• Korean Journal of Clinical Laboratory Science
• /
• v.37 no.3
• /
• pp.212-215
• /
• 2005

Carpal tunnel syndrome (CTS) is the most common entrapment neuropathy in clinical practice, with a 0.1% life time risk in the general population. Conventional neurophysiological studies have been useful in the diagnosis of this condition, as have a number of more specialized procedures. Therefore, we evaluated the diagnostic sensitivities of several parameters in nerve conduction technique for CTS patients. We analyzed 100 patients (159 hands) who were diagnosed with CTS clinically and electrophysiolosically. Median motor and sensory nerve conduction velocities (MCV and SCV) with wrist, palm, and finger stimulation were performed in traditional methods. Sensitivities of each test were calculated and compared to normal control data. The sensitivities of existing nerve conduction method were noted in terminal latency on median nerve, 2nd finger-wrist segment, 3rd finger-wrist segment, palm-wrist segment and distoproximal ratio, as 72.96%, 92.45%, 94.34%, 94.97%, and 97.48%, respectively. In the early course of CTS, sensory nerve conductions in the median nerve are more valuable than motor nerve conduction. Sensory nerve conductions are usually affected before motor nerve conductions in CTS. In this study, we detected that slowing of median SCV was the most frequent in the distoproximal ratio.

• Journal of Power Electronics
• /
• v.18 no.2
• /
• pp.640-650
• /
• 2018

A TRIAC dimmable LED driver with a wide tuning range and a two-stage uniform dimming scheme is proposed in this paper. To solve the restricted dimming range problem caused by the limited conduction ratio of TRIAC dimmers, a conduction ratio compensation technique is introduced, which can increase the output current up to the rated output current when the TRIAC dimmer turns to the maximum conduction ratio. For further optimization, a two-stage uniform dimming diagram with a rapid dimming curve and a slow dimming curve is designed to make the LED driver regulated visually uniform in the whole adjustable range of the TRIAC dimmer. The proposed control chip is fabricated in a TSMC $0.35{\mu}m$ 5V/650V CMOS/LDMOS process, and verified on a 21V/500mA circuit prototype. The test results show that, in the 90V/60Hz~132V/60Hz ac input range, the voltage linear regulation is 2.6%, the power factor is 99.5% and the efficiency is 83%. Moreover, in the dimming mode, the dimming rate is less than 1% when the maximum dimming current is 516mA and the minimum dimming current is only about 5mA.

• Journal of the Korea Society of Computer and Information
• /
• v.20 no.12
• /
• pp.67-74
• /
• 2015

The heat conduction equation, a type of a Poisson equation which can be applied in various areas of engineering is calculating its value with the iteration method in general. The equation which had difference discretization of the heat conduction equation is the simultaneous equation, and each line has the characteristic of expressing in sparse matrix of the equivalent number of none-zero elements with neighboring grids. In this paper, we propose a data structure for sparse matrix that can calculate the value faster with less memory use calculate the heat conduction equation. To verify whether the proposed data structure efficiently calculates the value compared to the other sparse matrix representations, we apply the representative iteration method, CG (Conjugate Gradient), and presents experiment results of time consumed to get values, calculation time of each step and relevant time consumption ratio, and memory usage amount. The results of this experiment could be used to estimate main elements of calculating the value of the general heat conduction equation, such as time consumed, the memory usage amount.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2008.10a
• /
• pp.1487-1493
• /
• 2008

The frost heaving is related with thermal conduction rate and permeability. If the thermal conduction rate can be controlled, it is effective to prevent from frost heaving. If soil mixed with shredded tire which has relatively lower thermal conduction rate than soil, it helps preventing from frost heaving. However, in this case, the shear strength can get weak. In this study, we compared thermal conduction rate of soil and shredded tire, and test uniaxial compression strength of soil which is mixed with shredded tire and cement in different ratio.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2003.11a
• /
• pp.481-484
• /
• 2003

This study is intended to investigate application of mica waste(MS) to fine aggregate for mortar by comparing it with cement mortar in which crushed sand(CS) and river sand(NS) are used. According to the results, as the physical properties of aggregate, specific gravity is large in order of MS, NS and CS, absorption ratio in order of MS, CS and NS, and unit weight and solid volume percentage in order of NS, CS and MS. In the case of MS mortar, mechanical properties, drying shrinkage and heat conduction ratio are reduced, but the radiative amount of infrared light is excellent compared with NS mortar. Fluidity and unit weight of MS mortar is larger than those of CS mortar, and strength does not make differences. Length change by drying shrinkage is larger, but heat conduction ratio and radiative amount of infrared light are smaller than CS mortar. Thus, it proves that MS can be used in place of NS and CS, but its quality is deteriorated slightly.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.35 no.4
• /
• pp.348-352
• /
• 2022

Resistive switching behaviors of a co-sputtered zinc silicate thin film (ZnO and SiO₂ targets) have been investigated. We fabricated an Ag/ZnSiO_x/highly doped n-type Si substrate device by using an RF magnetron sputter system. X-ray diffraction pattern (XRD) indicated that the Zn₂SiO₄ was formed by a post annealing process. A unique morphology was observed by scanning electron microscope (SEM) and atomic force microscope (AFM). As a result of annealing process, 50 nm sized nano clusters were formed spontaneously in 200~300 nm sized grains. The device showed a unipolar resistive switching process. The average value of the ratio of the resistance change between the high resistance state (HRS) and the low resistance state (LRS) was about 106 when the readout voltage (0.5 V) was achieved. Resistance ratio is not degraded during 50 switching cycles. The conduction mechanisms were explained by using Ohmic conduction for the LRS and Schottky emission for the HRS.

• Proceedings of the KIPE Conference
• /
• 2003.07a
• /
• pp.477-480
• /
• 2003

Generally, 2 phase excited brushless DC motor(BLDCM) operates only in the region of constant trapezoidal back-EMF on each phase. Therefore the efficiency decreases in comparison with 3phase excited BLDCM. This paper proposes the relation between the usage ratio of voltage and the change of fewer delivery of BLDCM according to extension of conduction intervals.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.3
• /
• pp.581-586
• /
• 2015

This paper has analyzed the variation of subthreshold swing for the ratio of channel length and thickness for asymmetric double gate MOSFET. The asymmetric double gate MOSFET has the advantage that the factors to control the short channel effects increase since top and bottom gate structure can be fabricated differently. The degradation of transport property due to rapid increase of subthreshold swing can be specially reduced in the case of reduction of channel length. However, channel thickness has to be reduced for decrease of channel length from scaling theory. The ratio of channel length vs. thickness becomes the most important factor to determine subthreshold swing. To analyze hermeneutically subthreshold swing, the analytical potential distribution is derived from Poisson's equation, and conduction path and subthreshold swing are calculated for various channel length and thickness. As a result, we know conduction path and subthreshold swing are changed for the ratio of channel length vs. thickness.

• Journal of Cardiovascular Imaging
• /
• v.30 no.1
• /
• pp.62-75
• /
• 2022

BACKGROUND: Due to its location very close to the bundle of His, mitral annulus calcification (MAC) might be associated with the development of atrioventricular (AV) conduction disturbances. This study assessed the association between MAC and AV conduction disturbances identified by cardiac implantable electronic device (CIED) use and electrocardiographic parameters. The association between MAC and traditional cardiovascular risk factors was also assessed. METHODS: This cross-sectional study analyzed 14,771 participants, predominantly men aged 60-75 years, from the population-based Danish Cardiovascular Screening trial. Traditional cardiovascular risk factors were obtained. Using cardiac non-contrast computed tomography imaging, MAC scores were measured using the Agatston method and divided into absent versus present and score categories. CIED implantation data were obtained from the Danish Pacemaker and Implantable Cardioverter Defibrillator Register. A 12-lead electrocardiogram was available for 2,107 participants. Associations between MAC scores and AV conduction disturbances were assessed using multivariate regression analyses. RESULTS: MAC was present in 22.4% of the study subjects. Participants with pacemakers for an AV conduction disturbance had significantly higher MAC scores (odds ratio [OR], 1.11; 95% confidence interval [CI], 1.01-1.23) than participants without a CIED, whereas participants with a CIED for other reasons did not. Prolonged QRS-interval was significantly associated with the presence of MAC (OR, 1.45; 95% CI, 1.04-2.04), whereas prolonged PQ-interval was not. Female sex and most traditional cardiovascular risk factors were significantly associated with high MAC scores. CONCLUSIONS: MAC was associated with AV conduction disturbances, which could improve our understanding of the development of AV conduction disturbances.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.54 no.1
• /
• pp.23-29
• /
• 2005

This paper presents the characteristics of leakage currents flowing through ZinC Oxide(ZnO) surge arrester blocks under mixed direct and 60 Hz alternating voltages. A mixed voltage, in which an alternating voltage is superimposed upon a direct voltage, appears on the HVDC system network. The mixed direct and alternating voltage generator with a peak open-circuit of 10 kV was designed and fabricated. The leakage currents and V-I curves for the fine and used ZnO surge arrester blocks were measured as a function of the voltage ratio k, where the voltage ratio k is defined as the ratio of the peak of alternating voltage to the peak of the mixed voltages. The resistive component in the leakage current in the low conduction region is significantly increased with increasing the voltage ratio k. The V-I characteristic curves for the mixed voltages lies between the direct and alternating characteristics, and the cross-over phenomenon in the high conduction region was appeared.