• Journal of IKEEE
• /
• v.26 no.4
• /
• pp.553-559
• /
• 2022

In this paper, RC snubber circuit design technology for oscillation suppression in half-bridge configuration of cascode gallium nitride (GaN) field effect transistors (FETs) is analyzed. A typical wide band-gap (WBG) device, cascode GaN FET, has excellent high-speed switching characteristics. However, due to such high-speed switching characteristics, a false turn-off problem is caused, and an RC snubber circuit is essential to suppress this. In this paper, the commonly used experimental-based RC snubber design technique and the RC snubber design technique using the root locus method are compared and analyzed. In the general method, continuous circuit changes are required until the oscillation suppression performance requirement is met based on experimental experience . However, in root locus method, the initial value can be set based on the non-oscillation R-C map. To compare the performance of the two aforementioned design methods, a simulation experiment and a switching experiment using an actual double pulse circuit are performed.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.22 no.4
• /
• pp.350-354
• /
• 2009

$Al_{2}O_{3}$ thin films were deposited on GaN(0001) by using a Remote Plasma Atomic Layer Deposition(RPALD) technique with a trimethylaluminum(TMA) precursor and oxygen radicals in the temperature range of $25{\sim}500^{\circ}C$. The growth rate per cycle was varied with the substrate temperature from $1.8{\AA}$/cycle at $25^{\circ}C$ to $0.8{\AA}$/cycle at $500^{\circ}C$. The chemical structure of the $Al_{2}O_{3}$ thin films was studied using X-ray photoelectron spectroscopy(XPS). The electrical properties of $Al_{2}O_{3}$/GaN Metal-Insulator-Semiconductor (MIS) capacitor grown at a $300^{\circ}C$ process temperature were excellent, a low electrical leakage current density(${\sim}10^{-10}A/cm^2$ at 1 MV) at room temperature and a high dielectric constant of about 7.2 with a thinner oxide thickness of 12 nm. The interface trap density($D_{it}$) was estimated using a high-frequency C-V method measured at $300^{\circ}C$. These results show that the RPALD technique is an excellent choice for depositing high-quality $Al_{2}O_{3}$ as a Sate dielectric in GaN-based devices.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.17 no.2
• /
• pp.277-282
• /
• 2017

Nickel germanide (NiGe) is one of the most promising alloy materials for source/drain (S/D) of Ge MOSFETs. However, NiGe has limited thermal stability up to $450^{\circ}C$ which is a challenge for fabrication of Ge MOSFETs. In this paper, a novel method is proposed to improve the thermal stability of NiGe using Co interlayer. As a result, we found that the thermal stability of NiGe was improved from $450^{\circ}C$ to $570^{\circ}C$ by using the proposed Co interlayer. Furthermore, we found that current-voltage (I-V) characteristic was improved a little by using Co/Ni/TiN structure after post-annealing. Therefore, NiGe formed by the proposed Co interlayer that is, Co/Ni/TiN structure, is a promising technology for S/D contact of Ge MOSFETs.

• Journal of Korean Academy of Medicine & Therapy Science
• /
• v.10 no.2
• /
• pp.5-11
• /
• 2018

Objective: The purpose of the present study is to investigate whether intensive ankle training using biofeedback to increase proprioceptive senses and ankle-joint muscle strength effectively improves the balance of normal adults. Method: This study included 20 voluntary participants with normal adults. The subjects were randomly divided into 2 groups: the biofeedback intensive ankle training group (n=10) and the ankle training group (n=10). The biofeedback group used a visual biofeedback program. Subjects of the group that underwent ankle training only tried to keep their bodies balanced as well as possible on an Aero-Step. Both groups performed the exercise equally for three 30-minute sessions weekly for six weeks. The differences between the measurements before and after the experiment were analyzed using Wilcoxon signed-rank tests. Mann-Whitney U tests were used to analyze the differences in variations between the groups. Results: The biofeedback group showed significant differences in the weight distributions A, B, C, D, LEFT, and HEEL and on the weight-distribution index. In contrast, the ankle training group showed significant differences in the weight distributions A, C, and LEFT. A comparison of the differences between the two groups found significant differences between them in the weight distributions A, B, C, D, LEFT, and HEEL. Conclusion: The biofeedback group showed a greater ability to control weight distribution. A longer experimental period involving more subjects would aid in developing exercise programs that are more diverse.

• Journal of the Korean institute of surface engineering
• /
• v.39 no.5
• /
• pp.199-205
• /
• 2006

Titanium nitride (TiN) coatings were produced on AISI 420 stainless steel by DC magnetron sputtering of a Ti target changing the processing variables, such as the flow rate of $N_2/Ar$, substrate temperature and the existence of Ti interlayer between TiN coatings and substrates. The hardness and residual stress in the films were investigated using nanoindentation and a laser scanning device, respectively. The stoichiometry and surface morphology were investigated using X-Ray Diffraction and SEM. The corrosion property of the films was also studied using a polarization method in NaCl (0.9%) solution. Mechanical properties including hardness and residual stress were related to the ratio of $N_2/Ar$ flow rate. The corrosion resistance also was related to the processing variables.

• Current Applied Physics
• /
• v.18 no.12
• /
• pp.1553-1557
• /
• 2018

Gallium nitride (GaN) nanoparticles are synthesized by the gallium particle trapping effect in a $N_2$ nonthermal plasma with metallic Ga vapor. A proposed method has an advantage of synthesized GaN nanoparticle purity because the gallium vapor from the inductively heated tungsten boat does not contain any impurity source. The synthesized particle size can be controlled by the amount of Ga vapor, which is adjusted using the plasma emission ratio of nitrogen to gallium, owing to the particle trapping effect. The synthesized nanoparticles are investigated by electron microscopy studies. High-resolution transmission electron microscopy (HRTEM) studies confirm that the synthesized GaN nanoparticles (10-40 nm) crystallize in a single-phase wurtzite structure. Room-temperature photoluminescence (PL) measurements indicate the band-edge emission of GaN at around 378 nm without yellow emission, which implies that the synthesized GaN nanoparticles have high crystallinity.

• Transactions of Materials Processing
• /
• v.26 no.3
• /
• pp.137-143
• /
• 2017

In this study, a wear test method was proposed to predict the wear life of the CrN layer coated on the surface of the press tools for manufacturing the auto-parts with ultra high strength steel (UHSS) with a tensile strength of 1.5 GPa. The pin-on-disc type wear test was carried out to confirm the feasibility and the reproducibility of the wear amount according to the test conditions such as the normal force, the sliding velocity, and the sliding speed. The test conditions were obtained from the finite element stamping analysis and the wear simulation. With the wear amount from the wear test, a prediction model of the wear depth in the CrN coating layer was proposed according to the test conditions with the design of experiments such as Taguchi method and the response surface method. The derived prediction model was then compared to the result of the Archard wear model, fully describing that the proposed model can effectively predict the wear life of the press tools for the auto-parts with UHSS.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.25 no.9
• /
• pp.702-710
• /
• 2012

Eco-friendly $(Na,K)NbO_3$ (NKN)-based piezoelectric ceramic materials were fabricated by conventional ceramic method for shear mode piezoelectric energy harvesting application. $NKN-LiTaO_3$ (LT) based compositions were adopted for the high $d_{15}{\times}g_{15}$ which is proportional to harvested energy density. The composition $0.935(Na_{0.535}K_{0.485})NbO_3-0.065LiTaO_3$ was found to be lie on the boundary of tetragonal and orthorhombic phases. With reducing Ta content, the dielectric constant decreased gradually while maintaining high $d_{15}$, which resulted in increased $d_{15}{\times}g_{15}$. The composition $0.935(Na_{0.535}K_{0.485})NbO_3-0.065Li(Nb_{0.990}Ta_{0.010})O_3$ was found to possess excellent piezoelectric and electromechanical properties ($d_{15}{\times}g_{15}=29\;pm^2/N$, $d_{15}$ = 417 pC/N, $k_{15}$ = 0.55), and high curie temperature ($T_c=455^{\circ}C$).

• Korean Journal of Crystallography
• /
• v.16 no.1
• /
• pp.38-42
• /
• 2005

The crystal structure of Bis(ethylenediamine) cuprate(II)$\cdot$dichromate, $Cu(C_2H_8N_2)_2{\cdot}Cr_2O_7$, has been determined by X-ray crystallography. Crystal data: a=5.682(2), b=8.567(3), c=14.839(3) ${\AA},\;{\alpha}=97.50(2),\;{\beta}=101.06(1),\;{\gamma}=109.38(2)^{\circ}$ Triclinic, P-1 (SG No=2), Z=2, V=653.9(2) ${\AA}^3,\;D_c=2.030gcm^{-3},\;{\mu}=3.273mm^{-1}$. The structure was solved by Patterson method and refined by full matrix least-square methods uslng unit weights. The final R and S values were $R_1=0.0256,\;R_w=0.0708,\;R_{all}=0.0316,\;S=1.151$ for the observed 2291 reflections. The two cupper complex ion has the usual distorted octahedral structure with mean four Cu-N distances of 2.010(3) $\AA$ and the longer mean Cu-O distance of 2.525(2) $\AA$. The Cu-complex and dichromate ions are linked to form infinite chain arranged alternatively along the [111]-direction. The neighboring chains in the (0-11) plane are connected with N1-O5 and N3-O1 hydrogen bonds.

• Industrial Engineering and Management Systems
• /
• v.15 no.3
• /
• pp.224-230
• /
• 2016

The use of new words, numerous spoken languages, and abbreviations on the Internet is extensive. As such, automatically acquiring words for the purpose of analyzing Internet content is very difficult. In a previous study, we proposed a method for Japanese word segmentation using character N-grams. The previously proposed method is based on a simple state-transition model that is established under the assumption that the input document is described based on four states (denoted as A, B, C, and D) specified beforehand: state A represents words (nouns, verbs, etc.); state B represents statement separators (punctuation marks, conjunctions, etc.); state C represents postpositions (namely, words that follow nouns); and state D represents prepositions (namely, words that precede nouns). According to this state-transition model, based on the states applied to each pseudo-word, we search the document from beginning to end for an accessible pattern. In other words, the process of this transition detects some words during the search. In the present paper, we perform experiments based on the proposed word acquisition algorithm using Japanese and Chinese newspaper articles. These articles were obtained from Japan's Kyoto University and the Chinese People's Daily. The proposed method does not depend on the language structure. If text documents are expressed in Unicode the proposed method can, using the same algorithm, obtain words in Japanese and Chinese, which do not contain spaces between words. Hence, we demonstrate that the proposed method is language independent.