• 전기의세계
• /
• v.26 no.6
• /
• pp.55-58
• /
• 1977

This paper deals with the transient analysis of an amplidyne dc voltage regulating system under the following conditions: (1) assuming all the components of the system to be linear, (2) considering the effect of amplidyne saturation. The mathematical technique employed is state variables method. The calculated response curves are compared with the experimental results obtained on a practical system. The main results can be summerized as follows: 1) The effect of amplidyne saturation on the transient response of a dc voltage regulating system is to reduce the overshoot and setting time. 2) With the increase in level of the step reference voltage, the system response becomes apesiodic. 3) The steady output voltage is reduced appreciably compared to the linear case.

• Proceedings of the Optical Society of Korea Conference
• /
• 2004.02a
• /
• pp.312-313
• /
• 2004

The optical gain saturation and noise figure characteristics of 1550nm traveling-wave semiconductor optical amplifiers are analyzed experimentally and theoretically. The result shows that there is an optimum active layer thickness for high saturation output power and low noise figure.

• Proceedings of the KOSOMBE Conference
• /
• v.1993 no.05
• /
• pp.116-119
• /
• 1993

In this paper, we implemented a pulse wave type oximeter system that continuously measure the of oxyhemoglobin saturation of the arterial blood(SaO2) and pulse rate with non-invasively. We use the transmission type and reflection type transducer for comparison the percentage of hemoglobin oxgen saturation. The light Iron the two kind of LEDs is transmitted through the tissue, then received by a single photodiode with alternatively. By the phase sensitive detection circuit, the output of the photodiode is separated in to red and near infrared signal. We calculated a ratio of light transmittance between two kind of LEDs, and then, it is applied to the oxgen saturation coefficent calculation formular.

• Korean Journal of Optics and Photonics
• /
• v.1 no.2
• /
• pp.162-168
• /
• 1990

Two ZnSe loss plates were installed in the resonator of waveguide CO2 laser which consisted of Pyrex capillary tube in order to change the internal loss. By rotating the loss plates, the output variations with the internalloss was measured on various discharge conditions. The variations could be explained by the Rigrod theory. and the saturation power and the unsaturated gain coefficient were determined by fitting of the experimental results. It was found that the saturation power increased while the unsaturated gain coefficient reduced as the discharge current or the gas flow rate increased.reased.

• Proceedings of the KIEE Conference
• /
• 1990.11a
• /
• pp.371-374
• /
• 1990

This paper presents the speed control of dc motor based on deadbeat response. The deadbeat response is that the output reaches the final value in the minimum possible settling time and stays there. This results demonstrate that the output reaches final value in one sampling time for the unsaturated region, and in one sampling time after getting free from the saturation state for the saturated region.

• Proceedings of the KIEE Conference
• /
• 1998.07d
• /
• pp.1462-1464
• /
• 1998

Poly-Si TFT(Thin Film Transistor) is a electronic device that can be applied to the field of large area electronics such as AMLCD. We have fabricated the poly-Si TFT with lateral body terminal that is counter-doped body electrode and investigated the electrical characteristics of it. The lateral body terminal being short with s terminal, we have measured the transfer charac (Vg-ld) and the output characteristic (Vd-ld) fabricated devices. The measured result showe only that leakage current in OFF-state was re and Kink effect in ON-state was suppressed bu that in output characteristic curve the output Id was sustained constantly with the output v Vd in the saturation region.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.19 no.1
• /
• pp.231-238
• /
• 2019

In this paper, we have studied how to improve the amplifiers efficiency by minimizing the combining loss when several unit power amplifiers are combined to obtain high output power. Specifically, we have developed Ka-band Spatial Combining Amplifier. The fabricated Spatial Combining Amplifier is a Ka-band 20W class SSPA, which uses a 5W class unit amplifier module 8EA designed using a GaN bare die. We also combined The unit amplifier module using 8-way spatial divider and combiner with a hybrid radial structure. The output combining loss of the fabricated spatial coupler is about 0.334dB, which is about 92.6% efficiency. In this paper, we developed a Spatial Combining Amplifier with a maximum saturation output of 10W and a power addition efficiency of over 15%. As a result, we achieved the maximum saturation output of 30W and the power addition efficiency of 19%.

• Journal of the Korean Society of Industry Convergence
• /
• v.17 no.3
• /
• pp.103-112
• /
• 2014

BY the Transformers and reactors, the input electrical energy is converted into magnetic energy. At the end through the magnetic energy was passed at the output parameter. Specially At the flyback transformer or a reactor airgap were designed to contain more magnetic energy. But that work is very difficult for the optimal design. It is that Contradictions are between the length of the Air-gap, Winding inductance, DC bias. As to e Several conflicting conditions in order to determine the optimum Air-gap has a lot of experience and trial & error is necessary. The approach proposed in this paper, the auxiliary winding on the core attached to part of primary core, that by applying a DC voltage has a dramatic effect like Core with designed Air-gap. This inventiveness and advantage is to regulate arbitrarily the Saturation Flux Quantity by the input signal to secondary winding. Accordingly obtained the biggest effect is that increasing limits of the saturation current destined by the material and shape of the conventional core. In other words, that can decreas the size of the transformer and reactor, While maintaining the current saturation capacity. This paper, prove its effect as using the local flux saturation in transformers and reactors for research by the computer program using the finite element method (FEM) simulation, followed by actual experiment to verify

• The Korean Journal of Applied Statistics
• /
• v.32 no.5
• /
• pp.693-702
• /
• 2019

Deep learning has gained popularity for the classification and prediction task. Neural network layers become deeper as more data becomes available. Saturation is the phenomenon that the gradient of an activation function gets closer to 0 and can happen when the value of weight is too big. Increased importance has been placed on the issue of saturation which limits the ability of weight to learn. To resolve this problem, Glorot and Bengio (Proceedings of the Thirteenth International Conference on Artificial Intelligence and Statistics, 249-256, 2010) claimed that efficient neural network training is possible when data flows variously between layers. They argued that variance over the output of each layer and variance over input of each layer are equal. They proposed a method of initialization that the variance of the output of each layer and the variance of the input should be the same. In this paper, we propose a new method of establishing initialization by adopting truncated normal distribution and truncated cauchy distribution. We decide where to truncate the distribution while adapting the initialization method by Glorot and Bengio (2010). Variances are made over output and input equal that are then accomplished by setting variances equal to the variance of truncated distribution. It manipulates the distribution so that the initial values of weights would not grow so large and with values that simultaneously get close to zero. To compare the performance of our proposed method with existing methods, we conducted experiments on MNIST and CIFAR-10 data using DNN and CNN. Our proposed method outperformed existing methods in terms of accuracy.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.3 no.1
• /
• pp.61-69
• /
• 1998

In this paper, discrete current control of voltage source inverters is proposed. As a current control scheme, the constant switching frequency predictive current control is adopted and implemented with DSP microprocessor system. In particular, the proposed method is for the compensation of the control lagging due to calculation delays in the microprocessor controller. In controlling the current, the inverter output voltage saturation problem is inevitable and usually affects the current control performance. So, the saturation boundary condition of the inverter output voltage and its effects on the current controal performance of the proposed current control scheme are investigated with experiment. Finally, the proposed scheme is applied to the active power filter system and some results are described for validation.