• 한국전자거래학회지
• /
• 제15권4호
• /
• pp.101-121
• /
• 2010

본 논문은 플래시 메모리와 하드디스크로 구성되는 하이브리드 저장장치의 성능을 높이기 위한 프리패칭 기법을 제안한다. 하이브리드 저장장치에 포함된 플래시 메모리는 하드디스크에 비해 쓰기/읽기 연산 속도가 상대적으로 빠르기 때문에 이를 캐시 공간처럼 활용하여 성능을 높일 수 있다. 프리패칭을 위한 기본 전략은 순차패턴 마이닝을 이용하는 것이며, 이를 이용하면 시간적 흐름을 가지는 과거 객체 참조열로부터 반복되는 객체 접근 패턴을 추출할 수 있다. 프리패칭 기법을 사용하여 하이브리드 저장장치의 성능을 최대화하기 위하여 본 논문은 두 가지 방법을 사용하였다. 첫 번째는 플래시 메모리 매핑을 위하여 기존의 FAST 알고리즘을 개선하였고, 두 번째는 제한된 플래시 메모리의 공간을 효율적으로 사용하기 위하여 프리패칭 단위로 파일 수준과 블록 수준을 동시에 고려하였다. 제안 기법의 효용성을 평가하기 위해 참조 지역성을 가지는 합성 데이터와 UCC 데이터를 활용하여 실험을 실시하여 제안된 방법의 우수성을 증명하였다.

• 대한기계학회논문집A
• /
• 제26권8호
• /
• pp.1545-1551
• /
• 2002

The optical storage device has recently experienced significant improvement, especially for the aspects of high capacity and fast transfer rate. However, it is necessary to study a new shape of air bearing surface for the rotary type actuator because the optical storage device has the lower access time than that of HDD (Hard Disk Drives). In this study, we proposed the air bearing shape by using SA (Simulated Annealing) algorithm which is very effective to achieve the global optimum instead of many local optimums. The objective of optimization is to minimize the deviation in flying height from a target value 100nm. In addition, the pitch and roll angle should be maintained within the operation limits.

• Journal of Power Electronics
• /
• 제15권4호
• /
• pp.1026-1034
• /
• 2015

In this paper, a unified control strategy using the current space vector modulation (CSVM) technique is proposed and applied to a bidirectional three-phase DC/AC converter. The operation of the converter changes with the direction of the power flow. In the charging mode, it works as a buck type rectifier; and during the discharging mode, it operates as a boost type inverter, which makes it suitable as an interface between high voltage AC grids and low voltage energy storage devices. This topology has the following advantages: high conversion efficiency, high power factor at the grid side, tight control of the charging current and fast transition between the charging and discharging modes. The operating principle of the mode analysis, the gate signal generation, the general control strategy and the transition from a constant current (CC) to a constant voltage (CV) in the charging mode are discussed. The proposed control strategy has been validated by simulations and experimental results obtained with a 1kW laboratory prototype using supercapacitors as an energy storage device.

• 사물인터넷융복합논문지
• /
• 제9권3호
• /
• pp.81-86
• /
• 2023

플래시 메모리 기반 저장장치인 SSD(solid state disk)는 높은 집적도와 빠른 데이터 처리가 가능한 장점을 가지고 있다. 따라서 급격하게 증가하고 있는 빅데이터를 관리하는 고용량 데이터 저장 시스템의 저장장치로 활용되고 있다. 그러나 저장 미디어인 플래시 메모리에 일정 횟수 이상 반복해서 쓰기/지우기 동작을 반복하면 셀이 마모되어 사용하지 못하는 물리적 한계가 있다. 본 논문에서는 플래시 메모리의 불량률을 줄이고 수명을 연장하기 위해 불량이 발생한 다중 비트 셀을 단일 비트 셀로 변환하여 사용하는 방법을 제안한다. 제안하는 아이디어는 물리적 특징이 다르지만 동일하게 불량으로 처리되고 있는 다중 비트 셀과 단일 비트 셀의 불량 및 처리 방법을 구분하였다. 그리고 불량이 예상되는 다중 비트 셀을 단일 비트 셀로 변환하여 불량률을 개선하고 전체적인 수명을 연장하였다. 마지막으로 시뮬레이션을 통해 SSD의 증가한 수명을 측정하여 제안하는 아이디어의 효과를 증명하였다.

• 한국인터넷방송통신학회논문지
• /
• 제22권6호
• /
• pp.57-62
• /
• 2022

최근 상변화메모리와 같은 고속 스토리지 매체의 출현으로 느린 디스크 스토리지에 적합하게 설계된 메모리 관리 기법에 대한 재고가 필요한 시점에 이르렀다. 본 논문에서는 상변화메모리를 가상메모리의 스왑장치로 이용하는 시스템을 위한 새로운 페이지 교체 정책을 제안한다. 제안하는 방식은 페이지 교체 정책이 전통적으로 추구하던 페이지 폴트 횟수 절감뿐 아니라 스왑 장치에 발생하는 쓰기량 절감을 동시에 추구한다. 이는 상변화메모리의 쓰기 연산이 느리고 쓰기 횟수에 제한이 있다는 점에 착안한 것이다. 구체적으로 살펴보면 메모리 부하가 높은 경우 페이지 폴트를 줄이는 데에 초점을 맞추고 메모리 공간에 여유가 있을 경우 스토리지 쓰기량을 줄이는 적응적인 방식을 채택한다. 이를 통해 제안하는 정책이 메모리 시스템의 성능을 저하시키지 않으면서 스토리지 쓰기량을 크게 절감함을 다양한 워크로드의 메모리 참조 트레이스를 재현하는 시뮬레이션 실험을 통해 보인다.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제2권3호
• /
• pp.197-204
• /
• 2002

DRAM, SRAM, and FLASH memory are three major memory devices currently used in most electronic applications. But, they have very distinct attributes, therefore, each memory could be used only for limited applications. MRAM (Magneto-resistive Random Access Memory) is a promising candidate for a universal memory that meets all application needs with non-volatile, fast operational speed, and low power consumption. The simplest architecture of MRAM cell is a series of MTJ (Magnetic Tunnel Junction) as a data storage part and MOS transistor as a data selection part. To be a commercially competitive memory device, scalability is an important factor as well. This paper is testing the actual electrical parameters and the scaling factors to limit MRAM technology in the semiconductor based memory device by an actual integration of MRAM core cell. Electrical tuning of MOS/MTJ, and control of resistance are important factors for data sensing, and control of magnetic switching for data writing.

• ETRI Journal
• /
• 제34권4호
• /
• pp.553-563
• /
• 2012

Serial peripheral interface (SPI) has been identified as a bottleneck in many wireless sensing systems today. SPI is used almost universally as the physical connection between the microcontroller unit (MCU) and radios, storage devices, and many types of sensors. Virtually all wireless sensor nodes today perform up to twice as many bus transactions as necessary to transfer a given piece of data, as an MCU must serve as the bus master in all transactions. To eliminate this bottleneck, we propose the master-handoff protocol. After the MCU initiates reading from the source slave device and writing to the sink slave device, the MCU as a master becomes a slave, and either the source or the sink slave becomes the temporary master. Experiment results show that this master-handoff technique not only cuts the data transfer time in half, but, more importantly, also enables a superlinear energy reduction.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2000년도 하계종합학술대회 논문집(3)
• /
• pp.97-100
• /
• 2000

As network resources have become faster and demands for multimedia service through network have increased, the demand for Media server system has increased. These kinds of media server solve their bottle neck problem of internal storage device by using parallel system which takes advantage of fast network resource. Many vendors have suggested each of their media server system to solve these problem radically, but most of them require major modification of infra component and additional drawback has added. For example, storage mechanism for specific media requires new file system which is totally different from traditional one, and algorithm for enhancing performance may not suit for traditional operating system environment. In this paper, we designed a parallel media server based on web interface of traditional system and implemented a program for media server. Implemented server system performs parallel processing through web interface without any modification of traditional system, and controls which is related to merging load by distributed data is charged only to client and control server and consequently load of storage server can be minimized. And also, data transfer protocol for streaming media includes Retransfer algorithm and client Admission control policy relevant to performance of whole system.

• 한국방송∙미디어공학회:학술대회논문집
• /
• 한국방송공학회 2010년도 하계학술대회
• /
• pp.360-363
• /
• 2010

Streaming Technology can support the real-time playback without downloading and storing multimedia data in local HDD. So, client browser or plug-in can represent multimedia data before the end of file transmission using streaming technology. Recently, the demand for efficient real-time playback and transmission of large amounts of multimedia data is growing rapidly. But most users' connections over network are not fast and stable enough to download large chunks of multimedia data. In this paper, we propose an intelligent IP streaming system based on personalized media service. The proposed IP streaming system enables users to get an intelligent recommendation of multimedia contents based on the user preference information stored on the streaming server or the home media server. The supposed intelligent IP streaming system consists of Server Metadata Agent, Pumping Server, Contents Storage Server, Client Metadata Agent and Streaming Player. And in order to implement the personalized media service, the user information, user preference information and client device information are managed under database concept. Moreover, users are assured of seamless access of streamed content event if they switch to another client device by implementing streaming system based on user identification and device information. We evaluate our approach with manufacturing home server system and simulation results.

• 대한임베디드공학회논문지
• /
• 제4권2호
• /
• pp.79-83
• /
• 2009

Streaming Technology can support the real-time playback without downloading and storing multimedia data in local HDD. So, client browser or plug-in can represent multimedia data before the end of file transmission using streaming technology. Recently, the demand for efficient real-time playback and transmission of large amounts of multimedia data is growing rapidly. But most users' connections over network are not fast and stable enough to download large chunks of multimedia data. In this paper, we propose an intelligent IP streaming system based on personalized media service. The proposed IP streaming system enables users to get an intelligent recommendation of multimedia contents based on the user preference information stored on the streaming server or the home media server. The supposed intelligent IP streaming system consists of Server Metadata Agent, Pumping Server, Contents Storage Server, Client Metadata Agent and Streaming Player. And in order to implement the personalized media service, the user information, user preference information and client device information are managed under database concept. Moreover, users are assured of seamless access of streamed content event if they switch to another client device by implementing streaming system based on user identification and device information. We evaluate our approach with manufacturing home server system and simulation results.