• Journal of the Korea Concrete Institute
• /
• v.20 no.3
• /
• pp.375-381
• /
• 2008

Various problems such as durability degradation may happen when extra water is added to concrete. Because of these reasons, the change of water content is managed by using rapid evaluation method of unit water content such as electric capacity method, heat drying method making use of micro wave, unit capacity mass method among various methods. Especially, in Japan, guidance for the change of water content ($\pm$ 10, 15, 20 kg/$m^3$ etc.) were regulated and used. However, it is the real situation that the guidance which were regulated in South Korea evaluate suitability only considering production and measurement error under the circumstances which are not considering the degree of durability degradation. Therefore, this study tries to investigate the influence of addition of extra water in the concrete on the durability degradation of concrete when it was added by artificial manipulation or by management error. From the test results, a guideline of the contents of extra water for the quality control is suggested with the consideration of the degree of durability degradation and the probable error resulted from the addition of extra water. The contents of extra water for tests are set as 0, 15, 25, 35 kg/$m^3$. To examine the durability degradation of concrete, freezing and thawing, carbonation, chloride penetration and compressive strength are tested.

• Journal of Biomedical Engineering Research
• /
• v.25 no.6
• /
• pp.439-445
• /
• 2004

Diffusion tensor image(DTI) exploits the random diffusional motion of water molecules. This method is useful for the characterization of the architecture of tissues. In some tissues, such as muscle or cerebral white matter, cellular arrangement shows a strongly preferred direction of water diffusion, i.e., the diffusion is anisotropic. The degree of anisotropy is often represented using diffusion anisotropy indices (relative anisotropy(RA), fractional anisotropy(FA), volume ratio(VR)). In this study, FA images were obtained using different gradient schemes(N=6, 11, 23, 35. 47). Mean values and the standard deviations of FA were then measured at several anatomic locations for each scheme. The results showed that both mean values and the standard deviations of FA were decreased as the number of gradient directions were increased. Also, the standard error of ADC measurement decreased as the number of diffusion gradient directions increased. In conclusion, different gradient schemes showed a significantly different noise performance and the schem with more gradient directions clearly improved the quality of the FA images. But considering acquisition time of image and standard deviation of FA, 23 gradient directions is clinically optimal.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.49 no.3
• /
• pp.8-14
• /
• 2012

Improving the speed of image processing is in great demand according to spread of high quality visual media or massive image applications such as 3D TV or movies, AR(Augmented reality). SIMD computer attached to a host computer can accelerate various image processing and massive data operations. MAMS is a multi-access memory system which is, along with multiple processing elements(PEs), adequate for establishing a high performance pipelined SIMD machine. MAMS supports simultaneous access to pq data elements within a horizontal, a vertical, or a block subarray with a constant interval in an arbitrary position in an $M{\times}N$ array of data elements, where the number of memory modules(MMs), m, is a prime number greater than pq. MAMS-PP4 is the first realization of the MAMS architecture, which consists of four PEs in a single chip and five MMs. This paper presents implementation of image processing algorithms and performance analysis for MAMS-PP16 which consists of 16 PEs with 17 MMs in an extension or the prior work, MAMS-PP4. The newly designed MAMS-PP16 has a 64 bit instruction format and application specific instruction set. The author develops a simulator of the MAMS-PP16 system, which implemented algorithms can be executed on. Performance analysis has done with this simulator executing implemented algorithms of processing images. The result of performance analysis verifies consistent response of MAMS-PP16 through the pyramid operation in image processing algorithms comparing with a Pentium-based serial processor. Executing the pyramid operation in MAMS-PP16 results in consistent response of processing time while randomly response time in a serial processor.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.18 no.7
• /
• pp.490-499
• /
• 2017

In recent years, the introduction of complex systems analysis based on various variables has become more active in order to identify and analyze complex problems of Modern Society. Prediction of patients' spatial perception and usability according to the spatial arrangement of the outpatient department is a very important factor for providing high quality hospital service. For objective analysis, the standard program procedure and analysis index for the diseases of the elderly were prepared and the uniformity of the atmospheric space was evaluated through heat map analysis and quantitative analysis. In this study, 73 cells were installed and simulated to analyze the uniformity of the four alternatives according to the change of the arrangement of the medical care space, receiving space, and consultation space using the complex system analysis method for the nursing hospitals. The resulting density was derived. The results are as follows. 1)The layout of the reception space has the greatest influence on the total spatial density of the waiting space. 2) The uniformity of the waiting space can be increased by separating the examination space and the examination space. 3)The closer the location of the receiving space is from the entrance, the greater the density of the waiting space. Finally, this study applied discrete event simulation to the evaluation of uniformity of atmosphere space, and proved that the actor - based model can be utilized for utilization and evaluation as spatial analysis methodology.

• Journal of Bio-Environment Control
• /
• v.21 no.4
• /
• pp.445-451
• /
• 2012

The thinning effects of lime sulfur either alone or combined with fish oil on two apple cultivars 'Fuji'/M.9 and 'Hongro'/M.9 were investigated during two consecutive seasons. Either 1% or 2% lime sulfur at full bloom decreased the amounts of both terminal and axillary fruits compared with unsprayed 'Fuji' control trees in the first year. However, 1% or 2% lime sulfur did not decrease terminal fruit set in the second year. Only, triple applications of 1% lime sulfur significantly reduced the number of terminal and axillary fruits in both years. Multiple application of 1% lime sulfur was the most effective in thinning of 'Hongro'. In the first year, double or triple applications of 1% lime sulfur was effective in thinning terminal or axillary fruit, but one time applications of 1% or 2% lime sulfur was not reduced axillary fruit in 'Hongro' apple trees. In the second season, all treatments reduced terminal or axillary fruit in 'Hongro' clusters, except single application of 1% lime sulfur. Fish oil did not always improve the thinning effects of lime sulfur in 'Fuji' or 'Hongro' apple trees. None of treatments caused significant russeting in the harvested fruits. Most of thinning treatments had little effect on 'Fuji' or 'Hongro' fruit quality in terms of fruit weight, firmness, soluble solids concentration or titratable acidity.

• Archives of design research
• /
• v.17 no.1
• /
• pp.37-48
• /
• 2004

Keiji Kobo is a unique self-generated design research group in Japan, which was founded in 1928 when Bauhaus movement was in its peak, and which lasted ten years until the end of the Second World War, when any activity of the group became virtually impossible due to the war. With insight to see the future, the group aimed at Modern Design advocating a new spirit in architecture, and played a significant role in prosperity of Japanese Modern Design assimilating Western design trends. Pursuing of craft works for everyday life--practical furniture works--Keiji Kobo actively executed various projects to realize modern philosophy. The range of the works of this group was very large: survey, mock-up, experiment, research, exhibition, lecture, order-based sale, advertising and writing. The works of the group were oriented to serious academicism, not compromising with commercialism. Considering the peculiar political situation such as Japanese Militarism, the spirit of functionalism that the group pursued was surprisingly academical and pure. This group was relatively small and clumsy, which lasted as short as around ten years. However, strong motivation was in their seemingly quiet movements, and the influence of the group cannot be underestimated even with today's criteria. There were a number of pioneers who contributed to today's prosperity of Japan and Keiji Kobo can be estimated to be one of the pioneers in the field of design. It was found that the contemporary intellectuals hoped that the committment and activity of the group would contribute to modernization of the life quality of ordinary people. In a sense, Keiji Kobo can be estimated to be a little Japanese equivalent for Bauhaus that could not fully bloom.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.18 no.6
• /
• pp.22-30
• /
• 2004

It is an attempt to suggest the standard valuation method of the environmental illumination for the bridges across the Han-river from an aesthetic point of view, deviating from the technical and traditional viewpoint. In Korea the current evaluation criterion to verify the value of bridge design has a partiality for the technical and structural safety rather than the sentient beauty on the whole. However, the recently cultural reform of Korean mass society with the elevation of the standard of living forces the engineering designers for bridges to focus not only on competing physical structures but also on enhancing the formative beauty including the illumination effects for night view. Additionally, the new policy, which transforms the environments around the Han-river into the major tourist attractions has been executing strongly by the city authorities to revitalize the symbolic, historic, and cultural identity of the capital city with the introduction of the high-quality environmental illumination for the bridges. As a result, It becomes necessary to establish the manual and standardization of the environmental illumination planning for the city in terms of the formative beauty, and this study is to suggest the valuation model method of the environmental illumination for the bridges as the initial step of the standardization. In the study, the valuation items of the standard questionnaire are selected by the documentary records and the consultation of various experts in architecture, design, fine art, urban planning and even administration to verify the essential elements of the aesthetic beauty with the local amenity and the environmental harmony for the chosen bridges across the Han-river.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.9 no.2
• /
• pp.23-32
• /
• 2006

Total suspended solids (TSS), five-day biochemical oxygen demand ($BOD_5$), total nitrogen (T-N), and total phosphorous (T-P) concentrations around and under a floating island were examined from October 2002 to September 2003. The island was installed in July 2002 on the surface of an agricultural irrigation reservoir located in the southern part of the Korean Peninsula. It was composed of six polyethylene panels. Each panel was 2 m (length) ${\times}$ 1 m (width) ${\times}$ 0.02 m (thick) and had about thirty-two holes each with a diameter of eight centimeters, through which plant roots grew down into the water. Coconut fibers of nine-centimeters in height were placed on the panel, which sustained plants rhizomes and roots. Both the fibers and the panel were raped with polyethylene wire mashes. About thirty irises (Iris pseudoacorus) were planted into the fibers of each panel. The concentrations of TSS, $BOD_5$, T-N and T-P below the island during the iris-growing season averaged 9.70, 2.59, 3.61 and 0.14 mg/L, respectively and those around it averaged 9.99, 2.83, 4.07 and 0.16 mg/L, respectively. The average concentrations of TSS, $BOD_5$, T-N and T-P below it during the iris non-growing season were 8.68, 2.37, 3.25 and 0.14 mg/L, respectively and those near it were 8.76, 2.43, 3.34 and 0.15 mg/L, respectively. At a significance level of ${\alpha}$=0.05, $BOD_5$, T-N and T-P concentrations under the island during the iris-growing season were significantly low when compared with those around it except TSS. No differences in TSS, $BOD_5$, T-N and T-P concentrations between around and near it were found at a significance level of ${\alpha}$=0.05 during the iris non-growing season. The removal of $BOD_5$, T-N, and T-P during the growing season were significantly high when compared with those during the non-growing season. TSS abatement of the floating island was very low during both the growing and non-growing seasons. The island's reductions of $BOD_5$, T-N and T-P were good during the growing season, especially T-N and T-P, which have been considered as primary pollutant sources causing the water quality degradation of reservoirs. The removal of T-N and T-P was primarily attributed to the absorption of nitrogen and phosphorous by the irises during the growing season.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.3 no.4
• /
• pp.348-354
• /
• 2015

Urethane waterproofing materials which currently being used most commonly in the Korean domestic market have high applicability and construct layers without forming any joints, but under the influence of low temperature and low humidity, as well as the thickness of the applied layer, the curing time of this material may become extended in construction sites. To resolve these issues, a proposed method of using water-hardening type of polyurethane waterproofing materials are being developed. However, there currently lacks any standards or evaluation methods on determining an optimal mixture ratio of water for the water-hardening polyurethane waterproofing materials. Therefore, workers and construction workers are relying on their hands-on-skills and experience to determine this ratio and are not able to obtain a consistent performance quality out of these materials. Therefore, for the establishment of a board applicability of the water-hardening polyurethane waterproofing methods in construction sites, this study objectively analyzes the changes in the performance of these materials depending on the changes of the water mixture ratio and attempts to procure the optimal ratio on the basis of forming a provisionary standard. The study prepares mixtures of varying ratio(no water added, 5, 10, 15, 20, 25, 30, 40 and 50) and conducts comparative analysis respective mixtures' performances and their changes in the physical properties in an objective manner and proposes a provisional optimal value that can serve as a data base that can be used as a reference for future studies.

• Journal of Korean Society of Forest Science
• /
• v.101 no.1
• /
• pp.148-157
• /
• 2012

Korea, with 63.7% of the land being forests, has unique characteristics of forest landscapes coming into view for most residential areas and roads. This study was undertaken with a purpose of supporting forest landscape management by partitioning the areas that landscape management is needed. Through analysing the degree of forest landscape management needs and the visual absorption capability for landscape changes, the zoning process and method for landscape management were conducted. In order to select the areas that are managed by priority for landscape, the degree of forest landscape management needs was quantitatively analyzed with the main scenic sites, travel frequencies, major forest landscape resources, and areas with demand for walking and automobile travel as the basis. The visual absorption capability that means the visual acceptance capability against physical landscape changes of the designated areas was analyzed in order to select the areas that are suitable for artificial landscape management. As a result, it became possible to express the degrees of forest landscape management needs in high, middle, and low sub-areas, and the visual absorption capability in high, middle, and low sub-areas, for each of the three zones in terms of spaces in the forest landscape management areas. For example, among the forest landscape transition zones, if the degree of forest landscape management needs is high and the visual absorption capability is high, then aggressive landscape management would be possible; this would also mean that this area could accept certain levels of physical landscape changes. By applying zoning methods like these, it was possible to attain a conclusive result that proper means of landscape design and management of the forest landscape resources and the surrounding areas could be provided.