• Korean Journal of Materials Research
• /
• v.16 no.4
• /
• pp.248-252
• /
• 2006

An investigation is reported on the coating of ZnS:Cu,Cl phosphors by $HfO_2$ using atomic layer deposition method. Hafnium oxide films were prepared at the chamber temperature of $280^{\circ}C$ using $Hf[N(CH_3)_2]_4\;and\;O_2$ as precursors and reactant gas, respectively. XPS and ICP-MS analysis showed the surface composition of coated phosphor powder was hafnium oxide. In FE-SEM analysis, the surface morphology of uncoated phosphors became smoother and clearer as the number of ALD cycle increased from 900 to 1800. The photoluminescence intensity for coated phosphors showed $7.3{\sim}13.4%$ higher than that of uncoated. The effect means that the reactive surface is uniformly coated with stable hafnium oxide to reduce the dead surface layer without change of bulk properties and also its absorptance is almost negligible due to ultrathin(nano-scaled) films. The growth rate is about $1.1{\AA}/cycle$.

• Economic and Environmental Geology
• /
• v.33 no.3
• /
• pp.181-193
• /
• 2000

This study was undertaken to evaluate the drinking water quality based on physicochemical properties and chemical compositions of the supply water in the Daedeok Campus, and to verify the analytical reliabilities of ICP-MS and IC equipped in the Central Research Facilities at Chungnam National University , Korea. The supply water belongs to $Ca^{2+}-({HCO_3}^-+{SO_4}^{2-})$type, whereas the original water from the Daecheong lake belongs to $(Ca^{2+}-(Mg^{2+})-{HCO_3}^-$ type. Generally, temperature (14.1$^{\circ}C$), pH (6.95), Eh (0 mV), electrical conductivity (117${\mu}$S/cm) and TDS (86.975mg/l) of supply water were higher than those of original lake water . Results using WATEQ4F revealed that potentially toxic ions of the supply water might exist mainly as free metals ($M^{2+}$) and a small amount as ${CO_3}^{2-}$ and $OH^-$ complexes. Also, the water composition belongs to the kaolinite field. Calculated average enrichment indies of the supply water normalized to lake water for anions, mamor cations, toxic cations and total ions are 1.05 , 1.56, 13.05 and 1.17 , respectively. Those values of the ground water in the Daedeok Campus showed 1.71, 4.78, 5.71 and 2.49 , respectively. However , contents of all constituents of these water are within the drinking water standard. All samples were filtered before the chemical analysis. Pale yellow or yellowish brown colored materials of colloidal particles coated the filter paper to thickness of 0.02 to 0.2mm. these are mainly Fe-Cy-Zn compounds with traces of Ni and Pb, the net weights of which compounds range from 0.01to 3.20mg/l. Most elements did not show any conceivable filtering effect of Cu, Fe and Zn. Especially, mean concentration of total Fe decreased considerably from 168.52${\mu}g$/lto 42.58${\mu}g$/l by filtering .

• Journal of the Korean Society for Heat Treatment
• /
• v.27 no.6
• /
• pp.281-287
• /
• 2014

Microstructural and mechanical characteristics of Al-6Si-2Cu alloy for engine mount bracket prepared by gravity casting (as-cast) and die-casting (as-diecast) process have been investigated. For the microstructural characterization, the inductively coupled plasma mass spectrometry (ICP-MS), optical microscope (OM), scanning electron microscope (SEM) and electron probe microanalysis (EPMA) analyses are conducted. For the intermetallic phases, the X-ray diffraction (XRD) and energy dispersive spectroscopy (EDS) are also conducted with quantitative and qualitative analysis. Micro Vickers hardness and static tensile test are achieved in order to measure mechanical properties of alloys. Secondary dendrite arm spacing (SDAS) of as-cast and as-diecast show 37um and 18um, respectively. A large amount of coarsen eutectic Si, $Al_2Cu$ intermetallic phase and Fe-rich phases are identified in the Al-6Si-2Cu alloy. Mechanical properties of gravity casting alloy are much higher than those of die-casting alloy. Especially, yield strength and elongation of gravity casting alloy show 2 times higher than die-casting alloy. After shot peening, shot peening refined the surface grains and Si particles of the alloys by plastic deformation. The surface hardness value shows that shot peening alloy has higher value than unpeening alloy.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.43 no.3
• /
• pp.270-276
• /
• 2010

This study estimated the heavy metal concentrations in octopus (Octopus minor) and conducted a food safety assessment of octopus. Octopus, a benthic cephalopod, was collected from the Seosan intertidal zone on the west coast of Korea. The samples were digested with acids, and then the cadmium (Cd), copper (Cu), and zinc (Zn) contents were analyzed using inductively coupled plasma mass spectrometry (ICP-MS). The Cd, Cu, and Zn range of concentrations in octopus were 0.06-19 (mean 5.8), 44-1,463 (mean 354.8), and 76-929 (mean 247.9) mg/kg on a dry weight basis, respectively. The concentrations of heavy metals were higher in the internal organs than in the mantle. Of the three heavy metals, copper had the highest concentrations in the internal organs because of the existence of hemocyanin bound with copper in octopus blood, whereas zinc had the highest concentrations in the mantle. No relationship between the concentration of heavy metals and biological parameters (length, weight, and sex) was found. The ratios (I/M) of the heavy metal concentrations in internal organs and mantle were highest for cadmium, although cadmium had much lower concentrations in the internal organs compared with copper and zinc. Considering the provisional tolerable weekly intake (PTWI) of the three heavy metals and the average intake of octopus per day, all three elements should have no adverse effects on humans.

• Bulletin of the Korean Chemical Society
• /
• v.28 no.8
• /
• pp.1375-1382
• /
• 2007

A column preconcentration method with pulverized Amberlite XAD-4 loaded with bismuthiol I (BI) has been developed for the determination of trace Cd(II) and Cu(II) in various real samples by flame atomic absorption spectrophotometry. Various experimental conditions, such as the size of XAD-4, adsorption flow rate, amount of bismuthiol I, stirring time for adsorbing bismuthiol I on XAD-4, pH of sample solution, amount of XAD-4- BI, desorption solvent, and desorption flow rate, were optimized. Also, the adsorption capacity and the adsorption rate of Cd(II) and Cu(II) on XAD-4-BI were investigated. The interfering effects of various concomitant ions were investigated, Bi(III), Sn(II) and Fe(III) were found to affect the determination. But the interference by these ions was completely eliminated by adjusting the amount of XAD-4-BI resin to 0.70 g, although the adsorption flow rate was slower. For Cd(II) our proposed technique obtained a dynamic range of 0.5-40 ng mL-1, a correlation coefficient (R2) of 0.9913, and a detection limit of 0.3 ng mL-1. For Cu(II), the corresponding values were 2.0-120 ng mL-1, 0.9921 and 1.02 ng mL-1. To validate this proposed technique, the aqueous samples (stream water, reservoir water, tap water and wastewater), the diluted brass sample and the plastic sample, as real samples, were used. Recovery yields of 91-103% were obtained. These measured data were not different from ICP-MS data at 95% confidence level. Our proposed method was also validated using rice flour CRM (normal, fortified) samples. From the results of our experiment, we found that the technique we present here can be applied to the determination of Cd(II) and Cu(II) in various real samples.

• The Journal of the Petrological Society of Korea
• /
• v.13 no.4
• /
• pp.238-243
• /
• 2004

Duwon meteorite was fallen on 23 November 1943 in Duwonmyeon, Goheung, Jeolanam-Do. We measured rare earth element abundance of Duwon meteorite by isotope dilution thermal ion mass spectrometry (ID-TIMS) and ICP-MS. As a result, except La and Ce, abundance of other rare earth element show a correspondence within 10％ of error range. However, La and Ce show more than 70％ in abundance, which is considered due to 1) experimental procedure or 2) inhomogeneity of sample. Leedey meteorite was fallen on 25 November 1943 in Dewey County, Oklahoma, USA. which suggested that fallen difference between Leedey and Duwon meteorites is only 2 days. Leedey and Duwon meteorites are classified as ordinary chondrite of L6 type. In Leedey chondrite-normalized REE pattern, Duwon meteorite shows nearly flattened, which suggests close relationship between Leedey and Duwon meteorites meteoritically or cosmochemically.

• Korean Journal of Veterinary Service
• /
• v.34 no.3
• /
• pp.279-284
• /
• 2011

This study was carried out to estimate the heavy metal contents (Pb, Cd, Cr, Cu, Mn) in avian eggs sold in Seoul area, Korea from August to December, 2010. The contents of lead, cadmium, chrome, copper, manganese were estimated by inductively coupled plasma mass spectrometry. The concentrations of heavy metals (mean${\pm}$standard deviation, mg/kg) in the avian eggs were as follows: Pb $0.010{\pm}0.018$, Cd $0.000{\pm}0.001$, Cr $0.018{\pm}0.022$, Cu $0.637{\pm}0.163$, Mn $0.397{\pm}0.132$. The contents of lead and cadmium in the eggs were lower than that in meat and other foods of previously reported results. Whereas the contents of copper, manganese were similar to the previously previous results. The average daily intakes of lead and cadmium in the avian eggs were 0.1 and 0.8% respectively, as compared with PTWI (Provisional Tolerable Weekly Intakes) established by FAO/WHO Expert Committee for Food Safety Evaluation.

• Journal of the Korean earth science society
• /
• v.26 no.8
• /
• pp.800-808
• /
• 2005

Elemental mobility during the weathering of granite in the Gwangju Hyangdeung area was investigated using ICP-MS analysis. It appeared that Al, Fe, Ti, K were lost from the profile, whereas Si, Ca, Na Mg, P and Mn were immobile during chemical weathering. In less weathered soil, large enrichment of K and Ti were found relative to Al, whereas other elements such as Si, Ca, Na, Mg and P are deplete. Fe content is constant throughout the weathered profiles. Amounts of Rb, Sr, Y, Cs, Pb, Th and U increased toward the surface. Nb, and Co have accumulated in the deepest parts of the weathered soil profile. These results agree with similar published studies. In addition, the analytical data shows that Ba and Ga increased, while Cu, Zn, Cr and Ni were relatively constant in this area. REE tend to increase in most samples, while LREEs, relative to Al, were enriched in the lower and upper saprolite. HREEs were enriched in the lower and upper saprolite.

• Bulletin of the Korean Chemical Society
• /
• v.28 no.11
• /
• pp.1985-1992
• /
• 2007

Ordered mesoporous silica (MCM-41) materials with different textural properties were prepared using alkyl (dodecyl, cetyl, eicosane) trimethyl ammonium bromide (DTAB, CTAB, ETAB, respectively) as structure directing surfactants, functionalized with amine groups and used as adsorbent for the toxic metal ions, Cr (VI), As (V), Pb (II) and Hg (II). Amino functionalization of mesoporous MCM-41 was achieved by cocondensation of N-[3-(trimethoxysilyl)-propyl] aniline with tetraethyl orthosilicate. Adsorption isotherm and adsorption capacity of the amine functionalized materials for Cr (VI), As (V), Pb (II) and Hg (II) ions were followed by inductively coupled plasma mass spectrometry (ICP-MS). Results demonstrate that amine functionalized MCM-41 prepared with ETAB showed higher adsorption capacity for Cr (VI), As (V), Pb (II) and Hg (II) ions in comparison to MCM-41 prepared with CTAB and DTAB. The higher adsorption capacity for MCM-41(ETAB) was correlated with amine content in the material (determined by CHN analysis) and relative decrease in pore volume and pore diameter. X-ray diffraction (XRD) analysis, nitrogen adsorptiondesorption measurements and Fourier Transform infrared spectrometry (FTIR) were used to follow the changes in the textural parameters and surface properties of the mesoporous materials as a result of amine functionalization to correlate with the adsorption characteristics. The adsorption process was found to depend on the pH of the medium.

• Korean Journal of Food Science and Technology
• /
• v.37 no.4
• /
• pp.519-524
• /
• 2005

This study was carried out to survey the contents of mineral and heavy metal of the commercial salt and salted-fermented shrimp. Mineral and heavy metal contents of Korean products and imported salts, and their effects on shrimps were analyzed through ICP-AES/MS. K and Mg contents of Korean salts and salted-fermented shrimp were relatively higher than those imported ones, However, no significant differences were found for mineral of commercial salted-fermented shrimps between Korean products and imported ones. Heavy metal contents of commercial salts lower than the maximum permissible limit set by KFDA. As, HB, and Ni were not detected in both commercial and lab-made salted-fermented shrimps. Cd were detected ranges of ND-0.5 ppm (average 0.1ppm) for commercial salted-fermented shrimps. Pb were detected ranges of ND-0.8ppm(average 0.28ppm) for lab-made salted-fermented shrimps.