• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.06a
• /
• pp.138-139
• /
• 2007

탄화규소반도체소자는 wide band-gap 반도체 재료로 고전압, 고속스위칭 특성이 우수하여 차세대 전력반도체소자로 매우 유망한 소자이다. 이러한 물리적 특성으로 전력변환소자인 고전압 MOSFET 소자를 개발하기 위한 연구가 활발히 진행되고 있다. 그러나 MOS 소자에서 가장 중요한 게이트 산화막의 특성이 소자에 적용하기에는 그 특성이 많이 취약한 상태이다. 따라서 이러한 단점을 해결하여 고전압 전력변환소자로 적용하기 위하여 게이트 산화막이 필요없는 JFET 소자가 많이 연구되고 있다. 본 논문에서는 JFET 소자를 normally-off type으로 동작시키기 위하여 게이트의 구조, 도핑농도 및 게이트 폭을 조절하여 simulation를 수행하였다. 케이트의 농도 및 접합깊이에 따라 normally-on 또는 off 특성에 큰 영향을 미치고 있으며 게이트 트렌치구조의 깊이에 따라서도 영향을 받는다. 본 simulation 결과 최적의 트렌치 길이, 폭 및 농도로 소자를 구성하여 $1.3m{\Omega}cm^2$의 온-저항 특성을 얻을 수 있었다.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.16 no.2
• /
• pp.221-225
• /
• 2016

This paper reports a new method to enable the normally-off operation of AlGaN/GaN heterojunction field-effect transistors (HFETs). A capacitor was connected to the gate input node of a normally-on AlGaN/GaN HFET with a Schottky gate where the Schottky gate acted as a clamping diode. The combination of the capacitor and Schottky gate functioned as a clamp circuit to downshift the input signal to enable the normally-off operation. The normally-off operation with a virtual threshold voltage of 5.3 V was successfully demonstrated with excellent dynamic switching characteristics.

• Journal of IKEEE
• /
• v.22 no.1
• /
• pp.205-208
• /
• 2018

In this work, we performed reverse- and forward-gate bias stress tests on normally-off AlGaN/GaN high electron mobility transistors(HEMTs) with p-AlGaN-gate for reliability assessment. Inverse piezoelectric effect, commonly observed in Schottky-gate AlGaN/GaN HEMTs during reverse bias stress, was not observed in p-AlGaN-gate AlGaN/GaN HEMTs. Forward gate bias stress tests revealed distinct degradation of p-AlGaN-gate devices exhibiting sudden increase of gate leakage current. We suggest that forward gate bias stress tests should be performed to define the failure criteria and assess the reliability of normally off p-AlGaN-gate GaN HEMTs.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.15 no.5
• /
• pp.497-503
• /
• 2015

It is essential to acquire an accurate and simple technique for extracting the interface trap density ($D_{it}$) in order to characterize the normally-off gate-recessed AlGaN/GaN hetero field-effect transistors (HFETs) because they can undergo interface trap generation induced by the etch damage in each interfacial layer provoking the degradation of device performance as well as serious instability. Here, the frequency-dependent capacitance-voltage (C-V) method (FDCM) is proposed as a simple and fast technique for extracting $D_{it}$ and demonstrated in normally-off gate-recessed AlGaN/GaN HFETs. The FDCM is found to be not only simpler than the conductance method along with the same precision, but also much useful for a simple C-V model for AlGaN/GaN HFETs because it identifies frequency-independent and bias-dependent capacitance components.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.12
• /
• pp.2741-2746
• /
• 2012

In this study, we propose a novel structure based on AlGaN substrate or buffer layer to implement a normally-off mode transistor that was difficult to be realized by conventional AlGaN/GaN heterojunction structures. The channel under the gate can be selectively depleted by growing an upper AlGaN barrier with a higher Al mole fraction and a top GaN charge elimination layer on AlGaN substrate or buffer layer. The proposed AlGaN heterojunction field effect transistor can achieve a threshold voltage of > 2 V, which is generally required in power device specification.

• Journal of IKEEE
• /
• v.24 no.4
• /
• pp.1167-1171
• /
• 2020

In this work, we proposed a graded gate-doping structure to alleviate an electric field in p-GaN gate layer in order to improve the reliability of normally-off GaN power devices. In a TCAD simulation by Silvaco Atlas, a distribution of the graded p-type doping concentration was optimized to have a threshold voltage and an output current characteristics as same as the reference device with a uniform p-type gate doping. The reduction of an maximum electric field in p-GaN gate layer was observed and it suggests that the gate reliability of p-GaN gate HFETs can be improved.

• Korean Chemical Engineering Research
• /
• v.60 no.2
• /
• pp.313-319
• /
• 2022

AlGaN/GaN based HfO₂ MOSHEMT (metal oxide semiconductor high electron transistor) with different gate recess depth was simulate to demonstrate a successful normally-off operation of the transistor. Three types of the HEMT structures including a conventional HEMT, a gate-recessed HEMT with 3 nm thick AlGaN layer, and MIS-HEMT without AlGaN layer in the gate region. The conventional HEMT showed a normally-on characteristics with a drain current of 0.35 A at V_G = 0 V and V_DS = 15 V. The recessed HEMT with 3 nm AlGaN layer exhibited a decreased drain current of 0.15 A under the same bias condition due to the decrease of electron concentration in 2DEG (2-dimensional electron gas) channel. For the last HEMT structure, distinctive normally- off behavior of the transistor was observed, and the turn-on voltage was shifted to 0 V.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.33 no.1
• /
• pp.16-20
• /
• 2020

In this study, a patterning method using self-aligned nanostructures was introduced to fabricate GaN-based fin-gate HEMTs with normally-off operation, as opposed to high-cost, low-productivity e-beam lithography. The honeycomb-shaped fin-gate channel width is approximately 40~50 nm, which is manufactured with a fine width using a proposed method to obtain sufficient fringing field effect. As a result, the threshold voltage of the fabricated device is 0.6 V, and the maximum normalized drain current and transconductance of Gm are 136.4 mA/mm and 99.4 mS/mm, respectively. The fabricated devices exhibit a smaller sub-threshold swing and higher Gm peak compared to conventional planar devices, due to the fin structure of the honeycomb channel.

• Proceedings of the Korean Society of Surveying, Geodesy, Photogrammetry, and Cartography Conference
• /
• 2006.04a
• /
• pp.229-234
• /
• 2006

On May 31, 2003. Landsat 7 experienced an anomaly causing the Scan Line Corrector(SLC) to stop functioning normally. The SLC-off causes individual scan lines to alternately overlap and then leave large gaps at the edge of the Image. A many scientists with ongoing experience using ETM+ data evaluated the scientific usability and validity of Landsat 7 products containing the SLC anomaly The best reference scene for gap-filling is the other SLC-on Landsat scene that provide same resolution, few changes, and similar data acquisition. But receiving of Landsat imagery is not stable in Korea. So SPOT image can be another alternative solution because it is a steady-state multispectral satellite image as Landsat image. In this study, we filled the SLC-off gap s of 2, 3, 4 bands using SPOT image by a local regression technique, and assigned the optimum spectral value to gaps of 1, 5, 7 bands based on a spectral adjacency. Through this process, we could restore Landsat SLC-off image and evaluated the accuracy of the results.

• Journal of Advanced Marine Engineering and Technology
• /
• v.27 no.3
• /
• pp.412-420
• /
• 2003

This study describes the merits of PWM control of hydraulic system using high speed on-off valves. Generally, Electro-hydraulic valves can be classified into two classification: valves which are controlled by analog signal and which are controlled by digital. The former includes hydraulic servo valves and proportional valves which require A/D converters as interface to digital computer and too costly and sensitive to oil contamination because of complexity in structures. The latter includes high speed on-off valves which do not require A/D converters because they are normally operated in a pulse width modulation(PWM) method, and are low in price and robust to oil contamination because of their simple structures. The objectives of this study is to analyze the limit cycle which regularly appear in the position control system using 2/2way high speed on-off valves and to give a criterion for the stability of this system. The nonlinear characteristics of PWM and cylinder friction of this system are described by harmonic linearization and the effects of parameter variations to the system stability are simulated.