• Journal of the Korea Institute of Military Science and Technology
• /
• v.15 no.2
• /
• pp.147-154
• /
• 2012

In this paper, we revise the JDL data fusion model to have an ability of distributed data fusion(DDF). Data fusion is a function that produces valuable information using data from multiple sources. After the network centric warfare concept was introduced, the data fusion was required to be expanded to DDF. We identify the data transfer and control between nodes is the core function of DDF. The previous data fusion models can not be used for DDF because they don't include that function. Therefore, we revise the previous JDL data fusion model by adding the core function of DDF and propose this new model as a model for DDF. We show that our model is adequate and useful for DDF by using several examples.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.26 no.3
• /
• pp.402-409
• /
• 2002

Experiments were performed with double-concentric diffusion flame(DDF) in order to investigate the characteristics of soot formation and temperature distributions. The flame size and shape of the DDF are similar to those of the well-known normal co-flow diffusion flame(WF), except the formation of a tiny inverse flame near the central tube exit. A laser light extinction technique was used to measure the soot volume fractions. The temperature distributions in the flame were measured by rapid insertion of a R-type thermocouple. Soot concentrations along the flame axis of the DDF were higher than those of the NDF. However, the maximum soot volume fraction of the DDF along the periphery of the flame was lower than that of the NDF. It is mainly due to the effect of nitrogen-dilution from the inner air. Measured temperature distribution explains these trends of soot concentration. The temperature along the flame axis was also higher in DDF than that of the NDF. However, the flame temperatures at the flame front of the two flames were almost same regardless of the inner flame. This phenomenon means that the inverse flame inside the DDF did not affect on the flame structure including the temperature and soot concentration, except the region around the flame axis.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.5
• /
• pp.436-442
• /
• 2013

The diversity-multiplexing tradeoff (DMT) function of a special half-duplex (HD) dynamic decode and forward (DDF) relay protocol with more than two antennas at the source node, two antennas at the relay node, and two antennas at the destination node is derived. This protocol is compared to a HD NAF protocol with the same number of source antennas and a HD DDF relay protocol with two antennas at the source node, more than two antennas at the relay node, and two antennas at the destination node.

• Journal of the Korean Institute of Gas
• /
• v.18 no.3
• /
• pp.13-19
• /
• 2014

Dynamic ductile fracture (DDF) has been studied in the transportation pipeline for the carbon dioxide capture and storage(CCS) system. DDF behavior of CCS transportation pipeline has been analyzed using Battelle Two Curve Method (BTCM) and compared with the DDF behavior of natural gas pipeline. The operating safety criteria against the DDF has been investigated based on the sensitivity analyses of the pipe thickness and the operating temperature for the $CO_2$ pipeline. The DDF criteria can be applied to confirm the operating safety of the $CO_2$ pipeline. If the commercial natural gas pipeline were used at room temperature as a $CO_2$ pipeline, the thickness of pipe should be at least 7mm and the pressure should be less than 54bar for the $CO_2$ pipeline system.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.40 no.2
• /
• pp.104-110
• /
• 2003

A new direct digital frequency synthesizer (DDFS) is proposed. The DDFS uses a new ROM compression method that divides each ROM in the conventional DDFS into two ROMs (a quantization ROM and an error ROM). The total size of the ROMs in the proposed DDFS is significantly reduced compared to the original ROM. The ROM compression ratio of 78 is achieved for a DDFS with 12bit output data. A DDFS with 12bit output data for sine function was implemented in a 0.35${\mu}{\textrm}{m}$ CMOS technology. The power dissipation is 9.56㎽ at 100MHz with 3.3V and the maximum operating clock frequency is 330MHz.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.6 no.8
• /
• pp.1283-1291
• /
• 2002

In this paper, the PLL driven by the DDFS is designed on the schematic using the Q-logic cell based library and is implemented using FPGA QL32 x16B. The measurement results of the frequency synthesizer switching speed were agreement with a register. The simulated results show that the clock delay was generated after eleven clock and if input is random, It has influence on output DA converter has to be very extensive. Therefore, the DDFS used noise shaper to drive PLL by regular interval for input state. Also the bandwidth of DA converter very extensive, the simulation shows that the variation of small input control word is better than the switching speed of PLL.

• IT SoC Magazine
• /
• s.3
• /
• pp.35-37
• /
• 2004

본 연구팀이 Hynix 0.35um CMOS 4M 2P 공정을 사용하여 제작한 민수용 DDFS (DAC를 포함한 single chip)는 DC부터 100MHz 까지 사용할 수 있으며(BW=100MHz) frequency 변환속도 약 30nS, 주파수해상도 0.0745Hz, 그리고 소비 전력은 120MHz 클럭에서 약 200mW이다. 본고에서는 언급하지 않았지만, 본 연구팀이 별도의 설계로 진행된 군수용 DDFS의 경우, 출력주파수는 DC부터 320MHz 까지 가능하고 소비 전력은 800MHz 클럭에서 약 400mW이다. 이처럼 DDFS는 특성 자체의 우수성 뿐 아니라, 각종 멀티미디어 기기 및 통신시스템의 급격한 디지털화 추세로 인해 주파수합성기도 디지털화 함으로써 VLSI화가 용이하고, 이에 따라 S/W에 의한 다기능화 (programmability), 응용성의 극대화, 및 저가격화를 추구할 수 있다는 점에서 주목해야 할 분야이다. 특히 반도체기술의 발전으로 지금까지 DDFS 구현의 가장 큰 장애로 대두되던 DAC의 고속화가 부분적으로 가능해지면서 (TTL-to-ECL interface 부가회로가 별도로 필요없이 직접적인 연결), DDFS의 시장 전망을 더욱 밝게 하고 있다.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.5
• /
• pp.426-435
• /
• 2013

The diversity-multiplexing tradeoff (DMT) functions of three special half-duplex (HD) dynamic decode-and-forward (DDF) protocols with multiple antennas only at the source node, only at the destination node, and only at the relay node are analytically derived. The DMT functions of these three relay protocols are compared with one another and with those of the nonorthogonal amplify and forward (NAF) protocols.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.23 no.11
• /
• pp.1355-1362
• /
• 1999

An experimental study on a double-concentric diffusion flame(DDF) has been carried on in order to Investigate the characteristics of soot formation compared to a normal coflow diffusion flame(NDF). Laser extinction technique has been used for an ethylene($C_2H_4$) and air flame with various flow rates. Soot formation In the double-concentric diffusion flame was enhanced by the inner inverse diffusion flame due to the increase in flame temperature and also suppressed due to the nitrogen-dilution from the inner air. Soot concentration at the flame axis of DDF was higher than that of the NDF, mainly because of the increase of temperature by inner flame. However, the maximum soot volume fraction of DDF was lower than NDF at the outer side of the flame, mainly due to the effect of nitrogen-dilution from the inner air.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.34D no.3
• /
• pp.123-130
• /
• 1997

We determine the dispersion profile of a dispersion decreasing fiber(DDF) for optimum pulse compression from a trade-off between high pulse compression and low pedestal power/short DDF length. We find that the optimum vlaue of the exponential dispersion decreasing factor .alpha. is 0.95 and that the corresponding optimum fiber length is 1.5 times of the initial soliton period. Passing through the dDF, ~10 times of pulse comparession ratio can be achieved without significant increase in pedestal power. To compress relatively broad pulses using a given DDF optimized at a specific pulse width, we also detemrine the optimum input pulse amplitude, as a function of input pulse width.