• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.31 no.3
• /
• pp.141-145
• /
• 2018

Ni-InGaAs shows promise as a self-aligned S/D (source/drain) alloy for n-InGaAs MOSFETs (metal-oxide-semiconductor field-effect transistors). However, limited thermal stability and instability of the microstructural morphology of Ni-InGaAs could limit the device performance. The in situ deposition of a Pd interlayer beneath the Ni layer was proposed as a strategy to improve the thermal stability of Ni-InGaAs. The Ni-InGaAs alloy layer prepared with the Pd interlayer showed better surface roughness and thermal stability after furnace annealing at $570^{\circ}C$ for 30 min, while the Ni-InGaAs without the Pd interlayer showed degradation above $500^{\circ}C$. The Pd/Ni/TiN structure offers a promising route to thermally immune Ni-InGaAs with applications in future n-InGaAs MOSFET technologies.

• Korean Journal of Crystallography
• /
• v.6 no.1
• /
• pp.49-55
• /
• 1995

The oriented islands of cubic galium nitride are grown on the (0001) surface of hexagonal GaN epitaxial films by halide vapour phase epitaxial process. The mutual orientation of cubic β-GaN and hexagonal α-GaN phase was observed as : [110](111) β-GaN//[1120](0001) α-GaN. Trigonally faced islands of β-GaN occupy the twined positions in relation to (111) plane in parallel to the film surface. The band gap value for β-GaN determuned from photo and local catchodoluminescent measurments is estimated to be 3.18±0.30eV at room temperature.

• Bulletin of the Korean Chemical Society
• /
• v.25 no.1
• /
• pp.51-54
• /
• 2004

Gallium nitride (GaN) powders were prepared by calcining a gallium(III) nitrate salt in flowing ammonia in the temperature ranging from 500 to 1050 $^{\circ}C$. The process of conversion of the salt to GaN was monitored by X-ray diffraction and $^{71}Ga$ MAS (magic-angle spinning) NMR spectroscopy. The salt decomposed to ${\gamma}-Ga_2O_3$ and then converted to GaN without ${\gamma}-{\beta}Ga_2O_3$ phase transition. It is most likely that the conversion of ${\gamma}-Ga_2O_3$ to GaN does not proceed through $Ga_2O$ but stepwise via amorphous gallium oxynitride ($GaO_xN_y$) as intermediates. The GaN nanowires and microcrystals were obtained by calcining the pellet containing a mixture of ${\gamma}-Ga_2O_3$ and carbon in flowing ammonia at 900 $^{\circ}C$ for 15 h. The growth of the nanowire might be explained by the vapor-solid (VS) mechanism in a confined reactor. Room-temperature photoluminescence spectra of as-synthesized GaN powders obtained showed the emission peak at 363 nm.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.21 no.6
• /
• pp.503-508
• /
• 2008

In order to reduce the piezoelectric field originated from the well layer which resides in InGaN/GaN light emitting diode, InGaN/GaN superlattice buffer layers were grown at the bottom and the top of the active layer. Measuring the photoluminescence spectra with different reverse bias voltages clearly revealed the condition of the flat band under which the transition energy is maximized and the linewidth is minimized. Accordingly, the piezoelectric field of $In_{0.15}Ga_{0.85}N$ in our sample was estimated as -1.08 MV/cm. It is less than half the value reported in the previous studies, and it is evidenced that the strain has reduced due to the superlattice buffer layers.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.26 no.2
• /
• pp.165-170
• /
• 2015

In this paper, we present design and measurement of LNA(Low Noise Amplifier) based on GaN HEMT(Gallium Nitride High Electron Mobility Transistor) to reduce the total noise figure of radar receiver and for robustness of LNA. In radar receiver using LNA based on GaAs(Gallium Arsenide) technology, limiter is necessary at the very front of the radar receiver to protect LNA. As a result, total noise figure of radar receiver is deteriorated. In this research, measured noise figure of LNA based on GaN HEMT is below 2 dB. In the case of commercialized GaAs LNA, recommended maximum input power is about 30 dBm. On the other hand, GaN HEMT LNA which is designed and measured is burned-out when input power is 43 dBm and robustness is guaranteed at input power 45.4 dBm.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.15 no.7
• /
• pp.591-596
• /
• 2002

In this work, epitaxial GaN is grown on sapphire substrate in AlGaN/GaN heterostructures. Deliberate oxygen doping of GaN grown by MOVPE has been studied. The electron concentration increased as a function of the square root of the oxygen partial Pressure. Oxygen is a shallow donor with a thermal ionization energy of $27\pm2 meV$ measured by temperature dependent Hall effects. A compensation ratio of $\theta$=0.3~0.4 was determined from Hall effect measurements. The formation energy of $O_N$ of $E^F$ =1.3eV determined from the experimental data, is lower than the theoretically predicted vague.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.42 no.12
• /
• pp.103-112
• /
• 2005

In this paper, in order to derive the current-voltage characteristics of n-AlGaN/GaN HEMTs with the piezoelectric and spontaneous polarizations, we suggested analytical solutions for the two-dimensional Poisson equation in the AlGaN and GaN regions by taking into account the longitudinal field variation, field-dependent mobility, and the continuity condition of the channel current flowing in the quantum well. Obtained expressions for long and short channel devices would be applicable to the entire operating regions in a unified manner. Simulation results show that the drain saturation current increases and the cutoff voltage decreases as drain voltage increases. Compared with the conventional models, the present model seems to provide more reasonable explanation for the drain-induced threshold voltage roll-off and the channel length modulation effect.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.2
• /
• pp.91-97
• /
• 2013

Self-heating effects during operation of high current AlGaN/GaN power transistors degrade the current-voltage characteristics. In particular, this problem becomes serious when a low thermal conductivity Si substrate is used. In this work, AlGaN/GaN-on-Si devices were fabricated with various channel widths and Si substrate thicknesses in which the structure dependent self-heating effects were investigated by temperature dependent measurements as well as thermal simulation. Accordingly, a device structure that can effectively dissipate the heat was proposed in order to achieve the maximum current in a multi-channel, large area device. Employing via-holes and common electrodes with a 100 ${\mu}m$ Si substrate thickness improved the current level by 75% reducing the channel temperature by 68%.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.02a
• /
• pp.124-124
• /
• 2010

Much interest has been focused on InGaN-based materials and their quantum structures due to their optoelectronics applications such as light emitting diode (LED) and photovoltaic devices, because of its high thermal conductivity, high optical efficiency, and direct wide band gap, in spite of their high density of threading dislocations. Build-in internal field-induced quantum-confined Stark effect in InGaN/GaN quantum well LED structures results in a spatial separation of electrons and holes, which leads to a reduction of radiative recombination rate. Therefore, many growth techniques have been developed by utilizing lateral over-growth mode or by inserting additional layers such as patterned layer and superlattices for reducing threading dislocations and internal fields. In this work, we investigated various characteristics of InGaN multiple quantum wells (MQWs) LED structures grown on selectively wet-etched porous (SWEP) GaN template layer and compared with those grown on non-porous GaN template layer over c-plane sapphire substrates. From the surface morphology measured by atomic force microscope, high resolution X-ray diffraction analysis, low temperature photoluminescence (PL) and PL excitation measurements, good structural and optical properties were observed on both LED structures. However, InGaN MQWs LED structures grown on SWEP GaN template layer show relatively low In composition, thin well width, and blue shift of PL spectra on MQW emission. These results were explained by rough surface of template layer, reduction of residual compressive stress, and less piezoelectric field on MQWs by utilizing SWEP GaN template layer. Better electrical properties were also observed for InGaN MQWs on SWEP GaN template layer, specially at reverse operating condition for I-V measurements.

• Journal of Adhesion and Interface
• /
• v.24 no.2
• /
• pp.60-63
• /
• 2023

The AlGaN/GaN heterostructure has high electron mobility due to the two-dimensional electron gas (2-DEG) layer, and has the characteristic of high breakdown voltage at high temperature due to its wide bandgap, making it a promising candidate for high-power and high-frequency electronic devices. Despite these advantages, there are factors that affect the reliability of various device properties such as current collapse. To address this issue, this paper used metal-organic chemical vapor deposition to continuously deposit AlGaN/GaN heterostructure and SiN passivation layer. Material and electrical properties of GaN HEMTs with/without SiN cap layer were analyzed, and based on the results, low-frequency noise characteristics of GaN HEMTs were measured to analyze the conduction mechanism model and the cause of defects within the channel.