• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.11 no.9
• /
• pp.683-686
• /
• 1998

Hot carrier effects as a function of bias stress time and bias stress consitions were syste-matically investigated in p-channel poly-Si TFT s fabricated on the quartz substrate. The device degradation was observed for the negative bias stress, while improvement of electrical characteristic except for subthreshold slope was observed for the positive bias stress. It was found that these results were related to the hot-carrier injection into the gate oxide and interface states at the poly-Si/$SiO_2$interface rather than defects states generation within the poly-Si active layer under bias stress.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.14 no.11
• /
• pp.869-873
• /
• 2001

The effects of alternate bias stress on p-channel poly-Si TFT\`s has been systematically investigated. We alternately applied positive and negative bias stress on p-channel poly-Si TFT\`s, device Performance(V$\_$th/, g$\_$m/, leakage current, S-slope) are alternately appeared to be increasing and decreasing. It has been shown that device performance degrade under the negative bias stress while improve under the positive bias stress. This effects have been related to the hot carrier injection into the gate oxide rather than the generation of defect states within the poly-Si/SiO$_2$ interface under alternate bias stress.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.24 no.12A
• /
• pp.2002-2007
• /
• 1999

In this paper, the n-channel poly-Si thin-film transistors (poly-Si TFT's) formed by solid phase crystallization (SPC) on glass were investigated by measuring the electrical properties of poly-Si films, such as I-V characteristics, mobility, leakage current, threshold voltage, and subthreshold slope. It is done to decide to be applied on TFT-LCD with large-size and high density. In n-channel poly-Si TFT with 2, 10, 25$\mu\textrm{m}$ of channel length, the field effect mobilities are 111, 126 and 125 $\textrm{cm}^2$/V-s and leakage currents are 0.6, 0.1, and 0.02 pA/$\mu\textrm{m}$, respectively. Low threshold voltage and subthreshold slope, and good ON-OFF ratio are shown, as well. Thus, the poly-Si TFT’s used by SPC are expected to be applied on TFT-LCD with large-size and high density, which can integrate display panel and peripheral circuit on a large glass substrate.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.35D no.12
• /
• pp.53-58
• /
• 1998

A buried channel poly-Si TFT (BCTFT) for application of high performance integrated circuits has been proposed and fabricated. BCTFT has unique features, such as the moderately-doped buried channel and counter-doped body region for conductivity modulation, and the fourth terminal entitled back bias for preventing kink effect. The n-type and p-type BCTFT exhibits superior performance to conventional poly-Si TFT in ON-current and field effect mobility due to moderate doping at the buried channel. The OFF-state leakage current is not increased because the carrier drift is suppressed by the p-n junction depletion between the moderately-doped buried channel and the counter-doped body region.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1999.05a
• /
• pp.489-492
• /
• 1999

The effects of alternate bias stress on p-channel poly-Si TPT's has been systematically investigated. It has been shown that the application of alternate bias stress affects device degradation for the negative bias stress as well as device improvement for the positive bias stress. This effects have been related to the hot carrier injection into the gate oxide rather than the generation of defect states within the poly-Si/SiO$_2$ under bias stress.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2000.07a
• /
• pp.324-327
• /
• 2000

In this paper, the effects of negative and positive bias stress on p-channel poly-Si TFT's fabricated by excimer laser annealing have been investigated After positive and negative bias stress, transcon-ductance(g$_{m}$) is increased because of a reduction of the effective channel length due to the injected electron in the gate oxide. In the positive bias stress, the injection of hole is appeared after stress time of 3600sec and g$_{m}$ is decreased. On the other hand, the gate voltage at the maximum g$_{m}$, S-swing and threshold voltage(V$_{th}$) are decreased because of the interface state generation due to the injection of electrons into the gate oxide.e.ide.e.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.52 no.6
• /
• pp.235-240
• /
• 2003

In this paper, we present the fabrication and the characteristic analysis of sequential lateral solidification(SLS) poly-Si thin film transistors(TFT's) with molybdenum gate for active matrix liquid displays (AMLCD's) pixel controlling devices. The molybdenum gate is applied for the purpose of low temperature processing. The maximum processing temperature is 55$0^{\circ}C$ at the dopant thermal annealing step. The SLS processed poly-Si film which is reduced grain and grain boundary effect, is applied for the purpose of electrical characteristics improvements of poly-Si TFT's. The fabricated low temperature SLS poly-Si TFT's had a varying the channel length and width from 10${\mu}{\textrm}{m}$ to 2${\mu}{\textrm}{m}$. And to analyze these devices, extract electrical characteristic parameters (field effect mobility, threshold voltage, subthreshold slope, on off current etc) from current-voltage transfer characteristics curve. The extract electrical characteristic of fabricated low temperature SLS poly-Si TFT's showed the mobility of 100~400cm$^2$/Vs, the off current of about 100pA, and the on/off current ratio of about $10^7$. Also, we observed that the change of grain boundary according to varying channel length is dominant for the change of electrical characteristics more than the change of grain boundary according to varying channel width. Hereby, we comprehend well the characteristics of SLS processed poly-Si TFT's witch is recrystallized to channel length direction.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.16 no.1
• /
• pp.26-32
• /
• 2003

Then-channel poly-Si thin-film transistors (poly-Si TFT's) formed by solid phase crystallization (SPC) method on glass were measured to obtain the electrical parameters such as of I-V characteristics, mobility, leakage current, threshold voltage, and subthreshold slope. Then, devices were analyzed to obtain the reliability and appliability on TFT-LCD with large-size and high density. In n-channel poly-Si TFT with 5$\mu\textrm{m}$/2$\mu\textrm{m}$, 8$\mu\textrm{m}$, 30$\mu\textrm{m}$ devices of channel width/length, the field effect mobilities are 111, 116, 125 $\textrm{cm}^2$/V-s and leakage currents are 0.6, 0.1, and 0.02 pA/$\mu\textrm{m}$, respectively. Low threshold voltage and subthreshold slope, and good ON-OFF ratio are shown, as well. Thus. the poly-Si TFT's used by SPC are expected to be applied on TFT-LCD with large-size and high density, which can integrate the display panel and peripheral circuit on a targe glass substrate.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2006.11a
• /
• pp.87-88
• /
• 2006

Recently, poly-Si TFT-LCD starts to be mass produced using excimer laser annealing (ELA) poly-Si. The main reason for this is the good quality poly-Si and large area uniformity. We report the influence of channel length and width on poly-Si TFTs performance. Transfer characteristics of p-channel poly-Si thin film transistors fabricated on polycrystalline silicon (poly-Si) thin film transistors (TFTs) with various channel lengths and widths of 2-30 ${\mu}m$ has been investigated. In this paper, we analyzed the data of p-type TFTs. We studied threshold voltage ($V_{TH}$), on/off current ratio ($I_{ON}/I_{OFF}$), saturation current ($I_{DSAT}$), and transconductance ($g_m$) of p-channel poly-Si thin film transistors with various channel lengths and widths.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2008.10a
• /
• pp.239-242
• /
• 2008

We have investigated the reliability of short channel ($L=1.5{\mu}m$) p-type ELA poly-Si TFTs under hot carrier stress. Threshold voltage of short channel TFT was significantly more shifted to positive direction than that of long channel TFT under the same stress. This result may be attributed to electron trapping at the interface between poly-Si film and gate oxide layer.