• Journal of the Korean Society of Marine Environment & Safety
• /
• v.26 no.6
• /
• pp.742-750
• /
• 2020

The flow noise generated by hull appendages is directly related to the performance of the sonar in terms of self-noise and induces a secondary noise source through interaction with the propeller and rudder. Thus, the noise in the near field should be analyzed accurately. However, the acoustic analogy method is an indirect method that is not used to simulate the propagation of an acoustic signal directly; therefore, diffraction, reflection, and scattering characteristics cannot be considered, and near-field analysis is limited. In this study, the propagation process of flow noise in water was directly simulated by using the lattice Boltzmann method. The lattice Boltzmann method could be used to analyze flow noise by simulating the collision and streaming processes of molecules, and it is suitable for noise analysis because of its compressibility, low dissipation rate, and low dispersion rate characteristics. The flow noise source was derived using Reynolds-averaged Navier-Stokes equations for the hull appendages, and the propagation process of the flow noise was directly simulated using the lattice Boltzmann method by applying the developed flow-acoustic boundary conditions. The derived results were compared with Ffowcs Williams-Hawkings results and hydrodynamic pressure results based on the receiver location to verify the usefulness of the lattice Boltzmann method within the near-field range in comparison with other techniques.

• Journal of Radiation Protection and Research
• /
• v.20 no.2
• /
• pp.79-83
• /
• 1995

A number of investigators have reported formation of radiolytic ultrafine particles produced by the interaction of ionizing radiation with atmospheric trace gases. Previous studies have suggested that a very high localized concentration of the hydroxyl radical produced by the radiolysis of water can react with atmospheric trace gases such as $SO_2$ and produce lower vapor pressure compounds that can subsequently nucleate. To determine the trace gas and water vapor concentration dependence of the active, positively charged, first decayt product of radon (Po-218), a well-controlled radon chamber was used in this research. The mobility spectrum of the decay products in the range of $0.07-5.0cm^2/V\;sec$ from the radon chamber was measured using alpha track detector installed inside a specially-designed electrostatic spectrometer. Measurements were taken for different concentrations (0.5ppm to 5ppm) of $SO_2$ in Purified, Compressed air. A kinetics Study following the clustering of $SO_2$ around the $PoO_x^+$ ion in an excess of $SO_2$ for interpretation of the reaction processes was performed.

• Journal of Digital Convergence
• /
• v.14 no.8
• /
• pp.293-303
• /
• 2016

Analysis of bargaining games utilizing evolutionary computation in recent years has dealt with important issues in the field of game theory. In this paper, we investigated interaction and coevolution process among heterogeneous artificial agents using evolutionary computation in the bargaining game. We present three kinds of evolving-strategic agents participating in the bargaining games; genetic algorithms (GA), particle swarm optimization (PSO) and differential evolution (DE). The co-evolutionary processes among three kinds of artificial agents which are GA-agent, PSO-agent, and DE-agent are tested to observe which EC-agent shows the best performance in the bargaining game. The simulation results show that a PSO-agent is better than a GA-agent and a DE-agent, and that a GA-agent is better than a DE-agent with respect to co-evolution in bargaining game. In order to understand why a PSO-agent is the best among three kinds of artificial agents in the bargaining game, we observed the strategies of artificial agents after completion of game. The results indicated that the PSO-agent evolves in direction of the strategy to gain as much as possible at the risk of gaining no property upon failure of the transaction, while the GA-agent and the DE-agent evolve in direction of the strategy to accomplish the transaction regardless of the quantity.

• Journal of Science and Technology Studies
• /
• v.3 no.1 s.5
• /
• pp.105-156
• /
• 2003

This paper aims to explore the cause and aspect of inter-ministerial policy conflict and its coordination in science and technology policy-making with the case of science and technology basic law-making process in Korea. This law-making processes are analysed through the three periods for the last 10 years starting 1992, such as law-formulation(1st) period, interim law-making (2nd) period, and final law-making(3rd) period. Based on these steps, it tries to concretely describe the phenomenon of policy conflict and the coordination mechanism among government departments and analyses the characteristics of dynamic interaction and mutual adjustment among the related agencies. The analysis is mainly focussed on the underlying causes and determinants of policy conflict, the development and coordination process of the conflict, the strategies and logics of the conflict participants, and eliciting some policy implications for effective policy coordination among government departments. Research results are summarized as follows. First, in science and technology policy-making the main causes of policy conflict among government departments are attributed to the difference of policy-orientation and jurisdiction-orientation of each agency. During the first period, the main aspect of policy conflict was policy-oriented, during the second, the main aspects of policy conflict were both policy-oriented and jurisdiction-oriented, and during the third, policy-oriented conflict was dominant. Second, the dominant typology and strategies of policy coordination which the participants used were vertical-political and horizontal-analytic approach. During the first period, horizontal and analytical approach were used, during the second, horizontal and political approach are mixedly used, and during the third, vertical and political approach were dominantly used. Third, The Korean National Assembly and the ruling party played a pivotal role in science and technology policy-making process(the basic law-making process) in particular during the final period.

• Journal of the Korean earth science society
• /
• v.23 no.5
• /
• pp.416-423
• /
• 2002

The concentrations of dimethylsulfide (DMS) and carbon disulfide (CS$_2$) were measured concurrently with relevant environmental parameters at Kosan, Cheju during Apr 2001. Results of our analysis indicate that the combined temporal variations of both DMS and CS$_2$ record three distinctible patterns that are separable from each other. For instance, DMS behaved very similarly to CS$_2$ during the 1st (5${\sim}$18 Apr) and 3rd period (23${\sim}$26 Apr). The pronouncingly high concentration of CS$_2$ was maintained during the first period, but DMS values peaked mostly during the third period. It was furthermore striking to find that changes in DMS levels occurred in an opposite direction relative to CS$_2$ during the 2nd period. Although most of these variabilities appear to be associated with the interaction of source/sink processes and the air parcel movement, certain aspects of their behavior are found to be highly complicated enough to account for.

• The Journal of the Petrological Society of Korea
• /
• v.21 no.1
• /
• pp.13-30
• /
• 2012

Phlogopite and kaersutite, showing distinctively different textural characteristics compared to the common phenocrysts, are observed in alkali basalt from Jeju Island. They occur as large crystals (2-10 mm) in host basalts, whereas fine-grained phlogopite and kaersutite occur in ultramafic mantle xenoliths and mafic gabbroic xenoliths, respectively, as an interstitial and microvein phases, or in corona textures (<1 mm). This textural characteristics of fine-grained grains clearly indicates secondary in origin. Phlogopite contains high $TiO_2$(4.1-6.9 wt%) and F(2.8-4.6 wt%) and relatively high mg#[=100Mg/(Mg+$Fe^t$) in mols, where $Fe^t$ is total iron](88-80), whereas kaersutite has high $TiO_2$(5.6-6.11 wt%) and much lower mg#s(68-64). Our textural observations and the geochemical character of these hydrous minerals suggest that they were unrelated to each other and mica formation happened early in the upper mantle before the mantle xenoliths had been trapped. In contrast, kaersutite formation has happened later, probably during the late stage of crystallization as intracrustal processes. The presence of phlogopite and kaersutitic amphibole is a direct evidence for K-, Ti-, F- and $H_2O$-bearing fluid/melt percolation in the lithosphere beneath Jeju Island, indicating that they are product of interaction between host rock/peridotite/fluid-melt. Thus, the upper mantle/lower crust beneath Jeju Island are metasomatized to various extents, characterized by a change in major metasomatic hydrous minerals from phlogopite to amphibole with decreasing depth.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.22 no.3
• /
• pp.57-68
• /
• 2017

Continuous monitoring of spatial and temporal changes in key marine environmental parameters such as SST (sea surface temperature) near IORS (Ieodo Ocean Research Station) is demanded to investigate the ocean ecosystem, climate change, and sea-air interaction processes. In this study, we aimed to develop the system for continuously measuring SST using a TIR (thermal infrared) sensor mounted at the IORS. New SST algorithm is developed to provide SST of better quality that includes automatic atmospheric correction and emissivity calculation for different oceanic conditions. Then, the TIR-based SST products were validated against in-situ water temperature measurements during May 17-26, 2015 and July 15-18, 2015 at the IORS, yielding the accuracy of 0.72-0.85 R-square, and $0.37-0.90^{\circ}C$ RMSE. This TIR-based SST observing system can be installed easily at similar Ocean Research Stations such as Sinan Gageocho and Ongjin Socheongcho, which provide a vision to be utilized as calibration site for SST remotely sensed from satellites to be launched in future.

• Journal of the Korean Institute of Traditional Landscape Architecture
• /
• v.40 no.4
• /
• pp.58-66
• /
• 2022

Biophilic design is an approach that attempts to connect people with nature to promote health, recovery and restoration processes. The purpose of this study was to systematically analyze restorative factors and characteristics of Soswaewon by applying a biophilic design analysis framework. To this end, a biophilic design classification system was established and content analysis and frequency analysis were conducted for 『Soswaewon 48 Young』. the ratio of plant words including bamboo, pine, and plum was the highest, and words related to dynamic water flow or interaction with water as well as various water types such as streams, waterfalls, and ponds were also high. appeared in rank. In addition, multisensory factors, seasonal changes, microclimatic factors, emotional elements that allow people to indirectly experience nature were expressed in various ways. The space layout and circulation provide opportunities to appreciate and experience the rich sensory resources of Soswaewon. In conclusion, this study confirmed the healing and restorative value of Soswaewon from the perspective of biophilic design, and it needs further research on the restorative factors of traditional spaces.

• 지역과문화
• /
• v.7 no.3
• /
• pp.1-21
• /
• 2020

Living culture emphasizes cultural activities in daily life based on local characteristics, and aims to integrate art with daily life to communicate with others through activities of local residents. In this process, the values that individuals and society should have, are evoked and restored. In order to understand the context and processes in which the values of the living culture are expressed as local culture, we analyzed the case of 'Gosaek Nongak(community band music, dance and rituals in Korea) conservation association' in Suwon area and tried to diagnose how art and daily life are integrated and restoring community life in the actual field. For this purpose, phenomenological research was conducted through literature review participatory observation, and in-depth interviews to categorize the social impacts of living culture activities and public support due to individual, community, and local influences. We found that public support for living culture led to increased artistic development and human interaction in the community, and that individuals who are thus empowered to seek artistic experience and actively interact with other people, emerge as vital subjects and practitioners of culture and arts in their local community. Furthermore, we found that the activities of living culture facilitated the formation of local identity for members and local residents. Through living culture activities, members and local residents became more aware of being members of the community and found value and meaning in participating in daily life and cultural activities.

• Membrane Journal
• /
• v.32 no.6
• /
• pp.442-455
• /
• 2022

High-temperature polymer electrolyte membrane fuel cell (HT-PEMFC) has been studied as an alternative to low-temperature PEMFC due to its fast activation of electrodes and high resistance to electrode poisoning by carbon monoxide. It is highly required to develop stable PEMs operating at high temperatures even doped by ion-conducting materials for the development of high-performance and durable HT-PEMFC systems. A number of studies have been conducted to develop polybenzimidazole (PBI)-based PEMs for applications in HT-PEMFC due to their high interaction with doped ion-conducting materials and outstanding thermomechanical stability under high-temperature operation. This review focused on the development of PBI-based PEMs showing high performance and durability. Firstly, the characteristic behavior of PBI-based PEMs doped with various ion-conducting materials including phosphoric acid was systematically investigated. And then, a comparison of the physicochemical properties of the PEMs according to the different membrane manufacturing processes was conducted. Secondly, the incorporation of porous polytetrafluoroethylene substrate and/or inorganic composites to PBI matrix to improve the membrane performances was studied. Finally, the construction of cross-linked structures into PBI-based PEM systems by polymer blending method was introduced to improve the PEM properties.