• Journal of the Korean Institute of Telematics and Electronics
• /
• v.25 no.11
• /
• pp.1274-1281
• /
• 1988

A new voltage-controlled oscillator based on a voltage-controlled integrator has been developed. It consists of a Schmitt-trigger and a voltage-controlled integrator, which is realized by an operational transconductance amplifier (OTA) and a grounded capacitor. The input control voltage changes the time constant of the integrator, and hence the oscillation frequency. The SPICE simulation shows that a prototype circuit, which oscillates at 12.21 KHz at 0 V, has the conversion sencitivity 2,437 Hz/V and the residual nonlinearity less than 0.68% in a control voltage range from -2 V to 2 V. It also shows that the circuit provides a temperature drift less than + 250 ppm/$^{\circ}$C for frequencies up to 100 KHz.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.49 no.1
• /
• pp.1-7
• /
• 2012

We have developed a new gate driver circuit for liquid crystal displays using oxide thin-film transistors (TFTs). In the new gate driver, negative gate bias is applied to turn off the oxide TFTs because the oxide TFT occasionally has negative threshold voltage (VT). In addition, we employed three parallel pull-down TFTs that are turned on in turns to enhance the stability. SPICE simulation showed that the proposed circuit worked successfully covering the VT range of -3 V ~ +6 V And fabrication results confirmed stable operation of the new circuit using oxide TFTs.

• Journal of Sensor Science and Technology
• /
• v.14 no.6
• /
• pp.387-394
• /
• 2005

In order to design SOI CMOS image sensors, SOI MOSFET model parameters were extracted using the equation of bulk MOSFET model parameters and were optimized using SPICE level 2. Simulated I-V characteristics of the SOI NMOSFET using the extracted model parameters were compared to the experimental I-V characteristics of the fabricated SOI NMOSFET. The simulation results agreed well with experimental results. A unit pixel for SOI CMOS image sensors was designed and was simulated for the PPS, APS, and logarithmic circuit using the extracted model parameters. In these CMOS image sensors, a nano-wire MOSFET photodetector was used. The output voltage levels of the PPS and APS are well-defined as the photocurrent varied. It is confirmed that SOI CMOS image sensors are faster than bulk CMOS image sensors.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.32A no.12
• /
• pp.149-158
• /
• 1995

This paper describes the development of a software tool LCD FRAME that may guide the analyzing process for the electrical characteristics and the design procedure for constructing the thin film transistor liquid crystal display(TFT/LCD) packages. LCD FRAME can analyze its electrical characteristics from the TFT/LCD system package configuration, and provide the design variables to meet the user's requirements. These analysis and design procedure can be done in real time according to the model at simplified package level of TFT/LCD. LCD_FRAME is an object-oriented expert system which considers package elements as objects. With this LCD_FRAME software tool, we analyzed the I-V characteristics of a-Si TFT and its signal distortion which has maximum 1.58 $\mu$s delay along the panel scan line of the package containing 480 ${\times}$ 240 pixels. We designed the package structure of maximum 6.35 $\mu$s signal delays and 3360 ${\times}$ 780 pixels, and as a result we showed that the proper structure of 20 $\mu$m scan line width, 60$\mu$m panel TFT gate width and 8 $\mu$m gate length. This LCD_FRAME software tool provides results of the analysis and the design in the form of input files of the SPICE program, text data files, and graphic charts.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2013.05a
• /
• pp.791-794
• /
• 2013

Electronic systems may be cause of various serious failures due to an ionizing radiation effect when exposed to a prompt gamma-ray pulse. This transient electrical malfunction can, in some cases, results in a failure of the electronic system of which the circuits are a part. Transient radiation measurement and evaluation system is required to development for enhanced radiation-resistance against the initial nuclear radiation produced by the detonation of a nuclear weapon of semiconductor devices. In these studies, we performed the following work. In the first part of the work, we carried out a SPICE simulation applied to nuclear radiation condition for PN diode and we also investigated the photocurrent by a pulsed gamma-ray on a PN diode using a TCAD simulation.

• Proceedings of the IEEK Conference
• /
• summer
• /
• pp.77-81
• /
• 2004

In this paper, we propose a analog front-end (AFE) for noncoherent On-Off Keying (OOK) Ultra Wide Band (UWB) system based on power detection. The proposed AFE are designed using 0.18 micron CMOS technology and verified by simulation using SPICE. The proposed AFE consist of Sample-and-Hold block, Analog-to-Digital converter, synchronizer, delayed clock generator and impulse generator. The time resolution of 1ns is obtained with 100MHz system clocks and the synchronized 10-bit digital outputs are delivered to the baseband. The impulse generator produces 1ns width pulse using digital CMOS gates. The simulation results show the feasibility of the proposed UWB AFE systems.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.56 no.1
• /
• pp.45-50
• /
• 2007

In this paper, this paper discusses how to improve the power control system of cold and hot water purifiers, in particular, system protecting device against abnormal voltage. The existing power supply control system came with a protecting device composed of varistor device only for impulse-type surges. Even though the existing system senses surge other than impulse-type, the system can not be protected. Accordingly, a new type of power control system was designed to protect the system from surge and ultimately prevent electricity accidents. The power control system suggested in this paper will be designed to protect the system by sensing input voltage and discontinuing power supply by means of SSR if voltage exceeding set value is sensed. To test the designed system, surge was imposed on the existing system and processes of system failure were experimented before safety of the designed power control system was simulated via P-spice program developed by Orcad in order to examine safety and reliability of the system.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.28 no.6
• /
• pp.91-98
• /
• 2014

For the purpose of designing and applying the optimum surge protection scheme, multi-stage coordinated surge protective device(SPD) system is suitable to successfully fulfill its tasks; first, to divert a large amount of the transient energy, second, to clamp the overvoltage to the level below the withstand impulse voltage of the equipment to be protected. The length of SPD connecting leads shall be as short as possible. Long connecting leads will degrade the protection effect of SPDs. In this paper, the influences of the length of connecting leads on the energy sharing in a coordinated SPD system were investigated experimentally, and the simulation of determining the energy sharing and protection voltage level of each SPD depending on the length of connecting leads was carried out by using P-spice program. It was confirmed that the protection voltage level and energy sharing in coordinated SPD systems are strongly influenced by the length of connecting leads.

• Journal of the Korean Society of Industry Convergence
• /
• v.24 no.5
• /
• pp.641-644
• /
• 2021

Wearable devices and IoT are being utilized in various fields, where all systems are developing in the direction of multi-functionality, low power consumption, and high speed. In this paper, we propose a DC -DC Step-down C onverter for IoT smart devices. The proposed DC -DC Step-down converter is composed of a control block of the power supply stage. It also consists of an overheat protection circuit, under-voltage protection circuit, an overvoltage protection circuit, a soft start circuit, a reference voltage circuit, a lamp generator, an error amplifier, and a hysteresis comparator. The proposed DC-DC converter was designed and fabricated using a Magnachip / Hynix 180nm CMOS process, 1-poly 6-metal, the measured results showed a good match with the simulation results.

• Journal of Pharmacopuncture
• /
• v.22 no.3
• /
• pp.122-130
• /
• 2019

Objectives: The medicinal plants are believed to enhance the natural resistance of the body to infections. Some of the main constituents of the plant and derived materials such as, proteins, lectins and polysaccharides have anti-inflammatory effects. Portulaca oleracea (P. oleracea) were used traditionally for dietary, food additive, spice and various medicinal purposes. This review article is focus on the anti-asthmatic effects of P. oleracea and its constituents. Methods: Various databases, such as the PubMed, Scopus, and Google Scholar, were searched the keywords including "Portulaca oleracea", "Quercetin", "Anti-inflammatory", "Antioxidant", "Cytokines", "Smooth muscle ", and " Relaxant effects " until the end of Jul 2018. Results: P. oleracea extracts and its constituents increased $IFN-{\gamma}$, IL-2, $IFN{\gamma}/IL-4$ and IL- 10/IL-4 ratio, but decreased secretion of $TNF-{\alpha}$, IL-4 and chemokines in both in vitro and in vivo studies. P. oleracea extracts and quercetin also signifcantly decreased production of NO, stimulated ${\beta}$-adrenoceptor and/or blocking muscarinic receptors in tracheal smooth muscles. Conclusion: P. oleracea extracts and quercetin showed relatively potent anti-asthmatic effects due to decreased production of NO, inflammatory cytokines and chemokines, reduced oxidant while enhanced antioxidant markers, and also showed potent relaxant effects on tracheal smooth muscles via stimulatory on ${\beta}$-adrenoceptor or/and blocking muscarinic receptors.