• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제51권3호
• /
• pp.99-104
• /
• 2002

lateral insulated gate bipolar transistors(LIGBTs) are extensively used in high voltage power IC application due to their low forward voltage drops. One of the main disadvantages of the LIGBT is its scow switching speed when compared to the LDMOSFET. And the LIGBT with reverse channel structure is lower current capability than the conventional LIGBT at the forward conduction mode. In this paper, the LIGBT which included p+ ring and p-channel gate is presented at the reverie channel structure. The presented LIGBT structure is proposed to suppress the latch up, efficiently and to improve the turn off time. It is shown to improve the current capability too. It is verified 2-D simulator, MEDICI. It is shown that the latch up current of new LIGBT is 10 times than that of the conventional LIGBT Additionally, it is shown that the turn off characteristics of the proposed LIGBT is i times than that of the conventional LIGBT. It is net presented the tail current of turn off characteristics at the proposed structure. And the presented LIGBT is not n+ buffer layer because it includes p channel gate and p+ ring.

• 한국전기전자재료학회논문지
• /
• 제17권3호
• /
• pp.305-310
• /
• 2004

We have studied the optimal phase retardation value of a homogeneously aligned liquid crystal (LC) driven by fringe-field when using the LC with positive dielectric anisotropy. In general, the transmittance of a homogeneous aligned LC cell under crossed polarizer is maximum when a twist angle of LC by in-plane rotation is 45$^{\circ}$ with polarizer and the cell retardation becomes λ/2. However, the device using the LC with positive dielectric anisotropy does not follow this since the degree of rotation of the LC is dependent on electrode position and in addition the LCs tilt up along the fringe-field. At the center of common and pixel electrode, the LC is most twisted around a middle position of a cell whereas at the edge position of pixel electrode, the LC is most twisted near bottom surface of a cell. Consequently, the optimal phase retardation of the device becomes much larger than λ/2 and the transmittance can be described using the combination of the in-plane switching and twisted nematic mode.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2012년도 추계학술대회 논문집
• /
• pp.88-90
• /
• 2012

A study on an integrated single stage AC/DC converter is presented in this paper. The input current can be controlled by the auxiliary winding($L_{aux}$), auxiliary primary winding($N_3$), and the boost inductor($L_B$) which are designed to operate in discontinuous conduction mode(DCM) to reduced the total harmonic distortion(THD) of input current. The auxiliary primary winding($N_3$) is critically selected in order to compress the input capacitor voltage($V_{in}$) as well as to reduce the current stress of the switch(Q). Low total harmonic distortion(THD), low input voltage($V_{in}$) in universal input voltage($V_{AC}$), low current stress at the switching device and high efficiency are the main consideration keys in this design to achieve high performance system with low cost of single stage AC/DC converter. A 30W single stage AC/DC prototype converter is under study.

• 한국광학회지
• /
• 제7권4호
• /
• pp.414-418
• /
• 1996

광표백 광도파로 자기정렬 전극을 이용하여 전기광학 폴리머 디지탈 광스위치를 제작하였다. 이 광스위치는 파장에 무관하게 동작하고 제작조건에 민감하지 않고 설계가 다양하다는 특성을 갖는다. 또한 광섬유와의 결합 손실이 작고 넓은 대역폭을 갖는 장점이 있다. 스위칭 성능을 향상시킬 목적으로 광표백 시간을 이용하여 광표백 광도파로의 도파모드 분포를 적절하게 조절함으로써 브랜치 영역에서의 모드 결합을 최적화 하였다. 또한 광과 인가 전계의 효과적인 겹침과 점진적으로 테이퍼된 전극을 형성하기 위해 자기정렬전극을 이용하였다. 측정된 누화는 1.32.mu.m와 1.55.mu.m에서 모두 -21dB 이하였고 각 출력포트의 소멸비도 모두 20dB 이상이었다.

• 한국막학회:학술대회논문집
• /
• 한국막학회 2004년도 추계 총회 및 학술발표회
• /
• pp.263-266
• /
• 2004

An experimental study was carried out on the recovery of ammonium lactate from simulated fermentation brothby desalting electrodialysis (DSED). All experiments, using AM-1 and CM-1 membranes, were operated in a constant current and a subsequent constant-voltage mode, and the switching point was determined based on the previous results. The effects of operating conditions such as operating current, initial feed concentration, and initial feed pH were investigated. Increased operating current resulted in a decreased operating time but an increased energy consumption per unit amount of ammonium lactate recovered. As the initial feed concentration was increased, the operating time increased while energy consumption decreased. The operating time and energy consumption slightly decreased as the initial feed pH was increased up to 6.0. However, no significant influences on the recovery of ammonium lactate were observed over 6.0. The rejections of acetate, glucose, and proteins were $10\%,\;93\%,\;and\;98\%$, respectively. Sulfate was not rejected at all.

• 제어로봇시스템학회논문지
• /
• 제17권8호
• /
• pp.833-842
• /
• 2011

The objectives of this research are development of guidance, navigation and control system for RUAV on virtual instrumentation and real flight test. For this research, the system is divided to DAQ (data acquisition) section, actuator section and controller section. And the hardware and software on each sections are realized on LabVIEW base. Waypoint guidance and control of auto flight are realized using PID gain tuning and waypoint vector tracking guidance algorism. For safe flight test, auto/manual switching module isolated from FCS (Flight Control System) is developed. By using the switch module, swift mode change was achieved during emergency flight case. Consequently, a meter level error of flight performance is achieved.

• 전자공학회논문지A
• /
• 제33A권10호
• /
• pp.130-138
• /
• 1996

The size of a device needs to scale down to increase its integrity and speed. As the size of the device is reduced, the hot-carrier degradation that severely effects on device reliabilty is concerned. In this paper, sub-micron buried-channel P-MOSFETs were fabircated, and the hot-carrier effects were invetigated. Also the hot-carrier effect in the buired-channel P-MOSFETs and the surface-channel P-MOSFETs were compared with simulation programs using SUPREM-4 and MINIMOS-4. This paper showed that the electric characteristics of sub-micron P-MOSFET are different from those of N-MOSFET. Also it showed that the punchthrough voltage ( $V_{pt}$ ) was abruptly drop after applying the stress and became almost 0V when the channel lengths were shorter than 0.6.mu.m. The lower punchthrough voltage causes the device to operte poorly by the deterioration of cut-off characteries in the switching mode. We can conclude that the buried channel P-MOSFET for CMOS circuits has a limit of the channel length to be around 0.6.mu.m.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2008년도 International Meeting on Information Display
• /
• pp.340-343
• /
• 2008

This work reports the simple fabrication of the single cell gap transflective liquid crystal display (LCD) using wire grid polarizer. The nano sized wire grid polarizer was patterned on common electrode itself, on the reflective part of FFS (Fringe field switching) mode whereas the common electrode was unpatterned at transmissive part. However, this structure didn't show single gamma curve, so we further improved the device by patterning the common electrode at transmissive part. As a result, V-T curve of proposed structure shows single gamma curve. Such a device structure is free from in-cell retarder, compensation film and reflector and furthermore it is very thin and easy to fabricate.

• 한국정보통신학회논문지
• /
• 제10권9호
• /
• pp.1617-1624
• /
• 2006

본 논문은 분산전원시스템(DGS)을 위 한 시스템 모델링, 수정된 SVPWM 적용 그리고 수동소자인 L과 C로 구성된 Z-원 인버터의 제어기에 대하여 기술하였다. 기존의 DC/DC 승압 컨버터나 변압기를 사용하지 않고 낮은 DC 입력을 상용 AC로 만들기 위해서 SVPWM의 영벡터 구간을 이용해 DC-링크단 전압을 승압하는데 이용하였다. 한 스위칭주기에 3개조의 스위칭소자 중에 2개조만 동시 도통되도록 하여 유효벡터의 손실 없이 승압이 가능하도록 하였다. 빠르고 오버슈트가 없는 전류응답과 낮은 정상상태 전압오차를 얻기 위해서 이산시간 슬라이딩모드 전류제어기와 강인한 서보기구 전압제어기를 설계하였다. 시뮬레이션을 통하여 제안된 알고리즘의 유용성을 확인하였다.

• 한국인터넷방송통신학회논문지
• /
• 제15권5호
• /
• pp.119-123
• /
• 2015

본 논문은 마크-젠더 변조기를 사용하여 광 신호를 생성하는 광 NRZ(nonreturn-to-zero) 송신기의 전송 특성을 이론적으로 분석하였다. 특히 단일 모드 광섬유를 통하여 분산 보상 방법 없이 1550nm 파장에서 25Gbps 광 NRZ 신호를 전송하고 그 성능을 chirp을 나타내는 ${\alpha}$-계수와 마크-젠더 변조기의 구동 전압비(=구동 전압/스위칭 전압)의 영향을 고려하여 평가하였다. 분산을 개선하기 위하여 음의 값을 가진 ${\alpha}$-계수를 사용하고 그 값들과 함께 구동 전압비의 크기를 적절히 조정하여 최적화된 상태에서 성능 개선을 시험하였다. 개선된 전송 성능은 비트 오류율(Bit Error Rate)과 광 아이 다이어그램으로 확인되었다.