• 대한토목학회논문집
• /
• 제34권3호
• /
• pp.895-906
• /
• 2014

대수심 부유 구조물의 하부기초 기술 중 하나인 dynamically penetration anchor (DPA 또는 흔히 torpedo anchor로 칭함)의 거동특성을 시험결과 및 수치 해석적 접근을 통해 분석하였다. 기존의 유한요소 해석기법으로는 이러한 대수심 anchor 구조물의 거동 특성을 적절히 모사하기 어렵기 때문에 본 연구에서는 이러한 부분을 해결하기 위해 Coupled Eulerian-Lagrangian (CEL) 법을 통해 지반-구조물 사이에서 발생하는 메쉬(mesh)의 distortion 현상 및 경계조건 등의 문제점을 대변형의 관점에서 해결하고자 하였다. 실측치와의 비교를 통해, CEL 기법의 타당성을 검증하였고, 그 결과 본 연구에서 적용한 CEL 기법이 기존 유한요소 기술로는 구현이 불가능한 대수심 anchoring system의 자유낙하에 의한 전반적인 거동 및 지반의 변형특성을 적절히 예측함을 알 수 있었다. 또한 검증된 기법을 바탕으로 dynamic anchor의 거동에 영향을 주는 여러 요소들에 대한 매개변수 연구를 추가로 수행하였다.

• Geomechanics and Engineering
• /
• 제28권2호
• /
• pp.197-207
• /
• 2022

The seismic holding behaviors of plate anchor embedded into submerged coarse-grained soils were investigated considering different anchor inclinations. The limit equilibrium method and the Pseudo-Dynamic Approach (PDA) were employed to calculate the inertia force of the soils within the failure rupture. In addition, assuming the permeability of coarse-grained soils was sufficiently large, the coefficient of hydrodynamic force applied on the inclined plate anchor is obtained through adopting the exact potential flow theory. Therefore, the seismic holding resistance was calculated as the combination of the inertia force and the hydrodynamic force within the failure rupture. The failure rupture can be developed due to the uplift loads, which was assumed to be an arc of a circle perpendicular to the anchor and inclines at (π/4 - φ/2). Then, the derived analytical solutions were evaluated by comparing the static breakout factor N_γ to the published experimental and analytical results. The influences of soil and wave properties on the plate anchor holding behavior are reported. Finally, the dynamic anchor holding coefficients N_γd, were reported to illustrate the anchor holding behaviors. Results show that the soil accelerations in x and z directions were both nonlinear. The amplifications of soil accelerations were more severe at lower normalized frequencies (ωH/V) compared to higher normalized frequencies. The coefficient of hydrodynamic force, C, of the plate anchor was found to be almost constant with anchor inclinations. Finally, the seismic anchor holding coefficient oscillated with the oscillation of the inertia force on the plate anchor.

• 한국강구조학회 논문집
• /
• 제26권1호
• /
• pp.21-30
• /
• 2014

본 연구에서는 헤어핀 보강 및 스트럽 보강 선설치앵커의 정적 및 동적 전단하중에 대한 저항강도 평가를 위한 실험을 수행하였다. 보강철근은 D6 이형철근을 사용하였으며 연단거리 120mm의 직경 20mm 앵커에 대해 정적 하중과 1Hz의 편진하중으로 각각 3개의 시험체에 대해 실험을 수행하였다. 헤어핀 보강 앵커는 헤어핀의 덮개가 강도에 직접 영향을 미치는 것으로 확인되었으며, 정적 대비 동적하중에서 강도의 저하는 없는 것으로 평가되었다. 스트럽 보강 앵커는 비보강 앵커에 비해 저항강도의 증가는 미소하였으며 동적하중에 의한 강도는 정적하중에 의한 강도와 거의 같은 값을 보였다.

• 한국의류학회지
• /
• 제30권11호
• /
• pp.1636-1647
• /
• 2006

The purpose of this study was to provide data that can be used to suggest idealistic anchor's image to capture ratings for the news program and to suggest guide for casting and training anchors for the broadcasting stations by examining the idealistic looks and images of TV news anchors by asking the general viewers who watch TV, The research methods was questionnaire survey. The subjects were 839 male and female audiences in theire 20's and 40's who residing in Seoul and Gyeonggi area. The study results are as follows: 1) The factors that decide impression of a female anchor The factors that decide female anchor's impression were 'specialty factor, friendliness factor, elegance factor, dynamic factor, and attractiveness factor'. 2) The difference in formation of impression according to makeup and hair style of a female anchor In case of specialty and friendliness factors scored high when putting on natural makeup, dynamic factors scored high when putting on elegant makeup, and attractiveness factor when putting on natural and romantic makeup. All factor were high when a female anchor had short-cut style and straight hair 3) Formation of anchor's impression from makeup and hair style according to the perceiver's variables (gender and age) Male and female audiences both gave hish score for a female anchor's specialty such as 'confident and reliable' and friendliness such as 'warm and comfortable' when a female anchor puts on natural makeup. They gave high score for attractiveness factor such as' good impression and refined' when putting on romantic makeup and high score for dynamic factor such as 'positive and confident' when putting on elegant makeup. Both male and female audiences gave high score fur all except friendliness factor when a female anchor had short-cut style compared to bobbed hair and high score far specialty factor when a female anchor had straight hair. The audiences both in their 20's and 40's gave high score for specialty and friendliness when a female anchor put on natural makeup while the perceivers at their 20's gave high score for elegance and dynamic factor when a female anchor put on elegant makeup. The audiences both in their 20's and 40's gave high score for all factors when female anchor had short-cut hair.

• Structural Engineering and Mechanics
• /
• 제58권1호
• /
• pp.39-58
• /
• 2016

Since the publication of ACI 318-02, the concrete capacity design (CCD) method has been used to determine the resistance of unreinforced concrete anchors. The regulation of steel-reinforced anchors was proposed in ACI 318-08. Until ACI 318-08, the shear resistance of concrete breakout for an unreinforced anchor during an earthquake was reduced to 75% of the static shear strength, but this reduction has been eliminated since ACI 318-11. In addition, the resistance of a hairpin-reinforced anchor was calculated using only the strength of the steel, and a regulation on the dynamic strength was not given for reinforced anchors. In this study, shaking table tests were performed to evaluate the dynamic shear strength of unreinforced and hairpin-reinforced cast-in-place (CIP) anchors during earthquakes. The anchors used in this study were 30 mm in diameter, with edge distances of 150 mm and embedment depths of 240 mm. The diameter of the hairpin steel was 10 mm. Shaking table tests were carried out on two specimens using the artificial earthquake, based on the United States Nuclear Regulatory Commission (US NRC)'s Regulatory Guide 1.60, and the Northridge earthquake. The experimental results were compared to the current ACI 318 and ETAG 001 design codes.

• Computers and Concrete
• /
• 제32권5호
• /
• pp.499-511
• /
• 2023

Anchor channels are commonly used for façade, tunnel, and structural connections. These connections encounter various types of loadings during their service life, including high rate or impact loading. For anchor channels that are placed close and parallel to an edge and loaded in shear perpendicular to and towards the edge, the failure is often governed by concrete edge breakout. This study investigates the transverse shear behavior of the anchor channels under quasi-static and high rate loadings using a numerical approach (3D finite element analysis) utilizing a rate-sensitive microplane model for concrete as constitutive law. Following the validation of the numerical model against a test performed under quasi-static loading, the rate-sensitive static, and rate-sensitive dynamic analyses are performed for various displacement loading rates varying from moderately high to impact. The increment in resistance due to the high loading rate is evaluated using the dynamic increase factor (DIF). Furthermore, it is shown that the failure mode of the anchor channel changes from global concrete edge failure to local concrete crushing due to the activation of structural inertia at high displacement loading rates. The research outcomes could be valuable for application in various types of connection systems where a high rate of loading is expected.

• 한국강구조학회 논문집
• /
• 제26권1호
• /
• pp.11-20
• /
• 2014

2001년 이후 앵커의 설계는 Concrete Capacity Design(CCD) 방법이 적용되고 있는데, 국내 기준에서는 지진하중에 대한 콘크리트의 파열파괴강도를 정적 파괴강도의 75%로 제한하고 있다. 본 연구에서는 무근콘크리트에 매입된 선설치앵커의 동적 전단하중에 대한 콘크리트 파열파괴강도 평가하기 위한 실험을 수행하였다. 이를 위해 직경 20 mm의 앵커에 대해 정적 하중과 동적 편진하중에 대한 실험을 각각 3개의 시험체에 대해 수행하였으며, 앵커의 연단거리는 120 mm를 적용하였다. 동적 실험은 15 cycle의 편진하중을 1 Hz의 속도로 재하하였으며 반복하중단계의 크기를 키워가면서 최종 파괴 시까지 가력하였다. 실험으로부터 동적 전단하중에 의한 콘크리트 파열파괴강도는 정적하중에 의한 것과 거의 같은 파괴강도를 보였다.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2009년도 세계 도시지반공학 심포지엄
• /
• pp.1100-1106
• /
• 2009

This study intends to develop a pulse discharge device to strengthen the pushing power by expanding the cavity of the anchor settlement to form a spheric root for the purpose of constructing the economical and stable anchor. and, a series of field test were carried out in order to check applicability of machines of pulse powered underreamed anchors. Through the experiments, the electrical characteristics of the pulse power equipment had been identified it and the dynamic pressure generated from the subsequent change had been measured. Here, the measured dynamic pressure is the cavity expansion pressure to impact on the ground around the anchor settlement. Since this pressure has effects of cavity expansion and bored surface hardening with dynamic hardening effects on the anchor settlement, it is expected that it will largely contribute the increase of pushing power with a strong frictional resistance.

• Geomechanics and Engineering
• /
• 제18권2호
• /
• pp.153-159
• /
• 2019

This paper examines the results from three-dimensional dynamic finite element analysis undertaken to develop a new dynamically installed anchor (DIA). Several candidate shapes of new DIAs were selected after an investigation into previous researches of existing DIA designs. The performances of selected DIAs during the installation and loading in non-homogeneous clay were investigated through large deformation finite element (LDFE) analyses. Findings were compared to the current anchors in operation (i.e., Torpedo and Omni-Max DIA) to assess the viability of the new designs in the field. Overall, the anchor embedment depths of the novel DIAs lied under the results of OMNI-Max DIA. And also, the tracked anchor trajectory confirmed that, the novel DIAs dove deeper with stiffer travelling angle, compared to the OMNI-Max DIA. These elements are more critical and beneficial especially in a field where the achieved embedment depths are generally low.

• 한국강구조학회 논문집
• /
• 제30권2호
• /
• pp.67-76
• /
• 2018

스터럽 보강 선설치 앵커의 동적 전단하중 하의 파열파괴강도를 평가하기 위한 실험 연구를 수행하였다. 전단 하중은 ACI 355.2 및 ETAG 001에 제시된 지진모의실험 방식으로 재하하였다. 시험체는 M36 앵커(연단거리 180mm)를 D10 스터럽(간격 100mm)으로 보강하였다. 이들 시험체는 거의 극한 파열파괴 강도에 도달한 후 앵커의 파단이 발생하였다. 이에 M42 앵커(연단거리 160mm)를 D6 스터럽(간격 100mm)으로 보강한 시험체에 대한 실험을 추가로 수행하였다. 실험 결과, 동적 전단강도는 정적 강도에 비해 낮은 값을 보이지 않았다. 또한, ACI 318 및 ETAG 001 기준은 스터럽 보강이 많을수록 파열파괴강도를 안전측으로 평가하는 것으로 나타났다.