• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2005.11a
• /
• pp.279-280
• /
• 2005

We have designed a single gap transflective liquid crystal display (LCD) driven by a fringe electric field and vertical field. The conventional FFS mode does not have an electrode on top substrate, it shows not only slow response time due to weak electric field but also slow discharging problem when electrostatic field is generated after fabricating the cell. To solve these problems, transflective LCD with ITO coated upper substrate was suggested but the transmittance was reduced significantly due to effects from vertical field. Hence, in the present paper, new transflective LCD with ITO coating only in the reflective region was characterized.

• Journal of the Semiconductor & Display Technology
• /
• v.15 no.3
• /
• pp.30-34
• /
• 2016

We investigated magnetic field, discharged voltage, and as-deposited film uniformity at facing targets sputtering (FTS) system with magnetic field type: i) concentrated and ii) distributed magnetic field type. And Al doped ZnO (AZO) films were prepared at two magnetic field type such as concentrated magnetic field type and distributed magnetic field type, respectively. Discharge voltage at the distribution type is lower than concentration type due to low magnetic flux (middle magnetic flux: Concentration 1200 G and Distribution 600 G). The films deposited at the distributed magnetic field were more uniform than concentration type. All of prepared AZO films had a resistivity of under $10^{-4}[{\Omega}{\cdot}cm]$ and a transmittance of more than 85 % in the visible range.

• Earthquakes and Structures
• /
• v.17 no.6
• /
• pp.533-543
• /
• 2019

This paper presents a study on the behavior of an RC bridge under near-field and far-field ground motions. For this purpose, a dynamic nonlinear finite element time history analysis has been conducted. The near-field and far-field records are chosen pairwise from the same events which are fits to the seismic design of the bridge. In order to perform an accurate seismic evaluation, the model has been analyzed under two vertical and horizontal components of ground motions. Parameters of relative displacement, residual displacement, and maximum plastic strain have been considered and compared in terms of near-field and far-field ground motions. In the following, in order to decrease the undesirable effects of near-field ground motions, a viscous damper is suggested and its effects have been studied. In this case, the results show that the near-field ground motions increase maximum relative and residual displacement respectively up to three and twice times. Significant seismic improvements were achieved by using viscous dampers on the bridge model. Somehow under the considered near-field ground motion, parameters of residual and relative displacement decrease dramatically even less than the model without damper under the far-field record of the same ground motion.

• Journal of Biosystems Engineering
• /
• v.29 no.2
• /
• pp.109-120
• /
• 2004

To obtain basic information for precision agriculture, spatial variability of rice growth condition was evaluated in 100m ${\times}$100m paddy field. The rice growth condition of four hundred locations in the field were investigated to analyze the spatial variability of their properties ; SPAD, plant length and tiller number. Geostatistical analysis was carried out to examine within-field spatial variability using semivariograms and kriged maps as well as descriptive statistics. Descriptive statistics showed that the coefficient of variation for SPAD, plant length, and tiller number exceeded 5.70 %, suggesting a relatively high variability. Geostatistical analysis indicated a high spatial dependence for all the properties except for the second tiller number. The range of spatial dependence was about 20 m for SPAD, plant length, and tiller number. Based on the results of spatial dependence, kriged maps were prepared for the properties to analyse their spatial distribution in the field. The results reflected the history of field management. In conclusion, the need for site-specific field management and possibility of precision agriculture were demonstrated even in an almost flat paddy field.

• Journal of Biomedical Engineering Research
• /
• v.35 no.4
• /
• pp.105-110
• /
• 2014

For the combination of MRI and magnetic particle hyperthermia(MPH), we investigated the relative heating efficiency with respect to the strength of the static magnetic field under which the magnetic nanoparticles are to be heated by RF magnetic field. We performed nanoparticle heating experiments at the fringe field of 3T MRI magnet with applying the RF magnetic field perpendicularly to the static magnetic field. The static field strengths were 0T, 0.1T, 0.2T, and 0.3T. To prevent the coil heat from conducting to the nanoparticle suspension, we cooled the heating solenoid coil with temperature-controlled water with applying heat insulators between the solenoid coil and the nanoparticle container. We observed significant decrease of heat generation, up to 6% at 0.3T(100% at 0T), due to the magnetic saturation of the nanoparticles of 15 nm diameter under the static field. We think MPH is still feasible at low magnetic field lower than 0.3T if stronger RF magnetic field generation is permitted.

• Journal of Electrical Engineering and Technology
• /
• v.8 no.6
• /
• pp.1481-1486
• /
• 2013

In this paper, a new two dimensional (2D) analytical model of a Dual Material Gate tunnel field effect transistor (DMG TFET) is presented. The parabolic approximation technique is used to solve the 2-D Poisson equation with suitable boundary conditions. The simple and accurate analytical expressions for surface potential and electric field are derived. The electric field distribution can be used to calculate the tunneling generation rate and numerically extract tunneling current. The results show a significant improvement of on-current and reduction in short channel effects. Effectiveness of the proposed method has been confirmed by comparing the analytical results with the TCAD simulation results.

• Journal of the Korean Society of Safety
• /
• v.21 no.5 s.77
• /
• pp.34-39
• /
• 2006

In this paper, we investigated the electric field distribution according to the roughness in aramid insulating paper for electric machine. Aramid insulating paper has been used to electric insulating of the traction motor and generators for large capacity. We studied the electric field distribution using boundary element method for Aramid insulating paper. As a result of simulation, the electric field increased according to the surface roughness existence. Electric field decreased due to radius of surface roughness reduction, and Electric field concentration appeared at electrode boundary and rough surface.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2008.04a
• /
• pp.468-471
• /
• 2008

Sound manipulation is to control sound field using multiple sound sources for appropriate purposes. In linear acoustics, a sound can be constructed by superimposing several fundamental sound fields such as a planewave and sphere shape sound field. That is how we manipulate sound field. In this paper, we introduce the theory of sound manipulation and its applications from the examples of the generation of fundamental sound field: a circle, a ring shape sound field and a planewave field.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2003.11a
• /
• pp.13-17
• /
• 2003

In this paper, the design parameters for the magnetic field source at extremely low frequency are proposed. This facility can be used for in vivo experiments with small animals to investigate biological response to the driving magnetic fields. In case that the exposed animals are motionless, the animals may be affected by the directivity of driving field. To avoid this effect, a 2-axis ELF magnetic field driving apparatus was designed, The optimum location and number of turns of each coil were obtained by numerical analysis. Applying these data to the MATLAB code (for computation), the magnetic field distribution was obtained. The calculation result for a well-designed facility showed that the space in which the amplitude of the magnetic field lies within the 95% of the magnetic field distribution was more than 60% of each axis length.

• Proceedings of the KIEE Conference
• /
• 1998.07e
• /
• pp.1782-1784
• /
• 1998

The effect of magnetic field was measured on NOx removal for cylinderical-wire plasma reactor with magnetic field applied to electric field vertically. Consumption power increased with increasing discharge voltage. When magnetic field was applied to electric field vertically, consumption power decreased NOx removal rate of plasma reactor with magnetic field were higher, 10-15%, than that of plsama reactor without magnetic field. And NOx removal rate decreased with increasing gas flow rate.