• Proceedings of the KIEE Conference
• /
• 2004.07c
• /
• pp.1585-1587
• /
• 2004

이중 에피층 구조를 가지는 SOI(Silicon-On-Insulator) LIGBT(Lateral Insulated Gate Bipolar Transistor)의 에피층 두께 변화에 따른 항복전압 특성을 분석하였다. 제안된 소자는 전하보상효과를 얻기 위해 n/p-epi의 이중 에피층 구조를 사용하였으며, 에피층 전체에 걸쳐서 전류가 흐를 수 있도록 하기 위해 trenched anode구조를 채택하였다. 본 논문에서는 n/p-epi층의 농도를 고정시킨 후 각각의 epi층의 두께를 변화시켜가며 simulation을 수행하였을 때 항복전압의 변화 및 표면과 epi층에서의 전계분포변화를 분석하였다.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.39 no.2
• /
• pp.140-145
• /
• 2002

A new CMOS buffer removing short-circuit power consumption is proposed. The gate-driving signal of the pull-up(pull-down) transistor at the output is controlled by delayed internal signal to get tri-state output momentarily by shunting off the path of the short-circuit current. The SPICE simulation results verified the operation of the proposed buffer and showed the enhancement of the power-delay product at 3.3V supply voltage about 42% comparing to the conventional tapered CMOS buffer(1).

• Proceedings of the KIPE Conference
• /
• 2011.07a
• /
• pp.287-289
• /
• 2011

본 논문은 인피니언 테크놀로지스의 RC-IGBT (Reverse Conducting Isolated Gate Bipolar Transistor)와 SOI 드라이브 IC(Integrated Circuit)를 사용한 DIL(Dual-In-Line) 구조의 저전력 모듈인 CIPOS TM (Control Integrated POwer System) 제품을 소개한다. 이 전력 모듈은 최적의 게이트 구동회로, 트렌치 필드스톱의 RC-IGBT를 사용하여 기존의 IGBT 와 Diode를 사용하는 구조에서 최소화 된 패키지 크기를 사용하여 높은 효율을 구현할 수 있다. 본 논문을 통하여 인버터의 어플리케이션에 적합하게 설계된 전력모듈에 대한 소개와 그 특징 및 시스템 구성을 위한 고려사항에 대하여 기술하였다.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.35D no.5
• /
• pp.1-10
• /
• 1998

A GaAs MMIC composed of VCO (voltage controlled oscillator) and mixer for PCS receiver has been developed using 1.mu.m ion implanted GaAs MESFET process. The VCO consists of a colpitts-type oscillator with a dielectric resonator and the circuit configuration of the mixer is a dual-gate type with an asymmetric combination of LO and RF FETs for the improvement of intermodulation characteristics. The common-source self-biasing is used in all circuits including a buffer amplifier and mixer, achieving a single power supply (3V) operation. The total power dissipation is 78mW. The VCO chip shows a phase noise of-99 dBc/Hz at 100KHz offset. The combined VCO/mixer chip shows a flat conversion gain of 2dB, the frequency-tuning factor of 80MHz/volts in the varacter bias ranging from 0.5V to 0.5V , and output IP3 of dBm at varactor bias of 0V. The fabricated chip size is 2.5mm X 1.4mm.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.34D no.10
• /
• pp.14-23
• /
• 1997

An MMIC downconverting mixer for cellular phone application has been successfully developed using an MMIC process including $1 \mu\textrm{m}$ ion implanted gaAs MESFET and passive lumped elements consisting of spiral inductor, $Si_3N_4$ MIM capacitor and NiCr resistor. The configuration of the mixer presented in this paper is single-ended dual-gate FET mixer with common-source self-bias circuits for single power supply operation. The dimension of the fabricated circuit is $1.4 mm \times 1.03 mm $ including all input matching circuits and a mixing circuit. The conversion gian and noise figure of the mixer at LO powr of 0 dBm are 5.5dB and 19dB, respectively. The two-tone IM3 characteristics are also measured, showing -60dBc at RF power of -30dBm. Allisolations between each port show better than 20dB.

• Proceedings of the KIEE Conference
• /
• 2001.07c
• /
• pp.1343-1345
• /
• 2001

본 논문은 스냅백을 효과적으로 제거하고 순방향 전압 강하를 줄이는 새로운 구조의 분리된 이중 게이트 SOI SA-LIGBT를 제안하였다. 제안된 소자는 분리된 단락 애노드와 플로팅 오믹 접합의 적용을 통해 스냅백이 성공적으로 제거되었고, 순방향전압강하는 전류밀도가 100A/$cm^2$일 때 기존의 SA-LIGBT에 비교해서 2V 감소된다. 또한 턴-오프 특성도 분리된 단락 애노드를 적용하였기 때문에 SA-LIGBT보다 개선되었다.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2008.05a
• /
• pp.325-328
• /
• 2008

This paper presents a new conceptual electromagnetic induction eddy current-based stainless steel plate spiral type heater for heat exchanger or dual packs Heater in hot water system boiler steamer and super heated steamer, which is more suitable and acceptable for new generation consumer power applications. In addition, an active clamped quasi resonant PWM high frequency inverter using trench gate IGBTs power module can operate under a principle of zero voltage soft commutation with PWM is developed and demonstrated fora high efficient induction heated hot water system and boiler in the consumer power applications This consumer induction heater power appliance using active clamp soft switching PWM high-frequency inverter is evaluated and discussed on the basis of the simulation and experimental results.

• 한국컴퓨터산업교육학회:학술대회논문집
• /
• 2003.11a
• /
• pp.71-74
• /
• 2003

A vertical trench electrode type EST has been proposed in this paper. The proposed device considerably improve the snap-back effect which leads to a lot of problem of device applications. In this paper, the vertical dual gate Emitter Switched Thyristor(EST) with trench electrode has been proposed for improving snap-back effect. It is observed that the forward blocking voltage of the proposed device is 800V. The conventional EST of the same size were no more than 633V. Because the proposed device was constructed of trench-type electrode, the electric field moved toward trench-oxide layer, and the punch through breakdown of the proposed EST is occurred at latest.

• Proceedings of the KIEE Conference
• /
• 2002.11d
• /
• pp.232-234
• /
• 2002

Due to development of power electronics technology, power conversion system are tend to small size, easy to use and light weight. Especially motor control system have increased concerns and interests about IPM(Intelligent Power Module) inverter, which contains protection circuit, drive circuit and power devices. So, we manufactured 3-phase inverter using DIP-IPM(Dual in-line package IPM) PS21245- E(1.5 Kw) made by MITSUBISHI Electric. Some of these features include -HVIC to Provide level shifting and gate drive for high-side IGBTs. The interface circuit between pwm controller and DIP-IPM can made by direct connection. In order to validate dynamic performance of the proposed system, the actual experiment worked out at wide speed range. The developed system is shown as a good dynamic characteristics.

• Transactions on Electrical and Electronic Materials
• /
• v.2 no.3
• /
• pp.33-37
• /
• 2001

A vertical trench electrode type EST has been proposed in this paper. The proposed device considerably improves snapback which leads to a lot of problems of device applications. In this paper, the vertical dual gate Emitter Switched Thyristor (EST) with trench electrode has been proposed for improving snab-back effect. It is observed that the forward blocking voltage of the proposed device is 745V. The conventional EST of the same size were no more than 633V. Because the proposed device was constructed of trench-type electrodes, the electric field moved toward trench-oxide layer, and the punch through breakdown of the proposed EST is occurred at latest.