act on impurities in crystal growth process. In case of tin sulfate, distribution of Platelets was very broad. When flaky ${\alpha}-Al_2O_3$ crystals were prepared zinc sulfate addition, thickness, size, and distribution of platelets was suited to industrial application. The average diameter of flaky ${\alpha}-Al_2O_3$ crystals was about 20 $\mu$m, and its thickness was about 0.3 $\mu$m. Increasing addition of zinc sulfate, thickness of ${\alpha}-Al_2O_3$ platelet was decreased.

• Resources Recycling
• /
• v.21 no.5
• /
• pp.65-71
• /
• 2012

The equilibrium distribution of bismuth and lead between molten PbO-$SiO_2$ slag and bismuth phase was studied in the temperature range of $775^{\circ}C$ to $850^{\circ}C$ in a MgO crucible. The oxygen partial pressure of atmosphere was controlled by $P_{CO2}/P_{CO}$ ratio. The value of $(%PbO)_{slag}/[%Pb]_{metal}$ increased with increasing $SiO_2$ content of slag, and the value of $(%Bi_2O_3)_{slag}/[%Bi]_{metal}$ decreased with increasing $SiO_2$ content of slag. The concentration of Pb in metal increased with increasing temperature. These experimental results agreed well with the thermodynamic prediction.

• Electrical & Electronic Materials
• /
• v.8 no.3
• /
• pp.324-331
• /
• 1995

0.36[wt%l $SiO_{2}$ and 0.1[wt%] $H_{3}$B $O_{3}$ were added to strontium ferrite magnets of the magnetoplumbite phase SrO.5.7F $e_{2}$ $O_{3}$ to hinder grain growth and accelerate sintering, respectively. This experiment was carried out to investigate effect of particle size distribution as a function of milling time(20, 30, 40, 50, 60, 70 hours) on the magnetic properties of SrO.5.7F $e_{2}$ $O_{3}$ ferrite magnet. The B-H curve, density and the degree of orientation were measured. And the microstructure of ferrite magnets was examined with a SEM. The optimal conditions and properties of the typical sample are the following : The milling time was 60 hours. Magnetic and physical properties are $B_{r}$=4, 000[G], $_{b}$ $H_{c}$=3, 330[Oe], (BH)max=3.786[MGOe], $_{I}$ $H_{c}$=3, 525[Oe], density=5.0063[g/c $m^{3}$] and orientation factor f=0.813.0.813.3.3.

• Applied Chemistry for Engineering
• /
• v.10 no.4
• /
• pp.509-514
• /
• 1999

In Preparing $BaTiO_3$ powder under hydrothermal conditions, effects of reaction period feedstock concentration and mixing rate on crystallinity, mean size and size distribution of particles were studied. Experimental results showed that the particle size became smaller with its narrow distribution as the reaction period and mixing rate increased, but feedstock concentration decreased in contrast with the results based on the classical nucleation-growth model. From these results, $BaTiO_3$ particles seem to be prepared hydrothermally through a multiple reaction procedure that includes dissolution, precipitation, hydrolysis-condensation, aggregation, diffusion and transformation.

• Journal of the Korean Ceramic Society
• /
• v.24 no.3
• /
• pp.263-269
• /
• 1987

It is investigated that the determination of the correlation between the change of microstructure and electrical properties. Yttria is added to the compositiojn of rhombohedral region in Pb(Mg1/3Nb2./3)O3-PbTiO3-PbZrO3 ternary system. Average grian size, lattice parameters and distribution of yttrium are characterized by XRD, SEM and EDS. Electrical properties are determined by measurement of Curie temperature, piezoelectric properties and hysteresis loops. The results are as follows; 1. Both lattice parameters, a and ${\alpha}$, are changed by addition of yttria to the composition of rhomboheadral region in Pb(Mg1/3Nb2./3)O3-PbTiO3-PbZrO3 ternary system and Curie temperature is proportional to the values at (90-${\alpha}$).

• Journal of Korean Society for Atmospheric Environment
• /
• v.10 no.2
• /
• pp.124-129
• /
• 1994

Aerosol size distribution was determined using Anderson sampler for the anions( sulfate nitrate and chloride ) and TSP. Ionic species concentration and size distribution have been investigated in the daytime and nightime individually. Size classified samples were extracted with distilled water and analyzed for C $l^{[-10]}$ , N $O_3$$^{[-10]}$ and S $O_4$$^{2-}$, by ion chromatography. The size distribution of these ions and TSP was analyzed to investigate the seasonal and diurnal variation of concentrations as follows: (1)Size distribution of TSP showed bi- modal type in the daytime, but indicated tri-mode distribution in the nightime without any seasonal variation. (2)Sulfate concentrations were higher in fine- mode both in the daytime and nightime but fraction of sulfate was higher in coarse-mode during the Yellow Sand Period. (3)Nitrate and Chloride ions are dominant in fine-mode in winter while dominant in coarse-mode in the summer.